Electrochemical determination of citalopram by adsorptive stripping voltammetry–determination in pharmaceutical products

The electrochemical behavior of citalopram was studied by square-wave and square-wave adsorptive-stripping voltammetry (SWAdSV). Citalopram can be reduced and accumulated at a mercury drop electrode, with a maximum peak current intensity being obtained at a potential of approximately -1.25V vs. AgCl/Ag, in an aqueous electrolyte solution of pH 12. A SWAdSV method has been developed for the determination of citalopram in pharmaceutical preparations. The method shows a linear range between 1.0x10-7 and 2.0x10-6 mol L-1 with a limit of detection of 5x10-8 mol L-1 for an accumulation time of 30 s. The precision of the method was evaluated by assessing the repeatability and intermediate precision, achieving good relative standard deviations in all cases (≤2.3%). The proposed method was applied to the determination of citalopram in five pharmaceutical products and the results obtained are in good agreement with the labeled values.

Citrate selective electrodes for the flow injection analysis of soft drinks, beers and pharmaceutical products

Aiming the establishment of simple and accurate readings of citric acid (CA) in complex samples, citrate (CIT) selective electrodes with tubular configuration and polymeric membranes plus a quaternary ammonium ion exchanger were constructed. Several selective membranes were prepared for this purpose, having distinct mediator solvents (with quite different polarities) and, in some cases, p-tert-octylphenol (TOP) as additive. The latter was used regarding a possible increase in selectivity. The general working characteristics of all prepared electrodes were evaluated in a low dispersion flow injection analysis (FIA) manifold by injecting 500µl of citrate standard solutions into an ionic strength (IS) adjuster carrier (10−2 mol l−1) flowing at 3ml min−1. Good potentiometric response, with an average slope and a repeatability of 61.9mV per decade and ±0.8%, respectively, resulted from selective membranes comprising additive and bis(2-ethylhexyl)sebacate (bEHS) as mediator solvent. The same membranes conducted as well to the best selectivity characteristics, assessed by the separated solutions method and for several chemical species, such as chloride, nitrate, ascorbate, glucose, fructose and sucrose. Pharmaceutical preparations, soft drinks and beers were analyzed under conditions that enabled simultaneous pH and ionic strength adjustment (pH = 3.2; ionic strength = 10−2 mol l−1), and the attained results agreed well with the used reference method (relative error < 4%). The above experimental conditions promoted a significant increase in sensitivity of the potentiometric response, with a supra-Nernstian slope of 80.2mV per decade, and allowed the analysis of about 90 samples per hour, with a relative standard deviation <1.0%.

Determination of methiocarb and Its degradation products, methiocarb sulfoxide and methiocarb sulfone, in bananas using QuEChERS extraction

The present work describes the development of an analytical method for the determination of methiocarb and its degradation products (methiocarb sulfoxide and methiocarb sulfone) in banana samples, using the QuEChERS (quick, easy, cheap, effective, rugged, and safe) procedure followed by liquid chromatography coupled to photodiode array detector (LCPAD). Calibration curves were linear in the range of 0.5−10 mg L−1 for all compounds studied. The average recoveries, measured at 0.1 mg kg−1 wet weight, were 92.0 (RSD = 1.8%, n = 3), 84.0 (RSD = 3.9%, n = 3), and 95.2% (RSD = 1.9%, n = 3) for methiocarb sulfoxide, methiocarb sulfone, and methiocarb, respectively. Banana samples treated with methiocarb were collected from an experimental field. The developed method was applied to the analysis of 24 samples (peel and pulp) and to 5 banana pulp samples. Generally, the highest levels were found for methiocarb sulfoxide and methiocarb. Methiocarb sulfone levels were below the limit of quantification, except in one sample (not detected).

Consolidating preservative-treated wood: Combined mechanical performance of boron and polymeric products in wood degraded by Coniophora puteana

When timber elements in heritage buildings are moderately degraded by fungi and assuming underlying moisture problems have been solved, two actions can be taken: i) use a biocide to stop fungal activity; ii) consolidate the degraded elements so that the timber keeps on fulfilling its structural and decorative functions. The aim of this work is to investigate the mechanical performance of maritime pine wood degraded by fungi after being treated with a biocide followed by impregnation with a polymer product. Three commercially available products were used: a boron water-based biocide, an acrylic consolidant and an epoxy-based consolidant. Treated and consolidated specimens were subjected to mechanical tests: axial compression test (NP 618), static surface hardness (ISO 3350) and bending test (NP 619). Sets of replicates were subjected to an evaporation ageing test (EN 73) after application of the products and also tested for mechanical behaviour. An increase in mechanical strength was observed for both consolidants with no significant influence from the previous use of biocide product. The specimens subjected to ageing showed a slightly better general mechanical performance.

Filament wound products made with thermoplastic matrix towpregs

Cost-effective glass-reinforced thermoplastic matri x towpregs produced by a powder coating line were used to manufacture composite pipes by fi lament winding. A conventional 6 axes filament-winding equipment was adapted for processi ng such structures. The influence of the filament winding speed and mandrel temperature on t he composite final properties was studied in the present work. An optimized processin g window was established by comparing the composite theoretical expected mechanical prope rties with the experimentally obtained ones. The final properties determined on the produc ed pipes and structures and the technological changes introduced to the conventiona l filament-winding equipment will be presented and discussed. Besides the processing des cription and conditions, it will be presented the relationship between processing condi tions and mechanical properties.

A Web-Based geographical information system prototype on Portuguese traditional food products

Dissertation submitted in partial fulfilment of the requirements for the Degree of Master of Science in Geospatial Technologies

Study on the growth promoting capacity of calf and fetal bovine serum for animal cells "in vitro" II: electrophoretic study and survey on the antiproteolytic activity of pools of calf and fetal bovine serum

Calf serum and fetal bovine serum present great variability as to its growth promoting efficiency (GPE). As supplement of culture media to cultivate cells of animal origin they stimulate the "in vitro" multiplication and maintain cell viability. When fourteen lots of calf sera of variable GPE had the total protein contents as well as the percentages of serum fractions determined, no significant differences that could possibly explain the variability of the GPE were observed. Evaluation of the antiproteolytic activity of nineteen lots of calf serum and eighteen serum lots of younger calves showed that the former exhibited lower antiproteolytic titers (1:40 to 1:80) than the latter (1:80 to 1:160). Twelve lots of fetal bovine serum studied in parallel, showed the highest concentration of antiproteolytic factors, with titers equal to 1:320. Sera of bovine origin, but not fetal sera, are usually heat-inactivated, what was demonstrated to be responsible for the decrease of the antiproteolytic activity of 75% of the lots tested. This could explain the inability of certain heat-inactivated sera in promoting multiplication of some cells "in vitro", as verified with primary monkey kidney cells. The results obtained in this study indicated the convenience of submiting each lot of serum to be introduced in cell culture to previous determination of its characteristics, such as growth promoting efficiency, antiproteolytic activity and also toxicity, absence of extraneous agents, etc., in order to minimize the possibility of using serum lots of questionable quality, thus preventing not only the loss of cell lines, but also undesirable and sometimes expensive delays.

Novos processos e produtos para o couro de base vegetal

Mestrado em Engenharia Química - Ramo Optimização Energética na Indústria Química

Production of recombinant protein hLIF in static and dynamic systems of animal cell culture

Thesis for the Degree of Master of Science in Biotechnology Universidade Nova de Lisboa, Faculdade de Ciências e Tecnologia

Species and biotype distribution of thermotolerant Campylobacters in animal reservoirs in Southern Chile

The prevalence of thermotolerant Campylobacters in mammals and birds from Southern Chile was determined. Campylobacters were isolated from 46.3% of the animals studied being C. jejuni biotipe 1 the most frequent (25.7%) followed by C. coli (17.4%) and C. jejuni biotipe 2 (3.2%).

A detecção remota e os SIG na produção animal - análise da contribuição e situação actual

Dissertação apresentada como requisito parcial para obtenção do grau de Mestre em Ciência e Sistemas de Informação Geográfica

Innovative manufacturing process for hybrid pultruded products based on cork and polymeric pre-shapes

Pultruded products are being targeted by a growing demand due to its excellent mechanical properties and low chemical reactivity, ensuring a low level of maintenance operations and allowing an easier assembly operation process than equivalent steel bars. In order to improve the mechanical drawing process and solve some acoustic and thermal insulation problems, pultruded pipes of glass fibre reinforced plastics (GFRF) can be filled with special products that increase their performance regarding the issues previously referred. The great challenge of this work was drawing a new equipment able to produce pultruded pipes filled with cork or polymeric pre-shaped bars as a continuous process. The project was carried out successfully and the new equipment was built and integrated in the pultrusion equipment already existing, allowing to obtain news products with higher added-value in the market, covering some needs previously identified in the field of civil construction.

Exposure to acellular blood products and risk of HIV infection in hemophiliacs from Belo Horizonte, Brazil

Results of a HIV prevalence study conducted in hemophiliacs from Belo Horizonte, Brazil are presented. History of exposure to acellular blood components was determined for the five year period prior to entry in the study, which occurred during 1986 and 1987. Patients with coagulations disorders (hemophilia A = 132, hemophilia B = 16 and coagulation disorders other than hemophilia = 16) were transfused with liquid cryoprecipitate, locally produced, lyophilized cryoprecipitate, imported from São Paulo (Brazil) and factor VIII and IX, imported from Rio de Janeiro (Brazil), Europe, and United States. Thirty six (22%) tested HIV seropositive. The univariate and multivariate analysis (logistic model) demonstrated that the risk of HIV infection during the study period was associated with the total units of acellular blood components transfused. In addition, the proportional contribution of the individual components to the total acellular units transfused, namely a increase in factor VIII/IX and lyophilized cryoprecipitate proportions, were found to be associated with HIV seropositivity. This analysis suggest that not only the total amount of units was an important determinant of HIV infection, but that the risk was also associated with the specific component of blood transfused

Febre purpúrica brasileira, virulência em modelo animal do Haemophilus Aegyptius (H. influenzae biogrupo aegyptius)

Febre Purpúrica Brasileira (FPB) é causada por cepas invasoras de Haemophilus aegyptius (H. influenzae biogrupo aegyptius, Hae). Estas cepas invasoras foram diferenciadas de cepas de Hae associadas apenas a conjuntivites (cepas não invasoras) através de marcadores moleculares específicos. Modelo de ratos recém nascidos depletados de complemento foi aplicado ao estudo de cepas de Hae, associadas e não associadas a FPB, com o objetivo de se caracterizar seus potenciais de virulência. Com dose infectante de 10(5) células, as cepas invasoras causaram bacteriemia em 80-100% dos ratos inoculados,.e a magnitude da bacteriemia variou de 10(2,5±0,49) a > 10(4,69) ufc/ml de sangue. Usando a mesma dose infectante as cepas controles não causaram bacteriemia frequente (0 a 50%) e a magnitude variou de 0 a 10(3,69±0,53) ufc/ml de sangue. As doses infectantes capazes de causar bacteriemia em 50% dos ratos inoculados (DB50%) para as cepas invasoras de Hae variaram de < 10³ a 10(4,2) bactérias, enquanto que para as cepas não invasoras, as DB50% variaram de 10(6,2) a > 10(7,3) bactérias. Imunização passiva com antissoros produzidos com cepas invasoras demonstrou que os ratos foram protegidos das bacteriemias causadas pelas cepas homólogas, mas não da infecção causada pela cepa heteróloga. Comparando a bacteriemia causada pelas cepas de Hae com a bacteriemia causada pelo H. influenzae b, cepa Eagan (Hib), foi demonstrado o maior potencial de invasibilidade de Hib. Este modelo animal demonstrou ser útil para esclarecer o maior potencial de virulência das cepas invasoras de Hae.

Downstream processing development of enveloped viruses for clinical applications: innovative tools for rational process optimization

Dissertation presented to obtain a Ph.D. degree in Engineering and Technology Sciences, Biotechnology at the Instituto de Tecnologia Química e Biológica, Universidade Nova de Lisboa