The prospects for the EU-Ukraine free trade agreement. OSW Commentary No. 94, 2012-10-15

The European Union and Ukraine initialled the Deep and Comprehensive Free Trade Area Agreement (DCFTA) on 19 July 2012. The scope of the agreement which the EU and Ukraine reached following their negotiations is much more extensive than that of a typical free trade agreement. It envisages not only the lifting of tariff and extra-tariff barriers but also, more importantly, Kyiv adopting EU legal solutions and standards in this area. Whether the agreement will be signed and implemented is still an open question and depends on the existing political conditions. On the one hand, the repression imposed by the government in Kyiv on its political opponents (including the detention of the former prime minister, Yulia Tymoshenko) has provoked criticism from the EU, which refuses to sign the agreement if the government in Kyiv continues to violate democratic principles. The manner in which Ukraine’s parliamentary elections are conducted this October will be the key test. On the other hand, Russia is increasingly active in its efforts to involve Ukraine in the integration projects it has initiated (the Customs Union and the Eurasian Economic Community). It should be noted that Moscow has effective instruments to exert its will, such as the dependence of the Ukrainian economy on supplies of Russian oil and gas and on exports to the Russian market. Besides, Moscow also has political instruments at its disposal. It is impossible to participate in integration projects both with the EU and with Russia. Therefore, Kyiv will have to make a strategic decision and choose the direction of its economic integration. Unless Ukraine takes concrete action to implement its agreements with the EU, primarily including the free trade agreement, its economic dependence on Russia will grow, and it will be more likely to join the Russian integration projects.

The solvent-solvent extraction of uranium from sulfuric acid solutions with oil soluble amines /

Fifty oil soluble amines were screened for possible use as extractants for uranium from sulfuric acid solutions. The most promising of these were studied further to obtain the optimum conditions for operation of such a process. Kerosene was used as the diluent.

Vasa Creek Channel Conditions and Slope Stability, Bellevue, Washington

The focus of this report is is the channel conditions at Vasa Creek, Bellevue, Washington, with regard to kokanee habitat and slope stability. This required a geomorphic and geologic assessment of the stream and riparian corridor along Vasa Creek. I focused my efforts in a 720m study-reach just south of I-90 in which City of Bellevue had no information. My assessment is divided into 3 categories: channel morphology, geology, and landslide hazards. I described the channel morphology by determining the gradient of the channel, longitudinal and cross-channel geometries, grain size distribution, embeddedness observations, type of channel reaches present, and the locations of significant in-channel woody-debris, landslides, scarps, landslide debris, and erosional features. This was done by conducting a longitudinal survey, 7 cross-channel surveys, pebble counts, and visual observations with the aid of a GPS device for mapping. I completed my geological assessment using both field observations and borehole data provided by GeoMapNW. Borehole data provided logs of the subsurface material at specific locations. In the field, I interpreted local geology using material in the channel as well as exposures in the adjacent slope. I completed the landslide hazard assessment using GIS methods supplemented by field observations. GIS methods included the use of aerial LiDAR to discern slope values and locations of features. Features of interest include the locations of scarps, landslides, landslide debris, and erosional features which were observed in the field. I classified 4 slope classes using ArcMap10 along with the locations of previously mapped landslides, scarps, and landslide debris. I describe the risk of slope failure according to the Washington Administration Code definition of critical areas (WAC 365-190-120 6a-i). My results are presented in the form of a map suite containing a channel morphology map, geology map, and landslide hazard map. The channel is a free-formed alluvial plane-bed reach with infrequent step-pools with riffles associated with landslide debris that chokes the channel. Overall I found that there is not the potential for kokanee habitat due flashy behavior (sudden high flow events), landslide inundation, and a lack of favorable conditions within the channel. The updated geologic map displays advance outwash deposits and alluvium present within the study-reach, as opposed to exposures of the Blakeley Formation along with other corrections from borehole data interpretations. The landslide hazard map shows that there are areas at high risk for slope failure along the channel that should be looked into further.

Analysis of the free vibration of rectangular plates with central cut-outs using the discrete Ritz method

We present an analysis of the free vibration of plates with internal discontinuities due to central cut-outs. A numerical formulation for a basic L-shaped element which is divided into appropriate sub-domains that are dependent upon the location of the cut-out is used as the basic building element. Trial functions formed to satisfy certain boundary conditions are employed to define the transverse deflection of each sub-domain. Mathematical treatments in terms of the continuities in displacement, slope, moment, and higher derivatives between the adjacent sub-domains are enforced at the interconnecting edges. The energy functional results, from the proper assembly of the coupled strain and kinetic energy contributions of each sub-domain, are minimized via the Ritz procedure to extract the vibration frequencies and. mode shapes of the plates. The procedures are demonstrated by considering plates with central cut-outs that are subjected to two types of boundary conditions. (C) 2003 Elsevier Ltd. All rights reserved.

Measurement of free drug and clinical end-point by high-performance liquid chromatography-mass spectrometry: Applications and implications for pharmacokinetic and pharmacodynamic studies

Free drug measurement and pharmacodymanic markers provide the opportunity for a better understanding of drug efficacy and toxicity. High-performance liquid chromatography (HPLC)-mass spectrometry (MS) is a powerful analytical technique that could facilitate the measurement of free drug and these markers. Currently, there are very few published methods for the determination of free drug concentrations by HPLC-MS. The development of atmospheric pressure ionisation sources, together with on-line microdialysis or on-line equilibrium dialysis and column switching techniques have reduced sample run times and increased assay efficiency. The availability of such methods will aid in drug development and the clinical use of certain drugs, including anti-convulsants, anti-arrhythmics, immunosuppressants, local anaesthetics, anti-fungals and protease inhibitors. The history of free drug measurement and an overview of the current HPLC-MS applications for these drugs are discussed. Immunosuppressant drugs are used as an example for the application of HPLC-MS in the measurement of drug pharmacodynamics. Potential biomarkers of immunosuppression that could be measured by HPLC-MS include purine nucleoside/nucleotides, drug-protein complexes and phosphorylated peptides. At the proteomic level, two-dimensional gel electrophoresis combined with matrix-assisted laser desorption/ionisation time-of-flight (TOF) MS is a powerful tool for identifying proteins involved in the response to inflammatory mediators. (C) 2003 Elsevier Science B.V. All rights reserved.

Growth, viral production and metabolism of a Helicoverpa zea cell line in serum-free culture

Insect cell cultures have been extensively utilised for means of production for heterologous proteins and biopesticides. Spodoptera frugiperda (Sf9) and Trichoplusia ni (High Five(TM)) cell lines have been widely used for the production of recombinant proteins, thus metabolism of these cell lines have been investigated thoroughly over recent years. The Helicoverpa zea cell line has potential use for the production of a biopesticide, specifically the Helicoverpa armigera single-nucleocapsid nucleopolyhedrovirus (HaSNPV). The growth, virus production, nutrient consumption and waste production of this cell line was investigated under serum-free culture conditions, using SF900II and a low cost medium prototype (LCM). The cell growth ( growth rates and population doubling time) was comparable in SF900II and LCM, however, lower biomass and cell specific virus yields were obtained in LCM. H. zea cells showed a preference for asparagine over glutamine, similar to the High Five(TM) cells. Ammonia was accumulated to significantly high levels (16 mM) in SF900II, which is an asparagine and glutamine rich medium. However, given the absence of asparagine and glutamine in the medium ( LCM), H. zea cells adapted and grew well in the absence of these substrates and no accumulation of ammonia was observed. The adverse effect of ammonia on H. zea cells is unknown since good production of biologically active HaSNPV was achieved in the presence of high ammonia levels. H. zea cells showed a preference for maltose even given an abundance supply of free glucose. Accumulation of lactate was observed in H. zea cell cultures.

Electrochemical synthesis of melanin free-standing films

Free-standing melanin films were successfully synthesised electrochemically from dopa. The Optimum synthetic conditions such as pH, concentration and current were determined, and it was found that free-standing film,.; could only be formed when ITO glass electrodes were used. The films were analysed by solid state NMR and XPS which showed the presence of indolic moieties characteristic of melanin-type macromolecules. The film showed higher conductivity than chemically synthesised melanin previously reported in literature and also exhibited photoconductivity. (c) 2005 Elsevier Ltd. All rights reserved.

Hydraulics of skimming flows on stepped chutes: The effects of inflow conditions?

Modern stepped spillways are typically designed for large discharge capacities corresponding to a skimming flow regime for which flow resistance is predominantly form drag. The writer demonstrates that the inflow conditions have some effect on the skimming flow properties. Boundary layer calculations show that the flow properties at inception of free-surface aeration are substantially different with pressurized intake. The re-analysis of experimental results highlights that the equivalent Darcy friction factor is f similar to 0.2 in average on uncontrolled stepped Chute and f similar to 0.1 on stepped chute with pressurized intake. A simple design chart is presented to estimate the residual flow velocity, and the agreement of the calculations with experimental results is deemed satisfactory for preliminary design.

Effect of adsorption deformation on thermodynamic characteristics of a fluid in slit pores at sub-critical conditions

Solvation. pressure due to adsorption of fluids in porous materials is the cause of elastic deformation of an adsorbent, which is accessible to direct experimental measurements. Such a deformation contributes to the Helmholtz free energy of the whole adsorbent-adsorbate system due to accumulation of compression or tension energy by the solid. It means that in the general case the solid has to be considered as not solely a source of the external potential field for the fluid confined in the pore volume, but also as thermodynamically nonmert component of the solid-fluid system. We present analysis of nitrogen adsorption isotherms and heat of adsorption in slit graphitic pores accounting for the adsorption deformation by means of nonlocal density functional theory. (c) 2006 Elsevier Ltd. All rights reserved.

Preparation of poly (alkylcyanoacrylate) nanoparticles by polymerization of water-free microemulsions

Phase diagrams of the pseudoternary systems ethyloleate, polyoxyethylene 20 sorbitan mono-oleate/sorbitan monolaurate and propylene glycol with and without butanol as a co-surfactant were prepared. Areas containing optically isotropic, one-phase systems were identified and samples therein designated as droplet, bicontinuous or solution type microemulsions using conductivity, viscosity and self-diffusion NMR. Nanoparticles were prepared by polymerization of selected microemulsions with ethyl-2-cyanoacrylate and the morphology of the particles was investigated. Addition of monomer to all types of microemulsions led to the formation of nanoparticles, which had an average size of 244 +/- 25 nm, an average polydispersity index of 0.15 +/- 0.04 and a zeta-potential of -17 +/- 3 mV. The formation of particles from water-free microemulsions of different types is surprising, particularly considering that polymerization is expected to occur at a water-oil interface by base-catalysed polymerization. It would appear that propylene glycol is sufficiently nucleophilic to initiate the polymerization. The use of water-free microemulsions as templates for the preparation of poly (alkylcyanoacrylate) nanoparticles opens up interesting opportunities for the encapsulation of bioactives which do not have suitable properties for encapsulation on the basis of water-containing microemulsions.

The effect of box shape on the dynamic properties of proteins simulated under periodic boundary conditions

The effect of the box shape on the dynamic behavior of proteins simulated under periodic boundary conditions is evaluated. In particular, the influence of simulation boxes defined by the near-densest lattice packing (NDLP) in conjunction with rotational constraints is compared to that of standard box types without these constraints. Three different proteins of varying size, shape, and secondary structure content were examined in the study. The statistical significance of differences in RMSD, radius of gyration, solvent-accessible surface, number of hydrogen bonds, and secondary structure content between proteins, box types, and the application or not of rotational constraints has been assessed. Furthermore, the differences in the collective modes for each protein between different boxes and the application or not of rotational constraints have been examined. In total 105 simulations were performed, and the results compared using a three-way multivariate analysis of variance (MANOVA) for properties derived from the trajectories and a three-way univariate analysis of variance (ANOVA) for collective modes. It is shown that application of roto-translational constraints does not have a statistically significant effect on the results obtained from the different simulations. However, the choice of simulation box was found to have a small (5-10%), but statistically significant effect on the behavior of two of the three proteins included in the study. (c) 2005 Wiley Periodicals, Inc.

Expansion tube operating conditions for studying nonequilibrium radiation relevant to Titan Aerocapture

The predictions of nonequilibrium radiation in the shock layer for a Titan aerocapture aeroshell vary significantly amongst Computational Fluid Dynamics (CFD) analyses and are limited by the physical models of the nonequilibrium flow processes. Of particular interest are nonequilibrium processes associated with the CN molecule which is a strong radiator. It is necessary to have experimental data for these radiating shock layers which will allow for validation of the CFD models. This paper describes the development of a test flow condition for subscale aeroshell models in a superorbital expansion tunnel. We discuss the need for a Titan gas condition that closely simulates the atmospheric composition and present experimental data of the free stream test flow conditions. Furthermore, we present finite-rate CFD calculations of the facility to estimate the remaining free stream conditions, which cannot be directly measured during experiments.