Ti:sapphire laser pumped high average power laser crystal Nd:GGG with high efficiency output

High-quality neodymium doped GGG laser crystals have been grown by Czochralski (Cz) method. Results of Nd:GGG thin chip laser operating at 1.064 μm pumped by Ti:sapphire laser operating at 808 nm were reported. The slop efficiency was as high as 20%.

Design of high-efficiency diffraction gratings based on total internal reflection for pulse compressor

We present designs of high-efficiency compression grating based on total internal reflection (TIR) for picosecond pulse laser at 1053 nm. The setup is devised by directly etching gratings into the bottom side of a prism so that light can successfully enter (or exit) the compression grating. Dependence of the -1 order diffraction efficiencies on the constructive parameters is analyzed for TE- and TM-polarized incident light at Littrow angle by using Fourier modal method in order to obtain optimal grating structure. The electric field enhancement within the high-efficiency TIR gratings is regarded as another criterion to optimize the structure of the TIR gratings. With the criterion of high diffraction efficiency, low electric field enhancement and sufficient manufacturing latitude, TIR compression gratings with optimized constructive parameters are obtained for TE- and TM-polarized incident light, respectively. The grating for TE-polarized light exhibits diffraction efficiencies higher than 0.95 within 23 nm bandwidth and relatively low square of electric field enhancement ratio of 5.7. Regardless of the internal electric field enhancement, the grating for TM-polarized light provides diffraction efficiencies higher than 0.95 within 42 nm bandwidth. With compact structure, such TIR compression gratings made solely of fused silica should be of great interest for application to chirped pulse amplification (CPA) systems. (c) 2007 Elsevier B.V. All rights reserved.

Design of high-efficiency diffraction gratings based on rigorous coupled-wave analysis for 800nm wavelength

We report on the design of a high diffraction efficiency multi-layer dielectric grating with wide incident angle and broad bandwidth for 800 nm. The optimized grating can achieve > 95% diffraction efficiency in the first order at an incident angle of 5 degrees from Littrow and a wavelength from 770nm to 830 nm, with peak diffraction efficiency of > 99.5% at 800 nm. The electric field distribution of the optimized multi-layer dielectric grating within the gratings ridge is 1.3 times enhancement of the incidence light, which presents potential high laser resistance ability. Because of its high-efficiency, wide incident, broad bandwidth and potential high resistance ability, the multi-layer dielectric grating should have practical application in Ti:sapphire laser systems.

An assessment of the efficiency of three active fish capture methods and a study of roach / bream hybrids on the Crossens drainage system near Southport.

An assessment of three methods of fish capture, to establish the best fishing method which reflects the best range of sizes and species of fish in a given area. The methods used were trawl netting, electrofishing, and seine netting which were assessed on the Crossens drainage system near Southport. The report also includes a study of roach / bream hybrids that were found at the site, which focuses on their distinguishing features and compared with the features of roach and bream.

A preliminary investigation of Elastomer Visible Implant (EVI)tag retention rates and the effect of tagging on the growth and survival of barbel (Barbus barbus L.).

The Elastomer Visible Implant system (EVI) is a relatively new technique for batch marking fish. The aim of this study was to assess retention rates and the possible effects of tagging on the growth and mortality of barbel, Barbus barbus, (81-197mm, fork length) over approximately 2 months using a syringe injection system.

Efficiency improvement of organic light-emitting diodes using 8-hydroxy-quinolinato lithium as an electron injection layer

Organic light-emitting diodes (OLEDs) using tris-(8-hydroxy-quinolinato) aluminum (Alq(3)) as an emitter, 8-hydroxy-quinolinato lithium (Liq) as an electron injection layer, were prepared. Experimental results show that the efficiency of device with Liq is three times higher than that without Liq. The device using Liq as an injection layer is less sensitive in efficiency to the Liq thickness than that using LiF. In addition to the Alq3 based devices, Liq is also very effective as an electron injection layer for 4,4'-bis(2,2-diphenylvinyl)-1,1'-biphenyl based blue OLED and poly (2-methoxy,5-(2-ethyl-hexyloxy)-1,4-phenylenevinylene) based orange polymer OLED. (c) 2004 Elsevier B.V. All rights reserved.

Statistical inference about the relative efficiency of a new survey protocol, based on paired-tow survey calibration data

Paired-tow calibration studies provide information on changes in survey catchability that may occur because of some necessary change in protocols (e.g., change in vessel or vessel gear) in a fish stock survey. This information is important to ensure the continuity of annual time-series of survey indices of stock size that provide the basis for fish stock assessments. There are several statistical models used to analyze the paired-catch data from calibration studies. Our main contributions are results from simulation experiments designed to measure the accuracy of statistical inferences derived from some of these models. Our results show that a model commonly used to analyze calibration data can provide unreliable statistical results when there is between-tow spatial variation in the stock densities at each paired-tow site. However, a generalized linear mixed-effects model gave very reliable results over a wide range of spatial variations in densities and we recommend it for the analysis of paired-tow survey calibration data. This conclusion also applies if there is between-tow variation in catchability.

Evaluation of the capture efficiency and size selectivity of four pot types in the prospective fishery for North Pacific giant octopus (Enteroctopus dofleini)

Over 230 metric tons of octopus is harvested as bycatch annually in Alaskan trawl, long-line, and pot fisheries. An expanding market has fostered interest in the development of a directed fishery for North Pacific giant octopus (Enteroctopus dofleini). To investigate the potential for fishery development we examined the efficacy of four different pot types for capture of this species. During two surveys in Kachemak Bay, Alaska, strings of 16 –20 sablefish, Korean hair crab, shrimp, and Kodiak wooden lair pots were set at depths ranging between 62 and 390 meters. Catch per-unit-of-ef for t estimates were highest for sablefish and lair pots. Sablefish pots caught significantly heavier North Pacific giant octopuses but also produced the highest bycatch of commercially important species, such as halibut (Hippoglossus stenolepis), Pacific cod (Gadus macrocephalus), and Tanner crab (Chionoecetes bairdi).

Efficiency and catch dynamics of collapsible square and conical pots used in the red king crab (Paralithodes camtschaticus) fishery

We compared the capture efficiency and catch dynamics of collapsible square and conical pots used in resource assessment and harvesting of red king crabs (Paralithodes camtschaticus [Tilesius, 1815]) in the Barents Sea. After two days of soaking, square pots caught three times as many crabs as conical pots, and their catches consisted of a higher proportion of male crabs and male crabs larger than 160 mm carapace length compared to the catches in the conical pots. Catches in the square pots did not increase as soak times were increased beyond two days, which indicates equilibrium between the rate of entries into and the rate of exits from the pots. Catches in conical pots, however, increased with increasing soak times up to eight days, the longest soak time examined in this study. These findings demonstrate the higher efficiency of square pots and the importance of understanding catch dynamics when making population assessments based on catchper-unit-of-effort data. The favorable catch characteristics and handling properties of the collapsible square pot may make this pot design suitable for other crab fisheries, as well.