Incipient turn-to-turn winding fault diagnosis of power transformers by the on-load exciting current Extended Park`s Vector Approach

This paper presents the application of the on-load exciting current Extended Park's Vector Approach for diagnosing incipient turn-to-turn winding faults in operating power transformers. Experimental and simulated test results demonstrate the effectiveness of the proposed technique, which is based on the spectral analysis of the AC component of the on-load exciting current Park's Vector modulus.

Transformers on-load exciting current Park`s vector approach as a tool for winding faults diagnostics

This paper presents the development of a new approach for diagnosing the occurrence of inter-turn short-circuits in the windings of three-phase transformers, which is based on the on-line monitoring of the on-load exciting current Park's Vector patterns. Experimental and simulated results demonstrate the effectiveness of the proposed technique for detecting winding inter-turn insulation faults in operating three-phase transformers.

Detection of trasformer intermittent winding faults by the on-load exciting current Park`s vector approach

This paper presents the application of the on-load exciting current Park's Vector Approach for diagnosing permanent and intermittent turn-to-turn winding faults in operating power transformers. First, an experimental investigation of the behaviour of the transformer under the occurrence of both permanent and intermittent winding faults is presented. Finally, experimental test results demonstrate the effectiveness of the proposed diagnostic technique, which is based on the on-line monitoring of the on-load exciting current Park's Vector patterns.

EU water framework directive: will the nitrate load reduction from diffuse sources produce the same results in all estuaries?

The impact of urban waste-water and non-point nitrate discharges in estuarine and near-shore coastal waters are analyzed. The study is focused on the effects of applying the European directives 91/271/EEC and 91/676/EEC to these systems. 4 Portuguese estuaries and two coastal lagoons with different characteristics are studied. A modelling system is applied and calibrated in each system. Three nitrate load scenarios are examined. It is shown that the morphologic and hydrodynamic characteristics of the domain largely control the ecological processes in these systems. The primary production limitation factors are split into “biologic” and “hydrodynamic” components. The physical limitation due to hydrodynamic and residence time is the most important factor. The combined limitation of “biologic” factors (temperature, light and nutrients availability) control productivity only in the systems where physical limitation is not important.

Application of Decision-Making Theory to the Regulation of Muscular Work Rate During Self-Paced Competitive Endurance Activity.

Successful participation in competitive endurance activities requires continual regulation of muscular work rate in order to maximise physiological performance capacities, meaning that individuals must make numerous decisions with regards to the muscular work rate selected at any point in time. Decisions relating to the setting of appropriate goals and the overall strategic approach to be utilised are made prior to the commencement of an event, whereas tactical decisions are made during the event itself. This review examines current theories of decision-making in an attempt to explain the manner in which regulation of muscular work is achieved during athletic activity. We describe rational and heuristic theories, and relate these to current models of regulatory processes during self-paced exercise in an attempt to explain observations made in both laboratory and competitive environments. Additionally, we use rational and heuristic theories in an attempt to explain the influence of the presence of direct competitors on the quality of the decisions made during these activities. We hypothesise that although both rational and heuristic models can plausibly explain many observed behaviours in competitive endurance activities, the complexity of the environment in which such activities occur would imply that effective rational decision-making is unlikely. However, at present, many proposed models of the regulatory process share similarities with rational models. We suggest enhanced understanding of the decision-making process during self-paced activities is crucial in order to improve the ability to understand regulation of performance and performance outcomes during athletic activity.

An investigation of container train service provision and load factors in Great Britain

The continued growth in the volume of international trade poses considerable economic and sustainability challenges, particularly as transport routes become more congested and concern grows about the role of transport movements in accelerating climate change. Rail freight plays a major role in the inland transport of containers passing through the main British container ports, and potentially could play a more significant role in the future. However, there is little detailed understanding of the nature of this particular rail market, especially in terms its current operating efficiency. This paper examines container train service provision to/from the four main ports, based on analysis of a representative survey of more than 500 container trains between February and August 2007. The extent to which the existing capacity is utilised is presented, and scenarios by which the number of containers carried could be increased without requiring additional train service provision are modelled, to identify the theoretical potential for greater rail volumes. Finally, the paper identifies the challenges involved in achieving higher load factors, emphasising the importance both of wider supply chain considerations and government policy decision-making.

Distributed Agent-Based Load Balancer for Cloud Computing

In this paper we present a concept of an agent-based strategy to allocate services on a Cloud system without overloading nodes and maintaining the system stability with minimum cost. To provide a base for our research we specify an abstract model of cloud resources utilization, including multiple types of resources as well as considerations for the service migration costs. We also present an early version of simulation environment and a prototype of agent-based load balancer implemented in functional language Scala and Akka framework.

A Meta-Heuristic Load Balancer for Cloud Computing Systems

This paper introduces a strategy to allocate services on a cloud system without overloading the nodes and maintaining the system stability with minimum cost. We specify an abstract model of cloud resources utilization, including multiple types of resources as well as considerations for the service migration costs. A prototype meta-heuristic load balancer is demonstrated and experimental results are presented and discussed. We also propose a novel genetic algorithm, where population is seeded with the outputs of other meta-heuristic algorithms.

Determination of electricity consumers’ load profiles via weighted evidence accumulation clustering using subsampling

With the electricity market liberalization, the distribution and retail companies are looking for better market strategies based on adequate information upon the consumption patterns of its electricity consumers. A fair insight on the consumers’ behavior will permit the definition of specific contract aspects based on the different consumption patterns. In order to form the different consumers’ classes, and find a set of representative consumption patterns we use electricity consumption data from a utility client’s database and two approaches: Two-step clustering algorithm and the WEACS approach based on evidence accumulation (EAC) for combining partitions in a clustering ensemble. While EAC uses a voting mechanism to produce a co-association matrix based on the pairwise associations obtained from N partitions and where each partition has equal weight in the combination process, the WEACS approach uses subsampling and weights differently the partitions. As a complementary step to the WEACS approach, we combine the partitions obtained in the WEACS approach with the ALL clustering ensemble construction method and we use the Ward Link algorithm to obtain the final data partition. The characterization of the obtained consumers’ clusters was performed using the C5.0 classification algorithm. Experiment results showed that the WEACS approach leads to better results than many other clustering approaches.

Typical load profiles in the smart grid context – a clustering methods comparison

The present research paper presents five different clustering methods to identify typical load profiles of medium voltage (MV) electricity consumers. These methods are intended to be used in a smart grid environment to extract useful knowledge about customer’s behaviour. The obtained knowledge can be used to support a decision tool, not only for utilities but also for consumers. Load profiles can be used by the utilities to identify the aspects that cause system load peaks and enable the development of specific contracts with their customers. The framework presented throughout the paper consists in several steps, namely the pre-processing data phase, clustering algorithms application and the evaluation of the quality of the partition, which is supported by cluster validity indices. The process ends with the analysis of the discovered knowledge. To validate the proposed framework, a case study with a real database of 208 MV consumers is used.

Fuzzy Monte Carlo mathematical model for load curtailment minimization in transmission power systems

This paper presents a methodology which is based on statistical failure and repair data of the transmission power system components and uses fuzzyprobabilistic modeling for system component outage parameters. Using statistical records allows developing the fuzzy membership functions of system component outage parameters. The proposed hybrid method of fuzzy set and Monte Carlo simulation based on the fuzzy-probabilistic models allows catching both randomness and fuzziness of component outage parameters. A network contingency analysis to identify any overloading or voltage violation in the network is performed once obtained the system states by Monte Carlo simulation. This is followed by a remedial action algorithm, based on optimal power flow, to reschedule generations and alleviate constraint violations and, at the same time, to avoid any load curtailment, if possible, or, otherwise, to minimize the total load curtailment, for the states identified by the contingency analysis. In order to illustrate the application of the proposed methodology to a practical case, the paper will include a case study for the Reliability Test System (RTS) 1996 IEEE 24 BUS.

Contextual intelligent load management with ANN adaptive learning module

With the current increase of energy resources prices and environmental concerns intelligent load management systems are gaining more and more importance. This paper concerns a SCADA House Intelligent Management (SHIM) system that includes an optimization module using deterministic and genetic algorithm approaches. SHIM undertakes contextual load management based on the characterization of each situation. SHIM considers available generation resources, load demand, supplier/market electricity price, and consumers’ constraints and preferences. The paper focus on the recently developed learning module which is based on artificial neural networks (ANN). The learning module allows the adjustment of users’ profiles along SHIM lifetime. A case study considering a system with fourteen discrete and four variable loads managed by a SHIM system during five consecutive similar weekends is presented.

Optimal scheduling of a renewable micro-grid in an isolated load area using mixed-integer linear programming

In the energy management of the isolated operation of small power system, the economic scheduling of the generation units is a crucial problem. Applying right timing can maximize the performance of the supply. The optimal operation of a wind turbine, a solar unit, a fuel cell and a storage battery is searched by a mixed-integer linear programming implemented in General Algebraic Modeling Systems (GAMS). A Virtual Power Producer (VPP) can optimal operate the generation units, assured the good functioning of equipment, including the maintenance, operation cost and the generation measurement and control. A central control at system allows a VPP to manage the optimal generation and their load control. The application of methodology to a real case study in Budapest Tech, demonstrates the effectiveness of this method to solve the optimal isolated dispatch of the DC micro-grid renewable energy park. The problem has been converged in 0.09 s and 30 iterations.

Intelligent SCADA for load control

A supervisory control and data acquisition (SCADA) system is an integrated platform that incorporates several components and it has been applied in the field of power systems and several engineering applications to monitor, operate and control a lot of processes. In the future electrical networks, SCADA systems are essential for an intelligent management of resources like distributed generation and demand response, implemented in the smart grid context. This paper presents a SCADA system for a typical residential house. The application is implemented on MOVICON™11 software. The main objective is to manage the residential consumption, reducing or curtailing loads to keep the power consumption in or below a specified setpoint, imposed by the costumer and the generation availability.

A influência da massagem na sensação retardada de desconforto muscular

Introdução: Apesar dos muitos estudos sobre a temática da sensação retardada de desconforto muscular, atualmente, ainda se discute a explicação dos mecanismos subjacentes a esta condição clínica, bem como, a sua prevenção e tratamento. A literatura sugere a massagem como uma das formas de terapia, contudo, os estudos têm mostrado resultados controversos. Objetivo: Verificar se a massagem aplicada 2 horas após um protocolo de exercício excêntrico tem influência na sensação retardada de desconforto muscular, bem como, se o seu efeito varia dependendo do tempo de aplicação. Métodos: 21 participantes (23,62±1,32 anos; 76,95±12,17 kg; 174,71±4,78 cm; 25,25±4,26 Kg/m 2) foram divididos em três grupos. Foi avaliada a dor, força muscular e a perimetria antes, e 2h, 24h, 48h, e 72h após um protocolo de exercício constituído por três séries de dez repetições de contrações excêntricas dos isquiotibiais do membro dominante, com 80% da força máxima, a uma velocidade constante de 60º/s, numa amplitude entre 0º e 80º, utilizando o dinamómetro isocinético Biodex System 4. A massagem foi efetuada 2 horas após o exercício em dois grupos experimentais com durações diferentes, sendo o terceiro grupo de controlo. Para identificar diferenças entre os grupos no momento inicial e na variável diferença entre o momento inicial e os restantes momentos, recorreu-se ao teste de Kruskal-Wallis, seguido de uma análise Post-Hoc através do teste de Dunn com um nível de significância de 0,05. Resultados: Verificou-se que a massagem teve efeito na redução da dor e na perimetria. Relativamente à força não foram encontradas alterações significativas. Conclusão: Os resultados mostraram que a massagem aplicada 2 horas após o exercício excêntrico, independentemente da duração utilizada, teve efeito na redução da dor, mas não na força muscular. Na perimetria apesar de haver alterações, estas não foram consideradas relevantes.