Ação promotora do berílio em catalisadores da síntese do estireno

The catalytic dehydrogenation of ethylbenzene in presence of steam is the main commercial route to produce styrene. The industrial catalysts are potassium- and chromia-doped hematite which show low surface areas leading to bad performance and short life. In order to develop catalysts with high areas, the effect of beryllium on the textural properties and on the catalytic performance of this iron oxide was studied. The influence of the amount of the dopant, the starting material and the calcination temperature were also studied. In sample preparations, iron and beryllium salts (nitrate or sulfate) were hydrolyzed with ammonia and then calcinated. The experiments followed a factorial design with two variables in two levels (Fe/Be= 3 and 7; calcination temperature= 500 and 700ºC). Solids without any dopant were also prepared. Samples were characterized by elemental analysis, infrared spectroscopy, surface area and porosity measurements, X-ray diffraction, DSC and TG. The catalysts were tested in a microreactor at 524ºC and 1 atm, by using a mole ratio of steam/ ethylbenzene=10. The selectivity was measured by monitoring styrene, benzene and toluene formation. It was found that the effect of beryllium on the characteristics of hematite and on its catalytic performance depends on the starting material and on the amount of dopant. Surface areas increased due to the dopant as well as the nature of the precursor; samples produced by beryllium sulfate showed higher areas. Beryllium-doped solids showed a higher catalytic activity when compared to pure hematite, but no significant influence of the anion of starting material was noted. It can be concluded that beryllium acts as both textural and structural promoter. Samples with Fe/Be= 3, heated at 500ºC, lead to the highest conversion and were the most selective. However, catalysts prepared from beryllium sulfate are the most promising to ethylbenzene dehydrogenation due to their high surface area which could lead to a longer life.

Membranas Inorgânicas e reatores catalíticos

Membrane reactors are reviewed with emphasis in their applications in catalysis field. The basic principles of these systems are presented as well as a historical development. The several kinds of catalytic membranes and their preparations are discussed including the problems, needs and challenges to be solved in order to use these reactors in commercial processes. Some applications of inorganic membrane reactors are also shown. It was concluded that these systems have a great potential for improving yield and selectivity of high temperature catalytic reactions. However, it is still an imerging technology with a need for a lot of fundamental research; several challenges should be overcome for the successful commercial application of these systems.

Propriedades texturais e catalíticas de óxidos de ferro contendo cromo e cobre

Chromium and copper-doped hematites were prepared with the aim of studying the synergistic effect of these dopants on the textural and on the catalytic properties of the iron oxides towards the high temperature shift reaction. It was found that the most active catalysts were those with the highest amount of copper. They had the Fe(II)/Fe(III) ratio near the stoichiometric value of magnetite, the highest surface areas under the reactional atmosphere and the greatest tendency to produce the active form; they also were poorly crystalline solids. The best performance was shown by the catalyst with Fe/Cu=10, heated at 300ºC. It can thus be concluded that copper acts both as textural and structural promoter in these catalysts.

Relato de uma experiência: recuperação e cadastramento de resíduos dos laboratórios de graduação do Instituto de Química da Universidade Federal do Rio Grande do Sul

An experience aiming to promote a residue interchange and recovery between the teaching laboratories of the Chemistry Institute of this University is described. At the present, several residues interchange have already appeared as advantageous. To make the work easier, a software has been developed in order to keep a record of all the residues generated by the teaching laboratories. Standard labels have been developed for the residues in order to organize them. The software and the label design are described.

Efeito da temperatura no desempenho catalítico de óxidos de ferro contendo cobre e alumínio

Aluminum and copper doped hematite was evaluated in the high temperature shift (HTS) reaction at several temperatures in order to find catalysts that can work in different operational conditions. It was found that the catalysts work in kinetic regime in the range of 300-400 ºC. Both copper and aluminum increases the activity and selectivity. Aluminum acts as textural promoter whereas copper acts as structural one. The most promising catalyst is that with both copper and aluminum which showed higher activity and selectivity than a commercial sample. This catalyst has the advantages of being non toxic and can work at low temperatures.

Desidrogenação do etilbenzeno sobre compostos de ferro e alumínio

Chromium and potassium-doped iron oxides are widely used as industrial catalysts in the dehydrogenation of ethylbenzene to produce styrene. They have several advantages but deactivate with time, because of the loss of potassium. Also, they are toxic due to chromium compounds. Therefore there is a need for developing alternative non toxic catalysts without potassium. Then, iron and aluminum compounds were prepared by different methods in this work. Different phases were produced depending on the preparation method. Aluminum-doped hematite was more active and selective to styrene than the aluminum ferrite. Aluminum acts both as textural and structural promoter in the catalysts.

Impacto dos catalisadores automotivos no controle da qualidade do ar

Advanced industrialized nations have experienced severe pollution problems over the past forty years, caused mainly by carbon monoxide, hydrocarbons and nitrogen oxide emissions from automobiles. Catalyst technology has played a major part in minimizing these emissions as required by even more restrictive laws. The catalyst has been optimized over the years to meet the requirements of high activity and long life. The oxidation of hydrocarbon and carbon monoxide are in advanced development stage while that of NOx catalysts is far less advanced. In the future, catalyst technology is expected to contribute to overcome the challenges to get a cleaner air.

Natureza do coque formado sobre a mordenita durante a transalquilação de benzeno

Zeolite catalysts have been extensively used in petroleum refining and the chemical industry although they are deactivated by coke deposition. In order to find the best condition to avoid deactivation, the coke formation on H-mordenite was studied in this work. The coke was produced during benzene transalkylation with C9+ aromatics, under several reaction conditions. It was found that hydrogenated coke was produced in all samples without affecting the selectivity of toluene and xylene formation. This is explained in terms of the mordenite structure and the presence of hydrogen.

Algas: da economia nos ambientes aquáticos à bioremediação e à química analítica

Algae constitute a large group of many different organisms, essentially aquatic and able to live in all systems giving them sufficient light and humidity. Some algae species have been used in the evaluation or in the bioremediation of aquatic systems. More recently algae have been suggested as interesting tools in the field of analytical chemistry. In this work the most important aspects related to the different uses of algae are presented with a brief discussion.

Ação promotora do zinco em catalisadores de síntese do estireno

Ethylbenzene dehydrogenation in the presence of steam is the main commercial route to produce styrene. The industrial catalyst is chromium and potassium-doped hematite, which easily deactivates with time due to potassium loss. In order to find non-toxic and potassium free catalysts, the promoter action of zinc on hematite was studied in this work. It was found that zinc acts as structural promoter by stabilizing the Fe3+ species (active phase) as maghemite. Although it decreases the specific surface area, it increases four times the catalytic activity as compared to hematite.

A natureza pedagógica da experimentação: uma pesquisa na licenciatura em química

In this paper we discuss the characteristics of experimental activities described by teachers and students in a teaching credentials course in Chemistry. The research pointed out a set of characteristics that seem to favor the learning process: the bringing up of the student's knowledge; the mediation by peers; the dialogue to set out the student's knowledge; the debate; the validation of arguments; the discussion about the context. The authors argument that, because of the empirical view of Science present in Chemistry courses, the discussion about the nature of Science is important.

Degradação e estabilização do diclofenaco em nanocápsulas poliméricas

The parameters which affect the degradation and stabilization of diclofenac in suspensions of nanocapsules and of the corresponding spray-dried powders were investigated. Formulations were subjected to 14 months of storage at room temperature. In addition, a study of the degradation of diclofenac was carried out by exposing the formulations or mixtures (drug and adjuvants) to UVC wavelengths. The presence of Epikuron 170® in a concentration higher than 3.06 mg/mL stabilizes the drug, avoiding its reduction or degradation. The degradation products were isolated, analyzed by gas chromatography-mass spectrometry, and identified as 2-(2',6'-dichlorophenyl)aminobenzyl alcohol and N-(2',6'-dichlorophenyl)anthranilylaldehyde.

Efeito do cromo nas propriedades catalíticas da MCM-41

The effect of chromium on the catalytic properties of MCM-41 was evaluated in order to develop new catalysts for the trimethylbenzene transalkylation with benzene to produce ethylbenzene, a high-value aromatic in the industry. It was found that chromium decreases the specific surface area but increases the acidity, turning MCM-41 into an active and selective catalyst for ethylbenzene and toluene production. The coke produced on the catalyst is hydrogenated and mainly located outside the pores and thus can be easily removed. The catalyst is more active and selective than mordenite, a commercial catalyst, and thus more promising for commercial applications.

Síntese e caracterização de alfa-fosfato de zircônio(IV) contendo agregados de cobre metálico

The alpha-zirconium (IV) hydrogenphosphate (alpha-ZrP) has received great attention in the last years due to its properties like ion exchange, intercalation, ionic conductivity and catalytic activity. This work reports a method to produce metallic copper clusters on alpha-ZrP to be used as catalysts in petrochemical processes. It was found that the solids were non-crystalline regardless of the uptake of copper and the reduction. The specific surface area increased as a consequence of the increase of the interlayer distance to accept the copper ions between the layers. During the reduction, big clusters of copper (0,5-11µ) with different sizes and shapes were produced.

Triterpenóides tipo cicloartano de própolis de Teresina - PI

The chemical study of the propolis produced in Teresina city, state of Piaui, resulted in the identification of six cycloartane triterpenoids: isomangiferolic acid, 24-methylenecycloartane-3beta,26-diol, mangiferolic acid, mangiferonic acid, ambonic acid and ambolic acid. The substances were characterized by one and two-dimensional ¹H and 13C NMR analysis.