Variation des bio-volumes des zooplancton du plateau continental entre le Cap des Palmes et le Cap des Trois Pointes

Three years of weekly sampling from a coastal station and 29 monthly cruises over the whole continental shelf were studied for zooplankton quantitative variation. Settled volumes were preferred to displacement volumes. At the coastal station, near Abidjan, a negative correlation was found between the log2 of zooplankton volume and the preceding fortnight temperature. On the whole shelf, the differences between the 6 considered areas were tested by the variance analysis. There were significative differences in shallow waters only (20 m). During the main cold season, the upwelling of Tabou causes a very important enrichment 30 to 60 nautical miles to the east. Eastwards the plankton drifts and decreases in abundance. The zooplankton maximum is not always inshore, but often in the middle of the shelf and sometimes over the slope. During the little cold season the enrichments caused by coastal upwelling are less abundant and restricted to smaller areas. During the warm season, the waters are uniformly poor. During the cold season, over the 60m depths, the zooplankton maximum lies between 10 and 20 m and seems to sink in deeper waters. In warm season the vertical repartition is rather homogeneous in the first 40 meters. The diel vertical migrations show a very consistent rhythm, varying with the season.

Measurements of light scattering from glass substrates by total integrated scattering

A total integrated scattering (TIS) measurement was performed to investigate the surface and volume scattering of K9 glass substrates with low reflectance. Ag layers with thicknesses of 60 nm were deposited on the front and back surfaces of the K9 glass substrates by the magnetron sputtering technique. Surface scattering of the K9 glass substrate was obtained by the TIS measurement of the Ag layers on the assumption that the Ag layers and the K9 substrate had the same surface profile. Volume scattering of the substrates was deduced by subtracting the front and back surface scattering from the total scattering of the substrates. (c) 2005 Optical Society of America.

von Neumann spin measurements with Rashba fields

We show that dynamics in the spin-orbit coupling field simulate the von Neumann measurement of a particle spin. We demonstrate how the measurement influences the spin and coordinate evolution of a particle by comparing two examples of such a procedure. The first example is a simultaneous measurement of spin components, sigma(x) and sigma(y), corresponding to non-commuting operators, which cannot be accurately obtained together at a given time instant due to the Heisenberg uncertainty ratio. By mapping spin dynamics onto a spatial walk, such a procedure determines measurement-time averages of sigma(x) and sigma(y), which can already be precisely evaluated in a single short-time measurement. The other, qualitatively different, example is the spin of a one-dimensional particle in a magnetic field. Here, the measurement outcome depends on the angle between the spin-orbit coupling and magnetic fields. These results can be applied to studies of spin-orbit coupled cold atoms and electrons in solids.

Measurements of resistance and reactance in fish with the use of bioelectrical impedance analysis: sources of error

New technologies can be riddled with unforeseen sources of error, jeopardizing the validity and application of their advancement. Bioelectrical impedance analysis (BIA) is a new technology in fisheries research that is capable of estimating proximate composition, condition, and energy content in fish quickly, cheaply, and (after calibration) without the need to sacrifice fish. Before BIA can be widely accepted in fisheries science, it is necessary to identify sources of error and determine a means to minimize potential errors with this analysis. We conducted controlled laboratory experiments to identify sources of errors within BIA measurements. We concluded that electrode needle location, procedure deviations, user experience, time after death, and temperature can affect resistance and reactance measurements. Sensitivity analyses showed that errors in predictive estimates of composition can be large (>50%) when these errors are experienced. Adherence to a strict protocol can help avoid these sources of error and provide BIA estimates that are both accurate and precise in a field or laboratory setting.