Composts addition may improve biology in cotton soils

Composts can provide a source of organic carbon and nutrients for soil biota and increase soil fertility as well as provide other biological and structural benefits hence compost addition to cotton soils is seen as a way to improve cotton soil biological health and fertility. In a six month incubation experiment we analysed the changes in microbial populations and activities related to C and N cycling following the application of feedlot, poultry manure and gin trash compost materials. A significant variation in the chemical composition, e.g. major nutrients and trace elements, was found between the three compost products. The feedlot compost generally contained higher levels of dissolved organic carbon, total nitrogen and bicarbonate extractable phosphorus whereas the Gin trash compost had lower carbon and nutrient concentrations. The effect of compost addition @ 5 and 10t/ha generally increased microbial activity but the effect was only evident during the first two weeks of incubation. Composts effects on the abundance of total bacteria (16S), nitrifying (amoA), nitrogen fixing (nifH) and denitrifying bacteria (nosZ) and total fungi (ITS gene) varied between different composts. The addition of feedlot and poultry compost material significantly increased the levels of dissolved organic carbon (DOC) and nitrogen (DON) in soil compared to that in control soils while ‘Gin trash’ compost had no effect. These differences reflected in the microbial catabolic diversity changes in the compost amended soils. Therefore, chemical analysis of the compost material before application is recommended to more fully consider its’ potential benefits.

Colour differentiation of high-lycopene tomato fruit through the addition of the colourless-epidermis (y) mutation

High-lycopene tomatoes (Solanum lycopersicum) are characterised by an intense red flesh-colour, due to an elevated concentration of the carotenoid, lycopene. However, this characteristic is only visible once fruit are cut open, making it impossible to differentiate intact high-lycopene fruit from standard tomato fruit, a clear market disadvantage. The reason that fruit colour of both high-lycopene and standard fruit looks almost identical from the outside is because tomato fruit normally contain the yellow flavonoid 'naringenin chalcone' in a thin layer of epidermal cells. It is this combination of naringenin chalcone and the underlying lycopene in the flesh that gives tomatoes their characteristic orange-red colour. By incorporation of the recessive colourless epidermis mutant allele 'y' (which prevents naringenin chalcone accumulation) into high-lycopene fruit, we have been able to create high-lycopene tomatoes (hp1.ogc.y) exhibiting a deep-pink colour visible from the outside. Hue angle of the skin of the high-lycopene 'y' mutant and a regular highlycopene tomato (hp1.ogc.Y) was 30 and 38°, respectively, while flesh values were similar at 31 and 32°, respectively. Removal of naringenin chalcone from the epidermis appeared to improve the visibility of underlying lycopene, such that fruit outer colour became a subsequent indicator of underlying flesh colour. The removal of epidermal pigmentation means that high-lycopene fruit can now be differentiated from standard tomato fruit in the market place without the need to cut fruit open.

Ultrasound-assisted extraction of R-phycoerythrin from Grateloupia turuturu with and without enzyme addition

The aim of this study was to compare two processes for the extraction of R-phycoerythrin (R-PE) from the red seaweed Grateloupia turuturu: ultrasound-assisted extraction (UAE) and ultrasound-assisted enzymatic hydrolysis (UAEH). Process efficiencies were both evaluated by the yield of R-PE extraction and by the level of liquefaction. Experiments were conducted at 40 and 22 °C, for 6 h, using an enzymatic cocktail and an original ultrasonic flow-through reactor. R-PE appeared very sensitive to temperature, thus 22 °C is strongly recommended for its extraction by UAEH or UAE. However, the higher processing temperature (40 °C) clearly increased the extraction of water-soluble compounds (up to 91% of liquefaction). These two new processes are thus promising alternatives for the extraction of water-soluble components including R-PE, from wet seaweeds, with extraction yields at least similar to conventional solid–liquid extraction.

High On/Off ratio memristive switching of manganite/cuprate bilayer by interfacial magnetoelectricity

Memristive switching serves as the basis for a new generation of electronic devices. Memristors are two-terminal devices in which the current is turned on and off by redistributing point defects, e.g., vacancies, which is difficult to control. Memristors based on alternative mechanisms have been explored, but achieving both the high On/Off ratio and the low switching energy desirable for use in electronics remains a challenge. Here we report memristive switching in a La_(0.7)Ca_(0.3)MnO_(3)/PrBa_(2)Cu_(3)O_(7) bilayer with an On/Off ratio greater than 103 and demonstrate that the phenomenon originates from a new type of interfacial magnetoelectricity. Using results from firstprinciples calculations, we show that an external electric-field induces subtle displacements of the interfacial Mn ions, which switches on/off an interfacial magnetic “dead” layer, resulting in memristive behavior for spin-polarized electron transport across the bilayer. The interfacial nature of the switching entails low energy cost about of a tenth of atto Joule for write/erase a “bit”. Our results indicate new opportunities for manganite/cuprate systems and other transition-metal-oxide junctions in memristive applications.

Water Quality Impacts due to the Addition of Biosolids-Derived Compost to Bioretention

Bioretention is a common stormwater control measure (SCM). While compost, combined with other bioretention soil media (BSM), has the potential for increased pollutant and water uptake and storage, it also may leach harmful nutrients. Limited information is available on the use of compost in SCMs. Therefore, this project seeks to analyze the impacts of the addition of biosolids-derived compost to bioretention. To accomplish this, bioretention mesocosm column studies were conducted to determine the leaching effects of 15%, 30%, and 30% tap water-washed compost, mixed with standard BSM. Synthetic storm runoff was applied to the columns and the effluent was analyzed for total nitrogen (N), phosphorus (P), and their speciation. All three columns leached N and P with maximum total N concentrations of 2,200, 2,100, and 300 mg-N/L and total P concentrations of 12, 4.9, and 4.6 mg-P/L for the 30%, 15%, and 30% washed mesocosms, respectively. Therefore, based on this study, it is not recommended that biosolids-derived compost be added to bioretention media.

Dimensional stability of an addition silicone after disinfection/sterilization

Poster presented at the “From Basic Sciences to Clinical Research” – First International Congress of CiiEM. Egas Moniz, Caparica, Portugal, 27-28 November 2015

Dimensional change of two addition silicones

Poster apresentado no XXIV Congresso da Ordem dos Médicos Dentistas. Lisboa, 12-14 Novembro 2015

Platinum–rhodium–tin/carbon electrocatalysts for ethanol oxidation in acid media: effect of the precursor addition order and the amount of tin

Carbon-supported Pt x –Rh y –Sn z catalysts (x:y:z = 3:1:4, 6:2:4, 9:3:4) are prepared by Pt, Rh, and Sn precursors reduction in different addition order. The materials are characterized by X-ray diffraction, transmission electron microscopy, and X-ray photoelectron spectroscopy techniques and are evaluated for the electrooxidation of ethanol in acidic media by cyclic voltammetry, chronoamperometry, and anode potentiostatic polarization. The influence of both the order in which the precursors are added and the composition of metals in the catalysts on the electrocatalytic activity and physico-chemical characteristics of Pt x –Rh y –Sn z /C catalysts is evaluated. Oxidized Rh species prevail on the surface of catalysts synthesized by simultaneous co-precipitation, thus demonstrating the influence of synthesis method on the oxidation state of catalysts. Furthermore, high amounts of Sn in composites synthesized by co-precipitation result in very active catalysts at low potentials (bifunctional effect), while medium Sn load is needed for sequentially deposited catalysts when the electronic effect is most important (high potentials), since more exposed Pt and Rh sites are needed on the catalyst surface to alcohol oxidation. The Pt3–Rh1–Sn4/C catalyst prepared by co-precipitation is the most active at potentials lower than 0.55 V (related to bifunctional effect), while the Pt6–Rh2–Sn4/C catalyst, prepared by sequential precipitation (first Rh and, after drying, Pt + Sn), is the most active above 0.55 V.

Effects of solid poly (ethylene glycols) addition to the solutions of aniline or N,N-dimethylaniline with water:experimental measurements and modelling

In this work, the liquid-liquid and solid-liquid phase behaviour of ten aqueous pseudo-binary and three binary systems containing polyethylene glycol (PEG) 2050, polyethylene glycol 35000, aniline, N,N-dimethylaniline and water, in the temperature range 298.15-350.15 K and at ambient pressure of 0.1 MPa, was studied. The obtained temperature-composition phase diagrams showed that the only functional co-solvent was PEG2050 for aniline in water, while PEG35000 even showed a clear anti-solvent effect in the N,N-dimethylaniline aqueous system. The experimental solid-liquid equilibria (SLE) data have been correlated by the non-random two-liquid (NRTL) model, and the correlation results are in accordance with the experimental results.

Influence of kaolin addition on the dynamics of oxygen mass transport in polyvinyl alcohol dispersion coatings

The permeability of dispersion barriers produced from polyvinyl alcohol (PVOH) and kaolin clay blends coated onto polymeric supports has been studied by employing two different measurement methods: the oxygen transmission rate (OTR) and the ambient oxygen ingress rate (AOIR). Coatings with different thicknesses and kaolin contents were studied. Structural information of the dispersion-barrier coatings was obtained by Fourier transform infrared spectroscopy (FTIR) spectroscopy and scanning electron microscopy (SEM). These results showed that the kaolin content influences both the orientation of the kaolin and the degree of crystallinity of the PVOH coating. Increased kaolin content increased the alignment of the kaolin platelets to the basal plane of the coating. Higher kaolin content was accompanied by higher degree of crystallinity of the PVOH. The barrier thickness proved to be less important in the early stages of the mass transport process, whereas it had a significant influence on the steady-state permeability. The results from this study demonstrate the need for better understanding of how permeability is influenced by (chemical and physical) structure.

ADDITION OF VINEGAR TO EXTEND THE SHELF-LIFE OF CABEÇA DE XARA

Cabeça de xara is a ready-to-eat meat product, whose production is very characteristic in Alentejo, a particular region of Portugal. It is a galantine usually moulded into parallelepiped shape made with various meats obtained from the Alentejano pig breed reared in the same region, namely deboned pork heads, tongue and connective tissue to which a number of condiments like salt, parsley, wine and pepper, are added. This work intended to test the feasibility of adding vinegar in order to increase the shelf-life of cabeça de xara, by reducing the contaminating microbiota responsible for spoilage, as well as controlling the pathogen Listeria monocytogenes. Three independent batches were produced and proximate composition, pH, aw, microbiological parameters and biogenic amines content evaluated. A sensory analysis was also performed throughout the storage period. No significant differences between control and vinegar samples was found regarding the proximate composition of cabeça de xara. As expected, pH is lower in the vinegar samples, however no differences in aw were observed between the two treatments. L. monocytogenes was present from the first month on only in one batch in the control treatment. However, it is inhibited by the addition of vinegar until the third month of storage, where L. monocytogenes is present but below the limit established in the 2073/2005 regulation. The presence of vinegar significantly decreased the content in biogenic amines, particularly cadaverine, putrescine and tyramine, throughout the storage period. Concerning sensory evaluation, no vinegar taste was reported by the panellists in a depreciating way.

Computational study on the asymmetric aminocatalysed Michael addition reaction of cyclohexanone to trans–β–nitrostyrene

Asymmetric organocatalysed reactions are one of the most fascinating synthetic strategies which one can adopt in order to induct a desired chirality into a reaction product. From all the possible practical applications of small organic molecules in catalytic reaction, amine–based catalysis has attracted a lot of attention during the past two decades. The high interest in asymmetric aminocatalytic pathways is to account to the huge variety of carbonyl compounds that can be functionalized by many different reactions of their corresponding chiral–enamine or –iminium ion as activated nucleophile and electrophile, respectively. Starting from the employment of L–Proline, many useful substrates have been proposed in order to further enhance the catalytic performances of these reaction in terms of enantiomeric excess values, yield, conversion of the substrate and turnover number. In particular, in the last decade the use of chiral and quasi–enantiomeric primary amine species has got a lot of attention in the field. Contemporaneously, many studies have been carried out in order to highlight the mechanism through which these kinds of substrates induct chirality into the desired products. In this scenario, computational chemistry has played a crucial role due to the possibility of simulating and studying any kind of reaction and the transition state structures involved. In the present work the transition state geometries of primary amine–catalysed Michael addition reaction of cyclohexanone to trans–β–nitrostyrene with different organic acid cocatalysts has been studied through different computational techniques such as density functional theory based quantum mechanics calculation and force–field directed molecular simulations.

The Clinical Impact Of Cerebellar Grey Matter Pathology In Multiple Sclerosis.

The cerebellum is an important site for cortical demyelination in multiple sclerosis, but the functional significance of this finding is not fully understood. To evaluate the clinical and cognitive impact of cerebellar grey-matter pathology in multiple sclerosis patients. Forty-two relapsing-remitting multiple sclerosis patients and 30 controls underwent clinical assessment including the Multiple Sclerosis Functional Composite, Expanded Disability Status Scale (EDSS) and cerebellar functional system (FS) score, and cognitive evaluation, including the Paced Auditory Serial Addition Test (PASAT) and the Symbol-Digit Modalities Test (SDMT). Magnetic resonance imaging was performed with a 3T scanner and variables of interest were: brain white-matter and cortical lesion load, cerebellar intracortical and leukocortical lesion volumes, and brain cortical and cerebellar white-matter and grey-matter volumes. After multivariate analysis high burden of cerebellar intracortical lesions was the only predictor for the EDSS (p<0.001), cerebellar FS (p = 0.002), arm function (p = 0.049), and for leg function (p<0.001). Patients with high burden of cerebellar leukocortical lesions had lower PASAT scores (p = 0.013), while patients with greater volumes of cerebellar intracortical lesions had worse SDMT scores (p = 0.015). Cerebellar grey-matter pathology is widely present and contributes to clinical dysfunction in relapsing-remitting multiple sclerosis patients, independently of brain grey-matter damage.