Development of a dosage strategy in patients receiving enoxaparin by continuous intravenous infusion using modelling and simulation

Aim To develop an appropriate dosing strategy for continuous intravenous infusions (CII) of enoxaparin by minimizing the percentage of steady-state anti-Xa concentration (C-ss) outside the therapeutic range of 0.5-1.2 IU ml(-1). Methods A nonlinear mixed effects model was developed with NONMEM (R) for 48 adult patients who received CII of enoxaparin with infusion durations that ranged from 8 to 894 h at rates between 100 and 1600 IU h(-1). Three hundred and sixty-three anti-Xa concentration measurements were available from patients who received CII. These were combined with 309 anti-Xa concentrations from 35 patients who received subcutaneous enoxaparin. The effects of age, body size, height, sex, creatinine clearance (CrCL) and patient location [intensive care unit (ICU) or general medical unit] on pharmacokinetic (PK) parameters were evaluated. Monte Carlo simulations were used to (i) evaluate covariate effects on C-ss and (ii) compare the impact of different infusion rates on predicted C-ss. The best dose was selected based on the highest probability that the C-ss achieved would lie within the therapeutic range. Results A two-compartment linear model with additive and proportional residual error for general medical unit patients and only a proportional error for patients in ICU provided the best description of the data. Both CrCL and weight were found to affect significantly clearance and volume of distribution of the central compartment, respectively. Simulations suggested that the best doses for patients in the ICU setting were 50 IU kg(-1) per 12 h (4.2 IU kg(-1) h(-1)) if CrCL < 30 ml min(-1); 60 IU kg(-1) per 12 h (5.0 IU kg(-1) h(-1)) if CrCL was 30-50 ml min(-1); and 70 IU kg(-1) per 12 h (5.8 IU kg(-1) h(-1)) if CrCL > 50 ml min(-1). The best doses for patients in the general medical unit were 60 IU kg(-1) per 12 h (5.0 IU kg(-1) h(-1)) if CrCL < 30 ml min(-1); 70 IU kg(-1) per 12 h (5.8 IU kg(-1) h(-1)) if CrCL was 30-50 ml min(-1); and 100 IU kg(-1) per 12 h (8.3 IU kg(-1) h(-1)) if CrCL > 50 ml min(-1). These best doses were selected based on providing the lowest equal probability of either being above or below the therapeutic range and the highest probability that the C-ss achieved would lie within the therapeutic range. Conclusion The dose of enoxaparin should be individualized to the patients' renal function and weight. There is some evidence to support slightly lower doses of CII enoxaparin in patients in the ICU setting.

Application of Monte Carlo simulations to identify an appropriate dosage strategy for patients receiving a continuous intravenous infusion of enoxaparin

Aim: To identify an appropriate dosage strategy for patients receiving enoxaparin by continuous intravenous infusion (CII). Methods: Monte Carlo simulations were performed in NONMEM, (200 replicates of 1000 patients) to predict steady state anti-Xa concentrations (Css) for patients receiving a CII of enoxaparin. The covariate distribution model was simulated based on covariate demographics in the CII study population. The impact of patient weight, renal function (creatinine clearance (CrCL)) and patient location (intensive care unit (ICU)) were evaluated. A population pharmacokinetic model was used as the input-output model (1-compartment first order output model with mixed residual error structure). Success of a dosing regimen was based on the percent of Css that is between the therapeutic range of 0.5 IU/ml to 1.2 IU/ml. Results: The best dose for patients in the ICU was 4.2IU/kg/h (success mean 64.8% and 90% prediction interval (PI): 60.1–69.8%) if CrCL60ml/min, the best dose was 8.3IU/kg/h (success mean 65.4%, 90% PI: 58.5–73.2%). Simulations suggest that there was a 50% improvement in the success of the CII if the dose rate for ICU patients with CrCL

Critical feature analysis of a radiotherapy machine

The software implementation of the emergency shutdown feature in a major radiotherapy system was analyzed, using a directed form of code review based on module dependences. Dependences between modules are labelled by particular assumptions; this allows one to trace through the code, and identify those fragments responsible for critical features. An `assumption tree' is constructed in parallel, showing the assumptions which each module makes about others. The root of the assumption tree is the critical feature of interest, and its leaves represent assumptions which, if not valid, might cause the critical feature to fail. The analysis revealed some unexpected assumptions that motivated improvements to the code.

Drug combination: pharmaceutical technologies applied to the manufacturing of combined dosage forms for oral administration

Lo scopo di questa ricerca di dottorato è stato lo studio di una forma di dosaggio flessibile e personalizzabile, indirizzata alle necessità individuali di ogni paziente, per il trattamento dell’iperplasia prostatica benigna. La terapia proposta prevede l’utilizzo di due farmaci, un alfa bloccante (farmaco A) e un inibitore delle 5- fosfodiesterasi (farmaco B) e, somministrati in una singola forma di dosaggio contenenti differenti dosi e combinazioni dei due farmaci. Lo sviluppo di un sistema di rilascio per la somministrazione orale di farmaco A e farmaco B è stato realizzato grazie alla tecnologia Dome Matrix. La tecnologia si basa sull’assemblaggio di moduli utilizzati come elementi di controllo del rilascio. L’assemblaggio dei moduli può essere ottenuto attraverso diverse configurazioni. Sono stati quindi realizzati sistemi assemblati in grado di galleggiare sul contenuto gastrico; la prolungata permanenza della forma farmaceutica nello stomaco favorisce la solubilizzazione dei due principi attivi che quindi potrebbero raggiungere il sito di assorbimento nel primo tratto intestinale già in dispersione molecolare, condizione ideale per essere assorbiti. La prima parte della ricerca è stata focalizzata sulla realizzazione di un sistema assemblato a rilascio modificato di farmaco A. Moduli contenenti diversi dosaggi di farmaco sono stati assemblati in varie configurazioni e dosi differenti per ottenere una forma di dosaggio flessibile, adattabile alle esigenze terapeutiche del paziente. La seconda parte del lavoro di tesi ha riguardato la realizzazione di un sistema assemblato, contenente entrambi i farmaci in associazione. L’ultima parte della ricerca è stata svolta presso la “University of Texas at Austin” sotto la supervisione del Professor Nicholas Peppas. Il lavoro svolto è stato focalizzato sullo studio delle caratteristiche di rigonfiamento dei singoli moduli di farmaco e dei loro sistemi assemblati; il comportamento di tali sistemi è stato investigato anche grazie all’utilizzo della tecnica di tomografia computerizzata a raggi X.

Molecular investigations into vaginal immunization with HIV gp41 antigenic construct H4A in a quick release solid dosage form

A robust vaginal immune response is considered essential for an effective prophylactic vaccine that prevents transmission of HIV and other sexually acquired diseases. Considerable attention has recently focused on the potential of vaginally administered vaccines as a means to induce such local immunity. However, the potential for vaccination at this site remains in doubt as the vaginal mucosa is generally considered to have low immune inductive potential. In the current study, we explored for the first time the use of a quick release, freeze-dried, solid dosage system for practical vaginal administration of a protein antigen. These solid dosage forms overcome the common problem associated with leakage and poor retention of vaginally administered antigen solutions. Mice were immunized vaginally with H4A, an HIV gp41 envelope based recombinant protein, using quick release, freeze-dried solid rods, and the immune responses compared to a control group immunized via subcutaneous H4A injection. Vaginally immunized mice failed to elicit robust immune responses. Our detailed investigations, involving cytokine analysis, the stability of H4A in mouse cervicovaginal lavage, and elucidation of the state of H4A protein in the immediate-release dosage form, revealed that antigen instability in vaginal fluid, the state of the antigen in the dosage form, and the cytokine profile induced are all likely to have contributed to the observed lack of immunogenicity. These are important factors affecting vaginal immunization and provide a rational basis for explaining the typically poor and variable elicitation of immunity at this site, despite the presence of immune responsive cells within the vaginal mucosae. In future mucosal vaccine studies, a more explicit focus on antigen stability in the dosage form and the immune potential of available antigen-responsive cells is recommended.

Design of films for oral dosage formulations

A novel method for tablet coating was studied where a thin polymer film was cast (pre-formed film), dried and applied as a coating hence eliminating the need for using any solvent during the actual coating process. A pre-formed film is initially heating to a temperature where it becomes flexible, a vacuum is applied and the film is then pulled around the tablet. The proposed films (gelatine or cellulose-based) were characterised in terms of their dissolution, swelling, mechanical and thermal properties prior to using them in the novel coating process; selected films were then coated onto tablets containing paracetamol or ibuprofen and the effect of the film on the subsequent dissolution was evaluated. It was found that the pre-formed films could be designed to be fast dissolving and mechanically strong to withstand the stress from the coating process. Also metoclopramide was incorporated in a gelatine film-coating formulation which was then successfully coated on paracetamol-containing core. Gelatin-based films were found to be successful in the novel coating process therefore to be suitable as finished coatings for immediate release dosage forms. Orally disintegrating dosage forms have been identified as a favourable dosage form due to the following reasons: fast onset of drug release, easy to use, not painful and possible increase of amount absorbed to systemic circulation. Selected films formulated for coating studies were also successfully formulated to contain active ingredient suitable for orally disintegrating dosage form; cellulose-based naratriptan-films were studied as orally disintegrating dosage forms of where the effect of formulation on the film properties was studied. It was found that strength of the film can affect the dissolution of the film but it may be the inclusion of specific excipients in the formulation which affect the penetration of the drug through mucosa.

Influence of ABCB1 polymorphisms and haplotypes on tacrolimus nephrotoxicity and dosage requirements in children with liver transplant

WHAT IS ALREADY KNOWN ABOUT THIS SUBJECT • Currently tacrolimus is the mainstay of immunosuppression for most children undergoing liver transplantation (LT). • The clinical use of this agent, however, is complicated by its various adverse effects (mainly nephrotoxicity), its narrow therapeutic-index and considerable pharmacokinetic variability. • The low and variable oral bioavailability of tacrolimus is thought to result from the action of the multidrug efflux-pump P-glycoprotein, encoded by the ABCB1 gene. WHAT THIS STUDY ADDS • A significant association between ABCB1 genetic polymorphisms and tacrolimus-associated nephrotoxicity in paediatric patients following LT is reported for the first time. Genotyping such polymorphisms may have the potential to individualize better initial tacrolimus therapy and enhance drug safety. • The long-term effect of ABCB1 polymorphisms on tacrolimus trough concentrations were investigated up to 5 years post-transplantation. A significant effect of intestinal P-glycoprotein genotypes on tacrolimus pharmacokinetics was found at 3 and 4 years post-transplantation suggesting that the effect is maintained long term. AIMS - The aim of this study was to investigate the influence of genetic polymorphisms in ABCB1 on the incidence of nephrotoxicity and tacrolimus dosage-requirements in paediatric patients following liver transplantation. METHODS - Fifty-one paediatric liver transplant recipients receiving tacrolimus were genotyped for ABCB1 C1236>T, G2677>T and C3435>T polymorphisms. Dose-adjusted tacrolimus trough concentrations and estimated glomerular filtration rates (EGFR) indicative of renal toxicity were determined and correlated with the corresponding genotypes. RESULTS - The present study revealed a higher incidence of the ABCB1 variant-alleles examined among patients with renal dysfunction (≥30% reduction in EGFR) at 6 months post-transplantation (1236T allele: 63.3% vs 37.5% in controls, P= 0.019; 2677T allele: 63.3% vs. 35.9%, p = 0.012; 3435T allele: 60% vs. 39.1%, P= 0.057). Carriers of the G2677->T variant allele also had a significant reduction (%) in EGFR at 12 months post-transplant (mean difference = 22.6%; P= 0.031). Haplotype analysis showed a significant association between T-T-T haplotypes and an increased incidence of nephrotoxicity at 6 months post-transplantation (haplotype-frequency = 52.9% in nephrotoxic patients vs 29.4% in controls; P= 0.029). Furthermore, G2677->T and C3435->T polymorphisms and T-T-T haplotypes were significantly correlated with higher tacrolimus dose-adjusted pre-dose concentrations at various time points examined long after drug initiation. CONCLUSIONS - These findings suggest that ABCB1 polymorphisms in the native intestine significantly influence tacrolimus dosage-requirement in the stable phase after transplantation. In addition, ABCB1 polymorphisms in paediatric liver transplant recipients may predispose them to nephrotoxicity over the first year post-transplantation. Genotyping future transplant recipients for ABCB1 polymorphisms, therefore, could have the potential to individualize better tacrolimus immunosuppressive therapy and enhance drug safety.

Impact of ATP-binding cassette, subfamily B, member 1 pharmacogenetics on tacrolimus-associated nephrotoxicity and dosage requirements in paediatric patients with liver transplant

Importance of the field: Tacrolimus is the most commonly used immunosuppressive agent following solid-organ transplantation in children. Its clinical use, however, is complicated by side effects (mainly nephrotoxicity), narrow therapeutic index and pharmacokinetic variability which can result in an increased risk of treatment failure or toxicity. Studies examining interindividual differences in the expression of the ABCB1 (ATP-binding cassette, subfamily B, member 1) gene (which encodes the drug transporter, P-gp) and its genetic polymorphisms have attempted to elucidate variations in tacrolimus response and disposition in children. Areas covered in this review: This review explores pharmacogenetic knowledge developed over the last decade regarding the impact of ABCB1 polymorphisms on tacrolimus toxicity and dosage requirements in children. What the reader will gain: A better understanding of the role of ABCB1 genetic polymorphisms (and corresponding haplotypes) and ABCB1 expression levels in various tissues and organs on tacrolimus outcomes in children with liver transplant. Take home message: Pharmacogenetics offers significant potential for optimising tacrolimus use. ABCB1 donor genotypes and ABCB1 expression level in the intestine and leukocytes may be useful in dosage selection. Large prospective studies are, however, required to further explore the potential of genetic testing in identifying children who are at risk of toxicity and to better individualise tacrolimus therapy.