Oxygen and hydrogen isotope ratios of pore waters from ODP sites in the Mediterranean Sea

Pore fluids from two ODP sites at Eastern Mediterranean mud volcanoes have been analyzed for their Cl concentration and their delta18O and deltaD isotopic composition. The Cl data span a wide range of concentrations, from extremely depleted with respect to seawater (as low as 60 mM) at the crest of Milano dome (site 970) to strongly enriched (up to 5.4 M) at Napoli dome (site 971). Chloride enrichment is known to be due to dissolving Messinian evaporites, whereas the source of the low-Cl fluid is deduced from stable isotope data presented here. The isotopic composition of the endmember fluid is found to be +10? for delta18O and -32? for deltaD for low- as well as for high-Cl waters. From this signature it can be concluded that neither gas hydrates nor meteoric water play a significant role in the freshening of the pore water. Several other processes altering the delta18O/deltaD composition of pore waters are discussed and considered to be of only negligible influence. The process characterizing the isotopic composition of the fluid is found to be clay mineral dehydration (mainly smectite-illite transformation), corresponding to a depth range of 3.5-7 km and an elevated temperature of about 120-165°C. A quantitative estimate shows that this reaction is capable of producing the observed extreme Cl depletion.

Strontium, oxygen and hydrogen isotope ratios of basalts from DSDP Hole 504B

DSDP Hole 504B was drilled into 6 Ma crust, about 200 km south of the Costa Rica Rift, Galapagos Spreading Center, penetrating 1.35 km into a section that can be divided into four zones-Zone I: oxic submarine weathering; Zone II: anoxic alteration; Zones III and IV: hydrothermal alteration to greenschist facies. In Zone III there is intense veining of pillow basalts. Zone IV consists of altered sheeted dikes. Isotopic geochemical signatures in relation to the alteration zones are recorded in Hole 504B, as follows: Zone Depth(m) Average87Sr/86Sr Average delta18O (?) Average deltaD (?) I 275-550 0.7032 7.3 -63 II 550-890 0.7029 6.5 -45 III 890-1050 0.7035 5.6 -31 IV 1050-1350 0.7032 5.5 -36 Alteration temperatures are as low as 10°C in Zones I and II based on oxygen isotope fractionation. Strontium isotopic data indicate that a circulation of seawater is much more restricted in Zone II than in Zone I. Fluid inclusion measurements of vein quartz indicate the alteration temperature was mainly 300 +/- 20°C in Zones III and IV, which is consistent with secondary mineral assemblages. The strontium, oxygen, and hydrogen isotopic compositions of hydrothermal fluids which were responsible for the greenschist facies alteration in Zones III and IV are estimated to be 0.7037, 2?, and 3?, respectively. Strontium and oxygen isotope data indicate that completely altered portions of greenstones and vein minerals were in equilibrium with modified seawater under low water/rock ratios (in weight) of about 1.6. This value is close to that of the end-member hydrothermal fluids issuing at 21°N EPR. Basement rocks are not completely hydrothermally altered. About 32% of the greenstones in Zones III and IV have escaped alteration. Thus 1 g of fresh basalt including the 32% unaltered portion are required in order to make 1 g of end-member solution from fresh seawater in water-rock reactions.

Geochemistry of Atlantis Massif serpentinites

The Lost City hydrothermal system at the southern Atlantis Massif (Mid-Atlantic Ridge, 30°N) provides a natural laboratory for studying serpentinization processes, the temporal evolution of ultramafic-hosted hydrothermal systems, and alteration conditions during formation and emplacement of an oceanic core complex. Here we present B, O, and Sr isotope data to investigate fluid/rock interaction and mass transfer during detachment faulting and exhumation of lithospheric sequences within the Atlantis Massif. Our data indicate that extensive serpentinization was a seawater-dominated process that occurred predominately at temperatures of 150-250 °C and at high integrated W/R ratios that led to a marked boron enrichment (34-91 ppm). Boron removal from seawater during serpentinization is positively correlated with changes in d11B (11-16 per mil) but shows no correlation with O-isotope composition. Modeling indicates that B concentrations and isotope values of the serpentinites are controlled by transient temperature-pH conditions. In contrast to prior studies, we conclude that low-temperature marine weathering processes are insignificant for boron geochemistry of the Atlantis Massif serpentinites. Talc- and amphibole-rich fault rocks formed within a zone of detachment faulting at temperatures of approximately 270-350 °C and at low W/R ratios. Talc formation in ultramafic domains in the massif was subsequent to an early stage of serpentinization and was controlled by the access of Si-rich fluids derived through seawater-gabbro interactions. Replacement of serpentine by talc resulted in boron loss and significant lowering of d11B values (9-10 per mil), which we model as the product of progressive extraction of boron. Our study provides new constraints on the boron geochemical cycle at oceanic spreading ridges and suggests that serpentinization associated with ultramafic-hosted hydrothermal systems may have important implications for the behavior of boron in subduction zone settings.

Elemental and isotopic compositions of metalliferous and pelagic sediments from the Galapagos mounds area, data of DSDP Leg 70

Nontronite, the main metalliferous phase of the Galapagos mounds, occurs at a subsurface depth of ~2-20 m; Mn-oxide material is limited to the upper 2 m of these mounds. The nontronite forms intervals of up to a few metres thickness, consisting essentially of 100% nontronite granules, which alternate with intervals of normal pelagic sediment. The metalliferous phases represent essentially authigenic precipitates, apparently formed in the presence of upwelling basement-derived hydrothermal solutions which dissolved pre-existent pelagic sediment. Electron microprobe analyses of nontronite granules from different core samples indicate that: (1) there is little difference in major-element composition between nontronitic material from varying locations within the mounds; and (2) adjacent granules from a given sample have very similar compositions and are internally homogeneous. This indicates that the granules are composed of a single mineral of essentially constant composition, consistent with relatively uniform conditions of solution Eh and composition during nontronite formation. The Pb-isotopic composition of the nontronite and Mn-oxide sediments indicates that they were formed from solutions which contained variable proportions of basaltic Pb, introduced into pore waters by basement-derived solutions, and of normal-seawater Pb. However, the Sr-isotopic composition of these sediments is essentially indistinguishable from the value for modern seawater. On the basis of 18O/16O ratios, formation temperatures of ~20-30°C have been estimated for the nontronites. By comparison, temperatures of up to 11.5°C at 9 m depth have been directly measured within the mounds and heat flow data suggest present basement-sediment interface temperatures of 15-25°C.

Isotopic composition and chemistry of pore waters from ODP Site 195-1201 sediments, West Philippine Basin

This report summarizes chemical and isotopic data from Ocean Drilling Program Leg 195 Site 1201. Pore water is divided into three intervals based on the rate of chemical change with depth. The shallowest interval is the red clay unit between 1.26 and 56.40 meters below seafloor (mbsf). In this section, there are overall decreases in the concentrations of alkalinity, boron, lithium, magnesium, potassium, sodium, and sulfate, whereas concentrations of calcium and chloride increase. Values of d18O and dD plot near standard mean ocean water to the right of the global meteoric water line (GMWL). Five samples from 72.60 and 83.33 mbsf yielded pore water for analyses. These samples help define a trend in the second interval, which is between 56.4 and 238.98 mbsf. Here, concentrations of magnesium, potassium, sodium, and sulfate decease, whereas concentrations of boron, calcium, and chloride increase. Concentrations of alkalinity and lithium remain roughly constant. The deepest interval, between 238.04 and 504.8 mbsf, has comparatively slower decreases of sodium and sulfate, increases of calcium and chloride, slow increases of alkalinity and lithium, and roughly constant concentrations of magnesium, potassium, and boron. Values of d18O and dD in pore water between 146.98 and 504.80 mbsf plot in a linear trend to the right of the GMWL.

Biogeochemistry and microbiology of groundwater during acetate and bicarbonate amendment to an alluvial aquifer

These data are from a field experiment conducted in a shallow alluvial aquifer along the Colorado River in Rifle, Colorado, USA. In this experiment, bicarbonate-promoted uranium desorption and acetate amendment were combined and compared to an acetate amendment-only experiment in the same experimental plot. Data include names and location data for boreholes, geochemical data for all the boreholes between June 1, 2010 and January 1, 2011, microarray data provided as signal to noise ratio (SNR) for individual microarray probes, microarray data provided as signal to noise ratio (SNR) by Genus.