Breeding of the Scuttle Fly Megaselia scalaris in a fish Carcass and Implications for the use in Forensic Entomology (Diptera: Phoridae).

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A comparative study of the extracutaneous pigmentary system in three anuran amphibian species evaluated during the breeding season.

The present investigation examined the extracutaneous pigmentation pattern of three species of anuran amphibians, Dendropsophus nanus, Physalaemus cuvieri, and Rhinella schneideri, during the course of their breeding seasons. Pigmentation intensity in the different organs was graded on a 4-category scale, in which category 0 refers to organs without pigment and category 3 refers to intensely pigmented organs, with 2 intermediate stages of progressively stronger pigmentation. Rhinella schneideri showed testicular pigmentation, with intra-specific variation (categories 0 and 1). In P. cuvieri the pigmentation in the lungs varied in time: all the animals showed pigmentation (category 1) at the beginning of the breeding season, and as the season progressed the absence of pigments became the most common pattern. In the liver of the first animals collected, the pigment intensity was high (category 2) with many iridophores present, but in the last specimens collected no iridophores were found. The variation in D. nanus occurred in the kidneys, where animals collected at the beginning of the season did not show pigmentation. Renal veins displayed few melanocytes (category 1); animals collected at the end of the season showed more pigmentation in the kidneys (category 2), whereas in the renal veins the intensity remained the same. The changes observed in the extracutaneous pigment system in some organs, during the reproductive period, may be due to physiological alterations or may represent a species-specific characteristic.

Niobium to alcohol mol ratio control of the concurring esterification and etherification reactions promoted by NbCl5 and Al2O3 catalysts under microwave irradiation

Alcohols and acids can be switched to produce ethers or esters by varying the alcohol to catalyst mol ratio, in a new etherification and esterification method using NbCl5/Al2O3 catalyst under "solvent free" conditions and promoted by MW (microwave) irradiation. A "two sites" mechanism for the reaction is proposed, in an attempt to clarify the tendency of the catalyst to be dependent on the alcohol alone during the esterification process. (c) 2008 Elsevier B.V. All rights reserved.

Estimates of genetic parameters, and cluster and principal components analyses of breeding values related to egg production traits in a White Leghorn population

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Morphological assessment of dentine and cementum following apicectomy with Zekrya burs and Er:YAG laser associated with direct and indirect Nd:YAG laser irradiation

Objectives. This study aimed to assess the apical surface morphology of maxillary central incisors resected 3.0 mm from the tooth apex using Zekrya burs or Er:YAG laser, with or without subsequent direct Nd:YAG laser irradiation (apical and buccal surfaces) and indirect irradiation (palatal surface).Study design. Forty maxillary central incisors were instrumented and obturated. The roots were divided into 4 groups according to the root resection method (Zekrya bur or Er: YAG laser -1.8 W, 450 mJ, 4 Hz, 113 J/cm(2)) and further surface treatment (none or Nd: YAG laser -2.0 W, 100 mJ, 20 Hz, 124 J/cm(2)). The teeth were prepared for SEM analysis. Scores ranging from 1 to 4 were attributed to cut quality and morphological changes. The data were analyzed by the Kruskal-Wallis test and by Dunn's test.Results. SEM images showed irregular surfaces on the apical portions resected with Zekrya burs, with smear layer and grooves in the resected dentine and slight gutta-percha displacement and plasticization. on the other hand, apicectomies carried out with Er: YAG laser showed morphological changes compatible with ablated dentine, with rough surfaces and craters. In spite of the presence of plasticized gutta-percha, with the presence of bubbles, an irregular adaptation of the filling material to the root walls was also observed. Direct Nd: YAG laser irradiation of the apical and buccal surfaces of the resected roots resulted in areas of resolidification and fusion in the dentine and cementum, with a vitrified aspect; indirect Nd: YAG laser irradiation of the palatal surfaces yielded a lower number of changes in the cementum, with irregular resolidification areas.Conclusions. There were no differences in terms of cut quality between the use of burs and Er: YAG laser or between the 2 surfaces (apical and buccal) treated with Nd: YAG laser with direct irradiation. However, morphological changes were significantly less frequent on surfaces submitted to indirect irradiation (palatal) when compared with those directly irradiated. (Oral Surg Oral Med Oral Pathol Oral Radiol Endod 2010; 109: e77-e82)

Generation of copper nanoparticles induced by fs-laser irradiation in borosilicate glass

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Breeding of Ornidia obesa (Diptera: Syrphidae: Eristalinae) on Pig Carcasses in Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Use of progeny testing in beef cattle: Prediction of genetic gain in a Nelore Cattle Breeding Program

Genetic gains predicted for selection, based on both individual performance and progeny testing, were compared to provide information to be used in implementation of progeny testing for a Nelore cattle breeding program. The prediction of genetic gain based on progeny testing was obtained from a formula, derived from methodology of Young and Weiler (J. Genetics 57: 329-338, 1960) for two-stage selection, which allows prediction of genetic gain per generation when the individuals under test have been pre-selected on the basis of their own performance. The application of this formula also allowed determination of the number of progeny per tested bull needed to maximize genetic gain, when the total number of tested progeny is limited.

Breeding activity of the neotropical treefrog Hyla elegans (Anura, Hylidae)

Breeding of Hyla elegans was monitored from August 1991 to July 1992 at a temporary pond in Ubatuba, State of Sao Paulo, southeastern Brazil. Males began to call as they entered the chorus, and defended their calling sites from other males, at times with physical interactions. Females, however, were not aggressive toward either males or other females. We found a positive correlation between the numbers of females and males in the chorus, but no significant correlation between OSR (number of reproducing females/number of reproducing males) and the number of males present. OSR was highly male-biased; on average, there were 10 males for each female; this low OSR may explain low average mating success of males. Females chose males as mates freely, and males did not attempt to intercept females approaching other males. Males in amplexus were larger and heavier than unmated, calling males. In addition, snoutvent lengths of males and females in amplexus were positively correlated, and males were, on average, 0.81 the length of females. Experimentally paired males and females with smaller or larger ratios of SVLs had a lower percent of fertilization than pairs near the population average.

Intrapulpar temperature during continuous CO2 laser irradiation in human molars: An in vitro study

To establish safety parameters, we in vitro studied the increase in intrapulpal temperature caused by the use of a cw CO2 laser. A thermistor was implanted in the inner part of the pulpal chamber of 25 human lower third molars to measure the intrapulpal temperature produced by laser powers between 2-10 W and exposure times of 0.5-25.0 s. The Pearson linear correlation factor applied to the measured values showed there is a direct relationship between the independent variable and the applied power. A variance analysis produced the linear regression equation: T=1.10+(0.127)E where T is the temperature and E the energy. The results showed that, with a power of 4 W and maximum exposure time of 2.5 s (10 J) and a power density of 12738.85 W cm-2, there will be no damaging reactions affecting the pulpal tissues.

External factors determining seasonal breeding in a subtropical population of the shore crab Pachygrapsus transversus (Gibbes, 1850) (Brachyura, Grapsidae)

Monthly samples of the shore crab Pachygrapsus transversus from two distinct annual periods showed that ovigerous females are present throughout the Year in the population. However, the relative ovigerous abundance of specimens among sexually mature changes from less than 10% during the winter months to almost 80% in summer. Linear correlations for each year revealed that both temperature and photoperiod were positively associated with relative abundance of ovigerous females. Multiple regression analyses suggested that photoperiod was the main factor affecting breeding in this species. Timing of observed reproductive pattern may enhance larval survival because of particular oceanographic conditions in the study region and favor early juvenile development due to certain species-specific growth features.

Breeding biology and nest site characteristics of the scarlet ibis in southeastern Brazil

The breeding biology of the only Scarlet Ibis Eudocimus ruber colony in southeastern Brazil was studied during the 1996-97 breeding season. The ibises began to visit their colony site by mid-September. Nest building and egg laying took place in early November and was synchronous, making the first nesting pulse. Mean clutch size in this pulse was 2.45 eggs/nest, and 0.67 young/nest reached age three weeks, when they were able to walk about the nest tree and environs. Predation was the main cause of nest failures (74% of all losses), followed by nest collapses (19%). A second nesting pulse, also synchronous, started in late December, when the young from the first nests were already able to wander about the colony and make short flights. Mean clutch size of this pulse was 2.05 eggs/nest and productivity was 0.34 young/nest. Nest collapses during storms accounted for 58% of the losses, and predation for a further 27%. A third pulse, with only a few nests, started when the second pulse young were in their third week, but no nest was successful. The incubation time was 21-24 days, and the young were able to fly well when 40 days old, deserting the colony by age 75 days. Nesting early in the breeding season yielded greater success. Nests were built close to each other (a sphere with a 1.8 m radius and centered on an average nest would include the four nearest neighbors) and there was always more than one nest per tree. Most nests were built on the upper third of the nest-tree and had some cover from overhanging branches. There was a trend for the ibises building their nests in even closer proximity during the second pulse, perhaps as a strategy to lessen individual predation risks. Received 30 August 2000, accepted 4 October 2000.

Morphology changes induced by laser irradiation on disperse red 13 films prepared by physical vapor deposition

Surface morphology changes induced by argon laser irradiation (514 nm) on disperse red 13 (DR13) films prepared by physical vapor deposition (PVD) were investigated. Atomic force microscopy was used to characterize the irradiated sample for different periods of irradiation. Needle-shape structures are observed which are attributed to the symmetry of DR13 molecules. The film becomes increasingly closely packed with the irradiation, with lower root mean square roughness for long exposure times. This is due to photoisomerization of DR13 molecules and probably heating of the sample, which can provide the required mobility for the molecular rearrangement. The rearrangement is such that voids in the film are filled in upon irradiating the sample, thus decreasing the film roughness and increasing the packing.

The effects of low laser irradiation on angiogenesis in injured rat tibiae

The influence of He-Ne laser radiation on the formation of new blood vessels in the bone marrow compartment of a regenerating area of the mid-cortical diaphysis of the tibiae of young adult rats was studied. A small hole was surgically made with a dentistry burr in the tibia and the injured area received a daily laser therapy over 7 or 14 days transcutaneously starting 24 h from surgery. Incident energy density dosages of 31.5 and 94.5 Jcm-2 were applied during the period of the tibia wound healing investigated. Light microscopic examination of histological sections of the injured area and quantification of the newly-formed blood vessels were undertaken. Low-level energy treatment accelerated the deposition of bone matrix and histological characteristics compatible with an active recovery of the injured tissue. He-Ne laser therapy significantly increased the number of blood vessels after 7 days irradiation at an energy density of 94.5 Jcm-2, but significantly decreased the number of vessels in the 14-day irradiated tibiae, independent of the dosage. These effects were attributed to laser treatment, since no significant increase in blood vessel number was detected between 8 and 15 non-irradiated control tibiae. Molecular mechanisms involved in low-level laser therapy of angiogenesis in post-traumatic bone regeneration needs further investigation.