10Be/9Be-based chronostratigraphy of ODP Hole 181-1121B from the Southwest Pacific Ocean

A 10Be/9Be-based chronostratigraphy has been determined for ODP 181, Site 1121 sediment core, recovered from the foot of the Campbell Plateau, Southwest Pacific Ocean. This core was drilled through the Campbell 'skin drift' in ca. 4500 m water depth on the mid-western margin of the extensive Campbell Nodule Field, beneath the flow of the major cold-water Deep Western Boundary Current (DWBC). In the absence of detailed biostratigraphy, beryllium isotopes have provided essential time information to allow palaeo-environmental interpretation to be undertaken on the upper 7 m of the core. Measured 10Be/9Be ratios of sediment, and of ferromanganese nodules entrapped in the sediment, decrease systematically with depth in the core, in accordance with radioactive decay. However, the 10Be/9Be data diverge from ca. 3 m below the seafloor (mbsf) to the top of the core, giving rise to several possible geochronological models. The preferred model assumes that the measured 10Be/9Be ratios of the nodule rims reflect initial 10Be/9Be ratios equivalent to contemporary seawater, and that these can be used to derive the true age of the sediment where the nodules occur. The nodule rim ages can be then used to interpret the sediment 10Be/9Be data, which indicate an overall age to ca. 7 mbsf of ca. 17.5 Ma. The derived chronology is consistent with diatom biostratigraphy, which indicates an age of 2.2-3.6 Ma at 1 mbsf. Calculated sedimentation rates range from 8 to 95 cm m.y.**-1, with an overall rate to 7 mbsf of ca. 39 cm m.y.**-1. The lowest rates generally coincide with the occurrence of entrapped nodules, and reflect periods of increased bottom current flow causing net sediment loss. Growth rates of individual nodules decrease towards the top of the sediment core, similar to the observed decrease in growth rate from core to rim of seafloor nodules from the Campbell Nodule Field. This may be related to an overall increase in the vigour of the DWBC from ca. 10 Ma to the present.

Calcareous nannofossils in Neogene sediments of ODP Leg 117 holes

Calcareous nannofossils were studied in 574 Neogene samples recovered from eight sites drilled in block-faulted basins on the continental margin of Oman. This portion of the Arabian Sea experiences seasonal upwelling associated with the southwest monsoon. Not surprisingly, some of the more typical Neogene warm-water nannoplankton are either missing entirely or are extremely rare in these sediments. Coccolithus pelagicus, a typical cold-water indicator, is extremely abundant in many samples of late Pliocene to early Pleistocene age. These intervals correspond to periods of Northern Hemisphere glaciation. Reworked Late Cretaceous and Cenozoic nannofossils are found in a majority of the samples. They were probably carried from the Arabian Peninsula or the continent of Africa on strong southwest summer winds. Ages for the various nannofossil events were calculated by projecting the nannofossil datums onto the magnetostratigraphic scale for Sites 724, 727, and 728. These are the first ages for the various nannofossil datums derived from Oman Margin sediments. The following ages have been calculated for these nannofossil events: FAD Emiliania huxleyi, 0.23 Ma; LAD Pseudoemiliania lacunosa, 0.38 Ma; FAD Helicosphaera inversa, 0.42 Ma; top of acme of Reticulofenestra sp. A, 0.70 Ma; FAD Gephyrocapsaparallela, 0.85 Ma; LAD Gephyrocapsa spp. (large), 1.07 Ma; LAD Helicosphaera sellii, 1.34 Ma; LAD Calcidiscus macintyrei, 1.47 Ma; FAD Gephyrocapsa oceanica, 1.53 Ma; FAD Gephyrocapsa caribbeanica, 1.80 Ma; LAD Discoaster brouweri, 2.03 Ma; LAD Discoasterpentaradiatus, 2.31 Ma; LAD Discoaster surculus, 2.42; LAD Discoaster tamalis, 2.77 Ma; LAD Sphenolithus abies, 3.44 Ma; and LAD Reticulofenestra pseudoumbilica, 3.44 Ma.

Planktonic foraminiferal faunas and stable isotope ratios of sediments from the Benguela Upwelling System

Two sediment cores retrieved from the continental slope in the Benguela Upwelling System, GeoB 1706 (19°33.7'S 11°10.5'E) and GeoB 1711 (23°18.9'S, 12°22.6'E), reveal striking variations in planktonic foraminiferal abundances during the last 160,000 years. These fluctuations are investigated to assess changes in the intensity and position of the upwelling centres off Namibia. Four species make up over 95% of the variation within the core, and enable the record to be divided into episodes characterized by particular planktonic foraminiferal assemblages. The fossil assemblages have meaningful ecological significance when compared to those of the modern day and the relationship to their environment. The cold-water planktonic foraminifer, Neogloboquadrina pachyderma sinistral [N. pachyderma (s)], dominates the modern-day, coastal upwelling centres, and Neogloboquadrina pachyderma dextral and Globigerina bulloides characterize the fringes of the upwelling cells. Globorotalia inflata is representative of the offshore boundary between newly upwelled waters and the transitional, reduced nutrient levels of the subtropical waters. In the fossil record, episodes of high N. pachyderma (s) abundances are interpreted as evidence of increased upwelling intensity, and the associated increase in nutrients. The N. pachyderma (s) record suggests temporal shifts in the intensity of upwelling, and corresponding trophic domains, that do not follow the typical glacial-interglacial pattern. Periods of high N. pachyderma (s) abundance describe rapid, discrete events dominating isotope stages 3 and 2. The timing of these events correlates to the temporal shifts of the Angola-Benguela Front (Jansen et al., 1997) situated to the north of the Walvis Ridge. Absence of high abundances of N. pachyderma (s) from the continental slope of the southern Cape Basin indicates that Southern Ocean surface water advection has not exerted a major influence on the Benguela Current System. The coincidence of increased upwelling intensity with the movement of the Angola-Benguela Front can be interpreted mainly by changes in strength and zonality of the trade wind system.

(Table 2) Age determination of sediment core NIOP-C2_929

In this study we present a sea surface temperature (SST) record from the western Arabian Sea for the last 20,000 years. We produced centennial-scale d18O and Mg/Ca SST time series of core NIOP929 with focus on the glacial-interglacial transition. The western Arabian Sea is influenced by the seasonal NE and SW monsoon wind systems. Lowest SSTs occur during the SW monsoon season because of upwelling of cold water, and highest SSTs can be found in the low-productivity intermonsoon season. The Mg/Ca-based temperature record reflects the integrated SST of the SW and NE monsoon seasons. The results show a glacial-interglacial SST difference of ~2°C, which is corroborated by findings from other Arabian Sea cores. At 19 ka B.P. a yet undescribed warm event of several hundred years duration is found, which is also reflected in the d18O record. A second centennial-scale high SST/low d18O event is observed at 17 ka B.P. This event forms the onset of the stepwise yet persistent trend toward Holocene temperatures. Highest Mg/Ca-derived SSTs in the NIOP929 record occurred between 13 and 10 ka B.P. Interglacial SST is ~24°C, indicating influence of upwelling. The onset of Arabian Sea warming occurs when the North Atlantic is experiencing minimum temperatures. The rapid temperature variations at 19, 17, and 13 ka B.P. are difficult to explain with monsoon changes alone and are most likely also linked to regional hydrographic changes, such as trade wind induced variations in warm water advection.

(Table 1) Abundance of selected diatom taxa in the mid-Pliocene of ODP Hole 167-1022A

Diatom assemblages from the middle part of the Pliocene (3.2-2.5 Ma) were investigated from Ocean Drilling Program Sites 1016, 1021, and 1022 in an effort to infer paleotemperature fluctuations off California. Diatoms are very sparse in virtually all of the samples that were examined from Sites 1016 and 1021. This is presumably because these sites were seaward (west) of the coastal zone of diatom productivity during the middle part of the Pliocene. Diatoms are relatively common in the vast majority of samples that were examined from Hole 1022A. Diatom assemblages are dominated by Chaetoceros spores (a coastal upwelling component), the cold-water (subarctic) taxa Neodenticula kamtschatica and its descendant Neodenticula koizumii, and Thalassionema nitzschioides, a temperate taxon that is typically found at the seaward edge of coastal upwelling zones. Paleotemperature interpretations, however, are not possible at this time because of the scarcity of comparative modern core-top data.

Ages and diatom temperature values of DSDP sites in the western Pacific Ocean

Maximum entropy spectral analyses and a fitting test to find the best suitable curve for the modified time series based on the non-linear least squares method for Td (diatom temperature) values were performed for the Quaternary portion of the DSDP Sites 579 and 580 in the western North Pacific. The sampling interval averages 13.7 kyr in the Brunhes Chron (0-780 ka) and 16.5 kyr in the later portion of the Matuyama Chron (780-1800 ka) at Site 580, but increases to 17.3 kyr and 23.2 kyr, respectively, at Site 579. Among dominant cycles during the Brunhes Chron, there are 411.5 kyr and 126.0 kyr at Site 579, and 467.0 kyr and 136.7 kyr at Site 580 correspond to 413 kyr and 95 to 124 kyr of the orbital eccentricity. Minor cycles of 41.2 kyr at Site 579 and 41.7 kyr at Site 580 are near to 41 kyr of the obliquity (tilt). During the Matuyama Chron at Site 580, cycles of 49.7 kyr and 43.6 kyr are dominant. The surface-water temperature estimated from diatoms at the western North Pacific DSDP Sites 579 and 580 shows correlation with the fundamental Earth's orbital parameters during Quaternary time.

An isotopic analysis of geothermal brine and calcite scaling from the Blue Mountain geothermal field, Winnemucca, Nevada

Understanding, and controlling, the conditions under which calcite precipitates within geothermal energy production systems is a key step in maintaining production efficiency. In this study, I apply methods of bulk and clumped isotope thermometry to an operating geothermal energy facility in northern Nevada to see how those methods can better inform the facility owner, AltaRock Energy, Inc., about the occurrence of calcite scale in their power plant. I have taken water samples from five production wells, the combined generator effluent, shallow cold-water wells, monitoring wells, and surface water. I also collected calcite scale samples from within the production system. Water samples were analyzed for stable oxygen isotope composition (d18O). Calcite samples were analyzed for stable oxygen and carbon (d13C) composition, and clumped isotope composition (D47). With two exceptions, the water compositions are very similar, likely indicating common origin and a well-mixed hydrothermal system. The calcite samples are likewise similar to one another. Apparent temperatures calculated from d18O values of water and calcite are lower than those recorded for the system. Apparent temperatures calculated from D47 are several degrees higher than the recorded well temperatures. The lower temperatures from the bulk isotope data are consistent with temperatures that could be expected during a de-pressurization of the production system, which would cause boiling in the pipes, a reduction in system temperature, and rapid precipitation of calcite scale. However, the high apparent temperature indicated by the D47 data suggests that the calcite is depleted in clumped isotopes given the known temperature of the system, which is inconsistent with this hypothesis. This depletion could instead result from disequilibrium isotopic fractionation during the aforementioned boil events, which would make both the apparent d18O-based and D47-based temperatures unrepresentative of the actual water temperature. This research can help improve our understanding of how isotopic analyses can better inform us about the movement of water through geothermal systems of the past and how it now moves through modern systems. Increased understanding of water movement in these systems could potentially allow for more efficient utilization of geothermal energy as a renewable resource.

Warm eyes provide superior vision in swordfishes

Large and powerful ocean predators such as swordfishes, some tunas, and several shark species are unique among fishes in that they are capable of maintaining elevated body temperatures (endothermy) when hunting for prey in deep and cold water [1-3]. In these animals, warming the central nervous system and the eyes is the one common feature of this energetically costly adaptation [4]. In the swordfish (Xiphias gladius), a highly specialized heating system located in an extraocular muscle specifically warms the eyes and brain up to 10degreesC-15degreesC above ambient water temperatures [2, 5]. Although the function of neural warming in fishes has been the subject of considerable speculation [1, 6, 7], the biological significance of this unusual ability has until now remained unknown. We show here that warming the retina significantly improves temporal resolution, and hence the detection of rapid motion, in fast-swimming predatory fishes such as the swordfish. Depending on diving depth, temporal resolution can be more than ten times greater in these fishes than in fishes with eyes at the same temperature as the surrounding water. The enhanced temporal resolution allowed by heated eyes provides warm-blooded and highly visual oceanic predators, such as swordfishes, tunas, and sharks, with a crucial advantage over their agile, cold-blooded prey.

Influence of macroscopic residual stress fields on fatigue crack growth measurement in SiC particulate reinforced 8090 aluminium alloy

The effect of residual stresses, induced by cold water quenching, on the morphology of fatigue crack fronts has been investigated in a powder metallurgy 8090 aluminium alloy, with and without reinforcement in the form of 20 wt-%SiC particles. Residual stress measurements reveal that the surface compressive stresses developed in these materials are significantly greater than in conventional metallurgy ingot 8090, because surface yielding occurs on quenching. The yield stresses of the powder route materials are greater than those of ingot produced 8090 and hence greater surface stresses can be maintained. In fatigue, severe crack front bowing is observed in the powder formed materials as a result of the reduction of the R ratio (minimum load/maximum load) by the compressive residual stresses at the sides of the specimen, causing premature crack closure and hence reducing the local driving force for fatigue crack growth ΔKeff. This distortion of the crack fronts introduces large errors into measurements of crack growth rate and threshold values of ΔK.