Distribution of nutrients in the root zone affects yield, quality and blossom end rot of tomato fruits

Tomato plants (Lycopersicon esculentum Mill. 'DRK') were grown hydroponically in two experiments to determine the effects of nutrient concentration and distribution in the root zone on yield, quality and blossom end rot (BER). The plants were grown in rockwool with their root systems divided into two portions. Each portion was irrigated with nutrient solutions with either the same or different electrical conductivity (EC) in the range 0 to 6 dS m(-1). In both experiments, fruit yields decreased as EC increased from moderate to high when solutions of equal concentration were applied to both portions of the root system. However, higher yields were obtained when a solution with high EC was applied to one portion of the root system and a solution of low EC to the other portion. For example, the fresh weight of mature fruits in the 6/6 treatment was only 20% that of the 3/3 treatment but the 6/0 treatment had a yield that was 40% higher. The reduction in yield in the high EC treatments was due to an increase in the number of fruits with BER and smaller fruit size. BER increased from 12% to 88% of total fruits as EC increased from 6/0 to 6/6 and fruit length decreased from 67 mm to 52 mm. Fruit quality (expressed as titratable acidity and soluble solids) increased as EC increased. In summary, high yields of high quality tomatoes with minimal incidence of BER were obtained when one portion of the root system was supplied with a solution of high EC and the other portion with a solution of moderate or zero EC.

Mapping quantitative trait loci for flag leave senescence as a yield determinant in winter wheat under optimal and drought stressed environments

The timing of flag leaf senescence (FLS) is an important determinant of yield under stress and optimal environments. A doubled haploid population derived from crossing the photo period-sensitive variety Beaver,with the photo period-insensitive variety Soissons, varied significantly for this trait, measured as the percent green flag leaf area remaining at 14 days and 35 days after anthesis. This trait also showed a significantly positive correlation with yield under variable environmental regimes. QTL analysis based on a genetic map derived from 48 doubled haploid lines using amplified fragment length polymorphism (AFLP) and simple sequence repeat (SSR) markers, revealed the genetic control of this trait. The coincidence of QTL for senescence on chromosomes 2B and 2D under drought-stressed and optimal environments, respectively, indicate a complex genetic mechanism of this trait involving the re-mobilisation of resources from the source to the sink during senescence.

Growth, yield and development of strawberry cv. 'Elsanta' under novel photoselective film clad greenhouses

Film greenhouse claddings are typically used to protect horticultural crops from low temperature and high rainfall conditions. However, a range of novel plastic films have been developed which filter specific radiation wavelengths with the aim of providing the grower with greater control of crop growth and development. A replicated experiment was conducted in 8 small experimental greenhouses, covered with different photoselective films characterised by a range of red/far-red ratios and PAR transmissions to study their effects on the growth, yield and quality of the strawberry cv. 'Elsanta'. Marketable yield per plant was 51% greater under the film with the highest light transmission (control) compared with the lower light transmission films. Similarly, unmarketable fruit number and average non-marketable individual fruit weight per plant was lowest under films with higher light transmissions and higher under lower light transmission films. Cropping duration was longer under films with high R/FR. Also plants under high R/FR were more compact (due to shorter petiole lengths) compared to plants grown under low R/FR. The results are discussed in relation to the increased use of photoselective films in protected horticulture and the need for higher quality fruit and vegetables.

On the yield stress of frozen sucrose solutions

Measurement or prediction of the mechanical and fracture properties of foods is very important in the design, operation and optimization of processes, as well as for the control of quality of food products. This paper describes the measurement of yield stress of frozen sucrose solutions under indentation tests using a spherical indenter. Effects of composition, temperature and strain rate on yield stress of frozen sucrose solutions have also been investigated.

Anti-cancer properties of phenolics from apple waste on colon carcinogenesis in vitro

Colorectal cancer is one of the most common cancers in Western countries. The World Health Organisation identifies diet as a critical risk factor in the development and progression of this disease and the protective role of high levels of fruit and vegetable consumption. Several studies have shown that apples contain several phenolic compounds that are potent anti-oxidants in humans. However, little is known about other beneficial properties of apple phenolics in cancer. We have used the HT29, HT115 and CaCo-2 cell lines as in vitro models to examine the effect of apple phenolics (0.01–0.1% apple extract) on key stages of colorectal carcinogenesis, namely; DNA damage (Comet assay), colonic barrier function (TER assay), cell cycle progression (DNA content assay) and invasion (Matrigel assay). Our results indicate that a crude extract of apple phenolics can protect against DNA damage, improve barrier function and inhibit invasion (p < 0.05). The anti-invasive effects of the extract were enhanced with twenty-four hour pretreatment of cells (p < 0.05). We have shown that a crude apple extract from waste, rich in phenolic compounds, beneficially influences key stages of carcinogenesis in colon cells in vitro.

Light-induced off-flavor development in cloudy apple juice

Cloudy apple juice has been found to develop off-flavors during storage in daylight. The development of off-flavors and volatile compounds was monitored in reconstituted juice prepared from 'Golden Delicious' and 'Fuji' apple concentrates stored in glass bottles under fluorescent light (3000 Ix, 8 degrees C). A strong metallic off-flavor was formed by photooxidation. A major contributor to the off-flavor was identified as 1-octen-3-one by gas chromatography-olfactometry. In addition, six volatile compounds, pentanal, 2-methyl-1-penten-3-one, hexanal, (E)-2-heptenal, 6-methyl-5-hepten-2-one, and (E)-2octenal, increased significantly after light exposure and could contribute to the off-flavor. Except for pentanal and hexanal, these volatiles were found only after light exposure. Higher levels of volatiles were observed in juice from 'Golden Delicious' apples than in juice from 'Fuji' apples, and this difference was consistent with higher levels of suspended solids. When the suspended solids were removed by centrifugation, the development of volatiles on exposure to light was reduced significantly.

Influence of harvest date and crop yield on the fatty acid composition of virgin olive oils from cv. Picual

In this study was analyzed the effect of crop year and harvesting time on the fatty acid composition of cv. Picual virgin olive oil. The study was carried out during the fruit ripening period for three crop seasons. The mean fatty acid composition of Picual oils was determined. The oils contained palmitic acid (11.9%), oleic acid (79.3%), and linoleic acid (2.95%). The content of palmitic acid and saturated fatty acids decreased during fruit ripening while oleic and linoleic acids increased. The amount of stearic and linolenic acids decreased. The amount of saturated acids, palmitic and stearic, and the polyunsaturated acids linoleic and linolenic was dependent on the time of harvest, whereas the amount of oleic acid varied with the crop year. The differences observed between crop years for both palmitic and linoleic acid may be explained by the differences in the temperature during oil biosynthesis and by the amount of summer rainfall for oleic acid content. A significant relationship was observed between the MUFA/PUFA ratio and the oxidative stability measured by the Rancimat method.

Effects of reduced height (Rht) and photoperiod insensitivity (Ppd) alleles on yield of wheat in contrasting production systems

Near isogenic lines (NILs) varying for reduced height (Rht) and photoperiod insensitivity (Ppd-D1) alleles in a cv. Mercia background (rht (tall), Rht-B1b, Rht-D1b, Rht-B1c, Rht8c+Ppd-D1a, Rht-D1c, Rht12) were compared for interception of photosynthetically active radiation (PAR), radiation use efficiency (RUE), above-ground biomass (AGB), harvest index (HI), height, weed prevalence, lodging and grain yield, at one field site but within contrasting (‘organic’ v ‘conventional’) rotational and agronomic contexts, in each of three years. In the final year, further NILs (rht (tall), Rht-B1b, Rht-D1b, Rht-B1c, Rht-B1b+Rht-D1b, Rht-D1b+Rht-B1c) in Maris Huntsman and Maris Widgeon backgrounds were added together with 64 lines of a doubled haploid (DH) population [Savannah (Rht-D1b) × Renesansa (Rht-8c+Ppd-D1a)]. There were highly significant genotype × system interactions for grain yield, mostly because differences were greater in the conventional system than in the organic system. Quadratic fits of NIL grain yield against height were appropriate for both systems when all NILs and years were included. Extreme dwarfing was associated with reduced PAR, RUE, AGB, HI, and increased weed prevalence. Intermediate dwarfing was often associated with improved HI in the conventional system, but not in the organic system. Heights in excess of the optimum for yield were associated particularly with reduced HI and, in the conventional system, lodging. There was no statistical evidence that optimum height for grain yield varied with system although fits peaked at 85cm and 96cm in the conventional and organic systems, respectively. Amongst the DH lines, the marker for Ppd-D1a was associated with earlier flowering, and just in the conventional system also with reduced PAR, AGB and grain yield. The marker for Rht-D1b was associated with reduced height, and again just in the conventional system, with increased HI and grain yield. The marker for Rht8c reduced height, and in the conventional system only, increased HI. When using the System × DH line means as observations grain yield was associated with height and early vegetative growth in the organic system, but not in the conventional system. In the conventional system, PAR interception after anthesis correlated with yield. Savannah was the highest yielding line in the conventional system, producing significantly more grain than several lines that out yielded it in the organic system.

A simplified, high-yield synthesis, and crystal structure of [tris{bis(2,4,6-triisopropylphenyl)tin}]

The species [{Sn(C2H2iPr3-2,4,6)2}3] has been obtained in a simple, essentially quantitative, synthesis from SnCl2 and ArLi in diethyl ether at low temperature. The crystal structure analysis confirms the trimeric nature of the molecular units but reveals some unusual features. The crystal contains the unusual feature of an asymmetric unit that consists of three units of [{SnAr2}3] in P21/c; the molecular unit is a scalene triangle, showing high consistency between the three molecules, in contrast to analogous trimeric species of silicon or germanium. The SnSn bonds are lengthened (average value 2.942 Å) owing to steric crowding.

The synthesis and properties of [Fe3(CO)11(RCN)] derivatives, and a high-yield general route to mono- and di-substituted derivatives of [Fe3(CO)12]; the crystal and molecular structure of [Fe3(CO)11(NCC6H4-2-Me)]

The clusters [Fe3(CO)11(RCN)] (1: R = Me, C3H5, C6H5, or C6H4-2-Me) have been prepared at low temperature from [Fe3(CO)12] and RCN in the presence of Me3NO. Compounds 1 react essentially quantitatively with a wide range of two-electron donors, L, (viz.: CO, PPh3, P(OMe)3, PPh2H, PPh2Me, PF3, CyNC (Cy = cyclohexyl), P(OEt)3, SbPh3, PBu3, AsPh3, or SnR2 (R = CH(SiMe3)2)) to give [Fe3(CO)11L] (2). In some cases (2), on treatment with Me3NO and then L′ (L′ = a second two-electron donor) yields [Fe3(CO)10LL′] in high yield. The crystal and molecular structures of 1 (L = NCC6H4Me-2) have been determined by a full single crystal structure analysis, and shown to have an axial nitrile coordinated at the unique iron atom, with two CO groups bridging the other two metal atoms.

Effect of cutting time, temperature and calcium on curd moisture, whey fat loses and curd yield by response surface methodology

Response surface methodology was used to study the effect of temperature, cutting time, and calcium chloride addition level on curd moisture content, whey fat losses, and curd yield. Coagulation and syneresis were continuously monitored using 2 optical sensors detecting light backscatter. The effect of the factors on the sensors’ response was also examined. Retention of fat during cheese making was found to be a function of cutting time and temperature, whereas curd yield was found to be a function of those 2 factors and the level of calcium chloride addition. The main effect of temperature on curd moisture was to increase the rate at which whey was expelled. Temperature and calcium chloride addition level were also found to affect the light backscatter profile during coagulation whereas the light backscatter profile during syneresis was a function of temperature and cutting time. The results of this study suggest that there is an optimum firmness at which the gel should be cut to achieve maximum retention of fat and an optimum curd moisture content to maximize product yield and quality. It was determined that to maximize curd yield and quality, it is necessary to maximize firmness while avoiding rapid coarsening of the gel network and microsyneresis. These results could contribute to the optimization of the cheese-making process.