Optical properties of zirconium oxynitride films: the effect of composition, electronic and crystalline structures

tThis work is devoted to the investigation of zirconium oxynitride (ZrOxNy) films with varied opticalresponses prompted by the variations in their compositional and structural properties. The films wereprepared by dc reactive magnetron sputtering of Zr, using Ar and a reactive gas mixture of N2+ O2(17:3).The colour of the films changed from metallic-like, very bright yellow-pale and golden yellow, for low gasflows to red-brownish for intermediate gas flows. Associated to this colour change there was a significantdecrease of brightness. With further increase of the reactive gas flow, the colour of the samples changedfrom red-brownish to dark blue or even to interference colourations. The variations in composition dis-closed the existence of four different zones, which were found to be closely related with the variationsin the crystalline structure. XRD analysis revealed the change from a B1 NaCl face-centred cubic zirco-nium nitride-type phase for films prepared with low reactive gas flows, towards a poorly crystallizedover-stoichiometric nitride phase, which may be similar to that of Zr3N4with some probable oxygeninclusions within nitrogen positions, for films prepared with intermediate reactive gas flows. For highreactive gas flows, the films developed an oxynitride-type phase, similar to that of -Zr2ON2with someoxygen atoms occupying some of the nitrogen positions, evolving to a ZrO2monoclinic type structurewithin the zone where films were prepared with relatively high reactive gas flows. The analysis carriedout by reflected electron energy loss spectroscopy (REELS) revealed a continuous depopulation of thed-band and an opening of an energy gap between the valence band (2p) and the Fermi level close to 5 eV.The ZrN-based coatings (zone I and II) presented intrinsic colourations, with a decrease in brightness anda colour change from bright yellow to golden yellow, red brownish and dark blue. Associated to thesechanges, there was also a shift of the reflectivity minimum to lower energies, with the increase of thenon-metallic content. The samples lying in the two last zones (zone III, oxynitride and zone IV, oxide films)revealed a typical semi-transparent-optical behaviour showing interference-like colourations only dueto the complete depopulation of the d band at the Fermi level. The samples lying in these zones presentedalso an increase of the optical bandgap from 2 to 3.6 eV.

Evolution of the functional properties of titanium–silver thin films for biomedical applications: Influence of in-vacuum annealing

In this work, the thermal stability of TiAgx thin films, deposited by magnetron sputtering, was evaluated, envisaging their application in biomedical devices, namely as electrodes for biosignal acquisition. Based on the composition and microstructural characterization, a set of four representative TiAgx thin films was selected in order to infer whether they are thermally stable in terms of functional properties. In order to achieve this purpose, the structural and morphological evolution of the films with annealing temperature was correlated with their electrical, mechanical and thermal properties. Two distinct zones were identified and two samples from each zone were extensively analysed. In the first zone (zone I), Ti was the main component (Ti-rich zone) while in the second, zone II, the Ag content was more significant. The selected samples were annealed in vacuum at four different temperatures up to 500 oC. For the samples produced within zone I, small microstructural changes were observed due to the recrystallization of the Ti structure and grain size increment. Also, no significant changes were observed with annealing temperature regarding the f l ’ functional properties, being thermally stable up to 500 oC. For higher Ag contents (zone II) the energy supplied by thermal treatments was sufficient to activate the crystallization of Ti-Ag intermetallic phases. A strong increase of the grain size of these phases was also reported. The structural and morphological organization proved to be determinant for the physical responses of the TiAgx system. The hardness and Y g’s modulus were significantly improved with the formation of the intermetallic phases. The silver addition and annealing treatments also played an important role in the electrical conductivity of the films, which was once again improved by the formation of Ti-Ag phases. The thermal diffusivity of the films was practically unchanged with the heat-treatment. This set of results shows that this intermetallic-like thin film system has good thermal stability up to high temperatures (as high as 500 oC), which in case of the highest Ag content zone is particularly evident for electrical and mechanical properties, showing an important improvement. Hardness increases about three times, while resistivity values become half of those from the lowest Ag contents zone. These set of characteristics are consistent with the targeted applications, namely in terms of biomedical sensing devices.

Comportamento tribológico de biocompósitos de matriz de titânio

Dissertação de mestrado integrado em Engenharia de Materiais

Sustainability assessment of envelope wall solutions using MAXergy methodology

Projeto de investigação integrado de International Master in Sustainable Built Environment

Turismo arqueológico: um projeto de valorização da arte rupestre no vale do Lima

Dissertação de mestrado em Património e Turismo Cultural

Development of multifunctional coatings deposited on polymers based sensors for biomedical applications

Tese de Doutoramento (Programa Doutoral em Engenharia de Materiais)

Gestão integrada dos recursos hídricos da região de Fafe: caracterização da qualidade das águas superficiais, potencial hidrogeológico das rochas fraturadas

Dissertação de mestrado em Geociências (área de especialização em Recursos Geológicos)

Intervenção precoce: as preocupações e os apoios sociais das mães do Vale do Sousa

Dissertação de mestrado em Educação Especial (área de especialização em Intervenção Precoce)

Interpersonal and attitudinal factors in women's work role: Cross-cultural comparison

The last four decades have seen a dramatic increase in the number of women entering employment. This is particularly true in Europe and although more European women are working outside the home, the patterns of female employment have changed very little. An analysis of these patterns is presented. It was found that women continue to dominate specific fields, particularly teaching and service providing. An investigation of the interpersonal behavior differences among 117 American women from the southeastern United States in three work roles--homemakers, women in traditional occupations, and in nontraditional occupations--was conducted and the sex-role orientation, attitudes toward success, and demographic indicators were examined in order to consider the interplay of these variables with female occupational role and interpersonal behavior. A second focus of the study is on the cross-cultural comparison of the psychological and work variables in women of two different cultures: America and Portugal. Thirty-one Portuguese women were a preliminary comparison sample. The American results showed significant differences between groups in self-perceived interpersonal behaviors and the findings contradicted current stereotypes. The cross-cultural data, although preliminary, indicates differences between the countries in social desirability, aggressive and assertive behaviors, and in sex-role attitudes, which seem to reflect the different stages of economic development. (MKA)

The construction of professional identities in the contexts of work

This chapter identifies and analyzes some characteristics of working situations that are important in the construction of professional identities. It is claimed that professional identity presumes a dynamic process and is constructed and reconstructed in social situations and interactions. Work has a central place in the life of individuals and societies. The contexts of work are places par excellence for investment, expression, negotiation and recognition of the actor themselves and of others. They are, thus, situations for the attribution offeelings about work, ofrelational transactions, oflearning and production of professional know ledge, which are fundamental elements in the (re )construction of professional identity and which are emphasized here below.

A promoção do capital psicológico,work engagement e saúde mental de trabalhadores

Dissertação de Mestrado em Políticas de Desenvolvimento de Recursos Humanos

More letters of Charles Darwin. A record of his work in a series of hitherto unpublished letters, ed. by Francis Darwin ... and A.C. Seward ...

2