876 resultados para Tariff on coffee
Resumo:
Although others regulations regarding feed-in tariffs for photovoltaics (PV) existed in Spain previously, the one that meant a paradigm change was the introduction in 2007 of law R.D.661/2007 which established a feed-in tariff of 41,75 cents/kWh if the installed capacity was greater than 100KWp and 44,04 cents/kWh if it was smaller. The high level of the subsidies together with the lack of a limit for the total installed capacity originates the well-known Spanish photovoltaic boom. In September 2008 the installed PV capacity accounted for 3.2GWp (while the official objective stated in the national renewable roadmap was only 400MWp). To avoid this situation a new law, R.D. 1578/2008, was proclaimed which established a decreasing feed-in tariff of 32 cents/kWh (for ground installations) and 34 cents/kWh (for rooftops) and it limited the annual installed capacity to 500MWp. Although it was successful in limiting the PV subsidies total costs, the successive and sudden changes in regulations resulted very harmful to the local PV industry. In this article, the strong influence of feed-in tariff in the development of PV installed capacity and market evolution in Spain will be analyzed in detail. In addition, a comparison with other subsidized technologies which installed capacity has had a smoother evolution, as wind energy, will be presented.
Resumo:
Tiny increases in the transmittance of optical materials within a CPV module can have an important impact on the economy of a plant. This is certainly true in systems comprising multi-junction solar cells, whose high performance, based on a balanced photocurrent generation among the series-connected junctions, is very sensitive to spectrum variations. Every efficiency point gained causes not only an increase in the kilowatts hour produced, but a higher benefit on it, since the difference between electricity tariff and Levelized Cost of Electricity (LCOE) rises. This work studies the impact on the LCOE of a plant based on modules comprising PMMA lenses of two different types, standard UV blocking grade which is normally used for outdoor applications at high DNI climate and a specialty stabilized UV-enhanced transmittance acrylic (see Figure 1). Energy production will be compared for these two systems throughout the year at different sites to analyze when (season, time of the day) and where the usage of the enhanced PMMA is justified.
Resumo:
In coffee processing the fermentation stage is considered one of the critical operations by its impact on the final quality of the product. However, the level of control of the fermentation process on each farm is often not adequate; the use of sensorics for controlling coffee fermentation is not common. The objective of this work is to characterize the fermentation temperature in a fermentation tank by applying spatial interpolation and a new methodology of data analysis based on phase space diagrams of temperature data, collected by means of multi-distributed, low cost and autonomous wireless sensors. A real coffee fermentation was supervised in the Cauca region (Colombia) with a network of 24 semi-passive TurboTag RFID temperature loggers with vacuum plastic cover, submerged directly in the fermenting mass. Temporal evolution and spatial distribution of temperature is described in terms of the phase diagram areas which characterizes the cyclic behaviour of temperature and highlights the significant heterogeneity of thermal conditions at different locations in the tank where the average temperature of the fermentation was 21.2 °C, although there were temperature ranges of 4.6°C, and average spatial standard deviation of ±1.21ºC. In the upper part of the tank we found high heterogeneity of temperatures, the higher temperatures and therefore the higher fermentation rates. While at the bottom, it has been computed an area in the phase diagram practically half of the area occupied by the sensors of the upper tank, therefore this location showed higher temperature homogeneity
Resumo:
The fermentation stage is considered to be one of the critical steps in coffee processing due to its impact on the final quality of the product. The objective of this work is to characterise the temperature gradients in a fermentation tank by multi-distributed, low-cost and autonomous wireless sensors (23 semi-passive TurboTag® radio-frequency identifier (RFID) temperature loggers). Spatial interpolation in polar coordinates and an innovative methodology based on phase space diagrams are used. A real coffee fermentation process was supervised in the Cauca region (Colombia) with sensors submerged directly in the fermenting mass, leading to a 4.6 °C temperature range within the fermentation process. Spatial interpolation shows a maximum instant radial temperature gradient of 0.1 °C/cm from the centre to the perimeter of the tank and a vertical temperature gradient of 0.25 °C/cm for sensors with equal polar coordinates. The combination of spatial interpolation and phase space graphs consistently enables the identification of five local behaviours during fermentation (hot and cold spots).
Resumo:
The issue of “trade and exchange rate misalignments” is being discussed at the G20, IMF and WTO, following an initiative by Brazil. The main purpose of this paper is to apply the methodology developed by the authors to exam the impacts of misalignment on tariffs in order to analyse the impacts of misalignments on the trade relations between two customs unions – the EU and Mercosur, as well as to explain how tariff barriers are affected. It is divided into several sections: the first summarises the debate on exchange rates at the WTO; the second explains the methodology used to determine exchange rate misalignments; the third and fourth summarises the methodology applied to calculate the impacts of exchange rate misalignments on the level of tariff protection through an exercise of ‘misalignment tariffication’; the fifth reviews the effects of exchange rate misalignments on tariffs and its consequences for the trade negotiations between the two areas; and the last concludes and suggests a way to move the debate forward in the context of regional arrangements.
Resumo:
This paper provides an overview of methods employed to quantify non-tariff measures (NTMs) and then analyses their differences and looks at what these mean for the Transatlantic Trade and Investment Partnership (TTIP) negotiations. The authors find several similarities in the approaches taken. Because all studies conclude that NTMs matter, they argue that policy-makers are right to focus on ‘regulatory cooperation’ in TTIP. Given the significant differences in NTMs across sectors, policy-makers are urged to dive deep into sector-specific elements of NTMs and focus on those sectors where the largest potential gains can be made (i.e. where NTMs are highest, such as in agriculture, automobiles, steel, textiles and insurance services). An area identified for further research is the fact that unlike trade taxes (i.e. tariffs), regulatory barriers to trade are not generally targeted as the primary policy objective, but rather stem from other strategic policy concerns such as consumer safety and/or social and environmental protection. This element should be further investigated.
Resumo:
Anirudh Shingal presents at the joint NCCR Trade Regulation/NCCR Climate Workshop on “Border measures and the PPM issue in the context of climate change”. This presentation explores the possibility of a unilateral tariff increase on the imports of the most carbon-intensive products (identified from literature) from countries non-committed to climate-friendly polices in a bid to push them towards “global” climate policies. The presentation provides a first look at the empirical model to be used as well as the choice of trading partners, carbon-intensive products and the time period. Preliminary statistical analysis undertaken reveals the importance of these products in the trade flows of both importing and exporting countries as well as the existence of low tariffs (on these products) in destination markets.
Resumo:
At head of title: 93d Congress, 1st session, Senate, Executive report ; no. 93-16.
Resumo:
Reproduced from type-written copy.
Resumo:
"International coffee agreement, 1962": p. 6-38.
Resumo:
Includes index.
Resumo:
"The studies here reported were made for the Committee on research of the Joint coffee trade publicity committee".--Prefatory note.
Resumo:
On cover: For speakers, writers, agents, etc.
Resumo:
Vol. 1, pt. 1 of v. 2, and v. 3 are complete reports. The remaining volumes are each an analysis and summary of the industry studied. Full reports on these industries were not published.
Resumo:
1. Introduction.--2. The constitutional relations of the dominion and the provinces.--3. The effects of federal monetary policy on western Canadian economy.--4. The effects of Federal Tariff policy on western Canadian economy.--5. The effects of declining income.--6. The financial problems of municipalities and school districts.--7. Analysis of Manitoba's treasury problem.--8. Manitoba's case--Summary and recommendations.--9. An examination of certain proposals for the readjustment of dominion - provincial financial relations.