Formation of brominated pollutants during the pyrolysis and combustion of tetrabromobisphenol A at different temperatures

Tetrabromobisphenol A (TBBPA) is the most widely used brominated flame retardant worldwide. A detailed examination of the degradation products emitted during thermal decomposition of TBBPA is presented in the study. Runs were performed in a laboratory furnace at different temperatures (650 and 800 °C) and in different atmospheres (nitrogen and air). More than one hundred semivolatile compounds have been identified by GC/MS, with special interest in brominated ones. Presence of HBr and brominated light hydrocarbons increased with temperature and in the presence of oxygen. Maximum formation of PAHs is observed at pyrolytic condition at the higher temperature. High levels of 2,4-, 2,6- and 2,4,6- bromophenols were found. The levels of polybrominated dibenzo-p-dioxins and furans have been detected in the ppm range. The most abundant isomers are 2,4,6,8-TeBDF in pyrolysis and 1,2,3,7,8-PeBDF in combustion. These results should be considered in the assessment of thermal treatment of materials containing brominated flame retardants.

De novo synthesis of brominated dioxins and furans

On the basis of laboratory experiments with model mixtures (active carbon + CuBr2 at different loads), this work studies the formation of polybrominated dibenzo-p-dioxins and dibenzofurans (PBDD/Fs) by de novo synthesis. For the different samples, the temperature of the maximum carbon oxidation rate was determined by thermogravimetric analysis, and a kinetic model was proposed for the degradation of the materials in an oxidizing atmosphere (synthetic air). The effect of the addition of different amounts of CuBr2 was studied, finding that its presence accelerates the degradation of the carbonaceous structure in the presence of oxygen. The thermal degradation of the samples in air is satisfactorily described by a first-order single-reaction model. In addition, combustion runs of one of the mixtures (consisting of activated carbon + 50 wt % CuBr2, pyrolyzed at 700 °C) were performed in a quartz horizontal laboratory furnace. The analysis of the emissions and the solid residue proved the formation of brominated dioxins and furans at 300, 400, and 500 °C, with a maximum yield at 300 °C (91.7 ng/g of total PBDD/Fs) and a higher bromination degree with increasing temperature.

Analysis of the Brominated Dioxin and Furan Emission Congener Pattern from Different Sources

Polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/F) have been studied for several decades and are well-known as unintentionally generated persistent organic pollutants (POPs), which pose serious health and environmental risks on a global scale1. Polybrominated dibenzo-p-dioxins and dibenzofurans (PBDD/F) have similar properties and effects to PCDD/F, as they are structural analogs with all the chlorine atoms substituted by bromine atoms. PBDD/F have been found in various matrices such as air, sediments, marine products, and human adipose samples.

Pyrolysis and combustion study of flexible polyurethane foam

The thermal degradation of flexible polyurethane foam has been studied under different conditions by thermogravimetric analysis (TG), thermogravimetric analysis-infrared spectrometry (TG-IR) and thermogravimetric analysis-mass spectrometry (TG-MS). For the kinetic study, dynamic and dynamic+isothermal runs were performed at different heating rates (5, 10 and 20 °C min−1) in three different atmospheres (N2, N2:O2 4:1 and N2:O2 9:1). Two reaction models were obtained, one for the pyrolysis and another for the combustion degradation (N2:O2 4:1 and N2:O2 9:1), simultaneously correlating the experimental data from the dynamic and dynamic+isothermal runs at different heating rates. The pyrolytic model considered consisted of two consecutive reactions with activation energies of 142 and 217.5 kJ mol−1 and reaction orders of 0.805 and 1.246. Nevertheless, to simulate the experimental data from the combustion runs, three consecutive reactions were employed with activation energies of 237.9, 103.5 and 120.1 kJ mol−1, and reaction orders of 2.003, 0.778 and 1.025. From the characterization of the sample employing TG-IR and TG-MS, the results obtained showed that the FPUF, under an inert atmosphere, started the decomposition breaking the urethane bond to produce long chains of ethers which were degraded immediately in the next step. However, under an oxidative atmosphere, at the first step not only the urethane bonds were broken but also some ether polyols started their degradation which finished at the second step producing a char that was degraded at the last stage.

Cost-Effective Force Field Tailored for Solid-Phase Simulations of OLED Materials

A united atom force field is empirically derived by minimizing the difference between experimental and simulated crystal cells and melting temperatures for eight compounds representative of organic electronic materials used in OLEDs and other devices: biphenyl, carbazole, fluorene, 9,9′-(1,3-phenylene)bis(9H-carbazole)-1,3-bis(N-carbazolyl)benzene (mCP), 4,4′-bis(N-carbazolyl)-1,1′-biphenyl (pCBP), phenazine, phenylcarbazole, and triphenylamine. The force field is verified against dispersion-corrected DFT calculations and shown to also successfully reproduce the crystal structure for two larger compounds employed as hosts in phosphorescent and thermally activated delayed fluorescence OLEDs: N,N′-di(1-naphthyl)-N,N′-diphenyl-(1,1′-biphenyl)-4,4′-diamine (NPD), and 1,3,5-tri(1-phenyl-1H-benzo[d]imidazol-2-yl)phenyl (TPBI). The good performances of the force field coupled to the large computational savings granted by the united atom approximation make it an ideal choice for the simulation of the morphology of emissive layers for OLED materials in crystalline or glassy phases.

Intra-population variation and geographic correlation in Canthon humectus hidalgoensis using FTIR-ATR spectroscopy

In some cases external morphology is not sufficient to discern between populations of a species, as occurs in the dung beetle Canthon humectus hidalgoensis Bates; and much less to determine phenotypic distances between them. FTIR-ATR spectroscopy show several advantages over other identification techniques (e.g. morphological, genetic, and cuticular hydrocarbons analysis) due to the non-invasive manner of the sample preparation, the relative speed of sample analysis and the low-cost of this technology. The infrared spectrum obtained is recognized to give a unique ‘fingerprint’ because vibrational spectra are specific and unique to the molecular nature of the sample. In our study, results showed that proteins, amino acids and aromatic ethers of insect exocuticle have promising discriminative power to discern between different populations of C. h. hidalgoensis. Furthermore, the correlation between geographic distances between populations and the chemical distances obtained by proteins + amino acids + aromatic ethers was statistically significant, showing that the spectral and spatial information available of the taxa together with appropriated chemometric methods may help to a better understanding of the identity, structure, dynamics and diversity of insect populations.

The role of mesoporosity and Si/Al ratio in the catalytic etherification of glycerol with benzyl alcohol using ZSM-5 zeolites

A comparative study of the influence of three different acid solids as catalysts (conventional zeolites Z15c with Si/Al = 19.5 and Z40c with Si/Al = 48.2, and a hierarchical zeolite Z40c-H with Si/Al = 50.0) for the etherification of glycerol with benzyl alcohol was performed. The catalytic activity and selectivity of these zeolites was elucidated at different catalyst contents. Three different ethers (3-benzyloxy-1,2-propanediol, which is a mono-benzyl-glycerol ether (MBG) and 1,3-dibenzyloxy-2-propanol, which is a di-benzyl-glycerol ether (DBG) and dibenzyl ether (DBz) were identified as the main products. MBG was the major product of the reaction catalyzed by the microporous Z15c zeolite with low Si/Al molar ratio, whereas DBG was formed in higher yield with the use of microporous Z40c and hierarchical Z40c-H zeolites, both of them having a similar high Si/Al molar ratio (≈50). MBG is a value-added product and it is obtained with good yield and selectivity when using the conventional zeolite Z15c as a catalyst. Under the best conditions tested, i.e., 25 mg of catalyst for 8 h at 120 °C, a 62% of conversion was obtained without the need of solvent, with an excellent 84% selectivity toward the MBG and no formation of DBz.

Pseudocapacitance of zeolite-templated carbon in organic electrolytes

Carbon and graphene-based materials often show some amount of pseudocapacitance due to their oxygen-functional groups. However, such pseudocapacitance is generally negligible in organic electrolytes and has not attracted much attention. In this work, we report a large pseudocapacitance of zeolite-templated carbon (ZTC) based on the oxygen-functional groups in 1 M tetraethylammonium tetrafluoroborate dissolved in propylene carbonate (Et4NBF4/PC). Due to its significant amount of active edge sites, a large amount of redox-active oxygen functional groups are introduced into ZTC, and ZTC shows a high specific capacitance (330 F g−1). Experimental results suggest that the pseudocapacitance could be based on the formation of anion and cation radicals of quinones and ethers, respectively. Moreover, ZTC shows pseudocapacitance also in 1 M lithium hexafluorophosphate dissolved with a mixture of ethylene carbonate and diethyl carbonate (LiPF6/EC+DEC) which is used for lithium-ion batteries and lithium-ion capacitors.

Aproveitamento de subproduto de maçã da indústria agroalimentar

Neste trabalho foi estudado um subproduto derivado da indústria agroalimentar produtora de sumo concentrado de maçã, conhecido por bagaço de maçã, com o objetivo de avaliar condições de extração de compostos fenólicos, o teor de compostos fenólicos totais, flavonóides e proantocianidinas e ainda a atividade antioxidante. Foram efetuadas extrações a partir do bagaço de maçã variando as condições de tempo, temperatura, razão massa:volume e solvente e os extratos obtidos avaliados quanto ao seu teor em compostos fenólicos totais pelo método FolinCiocalteu. O extrato aquoso do bagaço de maçã para uma temperatura de 100 ºC a um tempo de 2x4h e concentração de 50 mg/mL, apresentou o teor de compostos fenólicos mais elevado (9,37 mgEAG/g de bagaço de maçã, na base seca) em relação a todas as outras temperaturas, tempos de extração e solventes utilizados, como etanol (50% e 70%) e metanol. O doseamento de flavonóides totais baseou-se no método espetrofotométrico, usando o reagente cloreto de alumínio e a rutina como padrão. Os melhores resultados foram obtidos usando etanol (70%) como solvente à temperatura ambiente, cerca de 4,35 mgER/g. A amostra extraída com água apresentou valores bastante similares ao etanol, cerca de 4,27 mgER/g, usando uma temperatura de 100 ºC durante 2x4h. O conteúdo em proantocianidinas foi determinado pelo método 4-dimetilamino cinamaldeído (DMAC). O bagaço de maçã estudado demonstrou ser pobre no seu conteúdo de proantocianidinas, obtendo valores de 0,77 mgEEC/g. A atividade antioxidante do bagaço de maçã foi avaliada através de dois métodos distintos: 2,2-difenil-1-picril-hidrazilo (DPPH∙) e método do poder redutor (FRAP). O extrato aquoso obtido a 100 ºC a um tempo de 2x4h, demonstrou ser aquele com maior potencial, com uma capacidade antioxidante mais elevada que os restantes extratos, com valores de IC50 de 0,48 mg/mL e 0,65 mg/mL, para os métodos de DPPH∙ e FRAP, respetivamente.

Ether lipids in deep sea and swamp sediments

Methanogen ether lipids have been quantified in sediments from a Florida swamp and the Atlantic ocean. Swamp cores containing acyclic and monocyclic isopranyl ethers are clearly differentiated from deep sea sediments which also contain bicyclic compounds. A concentration maximum near the bottom of the sulfate reducing zone in deep sea sediments may reflect a biogeochemical system in which methanogenesis and sulfate reduction are coupled by the process of methane oxidation. Lipid diagenesis is evident in the deep sea sediments. Species zonation, possibly caused by oxygen sensitivity, is detected in the relative lipid abundances in swamp sediments.

Ambient water quality criteria for haloethers /

Mode of access: Internet.

La cellulose et les éthers cellulosiques; leurs applications industrielles.

"Bibliographie": p. [345]

Toxic substances : hearings before the Subcommittee on Science, Technology, and Space of the Committee on Commerce, Science, and Transportation, United States Senate, Ninety-fifth Congress, first session.

Hearings held Mar. 28-May 4, 1977 in various cities.

Guaiacol transprotection: replacement of the phenoxy isopropyl protecting function by acetyl

A one-step method for the conversion of isopropyl protected guaiacols to the corresponding acetates is reported. Treating 6-substituted isopropyl protected guaiacols with trimethylsilyl trifluoromethanesulfonate in a mixture of acetic anhydride and acetonitrile affords 6-substituted guaiacol acetates in yields ranging from 35% to 99%. (C) 2003 Elsevier Ltd. All rights reserved.

Macrocyclic systems containing 2,6,9-trioxabicyclo[3.3.1]-nona-3,7-dienes as chiral spacer groups: Synthesis, stereochemical features and preliminary complexation properties

Novel 2:2-macrocycles bearing bridged concave 2,6,9-trioxabicyclo[3.3.1]nona-3,7-dienes as chiral spacer units were obtained by cyclocondensation reaction of the chiral bisacid chloride and the corresponding diols, while use of methylene diamines instead of diols afforded 1:1 macrocycles only. Applying the same, but now template-assisted, experimental procedure to the reaction of the bisacid chloride with triethylene glycol brought about a significant increase in yield as well as a suitable simplification of the work-up during preparation and separation of the corresponding 1:1 as well as 2:2 macrocycles, when compared to results reported previously. HPLC separation on chiral columns revealed the presence of diastereoisomers [RR(S,S)- and RS-(meso)-forms] for all 2:2 macrocycles, which was further evidenced by the CD spectrum of one of those species as an example. Preliminary ESI-MS experiments indicated strong complexation abilities of the sulphur-containing ligand towards Ag(I), Cu(II) and Au(III) ions.