Performance of advanced generation from a hybrid Japanese cucumber

A endogamia reduz o vigor em plantas pela diminuição da proporção de loci heterozigotos. Entretanto, a influência da endogamia é diferente entre as espécies. O objetivo deste trabalho foi avaliar a depressão causada por endogamia em uma população de pepino do tipo japonês. A partir do intercruzamento entre plantas do híbrido Natsu suzumi foi obtida a geração F2, considerada como população S0. Obtiveram-se progênies S1, S2, S3, S4 e S5, através de autofecundações sucessivas pelo método do SSD ('Single Seed Descent'). Foram sete tratamentos (híbrido Natsu suzumi, populações S0 a S5) e o delineamento experimental foi em blocos ao acaso, com seis repetições e cinco plantas por parcela cultivadas em ambiente protegido de 21/08/2002 à 29/11/2002. Foram avaliados o número de folhas, semanalmente, o número e a massa de frutos, total e comercial, número de nós e porcentagem de nós com brotações laterais. Na comparação entre as populações S0 a S5 não foram observadas diferenças para todas as características avaliadas demonstrando não haver perda de vigor por endogamia nesta população.

Análise de desempenho experimental de redes IEEE 802.3.

The Ethernet technology dominates the market of computer local networks. However, it was not been established as technology for industrial automation set, where the requirements demand determinism and real-time performance. Many solutions have been proposed to solve the problem of non-determinism, which are based mainly on TDMA (Time Division Multiple Access), Token Passing and Master-Slave. This work of research carries through measured of performance that allows to compare the behavior of the Ethernet nets when submitted with the transmissions of data on protocols UDP and RAW Ethernet, as well as, on three different types of Ethernet technologies. The objective is to identify to the alternative amongst the protocols and analyzed Ethernet technologies that offer to a more satisfactory support the nets of the industrial automation and distributed real-time application

Análise teórico-experimental do coeficiente de perfomance (COP) de um sistema de refrigeração por jato-compressão

The use of waste heat of energy conversion equipment to produce a cooling effect, consists currently in a very interesting way of efficiency improvement of energy systems. The present research has as intention the theoretical and experimental study of a new intermittent refrigeration system ejector cycle characteristics, with use of waste heat. Initially, was doing a bibliographical survey about the vapor ejector refrigeration system technology. In the following stage was doing a simulation of the corresponding thermodynamic cycle, with preliminarily intention to evaluate the performance of the system for different refrigerants fluids. On the basis of the results of the simulation were selected the refrigerant fluid and developed an experimental group of benches of the refrigeration system considered, where pressure and temperature sensory had been inserted in strategical points of the refrigeration archetype and connected to a computerized data acquisition system for measure the refrigerant fluid properties in the thermodynamic cycle. The test results obtained show good agreement with the literature

Evaluation of the performance of a castor-oil based formulation in limiting pesticide residues in strawberry crops

A study was made to evaluate the effect of a castor oil-based detergent on strawberry crops treated with different classes of pesticides, namely deltamethrin, folpet, tebuconazole, abamectin and mancozeb, in a controlled environment. Experimental crops of greenhouse strawberries were cultivated in five different ways with control groups using pesticides and castor oil-based detergent. The results showed that the group 2, which was treated with castor oil-based detergent, presented the lowest amount of pesticide residues and the highest quality of fruit produced.

Performance of aerodynamic baffles in cylindrical grinding analyzed on the basis of air layer pressure and speed

Over the years, grinding has been considered one of the most important manufacturing processes. Grinding is a high precision process, and the loss of a single workpiece in this stage of the production is unacceptable, fir the value added to the material is very high due to many processes it has already undergone prior to grinding. This study aims to contribute toward the development of an experimental methodology whereby the pressure and speed of the air layer produced by the high rotation of the grinding wheel is evaluated with and without baffles, i.e., in an optimized grinding operation and in a traditional one. Tests were also carried out with steel samples to check the difference in grinding wheel wear with and without the use of baffles.

Molecular assay optimized by Taguchi experimental design method for venous thromboembolism investigation

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Effect of dietary phytase suplementation on the performance, bone densitometry, and phosphorus and nitrogen excretion of broilers

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Experimental damage detection grammian matrix

Structural Health Monitoring (SHM) has diverse potential applications, and many groups work in the development of tools and techniques for monitoring structural performance. These systems use arrays of sensors and can be integrated with remote or local computers. There are several different approaches that can be used to obtain information about the existence, location and extension of faults by non destructive tests. In this paper an experimental technique is proposed for damage location based on an observability grammian matrix. The dynamic properties of the structure are identified through experimental data using the eigensystem realization algorithm (ERA). Experimental tests were carried out in a structure through varying the mass of some elements. Output signals were obtained using accelerometers.

On the performance of a dual-mode non-linear vibration energy harvesting device

The research trend for harvesting energy from the ambient vibration sources has moved from using a linear resonant generator to a non-linear generator in order to improve on the performance of a linear generator; for example, the relatively small bandwidth, intolerance to mistune and the suitability of the device for low-frequency applications. This article presents experimental results to illustrate the dynamic behaviour of a dual-mode non-linear energy-harvesting device operating in hardening and bi-stable modes under harmonic excitation. The device is able to change from one mode to another by altering the negative magnetic stiffness by adjusting the separation gap between the magnets and the iron core. Results for the device operating in both modes are presented. They show that there is a larger bandwidth for the device operating in the hardening mode compared to the equivalent linear device. However, the maximum power transfer theory is less applicable for the hardening mode due to occurrence of the maximum power at different frequencies, which depends on the non-linearity and the damping in the system. The results for the bi-stable mode show that the device is insensitive to a range of excitation frequencies depending upon the input level, damping and non-linearity.

Experimental Active Vibration Control in Truss Structures Considering Uncertainties in System Parameters

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Uma análise experimental de abordagens heurísticas aplicadas ao problema do caixeiro viajante

Due to great difficulty of accurate solution of Combinatorial Optimization Problems, some heuristic methods have been developed and during many years, the analysis of performance of these approaches was not carried through in a systematic way. The proposal of this work is to make a statistical analysis of heuristic approaches to the Traveling Salesman Problem (TSP). The focus of the analysis is to evaluate the performance of each approach in relation to the necessary computational time until the attainment of the optimal solution for one determined instance of the TSP. Survival Analysis, assisted by methods for the hypothesis test of the equality between survival functions was used. The evaluated approaches were divided in three classes: Lin-Kernighan Algorithms, Evolutionary Algorithms and Particle Swarm Optimization. Beyond those approaches, it was enclosed in the analysis, a memetic algorithm (for symmetric and asymmetric TSP instances) that utilizes the Lin-Kernighan heuristics as its local search procedure

Uma análise experimental de algoritmos exatos aplicados ao problema da árvore geradora multiobjetivo

The Multiobjective Spanning Tree Problem is NP-hard and models applications in several areas. This research presents an experimental analysis of different strategies used in the literature to develop exact algorithms to solve the problem. Initially, the algorithms are classified according to the approaches used to solve the problem. Features of two or more approaches can be found in some of those algorithms. The approaches investigated here are: the two-stage method, branch-and-bound, k-best and the preference-based approach. The main contribution of this research lies in the fact that no research was presented to date reporting a systematic experimental analysis of exact algorithms for the Multiobjective Spanning Tree Problem. Therefore, this work can be a basis for other research that deal with the same problem. The computational experiments compare the performance of algorithms regarding processing time, efficiency based on the number of objectives and number of solutions found in a controlled time interval. The analysis of the algorithms was performed for known instances of the problem, as well as instances obtained from a generator commonly used in the literature

Liberação intraocular de ofloxacina associada a lente de contato biossintética em ceratite bacteriana experimental em cães

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of nucleotides on broiler performance and carcass yield

This study aimed at evaluating the effect of nucleotides on the performance and carcass yield of broilers fed diets with no antibiotic growth promoters (AGP), anticoccidials, or animal feedstuffs. In the trial, 600 Ross 308 male broilers were distributed in a completely randomized experimental design into six treatments with four replicates of 25 birds each. Treatments consisted of a control diet (CD), CD + AGP, CD + 0.04%, CD + 0.05%, CD + 0.06%, and CD + 0.07% nucleotides. The experimental diets did not contain anticoccidials, and birds were vaccinated against coccidiosis at three days of age. No significant differences were detected among broilers submitted to the different treatments in none of the studied parameters. Under the conditions of this experiment, diets supplemented with nucleotides did not influence broiler performance or carcass yield at 42 days of age, and were not different from the feeds not containing any additive or with AGP.

Performance, carcass characteristics and gain cost of feedlot cattle fed a high level of concentrate and different feed additives

The objective of this study was to evaluate the effects of feeding cattle with isoprotein and isoenergetic diets, with and without the addition of polyclonal antibody preparation (PAP), yeasts (YST) or monensin sodium (MON) on performance, carcass characteristics and gain cost in feedlot. Ninety-five 20-month old bullocks (323.3±21.8 kg) were distributed in 25 pens. The completely randomized experimental design had a 2 × 2 + 1 factorial arrangement and the treatments were replicated 5 times. There was no effect of MON for DMI throughout the feedlot period; however, MON reduced the dry matter intake (DMI) in g/kg of BW in the first 28 days when compared with the other treatments. The gain cost decreased with MON addition in relation to the other treatments. Inclusion of YST decreased average daily gain (ADG), final body weight, hot carcass weight, carcass weight, gain to feed ratio and DMI in g/kg body weight, worsening feed conversion and increasing the gain cost in the feeding periods. Inclusion of PAP increased ADG and decreased the gain cost, besides improving feed conversion. For MON and PAP, a difference was found for kidney-pelvic fat and kidney-pelvic fat per 100 kg of hot carcass weight. For MON and YST, there was a difference in ADG, feed conversion, gain cost and carcass yield and kidney-pelvic fat per 100 kg of hot carcass. Treatment YST worsened performance in relation to the non-supplemented treatments. Feeding PAP to animals did not influence performance and carcass characteristics of bullocks in feedlot negatively. Thus, PAP shows potential to substitute MON in cattle feeding using isoprotein and isoenergetic diets.