Social Network Analysis and Qualitative Comparative Analysis: Their mutual benefit for the explanation of policy network structures

By switching the level of analysis and aggregating data from the micro-level of individual cases to the macro-level, quantitative data can be analysed within a more case-based approach. This paper presents such an approach in two steps: In a first step, it discusses the combination of Social Network Analysis (SNA) and Qualitative Comparative Analysis (QCA) in a sequential mixed-methods research design. In such a design, quantitative social network data on individual cases and their relations at the micro-level are used to describe the structure of the network that these cases constitute at the macro-level. Different network structures can then be compared by QCA. This strategy allows adding an element of potential causal explanation to SNA, while SNA-indicators allow for a systematic description of the cases to be compared by QCA. Because mixing methods can be a promising, but also a risky endeavour, the methodological part also discusses the possibility that underlying assumptions of both methods could clash. In a second step, the research design presented beforehand is applied to an empirical study of policy network structures in Swiss politics. Through a comparison of 11 policy networks, causal paths that lead to a conflictual or consensual policy network structure are identified and discussed. The analysis reveals that different theoretical factors matter and that multiple conjunctural causation is at work. Based on both the methodological discussion and the empirical application, it appears that a combination of SNA and QCA can represent a helpful methodological design for social science research and a possibility of using quantitative data with a more case-based approach.

(Table 8.4, Page 220-223) Chemical composition of different growth structures of manganese nodules, SONNE cruise SO78

In the nodule field of the Peru Basin, situated south of the zone of high bioproductivity, a relatively high flux of biogenic matter explains a distinct redox boundary at about 10 cm depth separating very soft oxic surface sediments from stiffer suboxic sediments. Maximum abundance (50 kg/m**2) of diagenetic nodules is found near the calcite compensation depth (CCD), currently at 4250 m. There, the accretion rate of nodules is much higher (100 mm/Ma) than on ridges (5 mm/Ma). Highest accretion rates are found at the bottom of large nodules that repeatedly sink to a level immediately above the redox boundary. There, distinct diagenetic growth conditions prevail and layers of dense laminated Mn oxide of very pure todorokite are formed. The layering of nodules is mainly the result of organisms moving nodules within the oxic surface sediment from diagenetic to hydrogenetic environments. The frequency of such movements is much higher than that of climatic changes. Two types of nodule burial occur in the Peru Basin. Large nodules are less easily moved by organisms and become buried. Consequently, buried nodules generally are larger than surface nodules. This type of burial predominates in basins. At ridges where smaller nodules prevail, burial is mainly controlled by statistical selection where some nodules are not moved up by organisms.

Detrital zircon geochronology data, petrographic point count data and paleocurrent indicator data of Triassic turbidites in the Nanpanjiang Basin, South China

Triassic turbidites of the Nanpanjiang basin of south China represent the most expansive and voluminous siliciclastic turbidite accumulation in south China. The Nanpanjiang basin occurs at a critical junction between the southern margin of the south China plate and the Indochina, Siamo and Sibumasu plates to the south and southwest. The Triassic Yangtze carbonate shelf and isolated carbonated platforms in the basin have been extensively studied, but silicilastic turbidites in the basin have received relatively little attention. Deciphering the facies, paleocurrent indicators and provenance of the Triassic turbidites is important for several reasons: it promises to help resolve the timing of plate collisions along suture zones bordering the basin to the south and southwest, it will enable evaluation of which suture zones and Precambrian massifs were source areas, and it will allow an evaluation of the impact of the siliciclastic flux on carbonate platform evolution within the basin. Turbidites in the basin include the Early Triassic Shipao Formation and the Middle-Late Triassic Baifeng, Xinyuan, Lanmu Bianyang and Laishike formations. Each ranges upward of 700 m and the thickest is nearly 3 km. The turbidites contain very-fine sand in the northern part of the basin whereas the central and southern parts of the basin also commonly contain fine and rarely medium sand size. Coarser sand sizes occur where paleocurrents are from the south, and in this area some turbidites exhibit complete bouma sequences with graded A divisions. Successions contain numerous alternations between mud-rich and sand-rich intervals with thickness trends corresponding to proximal/ distal fan components. Spectacularly preserved sedimentary structures enable robust evaluation of turbidite systems and paleocurrent analyses. Analysis of paleocurrent measurements indicates two major directions of sediment fill. The northern part of the basin was sourced primarily by the Jiangnan massif in the northeast, and the central and southern parts of the basin were sourced primarily from suture zones and the Yunkai massif to the south and southeast respectively. Sandstones of the Lower Triassic Shipao Fm. have volcaniclastic composition including embayed quartz and glass shards. Middle Triassic sandstones are moderately mature, matrix-rich, lithic wackes. The average QFL ratio from all point count samples is 54.1/18.1/27.8% and the QmFLt ratio is 37.8/ 18.1/ 44.1%. Lithic fragments are dominantly claystone and siltstone clasts and metasedimentary clasts such as quartz mica tectonite. Volcanic lithics are rare. Most samples fall in the recycled orogen field of QmFLt plots, indicating a relatively quartz and lithic rich composition consistent with derivation from Precambrian massifs such as the Jiangnan, and Yunkai. A few samples from the southwest part of the basin fall into the dissected arc field, indicating a somewhat more lithic and feldspar-rich composition consistent with derivation from a suture zone Analysis of detrial zircon populations from 17 samples collected across the basin indicate: (1) Several samples contain zircons with concordant ages greater than 3000 Ma, (2) there are widespread peaks across the basin at 1800 Ma and 2500, (3) a widespread 900 Ma population, (3) a widespread population of zircons at 440 Ma, and (5) a larger population of younger zircons about 250 Ma in the southwestern part which is replaced to the north and northwest by a somewhat older population around 260-290 Ma. The 900 Ma provenance fits derivation from the Jiangnan Massif, the 2500, 1800, and 440 Ma provenance fits the Yunkai massif, and the 250 Ma is consistent with convergence and arc development in suture zones bordering the basin on the south or southwest. Early siliciclastic turbidite flux, proximal to source areas impacted carbonate platform evolution by infilling the basin, reducing accommodation space, stabilizing carbonate platform margins and promoting margin progradation. Late arrival, in areas far from source areas caused margin aggradation over a starved basin, development of high relief aggradational escarpments and unstable scalloped margins.

Significant factors in truck ride quality. Volume III: data compendium. Final report.

Federal Highway Administration, Structures and Applied Mechanics Division, Washington, D.C.

Instrumentation for measuring pavement-vehicle interaction. Volume II: Digalog Systems operation and maintenance manual, data acquisition system, model DLI 203. Final report.

Federal Highway Administration, Structures and Applied Mechanics Division, Washington, D.C.

RSV test monitoring and data publication - Renault R20TS-to-Calspan RSV 75 degree right side impact at Renault. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

RSV test monitoring and data publication - Renault R20TS-to-Calspan RSV 75 degree left side impact at Peugeot. Final report.

National Highway Traffic Safety Administration, Washington, D.C.

Reanalysis of wave runup on structures and beaches /

Example problems and methods of data analysis, together with general observations, are given. Smooth-slope runup results for both breaking and nonbreaking waves are presented in a set of curves similar to but revised from those in the Shore Protection Manual (SPM) (U.S. Army, Corps of Engineerings, Coastal Engineering Research Center, 1977). The curves are for structure slopes fronted by horizontal and 1 on 10 bottom slopes. The range of values of d sub s/H' sub o was extended to d sub s/H' sub o = 8; relative depth (d sub s/H' sub o) is important even for d sub s/H' sub o> 3 for waves which do not break on the structure slope. Rough-slope results are presented in similar curves if sufficient data were available. Otherwise, results are given as values of r, which is the ratio of rough-slope runup to smooth-slope runup. Scale-effect in runup is discussed.

Impact of air attack in World War II: selected data for civil defense planning.

Division 1 "prepared under Subcontract 669-1 with Stanford Research Institute [by] Lehigh University, the Institute of Research."

Variations in seafloor depth estimates under different swath-width characteristics of submarine structures in the California Borderlands

Senior thesis written for Oceanography 445

Comparison of Lagrangian Coherent Structures and Relative Dispersion in a Mixing Layer

Thesis (Master's)--University of Washington, 2016-06

Towards identifying the new structures formed on the γ-radiolysis of Ultem

Ultem irradiated up to 10.0 MGy has been analysed using C-13, H-1 and D-2 proton-carbon and proton-proton correlation NMR spectroscopy to shed light on the formation of new structures. Chemical shifts and correlation data were used to determine the structure or partial structures of several new components. The spectra indicated the presence of new groups and structures involving the isopropylidene group, the imide ring, and hydrogen-abstraction reactions. Possible pathways for formation of the new structures are proposed and the G-values for their formation have been estimated. (C) 2003 Elsevier Science Ltd. All rights reserved.

Comparison of beam theory and finite-element analysis with in vivo bone strain data from the alligator cranium

The mechanical behavior of the vertebrate skull is often modeled using free-body analysis of simple geometric structures and, more recently, finite-element (FE) analysis. In this study, we compare experimentally collected in vivo bone strain orientations and magnitudes from the cranium of the American alligator with those extrapolated from a beam model and extracted from an FE model. The strain magnitudes predicted from beam and FE skull models bear little similarity to relative and absolute strain magnitudes recorded during in vivo biting experiments. However, quantitative differences between principal strain orientations extracted from the FE skull model and recorded during the in vivo experiments were smaller, and both generally matched expectations from the beam model. The differences in strain magnitude between the data sets may be attributable to the level of resolution of the models, the material properties used in the FE model, and the loading conditions (i.e., external forces and constraints). This study indicates that FE models and modeling of skulls as simple engineering structures may give a preliminary idea of how these structures are loaded, but whenever possible, modeling results should be verified with either in vitro or preferably in vivo testing, especially if precise knowledge of strain magnitudes is desired. (c) 2005 Wiley-Liss, Inc.

Prediction of protein continuum secondary structure with probabilistic models based on NMR solved structures

Background: The structure of proteins may change as a result of the inherent flexibility of some protein regions. We develop and explore probabilistic machine learning methods for predicting a continuum secondary structure, i.e. assigning probabilities to the conformational states of a residue. We train our methods using data derived from high-quality NMR models. Results: Several probabilistic models not only successfully estimate the continuum secondary structure, but also provide a categorical output on par with models directly trained on categorical data. Importantly, models trained on the continuum secondary structure are also better than their categorical counterparts at identifying the conformational state for structurally ambivalent residues. Conclusion: Cascaded probabilistic neural networks trained on the continuum secondary structure exhibit better accuracy in structurally ambivalent regions of proteins, while sustaining an overall classification accuracy on par with standard, categorical prediction methods.

Estimating cause-specfic mortality from community- and facility-based data sources in the United Republic of Tanzania: options and implications for mortality burden estimates

Objective To compare mortality burden estimates based on direct measurement of levels and causes in communities with indirect estimates based on combining health facility cause-specific mortality structures with community measurement of mortality levels. Methods. Data from sentinel vital registration (SVR) with verbal autopsy (VA) were used to determine the cause-specific mortality burden at the community level in two areas of the United Republic of Tanzania. Proportional cause-specific mortality structures from health facilities were applied to counts of deaths obtained by SVR to produce modelled estimates. The burden was expressed in years of life lost. Findings. A total of 2884 deaths were recorded from health facilities and 2167 recorded from SVR/VAs. In the perinatal and neonatal age group cause-specific mortality rates were dominated by perinatal conditions and stillbirths in both the community and the facility data. The modelled estimates for chronic causes were very similar to those from SVR/VA. Acute febrile illnesses were coded more specifically in the facility data than in the VA. Injuries were more prevalent in the SVR/VA data than in that from the facilities. Conclusion. In this setting, improved International classification of diseases and health related problems, tenth revision (ICD-10) coding practices and applying facility-based cause structures to counts of deaths from communities, derived from SVR, appears to produce reasonable estimates of the cause-specific mortality burden in those aged 5 years and older determined directly from VA. For the perinatal and neonatal age group, VA appears to be required. Use of this approach in a nationally representative sample of facilities may produce reliable national estimates of the cause-specific mortality burden for leading causes of death in adults.