Effect of Airborne-Particle Abrasion and Mechanico-Thermal Cycling on the Flexural Strength of Glass Ceramic Fused to Gold or Cobalt-Chromium Alloy

Purpose: To evaluate the effect of airborne-particle abrasion and mechanico-thermal cycling on the flexural strength of a ceramic fused to cobalt-chromium alloy or gold alloy.Materials and Methods: Metallic bars (n = 120) were made (25 mm x 3 mm x 0.5 mm): 60 with gold alloy and 60 with Co-Cr. At the central area of the bars (8 mm x 3 mm), a layer of opaque ceramic and then two layers of glass ceramic (Vita VM13, Vita Zahnfabrick) were fired onto it (thickness: 1 mm). Ten specimens from each alloy group were randomly allocated to a surface treatment [(tungsten bur or air-particle abrasion (APA) with Al(2)O(3) at 10 mm or 20 mm away)] and mechanico-thermal cycling (no cycling or mechanically loaded 20,000 cycles; 10 N distilled water at 37 degrees C and then thermocycled 3000 cycles; 5 degrees C to 55 degrees C, dwell time 30 seconds) combination. Those specimens that did not undergo mechanico-thermal cyclingwere stored inwater (37 degrees C) for 24 hours. Bond strength was measured using a three-point bend test, according to ISO 9693. After the flexural strength test, failure types were noted. The data were analyzed using three factor-ANOVA and Tukey's test (alpha = 0.05).Results: There were no significant differences between the flexural bond strength of gold and Co-Cr groups (42.64 +/- 8.25 and 43.39 +/- 10.89 MPa, respectively). APA 10 and 20 mm away surface treatment (45.86 +/- 9.31 and 46.38 +/- 8.89 MPa, respectively) had similar mean flexural strength values, and both had significantly higher bond strength than tungsten bur treatment (36.81 +/- 7.60 MPa). Mechanico-thermal cycling decreased the mean flexural strength values significantly for all six alloy-surface treatment combinations tested when compared to the control groups. The failure type was adhesive in the metal/ceramic interface for specimens surface treated only with the tungsten bur, and mixed for specimens surface treated with APA 10 and 20 mm.Conclusions: Considering the levels adopted in this study, the alloy did not affect the bond strength; APA with Al(2)O(3) at 10 and 20 mm improved the flexural bond strength between ceramics and alloys used, and the mechanico-thermal cycling of metal-ceramic specimens resulted in a decrease of bond strength.

Preference ratios for mercury and other chemical elements in the Madeira River, Brazil

Samples of water, suspended solids, and bottom sediments from the Madeira River, Rondonia state, Brazil, were physically and chemically analyzed to investigate the actual Hg mobilization in the aquatic environment and compare it with that of other heavy metals and elements in the area. Two dimensionless Hg preference ratios were defined, expressing (1) the ratio of Hg and other elements in the liquid phase divided by the ratio of Hg and other elements in bottom sediments (P(l.phase)) and (2) the ratio of Hg and other elements in the particulate matter divided by the ratio of Hg and other elements in bottom sediments (P(s.solids)). These preference ratios are useful for comparing Hg transport in three different phases (liquid, particulate matter, and bottom sediments). They also were applicable to any analyzed elementin the area studied, because they generated an almost constant value when the maximum calculated was divided by the minimum (P(l.phase) = 2931; P(s.solids) = 84) and because of their sensitivity to the dominance of sorption processes by Fe oxides and hydroxides. Mercury could be transported preferentially to other analyzed elements in the particulate phase only if its concentration reached values at least 10(4)-fold higher than those expected or quantified in the area. (C) 2002 Elsevier B.V. Ltd. All rights reserved.

Thermal behavior of residues (sludge) originated from Araraquara water and sewage treatment station

The number of the cities with canalized water and sewage treatment stations has increased lately and consequently having in mind the great concern on environment preservation and the quality of the water used by society. However, these stations are nowadays causing another kind of problem: a huge quantity of sludge as residue. Due to the implication of the residue on the environment and, consequently, to human life quality, performing of an accurate investigation about the components of such sludge, as well as the thermal stability of this residue in the environment become necessary. This paper presents a study on sludge from water and sewage treatment station, as well as the thermal characterization of residue. Such study was performed through FTIR, atomic absorption, thermoanalytical (TG/DTG, DTA) techniques, that made it possible to observe that the main components of the sludge are clay, carbonates and organic substance, presenting a low rate of metals and a unique thermal behavior since the sludge from the treatment station has a higher thermal stability.

Extraction and exchange behavior of metal species in therapeutically applied peat

The binding and availability of metals (Al, Ca, Cd, Co, Cr, Cu, Fe, Mg, Mn, Ni, Pb, Zn) in therapeutically applied peat (GroBes Gifhorner Moor, Sassenburg/North Germany) was characterized by means of a versatile extraction approach. Aqueous extracts of peat were obtained by a standardized batch equilibrium procedure using high-purity water (pH 4.5 and 5.0), 0.01 mol l(-1) calcium chloride solution, 0.0 1 mol l(-1) ethylenediaminetetraacetic acid (EDTA) and 0.01 mol l(-1) diethylenetriarnine pentaacetic acid (DTPA) solution as metal extractants. In addition, the availability of peat-bound metal species was kinetically studied by collecting aliquots of extracts after different periods of extraction time (5, 10, 15, 30, 60 and 120 min). Metal determinations were performed by atomic spectrometry methods (AAS, ICP-OES) and dissolved organic matter (DOM) was characterized by UV/Vis measurements at 254 and 436 nm, respectively. of the extractants studied Ca, Mg and Mn were the most available metals, in contrast to peat-bound Fe and Al. The relative standard deviation s(r) of the developed extraction procedures was mostly in the range of 4 to 20%, depending on the metal and its concentration in peat. A pH increase favored the extraction of metals and DOM from peat revealing complex extraction kinetics. Moreover, a competitive exchange between peat-bound metal species and added Cu(II) ions showed that > 100 mg of Cu(II) per 50 g wet peat was necessary to exchange the maximum of bound metals (e.g. 21.8% of Al, 3.9% of Fe, 79.0% of Mn, 81.9% of Sr, related to their total content). (C) 2002 Elsevier B.V. B.V. All rights reserved.

TOXIC EFFECTS OF WATER EUTROPHICATION ON PANCREATIC, HEPATIC AND OSTEOGENIC TISSUES OF RATS

Pollution, industrial solvents, concentrations of metals and other environmental agents are widely related to biochemicals values which are used in disease diagnosis of environmental toxicity. A rat bioassay validated for the identification of toxic effects of eutrophication revealed increased serum activities of amylase, alanine transaminase (BLT) and alkaline phosphatase (ALP) in rats that received algae, filtered water and nickel or cadmium from drinking water. Serum Cu-Zn superoxide dismutase activity decreased from its basal level of 40.8 +/- 2.3 to 26.4 U/mg protein, at 7 days of algae and at 48 hr of nickel and cadmium water ingestion. The observation that lipoperoxide concentration was not altered in rats treated with filtered water, while amylase, ALT and ALP were increased in these rats and in those treated with nickel or cadmium, indicated that pancreatic, hepatic and osteogenic lesions by eutrophication were not related to superoxide radicals, and might be due to a novel toxic environmental agent found in filtered and non-filtered algae water.

An evaluation into the potential of biological processing for the removal of metals from sewage sludges

The use of sewage sludge in agricultural land as a means of sludge disposal and recycling has been shown to be economical and suitable because of the presence of nutrients such as nitrogen and phosphorus. However, municipal sludges often contain high quantities of toxic metals and other compounds that must be removed for its safe use in agricultural soils. The biological leaching of metals from sewage sludges has been shown to be a promising technique for metal detoxifying in such complex matrix. The process efficiency is dependent on several physico-chemical parameters, such as total solids concentration, metal forms, pH-ORP, and temperature. Scale-up of the process has not yet been defined and is still pursuing the correct operational design. Current research involving the bioleaching of metals from sewage sludge and its application to land, which affects soil physical properties, are presented and discussed.

Superoxide radical and nephrotoxic effect of cadmium exposure

Pollution and industrial practices result in concentrations of metals and other environmental agents that are related to environmental toxicity. Concentrations of metals are widely related to biochemicals values which are used in disease diagnosis due to environmental toxicity. This work was carried out in order to verify the nephrotoxic effect of cadmium and to clarify the contribution of reactive oxygen species (ROS) in this process. Cadmium chloride was tested for nephrotoxic damage in rats by a single intraperitoneal (i.p.) injection Cd 2+ (2 mg/kg) and oral intake (Cd2 +-100 mg/l-from CdCl 2). The cadmium-induced biochemical alterations included significant increased levels of serum creatinine concentrations, in rats with i.p. injection. Total urinary protein concentrations were only increased in rats with cadmium intake. Lipoperoxide was also increased after 3 and 7 days of the Cd 2+ treatment. No changes were observed in glutathione peroxidase activities. Cadmium-induced damage might be due to superoxide radicals (O 2 -), since Cu-Zn superoxide dismutase activities were decreased by Cd 2+ treatment. This study allows tentative conclusions to be drawn regarding which reactive oxygen metabolites play a role in cadmium nephrotoxicity. We concluded that the superoxide radical may be produced as a mediator of nephrotoxic action of cadmium.

Preliminary Overview of the Economies of Latin America and the Caribbean 2004

Includes bibliography

Economic Survey of Latin America and the Caribbean 2009-2010: The distributive impact of public policies

Includes bibliography

Latin America and the Caribbean in the World Economy 2010-2011: The region in the decade of the emerging economies

Incluye Bibliografía

DBI equations and holographic dc conductivity

We provide a simple method for writing the Dirac-Born-Infeld equations of a Dp-brane in an arbitrary static background whose metric depends only on the holographic radial coordinate z. Using this method we revisit the Karch-O'Bannon procedure to calculate the dc conductivity in the presence of constant electric and magnetic fields for backgrounds where the boundary is four- or three-dimensional and satisfies homogeneity and isotropy. We find a frame-independent expression for the dc conductivity tensor. For particular backgrounds we recover previous results on holographic metals and strange metals. © 2013 American Physical Society.

Soldagem TIG-AC onda retangular: efeitos da velocidade de soldagem sobre as propriedades mecânicas da Liga AA 6063-T6

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Determinação das condições de ataque químico seletivo para alteração de composição superficial de ligas de ouro

Pós-graduação em Engenharia Mecânica - FEG

Capital Flows to Latin America and the Caribbean: Recent Developments

For six years, the global economy has been driven by the U.S. Federal Reserve’s policies of easy money. Liquidity has flowed from developed to developing economies, financing infrastructure and corporate investment and allowing consumers to indulge in credit-fuelled retail spending. Thus the effective ending of the Fed’s third round of asset purchases (QE3) at the end of October represents both a watershed and the beginning of a new stage in the world economy. The end of asset-purchases comes at a challenging time for emerging markets, with China’s economy slowing, the Euro zone struggling to avoid a recession and the Japanese economy already in recession. The unwinding of the U.S. monetary stimulus, while the European Central Bank and the Bank of Japan step up their monetary stimulus, has underpinned an appreciation by the U.S. dollar, in which most commodities are priced. An appreciated dollar makes dollar-denominated commodities more expensive to buyers, thereby creating pressure for sellers to lower their prices. Latin American markets ended the third quarter of 2014 under pressure from a stronger U.S. dollar. In this changing external context, there are many signs that a slowdown in Latin American and Caribbean (LAC) financial markets, particularly debt markets, which have been breaking issuance records for the past six years, may slowdown from now on. Commodity prices – including those of oil, base metals and some goods – are in a prolonged slump. The Bloomberg commodity price index, a benchmark of commodity investments, has fallen to a five-year low as China’s economy slows down, and with it the demand for commodities. Investment into the LAC region has decelerated, in large part because of a deceleration of mining investments. Latin American currencies have suffered depreciations, as current account deficits have widening for a number of countries. And LAC companies, having issued record amounts of foreign currency bonds may now struggle to service their debt. In October, credit-rating agency Moody’s downgraded the bonds of Brazil’s Petrobras to tow notches above speculative grade because of the impact of falling oil prices and the weaker real on its debt. Growth prospects look brighter in 2015 relative to 2014, but a strengthening U.S. dollar, uneven global growth and weakness in commodity prices are skewing the risk toward the downside for the 2015 forecasts across the region. The Institute of International Finance expects the strengthening of the dollar to have a divergent impact across the region, however, depending on trade and financial linkages. The Institute of International Finance, Capital Flows to Emerging Markets, October 2, 2014. A stronger dollar lifts U.S. purchasing power, supporting exports, growth and capital inflows in countries with close trade links to the U.S. economy. However, rising dollar financing costs will increase pressure on countries with weak external positions. Given the effects of falling oil prices and a stronger dollar, some companies in the region, having issued record amounts of foreign currency bonds, may now struggle to service their debts. Prospects of Fed rate hikes resulting in tighter global liquidity amid the rapid rise in the corporate external bond stock has indeed raised concerns over some companies. However, there is still a shortage of bonds at a global level and the region still enjoys good economic policy management for the most part, so LAC debt markets may continue to enjoy momentum despite occasional bursts of high volatility – even if not at the record levels of recent years.

Caracterização da superfície da liga Ti-30Ta após crescimento de nanotubos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)