Purification, characterization, and specificity determination of a new serine protease secreted by penicillium waksmanii

The purpose of this work was to purify a protease from Penicillium waksmanii and to determine its biochemical characteristics and specificity. The extracellular protease isolated that was produced by P. waksmanii is a serine protease that is essential for the reproduction and growth of the fungus. The protease isolated showed 32 kDa, and has optimal activity at pH 8.0 and 35 C towards the substrate Abz-KLRSSKQ-EDDnp. The protease is active in the presence of CaCl2, KCl, and BaCl, and partially inhibited by CuCl2, CoCl2 and totally inhibited by AlCl3 and LiCl. In the presence of 1 M urea, the protease remains 50 % active. The activity of the protease increases 60 % when it is exposed to 0.4 % nonionic surfactant-Triton X-100 and loses 10 % activity in the presence of 0.4 % Tween-80. Using fluorescence resonance energy transfer analysis, the protease showed the most specificity for the peptide Abz-KIRSSKQ-EDDnp with k cat/K m of 10,666 mM-1 s-1, followed by the peptide Abz-GLRSSKQ-EDDnp with a k cat/K m of 7,500 mM -1 s-1. Basic and acidic side chain-containing amino acids performed best at subsite S1. Subsites S2, S3, S′ 2, and S′ 1, S ′ 3 showed a preference for binding for amino acids with hydrophobic and basic amino acid side chain, respectively. High values of k cat/K m were observed for the subsites S2, S3, and S′ 2. The sequence of the N-terminus (ANVVQSNVPSWGLARLSSKKTGTTDYTYD) showed high similarity to the fungi Penicillium citrinum and Penicillium chrysogenum, with 89 % of identity at the amino acid level. © 2012 Springer Science+Business Media New York.

Effect of phosphoric acid on the degradation of human dentin matrix

This study determined if dentin proteases are denatured by phosphoric acid (PA) used in etch-and-rinse dentin adhesives. Dentin beams were completely demineralized with EDTA for 30 days. We acid-etched experimental groups by exposing the demineralized dentin beams to 1, 10, or 37 mass% PA for 15 sec or 15 min. Control beams were not exposed to PA but were incubated in simulated body fluid for 3 days to assay their total endogenous telopeptidase activity, by their ability to solubilize C-terminal crosslinked telopeptides ICTP and CTX from insoluble dentin collagen. Control beams released 6.1 ± 0.8 ng ICTP and 0.6 ± 0.1 ng CTX/mg dry-wt/3 days. Positive control beams pre-incubated in p-aminophenylmercuric acetate, a compound known to activate proMMPs, released about the same amount of ICTP peptides, but released significantly less CTX. Beams immersed in 1, 10, or 37 mass% PA for 15 sec or 15 min released amounts of ICTP and CTX similar to that released by the controls (p > 0.05). Beams incubated in galardin, an MMP inhibitor, or E-64, a cathepsin inhibitor, blocked most of the release of ICTP and CTX, respectively. It is concluded that PA does not denature endogenous MMP and cathepsin activities of dentin matrices. © 2013 International & American Associations for Dental Research.

Effect of temperature on the lipolytic and proteolytic activity of Bacillus cereus isolated from dairy products

Bacillus cereus is a bacterium with deteriorating potential for dairy products, by being a psychrotrophic organism producer of lipases and proteases. This study evaluated the psychrotrophic behavior, lipolytic and proteolytic activity at 30°C, 10°C and 7°C of 86 strains of B. cereus lato sensu isolated from dairy products, marketed in Southern Brazil. It was also evaluated the optimal temperature for protease production. No strain grew at 7°C; but at 10°C, 84.9% of strains have grown. Only one strain had lipolytic activity at 30°C, and none at 7°C. At 10°C, 16.3% of strains produced lipases. All the strains presented proteolytic activity at 30°C; and at 10°C, 72.1% had this activity, and at 7°C, only 4.6%, an amount significantly lower (p < 0.05). The temperature of 20°C promoted the highest proteolytic activity, and at 10°C, the lowest activity. B. cereus can produce lipases and proteases at room and marginal chilling temperatures, causing technological defects in dairy products stored under these conditions. © 2008 IFRJ.

The importance of size-exclusion characteristics of type I collagen in bonding to dentin matrices

The mineral phase of dentin is located primarily within collagen fibrils. During development, bone or dentin collagen fibrils are formed first and then water within the fibril is replaced with apatite crystallites. Mineralized collagen contains very little water. During dentin bonding, acid-etching of mineralized dentin solubilizes the mineral crystallites and replaces them with water. During the infiltration phase of dentin bonding, adhesive comonomers are supposed to replace all of the collagen water with adhesive monomers that are then polymerized into copolymers. The authors of a recently published review suggested that dental monomers were too large to enter and displace water from collagen fibrils. If that were true, the endogenous proteases bound to dentin collagen could be responsible for unimpeded collagen degradation that is responsible for the poor durability of resin-dentin bonds. The current work studied the size-exclusion characteristics of dentin collagen, using a gel-filtration-like column chromatography technique, using dentin powder instead of Sephadex. The elution volumes of test molecules, including adhesive monomers, revealed that adhesive monomers smaller than ∼1000 Da can freely diffuse into collagen water, while molecules of 10,000 Da begin to be excluded, and bovine serum albumin (66,000 Da) was fully excluded. These results validate the concept that dental monomers can permeate between collagen molecules during infiltration by etch-and-rinse adhesives in water-saturated matrices. © 2013 Acta Materialia Inc.

Caracterização bioquímica de uma serino-protease produzida pelo fungo termofílico Myceliophthora sp

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Síntese de nanopartículas de sílica mesoporosa e aplicações como biomaterial

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Biomassa microbiana e atividade enzimática em solos do Estado de São Paulo sob vegetação nativa e cultivados

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Atividade enzimática em lodo de esgoto contaminado com cádmio e uso em solo cultivado com sorgo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Produção, purificação, caracterização bioquímica e determinação do padrão de ação de protease do fungo termofílico Thermoascus aurantiacus

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Produção e caracterização da protease coagulante obtida por fermentação submersa a partir do fungo termofílico Thermomucor indicae-seudaticae N31

Pós-graduação em Engenharia e Ciência de Alimentos - IBILCE

Análise bioquímica dos produtos de excreção/secreção de larvas de Dermatobia hominis

Pós-graduação em Medicina Veterinária - FMVZ

Identificação e caracterização dos produtos de excreção/secreção de trofozóitos de Giardia duodenalis

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise da expressão e silenciamento de genes do trato digestivo de Anopheles aquasalis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Envolvimento do inflamassoma e citocinas na resposta imunológica em infecção induzida pelo fungo Sporothrix schenckii

Pós-graduação em Biociências e Biotecnologia Aplicadas à Farmácia - FCFAR

Detecção das metaloproteinases-2 e -9 no plexo coróide e no liquor de cães naturalmente infectados por Leishmania chagasi

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)