Clinical study on survival rate of short implants placed in the posterior mandibular region: resonance frequency analysis.

OBJECTIVE Short implants are increasingly used, but there is doubt about their performance being similar to that of regular implants. The aim of this study was to compare the mechanical stability of short implants vs. regular implants placed in the edentulous posterior mandible. MATERIAL AND METHODS Twenty-three patients received a total of 48 short implants (5 × 5.5 mm and 5 × 7 mm) and 42 regular implants (4 × 10 mm and 4 × 11.5 mm) in the posterior mandible. Patients who received short implants had <10 mm of bone height measured from the bone crest to the outer wall of the mandibular canal. Resonance frequency analysis (RFA) was performed at time intervals T0 (immediately after implant placement), T1 (after 15 days), T2 (after 30 days), T3 (after 60 days), and T4 (after 90 days). RESULTS The survival rate after 90 days was 87.5% for the short implants and 100% for regular implants (P < 0.05). There was no significant difference between the implants in time intervals T1, T2, T3, and T4. In T0, the RFA values of 5 × 5.5 implants were higher than values of 5 × 7 and 4 × 11.5 implants (P < 0.05). A total of six short implants that were placed in four patients were lost (three of 5 × 5.5 mm and three of 5 × 7 mm). Three lost implants started with high ISQ values, which progressively decreased. The other three lost implants started with a slightly lower ISQ value, which rose and then began to fall. CONCLUSIONS Survival rate of short implants after 90 days was lower than that of regular implants. However, short implants may be considered a reasonable alternative for rehabilitation of severely resorbed mandibles with reduced height, to avoid performing bone reconstruction before implant placement. Patients need to be aware of the reduced survival rate compared with regular implants before implant placement to avoid disappointments.

The influence of different fever definitions on the rate of fever in neutropenia diagnosed in children with cancer

BACKGROUND The temperature limit defining fever (TLDF) is based on scarce evidence. This study aimed to determine the rate of fever in neutropenia (FN) episodes additionally diagnosed by lower versus standard TLDF. METHODS In a single center using a high TLDF (39.0°C tympanic temperature, LimitStandard), pediatric patients treated with chemotherapy for cancer were observed prospectively. Results of all temperature measurements and CBCs were recorded. The application of lower TLDFs (LimitLow; range, 37.5°C to 38.9°C) versus LimitStandard was simulated in silicon, resulting in three types of FN: simultaneous FN, diagnosed at both limits within 1 hour; earlier FN, diagnosed >1hour earlier at LimitLow; and additional FN, not diagnosed at LimitStandard. RESULTS In 39 patients, 8896 temperature measurements and 1873 CBCs were recorded during 289 months of chemotherapy. Virtually applying LimitStandard resulted in 34 FN diagnoses. The predefined relevantly (≥15%) increased FN rate was reached at LimitLow 38.4°C, with total 44 FN, 23 simultaneous, 11 earlier, and 10 additional (Poisson rate ratioAdditional/Standard, 0.29; 95% lower confidence bound, 0.16). Virtually applying 37.5°C as LimitLow led to earlier FN diagnosis (median, 4.5 hours; 95% CI, 1.0 to 20.8), and to 53 additional FN diagnosed. In 51 (96%) of them, spontaneous defervescence without specific therapy was observed in reality. CONCLUSION Lower TLDFs led to many additional FN diagnoses, implying overtreatment because spontaneous defervescence was observed in the vast majority. Lower TLDFs led as well to relevantly earlier diagnosis in a minority of FN episodes. The question if the high TLDF is not only efficacious but as well safe remains open.

Production of Ethanol from Hardwood

Diminishing crude oil and natural gas supplies, along with concern about greenhouse gas are major driving forces in the search for efficient renewable energy sources. The conversion of lignocellulosic biomass to energy and useful chemicals is a component of the solution. Ethanol is most commonly produced by enzymatic hydrolysis of complex carbohydrates to simple sugars followed by fermentation using yeast. C6Hl0O5 + H2O −Enxymes→ C6H12O6 −Yeast→ 2CH3CH2OH + 2C02 In the U.S. corn is the primary starting raw material for commercial ethanol production. However, there is insufficient corn available to meet the future demand for ethanol as a gasoline additive. Consequently a variety of processes are being developed for producing ethanol from biomass; among which is the NREL process for the production of ethanol from white hardwood. The objective of the thesis reported here was to perform a technical economic analysis of the hardwood to ethanol process. In this analysis a Greenfield plant was compared to co-locating the ethanol plant adjacent to a Kraft pulp mill. The advantage of the latter case is that facilities can be shared jointly for ethanol production and for the production of pulp. Preliminary process designs were performed for three cases; a base case size of 2205 dry tons/day of hardwood (52 million gallons of ethanol per year) as well as the two cases of half and double this size. The thermal efficiency of the NREL process was estimated to be approximately 36%; that is about 36% of the thermal energy in the wood is retained in the product ethanol and by-product electrical energy. The discounted cash flow rate of return on investment and the net present value methods of evaluating process alternatives were used to evaluate the economic feasibility of the NREL process. The minimum acceptable discounted cash flow rate of return after taxes was assumed to be 10%. In all of the process alternatives investigated, the dominant cost factors are the capital recovery charges and the cost of wood. The Greenfield NREL process is not economically viable with the cost of producing ethanol varying from $2.58 to $2.08/gallon for the half capacity and double capacity cases respectively. The co-location cases appear more promising due to reductions in capital costs. The most profitable co-location case resulted in a discounted cash flow rate of return improving from 8.5% for the half capacity case to 20.3% for the double capacity case. Due to economy of scale, the investments become more and more profitable as the size of the plant increases. This concept is limited by the amount of wood that can be delivered to the plant on a sustainable basis as well as the demand for ethanol within a reasonable distance of the plant.

Literature review of estimation of prevalence rate of HIV/AIDS in India using population survey and sentinel surveillance based data

HIV/AIDS is a treatable although incurable disease that presents immense challenges to those infected including physical, social and psychological effects. As of 2009, an estimated 2.4 million people were living with HIV or AIDS in India, 0.3% of the country's population. In India, it is difficult to not only treat but also to track because it is associated with socio-economic factors such as illiteracy, social biases, poor sanitation, malnutrition and social class. Nevertheless, it is important to know the prevalence of HIV/AIDS for several reasons. At the individual level, the quality of life of people living with HIV/AIDS is markedly lower than their counterparts without the disease and is associated with challenges. At the community level, it is important to identify high risk groups, monitor prevention efforts, and allocate appropriate resources to target programs for the reduction of transmission of HIV. ^