Fault symptoms of rolling element bearings under variable operating conditions - a multi domain analysis

Diagnostics of rolling element bearings have been traditionally developed for constant operating conditions, and sophisticated techniques, like Spectral Kurtosis or Envelope Analysis, have proven their effectiveness by means of experimental tests, mainly conducted in small-scale laboratory test-rigs. Algorithms have been developed for the digital signal processing of data collected at constant speed and bearing load, with a few exceptions, allowing only small fluctuations of these quantities. Owing to the spreading of condition based maintenance in many industrial fields, in the last years a need for more flexible algorithms emerged, asking for compatibility with highly variable operating conditions, such as acceleration/deceleration transients. This paper analyzes the problems related with significant speed and load variability, discussing in detail the effect that they have on bearing damage symptoms, and propose solutions to adapt existing algorithms to cope with this new challenge. In particular, the paper will i) discuss the implication of variable speed on the applicability of diagnostic techniques, ii) address quantitatively the effects of load on the characteristic frequencies of damaged bearings and iii) finally present a new approach for bearing diagnostics in variable conditions, based on envelope analysis. The research is based on experimental data obtained by using artificially damaged bearings installed on a full scale test-rig, equipped with actual train traction system and reproducing the operation on a real track, including all the environmental noise, owing to track irregularity and electrical disturbances of such a harsh application.

Signal Processing Diagnostic Tool for Rolling Element Bearings Using EMD and MED

The signal processing techniques developed for the diagnostics of mechanical components operating in stationary conditions are often not applicable or are affected by a loss of effectiveness when applied to signals measured in transient conditions. In this chapter, an original signal processing tool is developed exploiting some data-adaptive techniques such as Empirical Mode Decomposition, Minimum Entropy Deconvolution and the analytical approach of the Hilbert transform. The tool has been developed to detect localized faults on bearings of traction systems of high speed trains and it is more effective to detect a fault in non-stationary conditions than signal processing tools based on envelope analysis or spectral kurtosis, which represent until now the landmark for bearings diagnostics.

Indexing without spam

The presence of spam in a document ranking is a major issue for Web search engines. Common approaches that cope with spam remove from the document rankings those pages that are likely to contain spam. These approaches are implemented as post-retrieval processes, that filter out spam pages only after documents have been retrieved with respect to a user’s query. In this paper we suggest to remove spam pages at indexing time, therefore obtaining a pruned index that is virtually “spam-free”. We investigate the benefits of this approach from three points of view: indexing time, index size, and retrieval performances. Not surprisingly, we found that the strategy decreases both the time required by the indexing process and the space required for storing the index. Surprisingly instead, we found that by considering a spam-pruned version of a collection’s index, no difference in retrieval performance is found when compared to that obtained by traditional post-retrieval spam filtering approaches.

Remote sensing utility expansion through Earth Portal internet browser

A modular, graphic-oriented Internet browser has been developed to enable non-technical client access to a literal spinning world of information and remotely sensed. The Earth Portal (www.earthportal.net) uses the ManyOne browser (www.manyone.net) to provide engaging point and click views of the Earth fully tessellated with remotely sensed imagery and geospatial data. The ManyOne browser technology use Mozilla with embedded plugins to apply multiple 3-D graphics engines, e.g. ArcGlobe or GeoFusion, that directly link with the open-systems architecture of the geo-spatial infrastructure. This innovation allows for rendering of satellite imagery directly over the Earth's surface and requires no technical training by the web user. Effective use of this global distribution system for the remote sensing community requires a minimal compliance with protocols and standards that have been promoted by NSDI and other open-systems standards organizations.

Climate change and financial regulation : challenges for the financial sector post the Global Financial Crisis

Regulation has played a significant role in shaping the financial services sector in Australia over the past few decades. Regulatory changes have included the establishment of the Australian Prudential Regulation Authority (APRA), floating the Australian dollar, allowing foreign financial institutions to operate domestically, the introduction of the superannuation guarantee charge, and the removal of interest rate controls. As the economy emerges from the worst financial crisis since the great depression, a new force of change that is recognised as one of the most significant sources of risk and opportunity facing the business community in the foreseeable future is that of climate change. Climate change is expected to be a significant change agent in the financial services sector as extreme weather patterns, sea level rises, and atmospheric changes impact on asset values (both investment and lending), project finance, and risk products. The financial services industry will be particularly affected by these developments, both as a provider of financial products (capital, credit, investment, advice, and insurance), and also through its powerful influence on the economy in terms of capital allocation. In addition, industry constituents will be heavily impacted by government regulation in this area (reporting, emissions trading and environmental policies), with respect to their own business practices and also those of their clients. This study reports the results of interviews conducted with senior members of the finance sector working in the sustainability area to gauge their perceptions of the challenges facing the sector with respect to climate change. Our results confirm that that regulatory intervention will be critical to climate change response gaining traction and momentum. In particular, regulatory certainty will promote engagement, particularly in relation to the Carbon Pollution Reduction Scheme (CPRS), with other developments needed in terms of information disclosure, performance and remuneration, and incentive programs. Accordingly, the significant potential risks and opportunities that climate change presents to the sector, and the broader economy, will in part be managed/realised only if a swift and significant regulatory response is achieved.

Thermodynamic modeling of ethanol fumigation in a diesel engine

Due to rapidly diminishing international supplies of fossil fuels, such as petroleum and diesel, the cost of fuel is constantly increasing, leading to higher costs of living, as a result of the significant reliance of many industries on motor vehicles. Many technologies have been developed to replace part or all of a fossil fuel with bio-fuels. One of the dual fuel technologies is fumigation of ethanol in diesel engines, which injects ethanol into the intake air stream of the engine. The advantage of this is that it avoids any costly modification of the engine high pressure diesel injection system, while reducing the volume of diesel required and potentially increasing the power output and efficiency. This paper investigates the performance of a diesel engine, converted to implement ethanol fumigation. The project will use both existing experimental data, along with generating computer modeled results using the program AVL Boost. The data from both experiments and the numerical simulation indicate desirable results for the peak pressure and the indicated mean effective pressure (IMEP). Increase in ethanol substitution resulted in elevated combustion pressure and an increase in the IMEP, while the variation of ethanol injection location resulted in negligible change. These increases in cylinder pressure led to a higher work output and total efficiency in the engine as the ethanol substitution was increased. In comparing the numerical and experimental results, the simulation showed a slight elevation, due to the inaccuracies in the heat release models. Future work is required to improve the combustion model and investigate the effect of the variation of the location of ethanol injection.

Numerical modelling of porous injection in a radical farming scramjet

A numerical investigation of the behaviour of fuel injection through a porous surface in an inlet-fuelled, radial-farming scramjet is presented. The performance of porous fuel injection is compared to discrete port hole injection at an equivalence ratio of φ ≈ 0.4 for both cases. The comparison is performed at a Mach 6.5 flow condition with a total specific enthalpy of 4.3 MJ/kg. The numerical results are compared to experiments performed in the T4 shock tunnel where available. The presented results demonstrate for the first time, that porous fuel injection has the potential to outperform port hole injectors in scramjet engines in terms of fuel-air mixing, ignition delays and achievable combustion efficiencies despite reduced fuel penetration heights.

Chemiluminescence imaging in supersonic combustors operating in radical-farming mode

Emission spectroscopy was used to investigate ignition and combustion characteristics of supersonic combustion ramjet engines. Two-dimensional scramjet models with inlet injection, fuelled with hydrogen gas, were used in the study. The scramjet engines were configured to operate in radical farming mode, where combustion radicals are formed behind shock waves reflected at the walls. The chemiluminescence emission signals were recorded in a two-dimensional, time-integrated fashion to give information on the location and distribution of the radical farms in the combustors. High signal levels were detected in localised regions immediately downstream of shock reflections, an indication of localised hydroxyl formation supporting the concept of radical farming. Results are presented for a symmetric as well as an asymmetric scramjet geometry. These data represent the first successful visualisation of radical farms in the hot pockets of a supersonic combustor. Spectrally resolved measurements have been obtained in the ultraviolet wavelength range between 300 and 400 nm. This data shows that the OH! chemiluminescence signal around 306nm is not the most dominant source of radiation observed in the radical farms.

Numerical estimation of 3D mechanical forces exerted by cells on non-linear materials

The exchange of physical forces in both cell-cell and cell-matrix interactions play a significant role in a variety of physiological and pathological processes, such as cell migration, cancer metastasis, inflammation and wound healing. Therefore, great interest exists in accurately quantifying the forces that cells exert on their substrate during migration. Traction Force Microscopy (TFM) is the most widely used method for measuring cell traction forces. Several mathematical techniques have been developed to estimate forces from TFM experiments. However, certain simplifications are commonly assumed, such as linear elasticity of the materials and/or free geometries, which in some cases may lead to inaccurate results. Here, cellular forces are numerically estimated by solving a minimization problem that combines multiple non-linear FEM solutions. Our simulations, free from constraints on the geometrical and the mechanical conditions, show that forces are predicted with higher accuracy than when using the standard approaches.

Baidu’s perfect paradox : free speech and the right to censor

China’s biggest search engine has a constitutional right to filter its search results, a US court found last month. But that’s just the start of the story. Eight New York-based pro-democracy activists sued Baidu Inc in 2011, seeking damages because Baidu prevents their work from showing up in search results. Baidu follows Chinese law that requires it to censor politically sensitive results. But in what the plaintiffs’ lawyer has dubbed a “perfect paradox”, US District Judge Jesse Furman has dismissed the challenge, explaining that to hold Baidu liable for its decisions to censor pro-democracy content would itself infringe the right to free speech.

The Seventeenth Australasian Document Computing Symposium

Newsletter ACM SIGIR Forum: The Seventeenth Australian Document Computing Symposium was held in Dunedin, New Zealand on the 5th and 6th of December 2012. In total twenty four papers were submitted. From those eleven were accepted for full presentation and 8 for short presentation. A poster session was held jointly with the Australasian Language Technology Workshop.

The ranking based constrained document clustering method and its application to social event detection

With the growing size and variety of social media files on the web, it’s becoming critical to efficiently organize them into clusters for further processing. This paper presents a novel scalable constrained document clustering method that harnesses the power of search engines capable of dealing with large text data. Instead of calculating distance between the documents and all of the clusters’ centroids, a neighborhood of best cluster candidates is chosen using a document ranking scheme. To make the method faster and less memory dependable, the in-memory and in-database processing are combined in a semi-incremental manner. This method has been extensively tested in the social event detection application. Empirical analysis shows that the proposed method is efficient both in computation and memory usage while producing notable accuracy.

Asthma interventions in primary schools : a review

Objective To explore, in depth, the literature for evidence supporting asthma interventions delivered within primary schools and to identify any “gaps” in this research area. Methods A literature search using electronic search engines (i.e. Medline, PubMed, Education Resources Information Center (ERIC), International Pharmaceutical Abstracts (IPA), Cumulative Index to Nursing and Allied Health Literature (CINAHL), Embase and Informit) and the search terms “asthma”, “asthma intervention” and “school-based asthma education program” (and derivatives of these keywords) was conducted. Results Twenty-three articles met the inclusion criteria; of these eight were Randomised Controlled Trials. There was much variety in the type, content, delivery and outcome measures in these 23 studies. The most common intervention type was asthma education delivery. Most studies demonstrated improvement in clinical and humanistic markers, for example, asthma symptoms medication use (decrease in reliever medication use or decrease in the need for rescue oral steroid), inhaler use technique and spacer use competency, lung function and quality of life. Relatively few studies explored the effect of the intervention on academic outcomes. Most studies did not report on the sustainability or cost effectiveness of the intervention tested. Another drawback in the literature was the lack of details about the intervention and inconsistency in instruments selected for measuring outcomes. Conclusion School-based asthma interventions regardless of their heterogeneity have positive clinical, humanistic, health economical and academic outcomes.

Business process management in small business : a case study

Small Businesses account for a significant portion of the Australian business sector. With Business Process Management (BPM) gaining prominence in recent decades as a means of improving business performance, it would seem to only be a matter of time before it gains momentum within the Small Business sector. One may even question why it has not already achieved more traction within the sector. This case study involves a BPM initiative to develop process infrastructure in an establishing Small Business. It explores whether mainstream BPM tools, techniques and technologies can be applied in a Small Business setting. The chapter provides a background to the case organisation, outlines the activities undertaken in the BPM initiative and distils key observations drawn from participation in the initiative and consultation with stakeholders. Based on the case study experiences, a number of implications are identified for further consideration by the BPM discipline as it continues to address the question of how it can become more widely adopted amongst Small Businesses.

On extension and torsion of a compressible elastic circular cylinder

In this paper we examine the combined extension and torsion of a compressible isotropic elastic cylinder of finite extent. The equilibrium equations are formulated in terms of the principal stretches and then applied to the special case of pure torsion superimposed on a uniform extension (an isochoric deformation). Explicit necessary and sufficient conditions on the strain-energy function for the material to support this deformation with vanishing traction on the lateral surfaces of the cylinder are obtained. Some strain-energy functions satisfying these conditions are considered, existing results are recovered as special cases and new results are obtained. We also point out how the strain-energy functions generated from the considered isochoric deformation considered (of a compressible material) can be used to generate energy functions and corresponding solutions for the incompressible theory.