Effect of pre-imbibition and osmoconditioning on seed-germination in Phaseolus-vulgaris L. under water-stress

The effect of osmoconditioning and controlled water sowing was analysed in seeds of Phaseolus vulgaris L. cv. carioca on germination under water stress conditions. The pre-sowing in water at low temperature to limit germination resulted in the increase in the tolerance to water stress. The osmoconditioning with PEG for 48 hours increased the tolerance of bean seeds to water stress of -0.51MPa. The osmoconditioning or controlled water sowing can be used as a practice to increase the tolerance of bean seeds to water stress before planting in the field.

Impedance spectroscopy of SnO2: CoO during sintering

SnO2:m mol% CoO (0.5 less than or equal to m less than or equal to 6.0) ceramic specimens were studied by impedance spectroscopy in the 5 Hz-13 MHz frequency range during heating cold-pressed specimens from room temperature to 1250 degrees C. The electrical resistivity during sintering decreases from 4 to 6 orders of magnitude in the 400-1500 K temperature range depending on the amount of CoO. An increase in electrical resistivity in the 570-670 K range is related to the release of adsorbed water. The results for the 970-1500 K show that the higher the amount of the CoO addition, the lower is the temperature at which SnO2:CoO reaches a minimum electrical resistivity. This suggests that oxygen point defects created by dissolution of cobalt ions in the SnO2 lattice are controlling the densification rate of these ceramics.

Structural and spectroscopic study of oxyfluoride glasses and glass-ceramics using europium ion as a structural probe

Transparent oxyfluoride glasses and beta-PbF(2) nanocrystals containing glass-ceramics were prepared with varying Eu(3+) content (0.3, 0.4, 0.5 and 0.6%). The effect of Eu(3+) content on the preparation of glass-ceramics was investigated. From differential scanning calorimetry, the T(x)-T(g)(T(x)-temperature of the onset of crystallization; T(g)-glass transition temperature) parameter for glasses has shown slight variation, and an exothermic peak near T(g) called the ceramization temperature (T(c)) has been observed. Heat treatments were performed at this temperature to obtain transparent glass-ceramics containing beta-PbF(2) nanocrystals, identified by x-ray diffraction. Heat treatments for different periods of time were performed and were observed to be very important in the control of the crystal size and of the crystallization rate. Based upon the absorption spectra, the scattering level due to the presence of beta-PbF(2) nanocrystals in the glass-ceramics was observed to be similar to that for the mother glasses. Detailed analysis of emission spectra and decay time measurements led to the identification of Eu(3+) ions as the beta-PbF(2) crystalline phase. Excitation spectra at 70 K show the interaction of Eu(3+) ions with the fluorogermanate network.

Diurnal and seasonal variations of CWSI and non-water-stressed baseline with nectarine trees

The work described was part of the programme, Innovative biological indicators to improve the efficiency of water and nitrogen use and the fruit quality in tree crops Project, a partnership between ISA and INRA. Field studies were conducted in Portugal on different irrigated plots of nectarine trees; a fully irrigated (unstressed plot) and a plot that was not irrigated for some days (stressed plot). The aim of this work was to investigate the effects of plant water stress on canopy temperature, to determine the nonwater-stressed baseline and to observe diurnal and seasonal variations of Crop Water Stress Index (CWSI). Canopy temperature, psychrometric and wind speed data were taken each half-hour, between 9:30 and 15:30 h. Results showed that canopy temperature was higher during the daytime, for both unstressed and stressed plots. A linear regression of canopy-air temperature differential and the vapor pressure deficit (non-water-stress baseline) showed a r2= 0.65. During the stress period, the average canopy temperature of the stressed plot was up to 5.4°C higher than the unstressed plot. Diurnal and seasonal average of CWSI values showed differences between unstressed and stressed plots, during the stress period.

Proposal of convergence of e-Learning systems for t-Learning

This article presents considerations about viability on reutilize existing web based e-Learning systems on Interactive Digital TV environment according to Digital TV standard adopted in Brazil. Considering the popularity of Moodle system in academic and corporative area, such system was chosen as a foundation for a survey into its properties to create a specification of an Application Programming Interface (API) for convergence to t-Learning characteristics that demands efforts in interface design area due the fact that computer and TV concepts are totally different. This work aims to present studies concerning user interface design during two stages: survey and detail of functionalities from an e-Learning system and how to adapt them for the Interactive TV regarding usability context and Information Architecture concepts.

Trolleybus power system for operation with AC or DC distribution networks

This paper presents the development and experimental analysis of a special input stage converter for a Trolleybus type vehicle allowing its operation in AC (two wires, single-phase) or DC distribution networks. The architecture of proposed input stage converter is composed by five interleaved boost rectifiers operating in discontinuous conduction mode. Furthermore, due to the power lines characteristics, the proposed input power structure can act as AC to DC or as DC to DC converter providing a proper DC output voltage range required to the DC bus. When operation is AC to DC, the converter is capable to provide high power factor with reduced harmonic distortion for the input current, complying with the restrictions imposed by IEC 61000-3-4 standard. Finally, the main experimental results are presented in order to verify the feasibility of the proposed converter, demonstrating the benefits and the possibility for AC feeding system for trolleybus type vehicle. © 2010 IEEE.

Using serial bluetooth converters as a sensor link in networked control systems

Networked control systems (NCS) are distributed control system in which sensors, actuators and controllers are physically separated and connected through communication networks. NCS represent the evolution of networked control architectures providing greater modularity and control decentralization, ease maintenance and diagnosis and lower cost of implementation. A recent trend in this research topic is the development of NCS using wireless networks which enable interoperability between existing wired and wireless systems. This paper presents the feasibility analysis of using a serial RS-232 to Bluetooth converter as a wireless sensor link in NCS. In order to support this investigation, relevant performance metrics for wireless control applications such as jitter, time delay and messages lost are highlighted and calculated to evaluate the converter capabilities. In addition the control performance of an implemented motor control system using the converter is analyzed. Experimental results led to the conclusion that serial RS-232 Bluetooth converters can be used to implement wireless networked control systems (WNCS) providing transmission rates and closed control loop times which are acceptable for NCS applications. © 2011 IEEE.

A new microcontrolled structural health monitoring system based on the electromechanical impedance principle

This article presents a new method to detect damage in structures based on the electromechanical impedance principle. The system follows the variations in the output voltage of piezoelectric transducers and does not compute the impedance itself. The proposed system is portable, autonomous, versatile, and could efficiently replace commercial instruments in different structural health monitoring applications. The identification of damage is performed by simply comparing the variations of root mean square voltage from response signals of piezoelectric transducers, such as lead zirconate titanate patches bonded to the structure, obtained for different frequencies of the excitation signal. The proposed system is not limited by the sampling rate of analog-to-digital converters, dispenses Fourier transform algorithms, and does not require a computer for processing, operating autonomously. A low-cost prototype based on microcontroller and digital synthesizer was built, and experiments were carried out on an aluminum structure and excellent results have been obtained. © The Author(s) 2012.

Efficacy of four irrigation needles in cleaning the apical third of root canals

This study aimed to evaluate the influence of irrigation needle gauge and design, and the final root canal diameter on the apical cleaning efficacy. Twelve human mandibular incisors were used. At different stages of root canal widening (sizes 20, 30 and 40 K-files), root canals were filled with radiopaque contrast medium. Four different needles were evaluated: 23G with side opening, 22G with apical opening, 30G with side opening and 30G with apical opening. Irrigation was carried out with 2 mL distilled water. The same tooth was radiographed with a digital system several times to assess the four types of needle in those three stages of canal widening. Pre-irrigation (canals filled with contrast) and post-irrigation (canals with remaining contrast) images were submitted to digital subtraction using the Adobe Photoshop CS4 program. Pre-irrigation (filled with contrast) and subtracted (cleaned by irrigation) areas were outlined by a trained and blinded operator using the Image Tool 3.0 software. Their ratio was calculated to express the percentage of apical cleaning in each stage of canal widening (sizes 20, 30 and 40 K-files) with each of the four needles. Data obtained were subjected to one-way ANOVA and Tukey's tests. The 30G needles with side and apical opening promoted better apical cleaning at all stages of root canal widening (p<0.05). In conclusion, smaller diameter needles were more efficacious in cleaning the apical third of the root canals, regardless of their design.

Características principais de pacientes com PSA menor ou igual a 4,0 ng/ml, submetidos à biópsia de próstata guiada pelo ultrassom transretal

Pós-graduação em Bases Gerais da Cirurgia - FMB

Retificador boost entrelaçado com elevado fator de potência e sem ponte de diodos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Desenvolvimento de uma ferramenta computacional de apoio ao ensino de sistemas eletrônicos digitais

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo da germinação de sementes de Tibouchina mutabilis (Vell.) Cogn. (Melastomataceae)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Efeito da adição de nanopartículas na biolixiviação da calcopirita ('CU''FE''S IND.2') por Acidithiobacillus ferrooxidans LR

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influência do pneumoperitôneo sobre a pressão pleural, parâmetros cardiovasculares e hemogasométricos em eqüinos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)