Pleistocene-Pliocene strontium-isotope ratios of ODP Site 107-653 (Table 1)

Strontium isotopic determinations were made on samples from the Pliocene-Pleistocene sequence recovered at ODP Hole 653A, the proposed "deep-sea type section" for the Mediterranean region. Biostratigraphic correlations can be combined with the patterns of variations in the 87Sr/86Sr values to delineate the following: (1) the earliest Pliocene (MP11 to basal MP12 zones) is distinguished by fluctuations in the ratio, probably related to the unstable paleoceanographic conditions following the Zanclean flooding and initial in-filling of the Mediterranean after the Messinian desiccation, (2) during most of the Pliocene between approximately 4.5 and 2.4 Ma (MP12 to MP15 zones) the 87Sr/86Sr values remain relatively constant, producing a plateau in the strontium isotope-depth curve for this period, and (3) beginning at approximately 2.4 Ma (across the MP15/MP16 boundary) and continuing into the latest Pleistocene, the 7Sr/86Sr values increase significantly but show fluctuations that have both positive and negative slopes. The presence of a plateau in the curve generated for the Mediterranean type section duplicates in greater detail the late Neogene results reported by DePaolo (1986, doi:10.1130/0091-7613(1986)14<103:DROTNS>2.0.CO;2). The virtual lack of change in the ratio between 4.5 and 2.4 Ma essentially eliminates strontium isotopes as a high-resolution correlation method for this period. The fluctuations in the ratio beginning at 2.4 Ma may be a reflection of major climatic changes occurring in the latest Pliocene-Pleistocene. The relationship between glacial-interglacial cycles and seawater 87Sr/86Sr values suggested by DePaolo (1986) and Capo and DePaolo (1987) is uncertain but should be tested as significant increases and decreases in 87Sr/86Sr of seawater have apparently occurred since 2.4 Ma.

Strontium-90 on the Earth's surface : summary and interpretation of a world-wide soil sampling program /

"TID-6567."

The mineral industry of the British empire and foreign countries. Statistics, 1919-1921. Strontium minerals.

At head of title: Imperial Mineral Resources Bureau.

The mineral industry of the British empire and foreign countries. Statistics, 1920-1922. Strontium minerals.

At head of title: Imperial mineral resources bureau.

Removal of nuclear bomb debris, Strontium 90-Yttrium 90, and Cesium 137-Barium 137 from water with Corps of Engineers mobile water-treating equipment /

Mode of access: Internet.

Untersuchungen uber das Spectrum von Strontium im Orangen und Raten.

Thesis (doctoral)--Rheinische Friedrich-Wilhelms-Universitat, Bonn.

Beitrage zu den Beziehungen zwischen dem Krystall und seinem chemischen Bestande : die eutropischen Reihen der Calcium-Strontium-Baryum-Gruppe.

Thesis (doctoral)--Universitat Jena.

Identifying mobility in populations with mixed marine/terrestrial diets : strontium isotope analysis of skeletal material from a passage grave in Resmo, Öland, Sweden

Strontium isotope analysis of skeletal material as a means to reconstruct prehistoric residential patterns has previously mainly been applied to populations with terrestrial diets. Here we present a model for populations with mixed marine/terrestrial diets, which is based on two-component mixing of strontium isotopes. Applying this model, we can estimate the original strontium isotope value of the terrestrial component of the diet. Accordingly it is possible to identify non-local individuals even if they had a mixed marine/terrestrial diet. The model is applied to tooth enamel samples representing nine individuals recovered from a passage grave in Resmo, on the island of Öland in the Baltic Sea, where at least five non-local individuals, representing at least two different geographical regions of origin, were identified. Non-local individuals were more frequent during the Bronze Age than during previous phases.

Water chemistry controls on minor elemental concentrations and strontium isotopic compositions of freshwater biogenic carbonate in northeastern Washington streams

Tracking the movement of migratory freshwater fish is essential to those invested in rebuilding declining fish populations. Using strontium isotopic signatures to match calcified fish tissues to streams where fish spawn is a useful method of tracking migratory fish where physical tracking methods such as radio, acoustic, or external tags, have proven unsuccessful. In this study, we develop tools to practice this method of tracking fish in Lake Roosevelt and its upstream tributaries in Washington State by analyzing the elemental concentrations and 87Sr/86Sr ratios of water samples, and mussel shell samples. This study evaluates whether mussel shells act as an appropriate proxy for water chemistry by comparing the 87Sr/86Sr isotope ratios of water samples to the 87Sr/86Sr isotope ratios of mussel shells sampled from the same, or nearby, locations. We compare concentrations of Ba, Ca, Cd, Cu, Fe, Mg, Pb, Sr, and U in the water and mussel shell samples to determine the feasibility of using mussel shells as a proxy for water chemistry. If it is determined that the concentrations of these elements in mussel shells reflect that of the surrounding water composition, the elemental composition of mussel shells can be compared to that of calcified tissues in fish, such as otoliths, to infer the location of the natal stream. We report analyses of water and mussel shell samples collected from Lake Roosevelt, Sanpoil River, Spokane River, Colville River, Kettle River, Pend Oreille River, Kootenay River, and Columbia River in Washington State. Each of these rivers is a tributary to Lake Roosevelt, and each flows through different geologic units. We hypothesize that the differences in the rock units of each stream’s watershed are reflected in the elemental concentrations and strontium isotopic ratios of water in each stream and in the lake. We also hypothesize that the composition of the mussel shells will match the composition of the water samples, therefore allowing us to use the mussel shells as a proxy for local water chemistry. Additionally, we hypothesize that the composition of the mussel shells will vary by location, and that we will be able to then infer where a fish is from by matching the composition of the fish in question to the mussels we have analyzed. We found that 87Sr/86Sr values for water and mussel hinge samples collected from tributaries east of Lake Roosevelt are significantly higher than the 87Sr/86Sr values for samples collected from tributaries west of Lake Roosevelt with averages of 0.7235 and 0.7089, respectively. The average 87Sr/86Sr ratios for water and mussel hinge samples collected within Lake Roosevelt is 0.7158, which is between the averages for samples collected east and west of the lake. Generally, older rocks are exposed on the east side of the lake, and younger rocks on the west side of the lake, so our 87Sr/86Sr values support the hypothesis that geologic units are a primary control on water chemistry, and that tributary compositions mix to form an average weighed by flow in Lake Roosevelt. The 87Sr/86Sr values for water and mussel shell samples collected from the same locations have a strong, positive linear correlation, suggesting that mussel shell 87Sr/86Sr ratios reflect the 87Sr/86Sr ratios of the ambient water. With these data, we can distinguish between different streams and the lake, but cannot distinguish between samples from within the same stream or within Lake Roosevelt. The Sr:Ca and Fe:Ca ratios of water samples show positive correlations with mussel shell compositions, with R2 values of 0.82 and 0.52, respectively. Ratios of Mg, Ba, Cu, Cd, Pb, and U to Ca showed little or no positive correlation between water and mussel shell samples. The elemental concentration data collected for this study do not demonstrate whether a correlation between elemental ratios in water samples and elemental ratios in mussel shell samples collected from the same location exists. Positive Sr:Ca and Fe:Ca correlations for water versus mussel shell samples indicate that perhaps for some elements, the composition of mussel shells are representative of the composition of ambient water. Using elemental concentration ratios to complement 87Sr/86Sr isotopic data may enhance our ability to identify correlations between water and mussel shell samples, and ultimately between mussel shell and otolith samples. The hinge part of a mussel shell may be used as a proxy for local water composition because the mussel shell composition reflects that of the local ambient water. The hinge of the mussel has the same composition as the whole mussel shell. We measured variation of 87Sr/86Sr ratios in the water among different streams and Lake Roosevelt. The 87Sr/86Sr values for samples collected in tributaries east of Lake Roosevelt, which erode older rocks, are higher for mussel shell and water samples than the average 87Sr/86Sr values for mussel shell and water samples collected in tributaries west of Lake Roosevelt, which flow through younger rocks.

Effects of boron-strontium interactions on eutectic modification in Al-10 mass%Si alloys

The effects of boron and strontium interactions on the eutectic silicon in hypoeutectic Al-Si alloys have been studied. Samples were prepared from an AI-I 0 mass%Si base alloy with different Al-B additions, alone and in combination with strontium. In alloys containing no strontium, boron additions do not cause modification of the eutectic silicon, while in strontium containing alloys, boron additions reduce the level of modification of the eutectic silicon. Thermal analysis parameters and eutectic silicon microstructures were investigated with respect to the Sr to B ratio. In order to modify the eutectic silicon, a Sr/B ratio exceeding 0.4 is required.

Microstructure and mechanical properties of high pressure die cast magnesium alloy AE42 with 1% strontium

The addition of 1 wt-%Sr to AE42 results in an improvement in the tensile strength of the alloy at elevated temperatures of 150 and 175degreesC and an improvement in the constant load creep properties at 175degreesC. The improved elevated temperature tensile and creep strength of the alloy can be attributed to the presence of a strontium-containing phase in the microstructure of the alloy along with an increase in the stability of the microstructure of the alloy at high temperatures. (C) 2004 W. S. Maney Son Ltd.

Solidification mechanisms of unmodified and strontium-modified hypereutectic aluminium-silicon alloys

The effects of strontium on the solidi. cation mode of hypereutectic aluminium-silicon alloys have been studied. Samples were prepared from an aluminium-17wt% silicon-based alloy and strontium was added at several different concentrations. The development of the microstructure was investigated by cooling curve analysis, interrupted solidi. cation experiments and optical and scanning electron microscopy. It was found that nucleation of primary silicon is suppressed by additions of strontium. The suppressed nucleation results in supersaturation of the liquid prior to nucleation, and an increased growth rate after nucleation. As a result, the silicon crystals become less faceted and more dendritic with increasing strontium additions. Increasing the strontium concentration slightly refined the eutectic spacing and introduced a small amount of fibrous silicon. Electron back-scatter diffraction measurements were performed to determine the crystallographic relation between the primary and eutectic silicon phases. The eutectic silicon in the unmodified alloy does not have any crystallographic relationship with the primary silicon crystals. In contrast, the eutectic silicon crystals in the strontium-modified alloys often share an identical or twin relationship with nearby primary silicon crystals. The incidence of twinning within primary silicon crystals was relatively low and did not appear to increase with strontium additions.

The influence of strontium on porosity formation in Al-Si alloys

Strontium modification is known to alter the amount, characteristics, and distribution of porosity in Al-Si castings. Although many theories have been proposed to account for these effects, most can be considered inadequate because of their failure to resolve contradictions and discrepancies in the literature. In an attempt to critically appraise some of these theories, the amount, distribution, and morphology of porosity were examined in sand-cast plates of Sr-free and Sr-containing pure Al, Al-l wt pet Si, and Al-9 wt pet Si alloys. Statistical significance testing was used to verify apparent trends in the porosity data. No apparent differences in the amount, distribution, and morphology of porosity were observed between Sr-free and Sr-containing alloys with no or very small eutectic volume fractions. However, Sr modification significantly changed the amount, distribution, and morphology of porosity in alloys with a significant volume fraction of eutectic. ne addition of Sr reduced porosity in the hot spot region of the casting, and the pores became well dispersed and rounded. This result can be explained by considering the combined effect of the casting design and the differences in the pattern of eutectic solidification between unmodified and Sr-modified alloys.

Eutectic grains in unmodified and strontium-modified hypoeutectic aluminum-silicon alloys

Additions of strontium to hypoeutectic aluminum-silicon alloys modify the morphology of the eutectic silicon phase from a coarse platelike structure to a fine fibrous structure. Thermal analysis, interrupted solidification, and microstructural examination of sand castings in this work revealed that, in addition to a change in silicon morphology, modification with strontium also causes an increase in the size of eutectic grains. The eutectic grain size increases because fewer grains nucleate, possibly due to poisoning of the phosphorus-based nucleants, that are active in the unmodified alloy. A simple growth model is developed to estimate the interface velocity during solidification of a eutectic grain. The model confirms, independent of microstructural observations, that the addition of 100 ppm strontium increases the eutectic grain size by at least an order of magnitude compared with the equivalent unmodified alloy. The model predicts that the growth velocity varies significantly during eutectic growth. At low strontium levels, these variations may be sufficient to cause transitions between flake and fibrous silicon morphologies depending on the casting conditions. The model can be used to rationally interpret the eutectic grain structure and silicon morphology of fully solidified aluminum-silicon castings and, when coupled with reliable thermal data, can be used to estimate the eutectic grain size.

Eutectic grain size and strontium concentration in hypoeutectic aluminium-silicon alloys

Recently it has been shown that modification with strontium causes an increase in the size of eutectic grains. The eutectic grain size increases because there are fewer nucleation events, possibly due to the poisoning of phosphorus-based nuclei that are active in the unmodified alloy. The current paper investigates the effect of strontium concentration on the eutectic grain size. In the aluminium-10 wt.% silicon alloy used in this research, for fixed casting conditions, the eutectic grain size increases as the strontium concentration increases up to approximately 150ppm, beyond which the grain size is relatively stable. This critical strontium concentration is likely to differ depending on the composition of the base alloy, including the concentration of minor elements and impurities. It is concluded that processing and in-service properties of strontium modified aluminium-silicon castings are likely to be more stable if a minimum critical strontium concentration is exceeded. If operating below this critical strontium concentration exceptional control over composition and casting conditions is required. (c) 2005 Elsevier B.V. All rights reserved.