Power converter topologies for wind energy conversion systems: Integrated modeling, control strategy and performance simulation

This paper presents new integrated model for variable-speed wind energy conversion systems, considering a more accurate dynamic of the wind turbine, rotor, generator, power converter and filter. Pulse width modulation by space vector modulation associated with sliding mode is used for controlling the power converters. Also, power factor control is introduced at the output of the power converters. Comprehensive performance simulation studies are carried out with matrix, two-level and multilevel power converter topologies in order to adequately assert the system performance. Conclusions are duly drawn.

Durability performance of concrete made with fine recycled concrete aggregates

Fine recycled aggregates are seen as the last choice in recycling for concrete production. Many references quote their detrimental influence on the most important characteristics of concrete: compressive and tensile strength; modulus of elasticity; water absorption; shrinkage: carbonation and chloride penetration. These two last characteristics are fundamental in terms of the long-term durability of reinforced or prestressed concrete. In the experimental research carried out at IST, part of which has already been published, different concrete mixes (with increasing rates of substitution of fine natural aggregates sand - with fine recycled aggregates from crushed concrete) were prepared and tested. The results were then compared with those for a reference concrete with exactly the same composition and grading curve, but with no recycled aggregates. This paper presents the main results of this research for water absorption by immersion and capillarity, chloride penetration (by means of the chloride migration coefficient), and carbonation resistance, drawing some conclusions on the feasibility of using this type of aggregate in structural concrete, while taking into account any ensuing obvious positive environmental impact.

Hábitos de sono e performance académica: estudo comparativo entre Estónia e Portugal

Actualmente, na nossa sociedade, muitas das actividades diárias têm prioridade sobre o sono. A privação do sono em estudantes tem sido documentada em variados países e o problema reside no conflito entre a necessidade física e psicológica, dos estudantes, de dormir e os seus horários. Esta privação do sono é, muitas das vezes, relacionada com a diminuição do humor e do rendimento académico. No intuito de combater estes problemas, alguns estudantes recorrem ao uso de fármacos ou substâncias com vista a melhorar a sua qualidade de vida e o seu rendimento escolar. O objectivo deste estudo é (1) avaliar a qualidade de sono dos estudantes universitários, (2) avaliar a percentagem de estudantes que consomem fármacos ou substâncias para modificar o seu sono e (3) comparar os resultados entre duas escolas de saúde, Escola Superior de Tecnologia da Saúde do Porto, Portugal (ESTSP) e a Tallinn Health Care College, Estónia (THCC).

A relação entre a insuficiência de convergência e a visão funcional na performance de leitura

A insuficiência de convergência (IC) é a causa mais comum de astenopia muscular. Crianças com dificuldades na leitura têm uma maior prevalência de anomalias da visão binocular. A existência de problemas visuais na criança representa um esforço acrescido durante a leitura. A dificuldade sentida provoca problemas de distração ou atenção, frustração e evitamento da leitura, influenciando o processo de aprendizagem. Objectivos específicos da comunicação: 1. Identificar a prevalência da IC e seus sintomas; 2. Identificar os parâmetros da visão funcional que são influenciados pela IC; e 3. Investigar se existe associação entre anomalias associadas à IC e a leitura.

Análisis de los indicadores de performance de las instituciones microfinancieras: Comparativa con las entidades financieras formales

Desde sus comienzos en los años 70 al día de hoy, podemos hablar del sector de las microfinanzas como un sector en crecimiento, pero ya consolidado por el gran número de instituciones especializadas en servicios microfinancieros y el resultado de sus prácticas exitosas. En el trabajo que presentamos realizamos un estudio preeliminar sobre los indicadores de performance de las Instituciones de Microfinanzas (IMFs). Nuestro objetivo es detectar las particularidades en los resultados de dichos parámetros y ratios en dichas instituciones. Para ello llevamos a cabo un análisis teórico de los ratios más aceptados por la comunidad financiera implicada en el suministro de información sobre los resultados y la performance de las IMFs. El estudio se completa comparando los datos suministrados por estas instituciones con los equivalentes en entidades financieras tradicionales de nuestro entorno, haciendo especial hincapié en la actividad de estas últimas entidades en Latinoamérica.

Performance management in health centres: evidence from a field study

There has been a growing interest in research on performance measurement and management practices, which seems to reflect researchers’ response to calls for the need to increase the relevance of management accounting research. However, despite the development of the new public management literature, studies involving public sector organizations are relatively small compared to those involving business organizations and extremely limited when it comes to public primary health care organizations. Yet, the economic significance of public health care organizations in the economy of developed countries and the criticisms these organizations regularly face from the public suggests there is a need for research. This is particularly true in the case of research that may lead to improvement in performance measurement and management practices and ultimately to improvements in the way health care organizations use their limited resources in the provision of services to the communities. This study reports on a field study involving three public primary health care organisations. The evidence obtained from interviews and archival data suggests a performance management practices in these institutions lacked consistency and coherence, potentially leading to decreased performance. Hierarchical controls seemed to be very weak and accountability limited, leading to a lack of direction, low motivation and, in some circumstances to insufficient managerial abilities and skills. Also, the performance management systems revealed a number of weaknesses, which suggests that there are various opportunities for improvement in performance in the studied organisations.

Digital radiography detector performance

The characterization of physical properties of digital imaging systems requires the determination and measurement of detectors’ physical performance. Those measures such as modulation transfer function (MTF), noise power spectra (NPS), and detective quantum efficiency (DQE) provide objective evaluations of digital detectors’ performance. To provide an MTF, NPS, and DQE calculation from raw-data images it is necessary to implement a method that is undertaken by two major steps: (1) image acquisition and (2) quantitative measure determination method. In this chapter a comprehensive description about a method to provide the measure of performance of digital radiography detectors is provided.

Schizophrenia in males of cognitive performance: discriminative and diagnostic values

OBJECTIVE: To evaluate the discriminative and diagnostic values of neuropsychological tests for identifying schizophrenia patients. METHODS: A cross-sectional study with 36 male schizophrenia outpatients and 72 healthy matched volunteers was carried out. Participants underwent the following neuropsychological tests: Wisconsin Card Sorting test, Verbal Fluency, Stroop test, Mini Mental State Examination, and Spatial Recognition Span. Sensitivity and specificity estimated the diagnostic value of tests with cutoffs obtained using Receiver Operating Characteristic curves. The latent class model (diagnosis of schizophrenia) was used as gold standard. RESULTS: Although patients presented lower scores in most tests, the highest canonical function for the discriminant analysis was 0.57 (Verbal Fluency M). The best sensitivity and specificity were obtained in the Verbal Fluency M test (75 and 65, respectively). CONCLUSIONS: The neuropsychological tests showed moderate diagnostic value for the identification of schizophrenia patients. These findings suggested that the cognitive impairment measured by these tests might not be homogeneous among schizophrenia patients.

A strategy to extend reactive distillation column performance under catalyst deactivation

This work addresses the effects of catalyst deactivation and investigates methods to reduce their impact on the reactive distillation columns performance. The use of variable feed quality and reboil ratio are investigated using a rigorous dynamic model developed in gPROMS and applied to an illustrative example, i.e., the olefin metathesis system, wherein 2-pentene reacts to form 2-butene and 3-hexene. Three designs and different strategies on column energy supply to tackle catalyst deactivation are investigated and the results compared.

Performance of microstrip antennas in the presence of EBG in an indoor localization system

Indoor localization systems in nowadays is a huge area of interest not only at academic but also at industry and commercial level. The correct location in these systems is strongly influenced by antennas performance which can provide several gains, bandwidths, polarizations and radiation patterns, due to large variety of antennas types and formats. This paper presents the design, manufacture and measurement of a compact microstrip antenna, for a 2.4 GHZ frequency band, enhanced with the use of Electromagnetic Band-Gap (EBG) structures, which improve the electromagnetic behavior of the conventional antennas. The microstrip antenna with an EBG structure integrated allows an improvement of the location system performance in about 25% to 30% relatively to a conventional microstrip antenna.

Comparative study of power converter topologies and control strategies for the harmonic performance of variable-speed wind turbine generator systems

Power converters play a vital role in the integration of wind power into the electrical grid. Variable-speed wind turbine generator systems have a considerable interest of application for grid connection at constant frequency. In this paper, comprehensive simulation studies are carried out with three power converter topologies: matrix, two-level and multilevel. A fractional-order control strategy is studied for the variable-speed operation of wind turbine generator systems. The studies are in order to compare power converter topologies and control strategies. The studies reveal that the multilevel converter and the proposed fractional-order control strategy enable an improvement in the power quality, in comparison with the other power converters using a classical integer-order control strategy. (C) 2010 Elsevier Ltd. All rights reserved.

Performance of an immunochromatography test for vivax malaria in the Amazon region, Brazil

The study was carried out to evaluate the diagnostic performance of the ICT malaria Pf/PvTM test for vivax malaria diagnosis in Belém, Amazon region, Brazil. The results of blood malaria parasites examination using an immunochromatography test were compared with thick blood film (TBF) examination. It was also evaluated the performance of this test storaged at three different temperatures (25°C, 30°C, and 37°C) for 24 hours before use. Overall sensitivity of ICT Pf/PvTM was 61.8% with a specificity of 100%, positive and negative predictive value of 100% and 71.8%, respectively and accuracy of 80.6%. The test sensitivity was independent of the parasite density. This test needs to be further reviewed in order to have better performance for P. vivax malaria diagnosis.

MASDSheGATS – Scheduling System for Dynamic Manufacturing Environments

This chapter addresses the resolution of scheduling in manufacturing systems subject to perturbations. The planning of Manufacturing Systems involves frequently the resolution of a huge amount and variety of combinatorial optimisation problems with an important impact on the performance of manufacturing organisations. Examples of those problems are the sequencing and scheduling problems in manufacturing management, routing and transportation, layout design and timetabling problems.

The influence of curing conditions on the mechanical performance of concrete made with recycled concrete waste

Research on the use of Construction and Demolition Waste (CDW) as recycled aggregate (in particular crushed concrete) for the production of new concrete has by now established the feasibility of this environmentally-friendly use of otherwise harmful waste. However, contrary to conventional concrete (CC), no large applications of concrete made with recycled concrete have been made and there is still a lack of knowledge in some areas of production and performance of recycled aggregate concrete (RAC). One issue concerns curing conditions: these greatly affect the performance of concrete made on site and some potential users of RAC wonder how RAC is affected by far-from-ideal curing conditions. This paper shows the main results of experiments to determine the influence of different curing conditions on the mechanical performance of concrete made with coarse recycled aggregate from crushed concrete. The properties analyzed include compressive strength, splitting tensile strength, modulus of elasticity, and abrasion resistance. The general conclusion in terms of mechanical performance is that RAC is affected by curing conditions roughly in the same way as CC. (C) 2011 Elsevier Ltd. All rights reserved.

Análise de performance da família de motores de avião CFM56

Uma das fases que constitui um programa de desenvolvimento de um motor aeronáutico é a concepção de um modelo de simulação da sua performance, com recurso a informação recolhida em ensaios experimentais de grande escala. Estes ensaios são desenvolvidos em instalações de elevado nível tecnológico, criadas exclusivamente para esta finalidade e às quais apenas os grandes fabricantes têm acesso. O mesmo acontece com todos os resultados obtidos, os detalhes das simulações e os parâmetros de projecto, que são mantidos sigilosamente. Por outro lado, o local onde se inseriu o desenvolvimento desta dissertação, designadamente o banco de ensaio da TAP, não está previsto para projectar este tipo de equipamentos, o que impossibilita assim o acesso a informação fundamental ao estudo aprofundado dos reactores. Além disso, devido ao risco de provocar danos irreversíveis aos motores, existe ainda a impossibilidade de os instrumentar com sondas improvisadas pela equipa de engenharia. Neste sentido, e de forma a ir ao encontro dos parâmetros termodinâmicos pretendidos, o objectivo deste trabalho culminou no desenvolvimento de metodologias de cálculo analíticas que permitissem extrapolar diversas variáveis imensuráveis no ensaio do reactor, especificamente do CFM56-3. Com todo o percurso de caracterização do ciclo termodinâmico do referido motor, a TAP pretende que, a longo prazo, seja possível desenvolver uma ferramenta que simule a sua performance para auxiliar a equipa de engenharia do centro de reparação e ensaio de motores de avião. Assim, será igualmente abordado o desenvolvimento do modelo termodinâmico do CFM56-3, recorrendo ao software GasTurb.