Estudo comparativo do desgaste de ferramentas cerâmicas de Al2O3 em relação às de B4C + TiB2

Due to the high value of the bill that the Brazilian has been paying, one of the most expensive in the world, is becoming increasingly attractive the option for renewable energy in form of distributed micro and minigeneration. In other words, the renewable energy sources are becoming attractive not only because of environmental concerns, but also due to economic issues. This has become even more relevant and concrete after approval of rules by National Agency of Electric Energy (ANEEL) on 4/17/2012 (Normative Resolution n ° 482/2012 of 04/17/2012) aimed at reducing barriers to installation of small distributed generation, including microgeneration, with up to 100 kW of power, and minigeneration, 100 kW to 1 MW. The Normative Resolution n ° 482/2012 creates the Energy Clearing System, which allows consumers to install small generators in its consumer unit and exchange energy with the local distributor. The rule applies to generators that use renewable sources of energy (hydro, solar, biomass, wind and cogeneration qualified). In this context, this paper presents a technical and economic analysis of installing a residential microgenerating plant composed of photovoltaic cells, solar panels and small wind turbines

Viabilidade de turbinas eólicas de pequeno porte no Brasil

Facing a global scenario where oil is scarce and the emission of CO2 in the atmosphere is a world concern, the search for new methods of energy production becomes the focus of all countries. Based on these assumptions, the wind power gains highlight and happen to be the most exploited around the world, since this does not produce toxic waste, since it uses the wind, no raw material shortage and its cost and efficiency are increasingly attractive. Taking advantage of the geographical features of Brazil, coastal and territorial extension, this study aims to analyze the feasibility of using wind turbines widely used in Germany, one of the countries with the highest production of energy through wind, in Brazil. In order to increase the energy production without causing more environmental impacts, geographical analyses will be made, and to determine the features and costs of production of this type of energy generation, and at the end of this dissertation, will finish for one of the turbines, Montana, is it feasible to install, however due to the Government's little incentive return is not very expressive. With respect to the turbine Passaat, this is infeasible to install under current conditions

Estudo e modelagem 3D de uma turbina Francis

Most of the hydraulic turbines that are running in the world are the Francis type, because they are able to fit a wide range of head and flow. We also can declare that most of the installed hydraulic energy up to this date is generated by this type of turbine. On the other hand, if we pay attention to mechanical details of a Francis turbine we will see that among the three most used types it is the one that presents the more complex design. And, the simplest one is the Pelton type, whereas the Kaplan is the one less utilized. This work aims to develop the hydrodynamic calculation of a Francis turbine as well as to obtain its assembly drawing and 3D modeling drawing. In this way all details must be shown therefore needing a complete knowledge about this issue. Both 2D and 3D drawings help much if one wants the machine to be running in its power house. It is well noted that most of the entities that design and manufacture the Francis turbines are not brazilian. In this way the more we study how to design this kind of machine the more is our contribution to our country in order to conquer technology and manufacture Francis turbines

Aproveitamento energético de resíduos de esgotamento sanitário

This paper presents alternatives for waste energy recovery from the sewage of cities. Through a review of the literature it is observed that the technologies studied are usually turbines, microturbines, and engines adapted to the use of biogas. For project design analyzes the technologies found in some sewage treatment plants in Brazil and the world, compared with those found in the literature. With this study it can be concluded that the most used technologies are microturbines and motor generator sets, which are already implemented in some locations in the USA, Europe and even Brazil. It can also be concluded that the energy recovery of waste from sewage can enable design of wastewater treatment plants thereby contributing to improved quality of life

Comissionamento de turbinas hidráulicas: ensaios de faixa operativa, índex, test e rejeição de carga

With growing electricty demand, the importance of generation through hydropower, a renewable energy source, it’s of great importance. This demand derives from the country’s growth, as well as events that will occur in the coming years. The commission has a crucial role before the entry into operation of hydroelectric plant, sice, ensures a good operation of hydraulic and electrical systems, as well as the safety of the installation. This paper is a case study, commissioning in a PCH in especially the most important tests, such as range operation, índex tes and load rejection. In these trials we can get a Idea of the actual behavior of the unit, as well as future operation maneuvers, and evidence of real efficiency

Análise comparativa entre Brasil e Alemanha sobre autoprodução de energia elétrica residencial

The energy crisis has affected many countries. With the growing warning with the emission in the atmosphere and the lack of resources, the seek for sustainable sources for energy genaration have become even bigger. Some Countries, as Germany, started first in this journey, creating an incentive program to self-generation with renewable sources (wind, photovoltaics, biomass, etc.), giving priority for smaller plants. In Germany the program called EEG started in 2004. In Brazil, since the beggining of 2012, the self-generators did not know how they could be beneficted for self-generation, and self-generation didn't become commun in the country. However, with NR 482, of April 17th, 2012, the parameters were defined, and the self-generator could have a guideline. Therewith, studyies can be redirected for a better knowlegde of the conditions the self-generator will be sujected, in addition to Germany's case as reference to compare with Brazil's case. In this paper these studies are made, focused in wind power (wind turbines) and photovoltaic panels

Estudo sobre uma turbina a gás instalada em uma refinaria de petróleo

The gas turbine (GT) is known to have: low cost of capital over the amount of energy, high flexibility, high reliability, short delivery time, commissioning and commercial operation at the beginning and quick departure. The gas turbine is also recognized for its superior environmental performance, manifested in air pollution containment and reducing greenhouse gases (Mahi, 1994). Gas turbines in simple cycle mode (SC) have long been used by utilities to limited power generation peak. In addition, manufacturing facilities use gas turbines for power generation units on site, often in combination with the process of heat production, such as hot water and steam process. In recent years, the performance of industrial gas turbines has been improved due to significant investments in research and development, in terms of fuel to electricity conversion efficiency, plant capacity, availability and reliability. The greater availability of energy resources such as natural gas (NG), the significant reduction of capital costs and the introduction of advanced cycles, have also been a success factor for the increased use of gas turbines to load applications base (Poulikas, 2004). Open Cycle Gas Turbine with a greater degree of heat to the atmosphere may alternatively be used to produce additional electricity using a steam cycle, or to compose a cogeneration process. The combined cycle (CC) uses the heat from the gas turbine exhaust gas to increase the power output and increase the overall efficiency of more than 50% second (Najjar, 2001). The initial discovery of these cycles in the commercial power generation market was possible due to the development of the gas turbine. Only from the 1970s that gas turbine inlet temperature and therefore the exhaust gas temperature was sufficiently high to allow a better efficiency in the combined cycle ... (Complete Abstract click electronic access below)

Recuperação de turbinas hidráulicas danificadas por erosão cavitacional por soldagem com aço inoxidável/cobalto

Pós-graduação em Engenharia Mecânica - FEIS

Influence of structural nonlinearities in stall-induced aeroelastic response of pitching airfoils

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Thermodynamic, Economic and Emissions Analysis of a Micro Gas Turbine Cogeneration System operating on Biofuels

Pós-graduação em Engenharia Mecânica - FEG

Geração de energia por microturbina alimentada à biogás em uma propriedade rural: estudo de caso

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Construção e avaliação térmica de um sistema concentrador parabólico com seguidor solar

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise da viabilidade do uso de biogás gerado a partir de dejetos bovinos em microturbinas para fins de geração, cogeração e trigeração de energia

The use of digesters has become an important alternative for the proper disposal of organic agricultural wastes, serving as a solution to some environmental and health problems. Furthermore, the process of digestion provides commercially valuable by products such as biogas and bio fertilizer. The generation of biogas from agricultural waste, and its use in power generation systems has aroused great interest in rural areas because it enables supply in whole or in large part the energy demand of ownership by reducing production costs. The advent of technology has brought new forms of energy conversion of biogas, as the use of micro turbines specifies to be fuelled with biogas derived from the decomposition of organic matter in digesters, since it has a low level of methane in its composition, and high degree of impurities such as hydrogen sulphide, which are harmful to equipment and reduce the calorific value of biogas. The use of micro turbines behind other advantages like low emissions, great fuel flexibility and low maintenance. This paper presents an analysis of the feasibility of using biogas generated from cattle manure in micro turbines to generate electricity. Behind also an assessment of the energy potential that each animal has on various uses of biogas, and forms of energy recovery from the exhaust gases of the micro turbine. Also conducts an evaluation of the energy savings that the use of biogas aggregates properties.

Modelagem matemática para otimização de um potencial hidráulico utilizando turbinas Francis e Kaplan

Pós-graduação em Engenharia Mecânica - FEG

Nebraska Wind Power: A Comparitive Study of Knowledge and Attitudes

Abstract The goal of this project is to assess the knowledge and attitudes of Nebraskans on the issue of wind power. The point of this research is to learn whether the presence of wind power has a positive effect on a person’s knowledge about and attitudes toward wind power and wind turbines. Using mail surveys, qualitative and quantitative data were collected from the towns of Pierce and Ainsworth Nebraska. The surveys aided in seeing patterns of knowledge about wind power and wind turbines and positive and negative attitudes and major concerns regarding wind power.