The seismic SPT to determine the maximum shear modulus

This paper presents the first results of a system to carry out seismic SPT, which associates the up-hole seismic technique to the currently used SPT test. This hybrid test allows determining the maximum shear modulus (G 0) together with the SPT test. G 0 is the most important dynamic soil parameter and it is calculated based on the shear wave velocity (V S) measurements. The equipment and the method of analysis will be briefly described. The V s values measured using the S-SPT in one experimental research site located inland of Sao Paulo State-Brazil are presented and compared with down-hole and Seismic CPT test data. These preliminary results indicate that the S-SPT was satisfactory and can be used for dynamic site characterization.

Session report: Non-textbook type geomaterials

An abstract of all the papers presented in the Conference Section where the geotechnical material is considered non-conventional to classical Soil Mechanics is presented. Thirteen papers submitted to this Conference were considered as a non-textbook type geomaterial. The papers were grouped in four groups: tropical soils, tailings, cementation and heterogeneous soils. The objective is to present a report with the major contributions of the each paper to encourage the reader to read the original papers. © 2013 Taylor & Francis Group.

The use of CPT to evaluate the effect of helical pile installation in tropical soils

The uplift capacity of helical piles depends on the shear resistance of the soil above the helical plates. During helical pile installation, the soil traversed by the plates are sheared and displaced laterally, and consequently the soil structure is disturbed. Considering this fact, the aim of this paper is presenting the effect of helical piles installation in the soil mass by means of CPT tests carried out close to the soil cylinder above the pile helices. The CPT tests were performed at the CRHEA site from the Sao Carlos School of Engineering, Sao Carlos city, inland of Sao Paulo State, Brazil. In addition, an interpretation of CPT tests data for stratigrafic logging are presented and compared to Standard Penetration Tests (SPT) carried out at this site. This study showed that the CPT sleeve friction fs data were affected by the installation of helical pile in this particular tropical soil site. © 2013 Taylor & Francis Group.

Caracterização geofísica em aterro de resíduos sólidos para avaliação de condicionantes de instabilidade geotécnica

The disposal of solid waste can create environmental problems, in addition to the potential risk of instability even in planned geotechnical works, such as provisions in stacks or high ends of the landfill, because they represent mere adjustments in civil engineering works. The Leme city, SP, generates about 35 t/day of municipal waste, that are deposited in a landfill located in the Barro Preto neighborhood. This work conducted a geophysical survey, based on geotechnical instability evidence in area, for analysis of the conditioners that cause on the sides leachate resurgence landfill and its relationship to mass movements and ravines installation in cover soil, with consequent waste exposure. The results indicate horizons of low resistivity connected with resurgence points generated by the organic matter decomposition contained in the waste. Such horizons result in leachate concentration in some places, which, in turn, may lead to loss of cohesion of the materials constituting the residues mass. The results are areas with mass flow by rotational movements, which, together with the surface flow of rainwater, evolves into ravines and exposed residues, preferably at the resurgence point. The leachate flow on the surface affects areas beyond the limits at landfill with direct impact on local agriculture and risk to pedestrians using the highway bordered by the landfill beyond the soil and the local aquifer.

Evaluation of mechanical and thermal properties after chemical degradation of PVC and HDPE geomembranes

Chemical compatibility between geomembranes and site-specific waste liquids should be assessed since the waste liquids are highly complex mixtures. This paper presents some considerations about the chemical compatibility of geomembranes and some results of mechanical tests in HDPE and PVC geomembranes that were exposed to leachate and chemical residue (niobium). PVC and HDPE geomembranes of two thicknesses were tested: 1.0, 2.0 mm (PVC) and 0.8, 2.5 mm (HDPE). The results obtained show that after exposure the PVC geomembranes (1.0, 2.0 mm) were more rigid and stiffer than fresh samples. The HDPE geomembranes, on the other hand, when exposed to leachate and niobium residue presented increases in deformation. Melt flow index (MFI) tests were also carried out to verify the oxidation. © 2013 ejge.

Aspects of Mechanical Behavior and Modeling of a Tropical Unsaturated Soil

The research studies the applicability of two elastoplastic models for the collapse prediction of the lateritic soil profile from Southeastern Brazil. These tropical soils have peculiar geotechnical behavior, due to their mineralogical composition and porous structure coming from intense process of formation. Two elastoplastic models were analyzed: the Barcelona Basic Model (BBM) and another one based on BBM, however developed for tropical soils. Oedometric tests with suction control were performed at three distinct depths of the soil profile. The BBM was not suitable for the upper layer of the soil profile, because BBM considers the compressible behavior of the soil in function of the reduction of the elastoplastic compressibility index with the increase of the matric suction. The model developed for tropical soils showed better suited to the compressible behavior of the soil profile, resulting in good prediction of the collapse potential, mainly by accepting increasing values of the elastoplastic compressibility index of the soil profile with the matric suction rise. © 2013 Springer Science+Business Media Dordrecht.

Atlas ambiental como subsídio aos estudos de sustentabilidade - a bacia do Araçuaí no Vale do Jequitinhonha - MG

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Atlas escolar interativo: desenvolvimento de um protótipo para o quarto ciclo do ensino fundamental

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Extração semi-automática de rodovias no espaço-objeto: uso integrado de um estéreo par de imagens aéreas e um MDT

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Aplicação de métodos combinados de avaliação imobiliária na elaboração da planta de valores genéricos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influência da combinação e modernização dos sistemas que integram o GNSS no georreferenciamento de imóveis rurais

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Suporte à elaboração de plano diretor com ênfase na aplicação de instrumento urbanístico do estatuto da cidade. Estudo de caso: Bastos-SP

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desenvolvimento do protótipo de um atlas escolar interativo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Métodos para extração de informações a partir de imagens multiespectrais de escalas grandes

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Detecção de rodovias em imagens digitais de alta resolução com o uso da teoria de morfologia matemática

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)