Webbplats och grafisk profil för Falu Tank AB : samt teoretisk fördjupning inom webbdesign

I detta examensarbete har en webbplats skapats för Falu Tank AB med hjälp av Jennifer Flemings utvecklingsmodell, även framtagning av en logotyp och grafisk profil med tillhörande manual har ingått i examensarbetet. Falu Tank AB utför nytillverkning, rekonditionering samt kontroll av petroleumtankar. De erbjuder också oljeavskiljare, pumpöar och dubbelmantlade tankar. Arbetet har bestått av en bakgrundsundersökning på Falu Tank AB, samt litteraturstudier i webbdesign och grafisk profilering, med en teoretisk fördjupning inom webbdesign. Bra webbdesign innebär i första hand att sidan är välstrukturerad, enhetlig, lättnavigerad, användarvänlig och att den har en bra harmoni. Målet med webbplatsen var att den skulle vara funktionell, proffsig, och modern, med en passande design för att attrahera fler besökare. Jennifer Flemings utvecklingsmodell lämpade sig mycket väl vid utformningen av webbplatsen. Falu Tanks logotyp kändes gammal och intetsägande dessutom saknades en grafisk profil. Den framtagna profilen innefattar logotyp, färg och typografi, men även formgivning av visitkort, brevpapper och fakturor. Målet med den grafiska profilen var ett ge Falu Tank ett enhetligt, modernt och stilrent intryck inför kommande marknadsföring. Resultatet blev en stilren och tydlig grafisk profil med stark koppling till Falu Tank. (PDF1 - Rapport) (PDF2 - Bilagor) (PDF3 - Grafisk Manual)

Emissions from realistic operation of residential wood pellets heating systems

Emissions from residential combustion appliances vary significantly depending on the firing behaviours and combustion conditions, in addition to combustion technologies and fuel quality. Although wood pellet combustion in residential heating boilers is efficient, the combustion conditions during start-up and stop phases are not optimal and produce significantly high emissions such as carbon monoxide and hydrocarbon from incomplete combustion. The emissions from the start-up and stop phases of the pellet boilers are not fully taken into account in test methods for ecolabels which primarily focus on emissions during operation on full load and part load. The objective of the thesis is to investigate the emission characteristics during realistic operation of residential wood pellet boilers in order to identify when the major part of the annual emissions occur. Emissions from four residential wood pellet boilers were measured and characterized for three operating phases (start-up, steady and stop). Emissions from realistic operation of combined solar and wood pellet heating systems was continuously measured to investigate the influence of start-up and stop phases on total annual emissions. Measured emission data from the pellet devices were used to build an emission model to predict the annual emission factors from the dynamic operation of the heating system using the simulation software TRNSYS. Start-up emissions are found to vary with ignition type, supply of air and fuel, and time to complete the phase. Stop emissions are influenced by fan operation characteristics and the cleaning routine. Start-up and stop phases under realistic operation conditions contribute 80 – 95% of annual carbon monoxide (CO) emission, 60 – 90% total hydrocarbon (TOC), 10 – 20% of nitrogen oxides (NO), and 30 – 40% particles emissions. Annual emission factors from realistic operation of tested residential heating system with a top fed wood pelt boiler can be between 190 and 400 mg/MJ for the CO emissions, between 60 and 95 mg/MJ for the NO, between 6 and 25 mg/MJ for the TOC, between 30 and 116 mg/MJ for the particulate matter and between 2x10-13 /MJ and 4x10-13 /MJ for the number of particles. If the boiler has the cleaning sequence with compressed air such as in boiler B2, annual CO emission factor can be up to 550 mg/MJ. Average CO, TOC and particles emissions under realistic annual condition were greater than the limits values of two eco labels. These results highlight the importance of start-up and stop phases in annual emission factors (especially CO and TOC). Since a large or dominating part of the annual emissions in real operation arise from the start-up and stop sequences, test methods required by the ecolabels should take these emissions into account. In this way it will encourage the boiler manufacturers to minimize annual emissions. The annual emissions of residential pellet heating system can be reduced by optimizing the number of start-ups of the pellet boiler. It is possible to reduce up to 85% of the number of start-ups by optimizing the system design and its controller such as switching of the boiler pump after it stops, using two temperature sensors for boiler ON/OFF control, optimizing of the positions of the connections to the storage tank, increasing the mixing valve temperature in the boiler circuit and decreasing the pump flow rate. For 85 % reduction of start-ups, 75 % of CO and TOC emission factors were reduced while 13% increase in NO and 15 % increase in particle emissions was observed.

Detecção de anticorpos contra o vírus da diarréia viral bovina no soro sangüíneo, no leite individual e no leite de conjunto em tanque de expansão de rebanhos não vacinados

Pela pesquisa de anticorpos contra o vírus da diarréia viral bovina (BVD), utilizando o teste de ELISA indireto, foi estudada a correlação existente entre a proporção de vacas lactantes e a presença de anticorpos no leite de conjunto do tanque de expansão. Para isso foram analisadas amostras de soro sangüíneo e de leite individual de 376 vacas lactantes não vacinadas, provenientes de 10 propriedades localizadas nas regiões Sul do Estado de Minas Gerais e Nordeste do Estado de São Paulo, assim como uma amostra do leite do tanque de expansão de cada rebanho. em todas as propriedades foram encontradas vacas reagentes no soro sangüíneo, cuja freqüência variou de 12,28 a 100,00%. Já a análise do leite individual não revelou animais reagentes em duas propriedades, e nas demais a freqüência variou de 5,26 a 70,83%. Foram detectados anticorpos no leite do tanque de expansão das propriedades cuja proporção de soros sangüíneos reagentes foi igual a ou maior que 82,86%, e cuja proporção de leites individuais reagentes foi igual a ou maior que 32,14%.

Continuous ethanol production in a nonconventional five-stage system operating with yeast cell recycling at elevated temperatures

Three ranges of increasing temperatures (35-43, 37-45, 39-47degreesC) were sequentially applied to a five-stage system continuously operated with cell recycling so that differences of 2degreesC (between one reactor to the next) and 8degreesC (between the first reactor at the highest temperature and the fifth at the lowest temperature) were kept among the reactors for each temperature range. The entire system was fed through the first reactor. The lowest values of biomass and viability were obtained for reactor R-3 located in the middle of the system. The highest yield of biomass was obtained in the effluent when the system was operated at 35-43degreesC. This nonconventional system was set up to simulate the local fluctuations in temperature and nutrient concentrations that occur in different regions of the medium in an industrial bioreactor for fuel ethanol production mainly in tropical climates. Minimized cell death and continuous sugar utilization were observed at temperatures normally considered too high for Saccharomyces cerevisiae fermentations.

A continuously differentiable upwinding scheme for the simulation of fluid flow problems

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Continuously deformable topological structure

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Hydrodynamic characterization and performance evaluation of an aerobic three phase airlift fluidized bed reactor in a recirculation aquaculture system for Nile Tilapia production

The hydrodynamic characterization and the performance evaluation of an aerobic three phase fluidized bed reactor in wastewater fish culture treatment are presented in this report. The objective of this study was to evaluate the organic matter, nitrogen and phosphorous removal efficiency in a physical and biological wastewater treatment system of an intensive Nile Tilapia laboratory production with recirculation. The treatment system comprised of a conventional sedimentation basin operated at a hydraulic detention time HDT of 2.94 h and an aerobic three phase airlift fluidized bed reactor AAFBR operated at an 11.9 min HDT. Granular activated carbon was used as support media with density of 1.64 g/cm(3) and effective size of 0.34 mm in an 80 g/L constant concentration. Mean removal efficiencies of BOD, COD, phosphorous, total ammonia nitrogen and total nitrogen were 47%, 77%, 38%, 27% and 24%, respectively. The evaluated system proved an effective alternative for water reuse in the recirculation system capable of maintaining water quality characteristics within the recommended values for fish farming and met the Brazilian standards for final effluent discharges with exception of phosphorous values. (C) 2011 Elsevier B.V. All rights reserved.

Molecular identification and thermoresistance to boiling of Nocardia farcinica and Nocardia cyriacigeorgica from bovine bulk tank milk

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Nitrogen fluxes from treefrogs to tank epiphytic bromeliads: an isotopic and physiological approach

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Remarks on Parametric Surface Waves in a Nonlinear and Non-Ideally Excited Tank

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Hydrolysis of whey lactose by immobilized β-Galactosidase

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Modelling and optimization of the cephalosporin C production bioprocess in a fed-batch bioreactor with invert sugar as substrate

Cephalosporin C production process optimization was studied based on four experiments carried out in an agitated and aerated tank fermenter operated as a fed-batch reactor. The microorganism Cephalosporium acremonium ATCC 48272 (C-10) was cultivated in a synthetic medium containing glucose as major carbon and energy source. The additional medium contained a hydrolyzed sucrose solution as the main carbon and energy source and it was added after the glucose depletion. By manipulating the supplementary feed rate, it was possible to increase antibiotic production. A mathematical model to represent the fed-batch production process was developed. It was observed that the model was applicable under different operation conditions, showing that optimization studies can be made based on this model. (C) 1999 Elsevier B.V. Ltd. All rights reserved.

Association of two new Coryphasia species (Araneae, Salticidae) with tank-bromeliads in southeastern Brazil: Habitats and patterns of host plant use

Two allopatric species of Coryphasia (Araneae: Salticidae), both described for the first time in this study, have been found associated with Bromeliaceae in distinct phytophysiognomies (e.g., inselbergs, highland forests and restingas) from southeastern Brazil. In this study, we investigated whether these salticids were associated specifically with bromeliads, and whether they used bromeliads of different species and sizes in distinct geographic regions. The Coryphasia species were rarely found outside bromeliads, occupied larger bromeliad species among those available, and were generally more frequent on bromeliads in open areas, such as inselbergs on mountain tops. The two Coophasia species were observed submerging in phytotelmata, possibly as an anti-predatory behavior. The patterns of spatial and microspatial distribution and the submergence behavior of these species were similar to those of other bromeliad-dwelling salticids, which suggests a convergence among spiders that live on bromeliads.

Combination of nickel and titanium complexes containing nitrogen ligands as catalyst for polyethylene reactor blending

Ethylene was polymerized using a combination of Ni(diimine)Cl-2 (1) (diimine = 1,4-bis(2,6-di-isopropylphenyl)-acenaphthenediimine) and {Tp(Ms)*} TiCl3 (2) (Tp(Ms)* = hydridobis(3-mesitylpyrazol-1-yl)(5-mesityl-pyrazol-1-yl)) compounds in the presence of methyl-aluminoxane (MAO) at 30 degrees C. The productivity reaches a maximum at X-Ni = 0.75 (1400 kg of PE/mol[M] . h), and the produced polyethylene (PE) showed maximal melt flow index (0.13 g/10 min) and minimal intrinsic viscosity (2.24 dL/g) compared to polyethylenes obtained with different values of nickel loading fractions (X-Ni). Productivity intrinsic viscosity data, as well as melt flow index measurements markedly depend upon the content of the late transition metal, thus suggesting a synergic effect between nickel and titanium catalysts.

Characteristics of Dielectric Barrier Discharge Reactor for Material Treatment

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)