865 resultados para Agricultural Learning of Barbacena, MG
Resumo:
Magnesium complex hydrides as Mg 2FeH 6 are interesting phases for hydrogen storage in the solid state, mainly due to its high gravimetric and volumetric densities of H2. However, the synthesis of this hydride is not trivial because the intermetallic phase Mg2Fe does not exist and Mg and Fe are virtually immiscible under equilibrium conditions. In this study, we have systematically studied the influence of the most important processing parameters in reactive milling under hydrogen (RM) for Mg 2FeH 6 synthesis: milling time, ball-to-powder weight ratio (BPR), hydrogen pressure and type of mill. Low cost 2Mg-Fe mixtures were used as raw materials. An important control of the Mg 2FeH 6 direct synthesis by RM was attained. In optimized combinations of the processing parameters, very high proportions of the complex hydride could be obtained. © (2011) Trans Tech Publications.
Resumo:
Pós-graduação em Agronomia (Ciência do Solo) - FCAV
Resumo:
Pós-graduação em Agronomia (Ciência do Solo) - FCAV
Resumo:
Pós-graduação em Geociências e Meio Ambiente - IGCE
Resumo:
The tire inflation pressure, among other factors, determines the efficiency in which a tractor can exert traction. It was studied the effect of using two tire inflation pressures, 110.4 kPa in the front and rear wheels, 124.2 kPa in the front wheel and 138 kPa in the rear wheels, the energetic efficiency of an agricultural tractor of 147 kW of engine power, in the displacement speed of 6.0 km.h-1, on track with firm surface, with the tractor engine speed of 2000 rpm. For each condition of the tire pressure, the tested tractor was subjected to constant forces in the drawbar of 45 kN and 50 kN, covering 30 meters. It was used a randomized complete block with a 2x2 factorial arrangement (tire pressure and drawbar power) with four replications, totaling 16 experimental units. Data were subjected to analysis of variance, using the Tukey test at 5% probability for comparison averages. The lowest hourly and specific fuel consumption, the lowest slippage of the wheelsets and the highest efficiency in the drawbar was obtained with the tire inflation pressure of 110.4 kPa in the front and rear tires of the tractor, highlighting that lower pressures improve energetic and operational performance of the tractor.
Resumo:
Agrochemicals on crop cultivated areas is a source of contamination for bees and may cause physiological and behavioral disorders and mortality. The LD50 of the pesticides fipronil and imidacloprid was determined and their effect on the learning behavior of Apis mellifera L. honeybee evaluated. LD50 was determined by the ingestion of contaminated food with different concentrations of insecticide concentrations: Fipronil (0, 0.8, 0.4, 0.2, 0.1 and 0.05 µg bee-1) and imidacloprid (0, 0.4, 0.2, 0.1, 0.05 and 0.025 µg bee-1). The method of proboscis extension reflection (PER) and learning through citral odor evaluated their responses to food stimulation. LD50 obtained were 0.28 ± 0.11 and 0.10 ± 0.04 µg bee-1 for fipronil and imidacloprid, respectively. The PER test showed no significant difference (p < 0.05) although agrochemicals affected the learning of bees. Insecticides fipronil and imidacloprid are extremely harmful to foraging Africanized Apis mellifera bees.
Resumo:
This work evaluated the quality of the fruit in peach and nectarine cultivars with and without the application of hydrogenated cyanamide and mineral oil, for two production cycles (2009 and 2010). The experiment was carried out at the School of Agricultural Science of the São Paulo State University (UNESP), at Botucatu in the Brazilian state of São Paulo, located at latitude 22º51'55 S and longitude 48º26'22 E, at an altitude of 810 m. The predominant climate type is warm temperate (mesothermal) with rains in the summer and dry in the winter. The following were evaluated: soluble solids, titratable acidity, pH, ratio, firmness, vitamin C and pulp yield. The use of hydrogenated cyanamide and mineral oil had no effect on the quality attributes of the fruit, except for pH, where those fruits under application of the products showed higher values. The cultivars all had a pulp yield greater than 90%, with 'Tourmaline' showing the highest yield (96 %). The levels of vitamin C varied according to the cultivars, where 'Marli' (16.9 mg 100 g-1) and 'Dourado-2' (16.5 mg 100 g-1), stood out for having the highest levels.
Prevention of repeated episodes of type 2 reaction of leprosy with the use of thalidomide 100 mg/day
Resumo:
BACKGROUND: Leprosy can have its course interrupted by type 1 and 2 reactional episodes, the last named of erythema nodosum leprosum (ENL). Thalidomide has been the medication of choice for the control of ENL episodes since 1965. OBJECTIVES: These episodes can repeat and cause damages to the patient. In order to prevent these episodes, an extra dose of 100 mg/day thalidomide was used during six months, followed by a follow-up period of six more months after thalidomide discontinuation. METHODS: We included 42 patients with multibacillary (MB) leprosy who had episodes of ENL. They were male and female patients aged between 18 and 84 years. RESULTS: Of the 42 patients, 39 (92.85%) had the lepromatous form and three (7.15%) had the borderline form. We found that 100% of patients had no reactional episode during the use of the drug. During the follow-up period after thalidomide discontinuation, 33 (78.57%) patients had no reactional episode and nine (21.43%), all of them with the lepromatous form, had mild episodes, which were controlled using non-steroidal anti-inflammatory. There were no thalidomide-related side effects. CONCLUSION: A maintenance dose of 100 mg/day of thalidomide showed to be effective to prevent repeated type 2 reactional episodes of ENL.
Resumo:
Agricultural use of tannery sludge (TS) may increase risks to soils. Thus, composting is recognized as one of the most suitable alternatives for TS recycling. Field experiments were carried out to evaluate the effects of composted tannery sludge (CTS) on chromium (Cr), cadmium (Cd), nickel (Ni), and lead (Pb) accumulation in soil after 3 years. Soil samples were collected 60 days after CTS application. After 3 years, The CTS increased Cr and Ni content, while Cd and Pb contents decreased. The third year, Cr contents showed linear increases as CTS rates were applied. The application of CTS, after 3 years, in the 2.5, 5, and 10 Mg ha(-1) increased Cr significantly (140.7%, 159.7%, and 19%, respectively) and Ni (32%, 53%, and 43.8%, respectively) contents in the soil surface layer. This means that consecutive amendments of CTS increase Cr contents in the soil and plants.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
The present study aimed to evaluate the efficacy of fipronil (1 mg/kg) against three strains of ivermectin-resistant Rhipicephalus (Boophilus) microplus (R. (B.) microplus), naturally infesting cattle from different states of Brazil. Three rural properties with a history of macrocyclic lactones ineffectiveness against the cattle tick, and low frequency use of fipronil in the herd, were selected for the study. The animals were randomized according to the mean tick counts, performed on days 3, 2 and I, into three groups with 10 animals each: T01, control (saline solution); T02, subcutaneous ivermectin (0.63 mg/kg) and T03, topical fipronil (1 mg/kg). Treatment was performed on day 0. Counts of partially engorged female ticks were performed on days 3,7 and 14 post-treatment (DPT), and then every 7 days until the 49th DPT. In all three experiments, it was possible to diagnose resistance of R. (B.) microplus to ivermectin (0.63 mg/kg). The maximum efficacy (arithmetic mean) obtained for ivermectin was 64% in experiment II. On the other hand, the formulation containing fipronil (1 mg/kg) reached high efficacy values (>= 97%) in all three experiments. The results from all experiments in this study demonstrate the high efficacy of 1 mg/kg fipronil, administered pour-on in naturally infested cattle, against strains of R. (B.) microplus that are resistant to 630 mcg/kg ivermectin. (C) 2014 Elsevier B.V. All rights reserved.
Resumo:
The objective of this study was to evaluate the phytotoxicity of Solanum aculeatissimum Jacq. leaves ethanolic extract in seeds germination, development and fixation of Lactuca sativa seedlings. The same study also aimed to assess the mitotic index of lettuce roots meristematic cells, quantification of phenols and total flavonoids and triage by mean of phytochemical testing of the main secondary metabolites classes. Bioassays of germination, development of root and hypocotyl were carried out in Petri dishes using achenes of Lactuca sativa L. cv. 'Grand Rapids' (lettuce). Concomitantly, were evaluated the physico-chemical characteristics (pH, osmotic potential and electrical conductivity), mitotic index, quantification of total phenols and flavonoids and determination of phytochemical profile of the treatments extract. The results obtained in the bioassays demonstrate that the ethanol extract of S. aculeatissimuma presents phytotoxic potential in the development of lettuce seedlings, given that the concentration of 20 mg/ml showed greater inhibition (41% of germination). The extract contains significant amounts of antioxidants, total flavonoid and phenols, where the concentration 1000µg/mL showed higher values (86.50%). Furthermore, it was possible to observe the presence of compounds with allelopathic activity in the phytochemical screening test as coumarins, tannins, terpenes, flavonoids and alkaloids. Given the above it is clear that the ethanolic extract of S. aculeatissimum presents allelopathic substances with phytotoxic activity that can affect the germination and development of other plant species in their natural environment.
Resumo:
One approach to verify the adequacy of estimation methods of reference evapotranspiration is the comparison with the Penman-Monteith method, recommended by the United Nations of Food and Agriculture Organization - FAO, as the standard method for estimating ET0. This study aimed to compare methods for estimating ET0, Makkink (MK), Hargreaves (HG) and Solar Radiation (RS), with Penman-Monteith (PM). For this purpose, we used daily data of global solar radiation, air temperature, relative humidity and wind speed for the year 2010, obtained through the automatic meteorological station, with latitude 18° 91' 66 S, longitude 48° 25' 05 W and altitude of 869m, at the National Institute of Meteorology situated in the Campus of Federal University of Uberlandia - MG, Brazil. Analysis of results for the period were carried out in daily basis, using regression analysis and considering the linear model y = ax, where the dependent variable was the method of Penman-Monteith and the independent, the estimation of ET0 by evaluated methods. Methodology was used to check the influence of standard deviation of daily ET0 in comparison of methods. The evaluation indicated that methods of Solar Radiation and Penman-Monteith cannot be compared, yet the method of Hargreaves indicates the most efficient adjustment to estimate ETo.
Resumo:
Morphology and deformation mechanisms and tensile properties of tetrafunctional multigraft (MG) polystrene-g-polyisoprene (PS-g-PI) copolymers were investigated dependent on PS volume fraction and number of branch points. The combination of various methods such as TEM, real time synchrotron SAXS, rheo-optical FTIR, and tensile tests provides comprehensive information at different dimension levels.TEMand SAXS studies revealed that the number of branch points has no obvious influence on the microphase-separated morphology of tetrafunction MG copolymers with 16 wt % PS. But for tetrafunctional MG copolymers with 25 wt % PS, the size and integrity of PS microdomains decrease with increasing number of branch point. The deformation mechanisms ofMGcopolymers are highly related to the morphology. Dependent on the microphase-separated morphology and integrity of the PS phase, the strain-induced orientation of the PS phase is at different size scales. Polarized FT-IR spectra analysis reveals that, for all investigated MG copolymers, the PI phase shows strain-induced orientation along SD at molecular scale. The proportion of the PI block effectively bridging PS domains controls the tensile properties of the MGcopolymers at high strain, while the stress-strain behavior in the low-mediate strain region is controlled by the continuity of PS microdomains. The special molecular architecture, which leads to the higher effective functionality of PS domains and the higher possibility for an individual PI backbone being tethered with a large number of PS domains, is proposed to be the origin of the superelasticity for MG copolymers.
Resumo:
This report shows an unexpected toxicity decrease during atrazine photoelectrodegradation in the presence of NaCl. Atrazine is a pesticide classified as endocrine disruptor occurring in industrial effluents and agricultural wastewaters. We therefore studied the effects of the degradation method, electrochemical and electrochemical photo-assisted, and of the supporting electrolyte, NaCl and Na2SO4, on the residual toxicity of treated atrazine solutions. We also studied the toxicity of treated atrazine solutions using Results show that at initial concentration of 20 mg L-1, atrazine was completely removed in up to 30 min using 10 mA cm(-2) electrolysis in NaCl medium, regardless of the electrochemical method used. The total organic carbon removal by the photo-assisted method was 82% with NaCl and 95% with Na2SO4. The solution toxicity increased during sole electrochemical treatment in NaCl, as expected. However, the toxicity unexpectedly decreased using the photo-assisted method. This finding is a major discovery because electrochemical treatment with NaCl usually leads to the formation of toxic chlorine-containing organic degradation by-products.