Epitaxial strain and electric boundary condition effects on the structural and ferroelectric properties of BiFeO3 films

The influence of both compressive and tensile epitaxial strain along with the electrical boundary conditions on the ferroelastic and ferroelectric domain patterns of bismuth ferrite films was studied. BiFeO3 films were grown on SrTiO3(001), DyScO3(110), GdScO3(110), and SmScO3(110) substrates to investigate the effect of room temperature in-plane strain ranging from -1.4% to +0.75%. Piezoresponse force microscopy, transmission electron microscopy, x-ray diffraction measurements, and ferroelectric polarization measurements were performed to study the properties of the films. We show that BiFeO3 films with and without SrRuO3 bottom electrode have different growth mechanisms and that in both cases reduction of the domain variants is possible. Without SrRuO3, stripe domains with reduced variants are formed on all rare earth scandate substrates because of their monoclinic symmetry. In addition, tensile strained films exhibit a rotation of the unit cell with increasing film thickness. On the other side, the presence of SrRuO3 promotes step flow growth of BiFeO3. In case of vicinal SrTiO3 and DyScO3 substrates with high quality SrRuO3 bottom electrode and a low miscut angle of approximate to 0.15 degrees we observed suppression of the formation of certain domain variants. The quite large in-plane misfit of SrRuO3 with GdScO3 and SmScO3 prevents the growth of high quality SrRuO3 films and subsequent domain variants reduction in BiFeO3 on these substrates, when SrRuO3 is used as a bottom electrode.

Effect of offset web holes on web crippling strength of cold-formed steel channel sections under end-two-flange loading condition

A combination of experiments and non-linear finite element analyses are used to investigate the effect of offset web holes on the web crippling strength of cold-formed steel channel sections under the end-two-flange (ETF) loading condition; the cases of both flanges fastened and unfastened to the support are considered. The web holes are located at the mid-depth of the sections, with a horizontal clear distance of the web holes to the near edge of the bearing plate. Finite element analysis results are compared against the laboratory test results; good agreement was obtained in terms of both strength and failure modes. A parametric study was then undertaken to investigate both the effect of the position of holes in the web and the cross-section sizes on the web crippling strength of the channel sections. It was demonstrated that the main factors influencing the web crippling strength are the ratio of the hole depth to the depth of the web, and the ratio of the distance from the edge of the bearing to the flat depth of the web. Design recommendations in the form of web crippling strength reduction factors are proposed in this study.

Cosmopolitanism as the existential condition of humanity

Cosmopolitanism as the existential condition of humanity refers to the view that human beings are both transcendent and social. This is argued through another pair of concepts, commonality and difference. If humans are moral, it is because they recognise each other as sharing a basic ontology. But this morality is expressed in the sort of regard that separates ‘me’ from ‘you’. Two aspects of difference are elaborated: foreignness feared as alien but also found in oneself, and alterity as irreducibly other. How can these differences keep us both individual and social?

On the Condition Number Distribution of Complex Wishart Matrices

This paper investigates the distribution of the condition number of complex Wishart matrices. Two closely related measures are considered: the standard condition number (SCN) and the Demmel condition number (DCN), both of which have important applications in the context of multiple-input multipleoutput (MIMO) communication systems, as well as in various branches of mathematics. We first present a novel generic framework for the SCN distribution which accounts for both central and non-central Wishart matrices of arbitrary dimension. This result is a simple unified expression which involves only a single scalar integral, and therefore allows for fast and efficient computation. For the case of dual Wishart matrices, we derive new exact polynomial expressions for both the SCN and DCN distributions. We also formulate a new closed-form expression for the tail SCN distribution which applies for correlated central Wishart matrices of arbitrary dimension and demonstrates an interesting connection to the maximum eigenvalue moments of Wishart matrices of smaller dimension. Based on our analytical results, we gain valuable insights into the statistical behavior of the channel conditioning for various MIMO fading scenarios, such as uncorrelated/semi-correlated Rayleigh fading and Ricean fading. © 2010 IEEE.

Familial hypocalciuric hypercalcaemia as a differential diagnosis of hyperparathyroidism:studies in a large kindred and a review of surgical experience in the condition

We have studied 46 members of a large kindred with familial hypocalciuric hypercalcaemia (FHH) after a neck exploration failed to cure hypercalcaemia in an asymptomatic patient. Serum calcium, serum phosphate, plasma parathormone and vitamin D metabolites do not distinguish affected members from patients with hyperparathyroidism. Because of the continuing debate as to whether or not FHH is a variant of, or distinct from, hyperparathyroidism, we have carried out a review of surgical experience with subtotal parathyroidectomy in hyperparathyroidism secondary to parathyroid hyperplasia and in FHH. Whereas the procedure is successful in 90 per cent of the former cases only one case of FHH has been cured by it. This provides evidence for the two conditions being aetiologically distinct. Before patients with asymptomatic hypercalcaemia are referred for parathyroid surgery the calcium:creatinine clearance ratio should be measured using a 2 h urine sample collected after an overnight fast and a fasting blood sample. If this ratio is less than 0.01 then screening of first degree relations should be undertaken before any parathyroid surgery is performed. Unnecessary surgery can therefore be avoided.

Survival in dialysis patients is different between patients with diabetes as primary renal disease and patients with diabetes as a co-morbid condition.

AIMS/HYPOTHESIS:

A previous study in Dutch dialysis patients showed no survival difference between patients with diabetes as primary renal disease and those with diabetes as a co-morbid condition. As this was not in line with our hypothesis, we aimed to verify these results in a larger international cohort of dialysis patients.

METHODS:

For the present prospective study, we used data from the European Renal Association-European Dialysis and Transplant Association (ERA-EDTA) Registry. Incident dialysis patients with data on co-morbidities (n?=?15,419) were monitored until kidney transplantation, death or end of the study period (5 years). Cox regression was performed to compare survival for patients with diabetes as primary renal disease, patients with diabetes as a co-morbid condition and non-diabetic patients.

RESULTS:

Of the study population, 3,624 patients (24%) had diabetes as primary renal disease and 1,193 (11%) had diabetes as a co-morbid condition whereas the majority had no diabetes (n?=?10,602). During follow-up, 7,584 (49%) patients died. In both groups of diabetic patients mortality was higher compared with the non-diabetic patients. Mortality was higher in patients with diabetes as primary renal disease than in patients with diabetes as a co-morbid condition, adjusted for age, sex, country and malignancy (HR 1.20, 95% CI 1.10, 1.30). An analysis stratified by dialysis modality yielded similar results.

CONCLUSIONS/INTERPRETATION:

Overall mortality was significantly higher in patients with diabetes as primary renal disease compared with those with diabetes as a co-morbid condition. This suggests that survival in diabetic dialysis patients is affected by the extent to which diabetes has induced organ damage.

Condition Assessment and Preservation of Open-Air Rock Art Panels During Climate Change

Thousands of Neolithic and Bronze Age open-air rock art panels exist across the countryside in northern England. However, desecration, pollution, and other factors are threatening the survival of these iconic stone monuments. Evidence suggest that rates of panel deterioration may be increasing, although it is not clear whether this is due to local factors or wider environmental influences accelerated by environmental change. To examine this question, 18 rock art panels with varied art motifs were studied at two major panel locations at Lordenshaw and Weetwood Moor in Northumberland. A condition assessment
tool was used to first quantify the level of deterioration of each panel (called “staging”). Stage estimates then were compared statistically with 27 geochemical and physical descriptors of local environments, such as soil moisture, salinity, pH, lichen coverage, soil anions and cation levels, and panel orientation, slope, and standing height. In parallel, climate modelling was performed using UKCP09 to assess how projected climatic conditions (to 2099) might affect the environmental descriptors most correlated with elevated stone deterioration. Only two descriptors significantly correlated (P < 0.05) with increased stage: the standing height of the panel and the exchangeable cation content of the local soils, although moisture conditions also were potentially influential at some panels. Climate modelling predicts warming temperatures, more seasonally variable precipitation, and increased wind speeds, which hint stone deterioration could accelerate in the future due to increased physiochemical weathering. We recommend key panels be targeted for immediate management intervention, focusing on reducing wind exposures, improving site drainage, and potentially immobilizing soil salts.

Stone-built heritage inventory and ‘performance in use’ condition assessment of stonework

An academic–industrial partnership was formed with the aim of constructing a natural stone database for Northern Ireland that could be used by the public and practitioners to understand both the characteristics of the stone used in construction across Northern Ireland and how it has performed in use, and, through a linked database of historical quarries, explore the potential for obtaining locally sourced replacement stone. The aims were to improve the level of conservation specification by those with a duty of care for historical structures, and to enhance the quality of the conservation work undertaken by archi- tects and contractors through their improved knowledge of stone and stone decay processes.

Investigation of moisture condition and Autoclam sensitivity on air permeability measurements for both normal concrete and high performance concrete

While on site measurement of air permeability provides a useful approach for assessing the likely long term durability of concrete structures, no existing test method is capable of effectively determining the relative permeability of high performance concrete (HPC). Lack of instrument sensitivity and the influence of concrete moisture are proposed as two key reasons for this phenomenon. With limited systematic research carried out in this area to date, the aim if this study was to investigate the influence of instrument sensitivity and moisture condition on air permeability measurements for both normal concrete and HPC. To achieve a range of moisture conditions, samples were dried initially for between one and 5 weeks and then sealed in polythene sheeting and stored in an oven at 50 C to internally distribute moisture evenly. Moisture distribution was determined throughout using relative humidity probe and electrical resistance measurements. Concrete air permeability was subsequently measured using standardised air permeability (Autoclam) and water penetration (BS EN: 12390-8) tests to assess differences between the HPCs tested in this study. It was found that for both normal and high performance concrete, the influence of moisture on Autoclam air permeability results could be eliminated by pre-drying (50 ± 1 C, RH 35%) specimens for 3 weeks. While drying for 5 weeks alone was found not to result in uniform internal moisture distributions, this state was achieved by exposing specimens to a further 3 weeks of sealed pre-conditioning at 50 ± 1 C. While the Autoclam test was not able to accurately identify relative HPC quality due to low sensitivity at associated performance levels, an effective preconditioning procedure to obtain reliable air permeability of HPC concretes was identified. © 2013 The Authors

Earthmoving trucks condition level prediction using neural networks

Purpose: The purpose of this paper is to present an artificial neural network (ANN) model that predicts earthmoving trucks condition level using simple predictors; the model’s performance is compared to the respective predictive accuracy of the statistical method of discriminant analysis (DA).

Design/methodology/approach: An ANN-based predictive model is developed. The condition level predictors selected are the capacity, age, kilometers travelled and maintenance level. The relevant data set was provided by two Greek construction companies and includes the characteristics of 126 earthmoving trucks.

Findings: Data processing identifies a particularly strong connection of kilometers travelled and maintenance level with the earthmoving trucks condition level. Moreover, the validation process reveals that the predictive efficiency of the proposed ANN model is very high. Similar findings emerge from the application of DA to the same data set using the same predictors.

Originality/value: Earthmoving trucks’ sound condition level prediction reduces downtime and its adverse impact on earthmoving duration and cost, while also enhancing the maintenance and replacement policies effectiveness. This research proves that a sound condition level prediction for earthmoving trucks is achievable through the utilization of easy to collect data and provides a comparative evaluation of the results of two widely applied predictive methods.