Life and death in a civitas capital: metabolic disease and trauma in the children from late Roman Dorchester, Dorset

The impact that “Romanization” and the development of urban centers had on the health of the Romano-British population is little understood. A re-examination of the skeletal remains of 364 nonadults from the civitas capital at Roman Dorchester (Durnovaria) in Dorset was carried out to measure the health of the children living in this small urban area. The cemetery population was divided into two groups; the first buried their dead organized within an east–west alignment with possible Christian-style graves, and the second with more varied “pagan” graves, aligned north–south. A higher prevalence of malnutrition and trauma was evident in the children from Dorchester than in any other published Romano-British group, with levels similar to those seen in postmedieval industrial communities. Cribra orbitalia was present in 38.5% of the children, with rickets and/or scurvy at 11.2%. Twelve children displayed fractures of the ribs, with 50% of cases associated with rickets and/or scurvy, suggesting that rib fractures should be considered during the diagnosis of these conditions. The high prevalence of anemia, rickets, and scurvy in the Poundbury children, and especially the infants, indicates that this community may have adopted child-rearing practices that involved fasting the newborn, a poor quality weaning diet, and swaddling, leading to general malnutrition and inadequate exposure to sunlight. The Pagan group showed no evidence of scurvy or rib fractures, indicating difference in religious and child-rearing practices but that both burial groups were equally susceptible to rickets and anemia suggests a shared poor standard of living in this urban environment.

Goal sketching and the business case

This paper describes how the business case can be characterized and used to quickly make an initial and structurally complete goal-responsibility model. This eases the problem of bringing disciplined support to key decision makers in a development project in such a way that it can be instantiated quickly and thereafter support all key decision gateways. This process also greatly improves the understanding shared by the key decision makers and helps to identify and manage load-bearing assumptions.

Effectiveness of landmark analysis for establishing locality in p2p networks

Locality to other nodes on a peer-to-peer overlay network can be established by means of a set of landmarks shared among the participating nodes. Each node independently collects a set of latency measures to landmark nodes, which are used as a multi-dimensional feature vector. Each peer node uses the feature vector to generate a unique scalar index which is correlated to its topological locality. A popular dimensionality reduction technique is the space filling Hilbert’s curve, as it possesses good locality preserving properties. However, there exists little comparison between Hilbert’s curve and other techniques for dimensionality reduction. This work carries out a quantitative analysis of their properties. Linear and non-linear techniques for scaling the landmark vectors to a single dimension are investigated. Hilbert’s curve, Sammon’s mapping and Principal Component Analysis have been used to generate a 1d space with locality preserving properties. This work provides empirical evidence to support the use of Hilbert’s curve in the context of locality preservation when generating peer identifiers by means of landmark vector analysis. A comparative analysis is carried out with an artificial 2d network model and with a realistic network topology model with a typical power-law distribution of node connectivity in the Internet. Nearest neighbour analysis confirms Hilbert’s curve to be very effective in both artificial and realistic network topologies. Nevertheless, the results in the realistic network model show that there is scope for improvements and better techniques to preserve locality information are required.

Active networks: an evolution of the internet

Active Networks can be seen as an evolution of the classical model of packet-switched networks. The traditional and ”passive” network model is based on a static definition of the network node behaviour. Active Networks propose an “active” model where the intermediate nodes (switches and routers) can load and execute user code contained in the data units (packets). Active Networks are a programmable network model, where bandwidth and computation are both considered shared network resources. This approach opens up new interesting research fields. This paper gives a short introduction of Active Networks, discusses the advantages they introduce and presents the research advances in this field.

Design for design: support for creative practice in computer-supported collaborative work (CSCW) in design

This paper describes a novel methodology for observing and analysing collaborative design by using the concepts of cognitive dimensions related to concept-based misfit analysis. The study aims at gaining an insight into support for creative practice of graphical communication in collaborative design processes of designers while sketching within a shared white board and audio conferencing environment. Empirical data on design processes have been obtained from observation of groups of student designers solving an interior space-planning problem of a lounge-diner in a shared virtual environment. The results of the study provide recommendations for the design and development of interactive systems to support such collaborative design activities.

From activity to active learning: drawing and dialogue interaction in virtual learning environments for computer-supported collaborative work in design.

Virtual learning environments (VLEs) would appear to be particular effective in computer-supported collaborative work (CSCW) for active learning. Most research studies looking at computer-supported collaborative design have focused on either synchronous or asynchronous modes of communication, but near-synchronous working has received relatively little attention. Yet it could be argued that near-synchronous communication encourages creative, rhetorical and critical exchanges of ideas, building on each other’s contributions. Furthermore, although many researchers have carried out studies on collaborative design protocol, argumentation and constructive interaction, little is known about the interaction between drawing and dialogue in near-synchronous collaborative design. The paper reports the first stage of an investigation into the requirements for the design and development of interactive systems to support the learning of collaborative design activities. The aim of the study is to understand the collaborative design processes while sketching in a shared white board and audio conferencing media. Empirical data on design processes have been obtained from observation of seven sessions with groups of design students solving an interior space-planning problem of a lounge-diner in a virtual learning environment, Lyceum, an in-house software developed by the Open University to support its students in collaborative learning.

Sequence-selective assembly of tweezer-molecules on linear templates enables frameshift-reading of sequence information

Monomer-sequence information in synthetic copolyimides can be recognised by tweezer-type molecules binding to adjacent triplet-sequences on the polymer chains. In the present paper different tweezer-molecules are found to have different sequence-selectivities, as demonstrated in solution by 1H NMR spectroscopy and in the solid state by single crystal X-ray analyses of tweezer-complexes with linear and macrocyclic oligo-imides. This work provides clear-cut confirmation of polyimide chain-folding and adjacent-tweezer-binding. It also reveals a new and entirely unexpected mechanism for sequence-recognition which, by analogy with a related process in biomolecular information processing, may be termed "frameshift-reading". The ability of one particular tweezer-molecule to detect, with exceptionally high sensitivity, long-range sequence-information in chain-folding aromatic copolyimides, is readily explained by this novel process.

Goal sketching from a concise business case

This paper describes how the business case can be characterized and used to quickly make an initial and structurally complete goal-responsibility model. This eases the task of bringing disciplined support to key decision makers in a development project in such a way that it can be instantiated quickly and thereafter support all key decisions. This process also greatly improves the understanding shared by the key decision makers and helps to identify and manage loadbearing assumptions. Recent research has revealed two interesting issues, which are highlighted in this paper.

The seventh colloquium on high resolution molecular spectroscopy

This conference, held 14-18 September 1981, addressed many aspects of high resolution molecular spectroscopy. Measurement techniques for remotely identifying trace gases in the atmosphere were discussed. Instrumentation for highly accurate and precise measurement of molecular emissions were described. The objective of the colloquium was to bring together molecular spectroscopists working in different regions of the electromagnetic spectrum from the ultraviolet to radio frequencies. These scientists shared a common interest in high resolution gas phase spectra and their analyses. The objective was met through the presentation of about 20 invited papers and many more contributed papers.

Speciation in fig wasps

There are over 700 species of fig trees in the tropics and several thousand species of fig wasps are associated with their syconia (inflorescences). These wasps comprise a monophyletic family of fig pollinators and several diverse lineages of non-pollinating wasps. The pollinator larvae gall fig flowers, while larvae of non-pollinating species either initiate their own galls or parasitise the galls of other wasps. A single fig species has 1-4 pollinator species and also hosts up to 30 non-pollinating wasp species. Most wasps show a high degree of host plant specificity and are known from only a single fig species. However, in some cases wasps may be shared across closely related fig species. There is impressive morphological coevolution between figs and fig wasps and this, combined with a high degree of partner specificity, led to the expectation that figs and pollinators have cospeciated extensively. Comparison of deep phylogenies supports long-term codivergence of figs and pollinators, but also suggests that some host shifts have occurred. Phylogenies of more closely related species do not match perfectly and may even be incongruent, suggesting significant roles for processes other than strict cospeciation. Combined with recent evidence on host specificity patterns, this suggests that pollinator wasps may often speciate by host shifts between closely related figs, or by duplication (the wasp speciates but the fig doesn't). The frequencies and biological details of these different modes of speciation invite further study. Far less is known about speciation in non-pollinating fig wasps. Some lineages have probably coevolved with figs and pollinators for most of the evolutionary history of the symbiosis, while others appear to be more recent colonisers. Many species appear to be highly host plant specific, but those that lay eggs through the fig wall without entering the syconium (the majority of species) may be subject to fewer constraints on host-shifting than pollinators. There is evidence for substantial host shifting in at least one gens, but also evidence for ecological speciation on the same host plant by niche shifts in other cases. Finally, recent work has begun to address the issue of “community phylogeny” and provided evidence for long-term co-divergence of multiple pollinating and non-pollinating wasp lineages with their host figs.