A model for nonlinear viscoelastic mechanical responses of collagenous soft tissues

Experimental observations of the time-dependent mechanical responses of collagenous tissues have demonstrated behavior that deviates from standard treatments of linear or quasi-linear viscoelasticity. In particular, time-dependent deformation can be strongly coupled to strain level, and strain-rate independence can be observed under monotonic loading, even for a tissue with dramatic stress relaxation. It was postulated that this nonlinearity is fundamentally associated with gradual recruitment of individual collagen fibrils during applied mechanical loading. Based on previously observed experimental results for the time-dependent response of collagenous soft tissues, a model is developed to describe the mechanical behavior of these tissues under uniaxial loading. Tissue stresses, under applied strain-controlled loading, are assumed to be a sum of elastic and viscoelastic stress contributions. The relative contributions of elastic and viscoelastic stresses is assumed to vary with strain level, leading to strain- and time-dependent mechanical behavior. The model formulation is examined under conditions of monotonic loading at varying constant strain rates and stress-relaxation at different applied strain levels. The model is compared with experimental data for a membranous biological soft tissue, the amniotic sac, and is found to agree well with experimental results. The limiting behavior of the novel model, at large strains relative to the collagen recruitment, is consistent with the quasi-linear viscoelastic approach. © 2006 Materials Research Society.

Soft turn-on of NPT IGBT under Active Voltage Control

In this paper the soft turn-on of NPT IGBT under Active Voltage Control (AVC) is presented. The AVC technique is able to control the IGBT switching trajectory according to a pre-defined reference signal generated by a FPGA chip. By applying a special designed reference signal at turn-on, the IGBT turn-on current overshoot and diode recovery can be optimized. Experiments of soft turn-on with different reference signal are presented in this paper. This technique can be used to reduce the switching stress on the device and on other components of the circuit. © 2011 IEEE.

Geotechnical observations of construction OF A large shallow SCL tunnel in soft ground

The Fort Canning Tunnel is the first road tunnel in Singapore to be built using the sprayed concrete lining (SCL) method. The major technical challenge of this was to construct a 15m wide tunnel by mining in soft ground under a shallow overburden of 3m to 9m. This paper describes the geotechnical investigations and monitoring controls for the safe and progressive execution of the works, such as soil investigations, trial forepoling works, surface settlement monitoring, tunnel settlement monitoring, face movement monitoring, and the observational approach to construction. The monitored field data showed the volume loss to range from 0.4% to 2.1%, and the observed surface settlement trough was found to agree well with the theoretical Gaussian trough. Other observations made include substantial surface settlements induced by the stress relief at and ahead of the tunnel face in spite of the forepoling umbrella, and the higher volume losses associated with higher overburden. Tunnel face movements were observed during installation of forepoling. These observations are of interest to engineers planning future SCL tunnels in similar conditions.

The zonation of soft-bottom sediments in Gorgan Bay (Caspian Sea) using macrobenthos as indicator of ecological health

In this study, in order to assess the ecological health status and zoning of soft bottom of Gorgan Bay, the spatial and temporal distribution of macrofauna and their relationship with environmental stress were investigated. Sediment samples were collected using a Van Veen grab at 22 sampling points, seasonally during 2012-2013. The averages (±SD) of the percentages of sand, silt, clay and TOM (Total Organic Matter) in the sediment samples were determined (44.4± 15, 53.4 ± 14, and 2.2 ±2.2 and 7.2% ± 1.6, respectively). Our results showed that mean (range) of Al, As, Cu, Fe, Ni, Pb and Zn in the sediment samples were 1.2 % (0.4-2.1), 4.8 (2.5- 10.3) ppm, 10.5 (4.4-16.9) ppm, 1 (0.4 – 1.6) % , 13.6 (6.2-21.5) ppm, 9.1 (4.7-12.9) ppm and 23.9 (3.1-39.4) ppm, respectively. In spring, both Al and Ni were higher than the guideline level. In the event that arsenic was exceeds the guidelines in summer. In this study, 14 species of macrofauna from 12 families were identified. Polychaeta with 3 species was the most dominant group in terms of abundance. The four most abundant taxa making up 85% of all specimens (Streblospio gynobranchiata, Tubificidae, Hediste versicolor and Abra segmentum). The western area were characterized by the higher species diversity (H', 1.94). So Gorgan Bay presents transitional macrobenthic assemblages that are spatially distributed along substrate gradients .The mean of Shannon index, BENTIX, BO2A, AMBI and M-AMBI in the bay was 1.3, 2.2, 0.4, 3.2 and 0.65 respectively. According to the results of these indices, ecological status of the western part of the bay assessed better than the other parts. According to the results of the nmMDS (non-metric Multidimensional Scaling), PCA (Principal Components Analysis), the map of distribution of heavy metals and the map of the ecological status , it seems Gorgan Bay is divided into two separate zones (the eastern and the western parts).M-AMBI finaly introduced reliable index for assessing the ecological status of the Bay.

Effects of hydrocarbons on reproductive physiology of the pearl oyster, Pinctada fucata

There are a lot of evidence that show hvdrocarbones cause some defect in reproduction and growth of bivalves. Bivalves are filter-feeder, thus accumulate more hydrocarbones in their tissue. In this study adult pearl producing oysters (Pinctada fucata) are used for all experimens. Samples of oysters, water and sediment from four natural beds; Nakhiloo (clean), Hendurabi (semipolluted), Lavan 1 (semipolluted) and Lavan 2 (polluted) were gatherd for 13 succesive months. Temperature, salinity, pH, oxygen and turbidity were recorded in each sampling. Oysters were kept in laboratory for adapation and then their length (DVM) were measured. Hemolymph samples were collected by insuline syring. Sediments and soft tissues of oysters were dissolved in carbon tetrachloride and when heated to extract oil hydrocarbones. UV, GC and IR were used to assay oil hydrocarbones. Accumulation of hydrocabones in soft tissue were as follows : Kakhiloo

Soft-lithographic processed soluble micropatterns of reduced graphene oxide for wafer-scale thin film transistors and gas sensors

PDMS based imprinting is firstly developed for patterning of rGO on a large area. High quality stripe and square shaped rGO patterns are obtained and the electrical properties of the rGO film can be adjusted by the concentration of GO suspension. The arrays of rGO electronics are fabricated from the patterned film by a simple shadow mask method. Gas sensors, which are based on these rGO electronics, show high sensitivity and recyclable usage in sensing NH 3. © 2012 The Royal Society of Chemistry.

Faecal pellets in deep marine soft clay crusts: Implications for hot-oil pipeline design

In recent years, the presence of crusts within near surface sediments found in deep water locations off the west coast of Angola has been of interest to hot-oil pipeline designers. The origin for these crusts is considered to be of biological origin, based on the observation of thousands of faecal pellets in natural crust core samples. This paper presents the results of laboratory tests undertaken on natural and faecal pellet-only samples. These tests investigate the role faecal pellets play in modifying the gemechanical behaviour of clayey sediments. It is found that faecal pellets are able to significantly alter both the strength and the average grain-size of natural sediments, and therefore, influence the permeability and stiffness. Hot-oil pipelines self-embed into and subsequent shear on crusts containing faecal pellets. Being able to predict the time required for installed pipelines to consolidate the underlying sediment and thus, how soon after pipe-laying, the interface strength will develop is of great interest to pipeline designers. It is concluded from wet-sieving samples before and after oedometer tests, that the process of pipe laying is unlikely to destroy pellets. They will therefore, be a major constituent of the sediment subject to soil-pipeline shearing behaviour during axial pipe-walking and lateral buckling. Based on the presented results, a discussion highlighting the key implications for pipeline design is therefore provided. Copyright © 2011 by ASME.