Analysis of a circular patch antenna radiating in a parallel-plate radial guide

A field matching method is described to analyze a recessed circular cavity radiating into a radial waveguide. Using the wall impedance approach, the analysis is divided into two separate problems of the cavity and its external environment. Based on this analysis, a computer algorithm is developed for determining wall admittances as seen at the edge of the patch in the cavity, the radial admittance matrix for the two-probe feed arrangement, and the input impedance as observed from the coaxial line feeding the cavity. This algorithm is tested against the general-purpose Hewlett-Packard finite-element High Frequency Structure Simulator as well as against measured results. Good agreement in all considered cases is noted.

Interacting roles of myofibroblasts, apoptosis and fibrogenic growth factors in the pathogenesis of renal tubulo-interstitial fibrosis

The interrelationship between myofibroblasts and fibrogenic growth factors in the pathogenesis of renal fibrosis is poorly defined. A temporal and spatial analysis of myofibroblasts, their proliferation and death, and presence of transforming growth factor-beta1 (TGF-beta1) and platelet-derived growth factor-B (PDGF-B) was carried out in an established rodent model in which chronic renal scarring and fibrosis occurs after healed renal papillary necrosis (RPN), similar to that seen with analgesic nephropathy. Treated and control groups (N = 6 and 4, respectively) were compared at 2, 4, 8 and 12 weeks. A positive relationship was found between presence of tubulo-interstitial myofibroblasts and development of fibrosis. Apoptotic myofibroblasts were identified in the interstitium and their incidence peaked 2 weeks after treatment. Levels of interstitial cell apoptosis and fibrosis were negatively correlated over time (r = -0.57, p < 0.01 ), suggesting that as apoptosis progressively failed to limit myofibroblast numbers, fibrosis increased. In comparison with the diminishing apoptosis in the interstitium, the tubular epithelium had progressively increasing levels of apoptosis over time, indicative of developing atrophy of nephrons. TGF-beta1 protein expression had a close spatial and temporal association with fibrosis and myofibroblasts, whilst PDGF-B appeared to have a closer link with populations of other chronic inflammatory cells such as infiltrating lymphocytes. Peritubular myofibroblasts were often seen near apoptotic cells in the tubular epithelium, suggestive of a paracrine toxic effect of factor/s secreted by the myofibroblasts. In vitro , TGF-beta1 was found to be toxic to renal tubular epithelial cells. These findings suggest an interaction between myofibroblasts, their deletion by apoptosis, and the presence of the fibrogenic growth factor TGF-beta1 in renal fibrosis, whereby apoptotic deletion of myofibroblasts could act as a controlling factor in progression of fibrosis.

Investigations of growth processes in Y-Ba-Cu-O materials by microstructural examination of quenched samples

Y-Ba-Cu-O samples with additions of Y2O3 and CeO2 were quenched during seeded isothermal melt processing and examined by optical microscopy and scanning electron microscopy. Large YBa2Cu3O7-y (Y123) particles in the starting powder were found to form a distinct type of melt during heating, which was unaffected by the Y2O3 or CeO2 additives. This type of melt later formed regions with a low concentration of Y2BaCuO5 (Y211) particles in the Y123 matrix. The maximum growth rate of Y123 that could be sustained in the sample was found to be lower in the melt formed from large Y123 particles, and this may lead to growth accidents and subgrains in some samples.

Growth of subtropical ECM fungi with different nitrogen sources using a new floating culture technique

Eight species of ectomycorrhizal (ECM) fungi in the genera Amanita. Gymnoboletus, Lactarius, and Russula were isolated from subtropical plant communities in eastem Australia. Two species were isolated from each of rainforest, Nothofagus forest, Eucalyptus forest, and Eucalyptus dominated wallum (heath) forest. These communities differ strongly in their soluble soil nitrogen (N) composition. The ability of the fungi to use inorganic (nitrate, ammonium) and organic (amide, peptide, protein) nitrogen sources was determined. As the fungi did not grow in liquid culture, a 'floating culture' technique was devised that allows hyphal growth on a screen floating on liquid medium. With some exceptions, fungal biomass production in floating culture closely reflected fungal growth on solid media assessed by total colony glucosamine content. Most isolates grown in floating culture had similar glucosamine concentrations on all N sources, with isolate specific concentrations ranging from 6 to 12 mug glucosamine g(-1) DW. However, Russula spp. had up to 1.7-fold higher glucosamine concentrations when growing with glutamine or ammonium compared to nitrate, glutathione or protein. Floating cultures supplied with 0.5, 1.5. 4.5, or 10 mm N mostly produced greatest biomass with 4.5 mM N. In vitro nitrate reductase activity (NRA) ranged from very low (0.03 mumol NO2- g(-1) fw h(-1)) in Russula sp. (wallum) to high (2.16 mumol NO2- g(-1) fw h(-1)) in Gymnoboletus sp. (rainforest) and mirrored the fungi's ability to use nitrate as a N source. All Russula spp. (wallum, Nothofagus and Eucalyptus forests), Lactarills sp, (rainforest) and.4manita sp. (wallum) utilized ammonium and glutamine but had little ability to use other N sources. In contrast,Amanita species (Nothofagus and Eucalyptus forests) grew on all N sources but produced most biomass with ammonium and glutamine. Only Gymnoboletus sp. (rainforest) showed similar growth with nitrate and ammonium as N sources. Fungal N source use was not associated with taxonomic groups, but is discussed in the context of soil N sources in the different habitats.

Productivity growth in Australian manufacturing sector: some new evidence

This article examines the productivity performance of Australia's manufacturing sector by decomposing its output growth into input growth, technological progress and gains in technical efficiency. This three-way decomposition is done with an improved version of the stochastic frontier model using eight, two-digit industry level data from 1968/9 to 1994/5. Empirical evidence shows that input growth fueled output growth from 1968/9 to 1973/4, but since then, total factor productivity (TFP) growth has been the main contributor of output growth. While the trend of TFP growth was found to be promising for most industries with positive and increasing technological progress, the negative gains from technical efficiency over time is however cause for concern.

Development of a fully quantitative approach to the interpretation of stress echocardiography using radial and longitudinal myocardial velocities

Background: Tissue Doppler may be used to quantify regional left ventricular function but is limited by segmental variation of longitudinal velocity from base to apex and free to septal walls. We sought to overcome this by developing a composite of longitudinal and radial velocities. Methods and Results. We examined 82 unselected patients undergoing a standard dobutamine echocardiogram. Longitudinal velocity was obtained in the basal and mid segments of each wall using tissue Doppler in the apical views. Radial velocities were derived in the same segments using an automated border detection system and centerline method with regional chords grouped according to segment location and temporally averaged. In 25 patients at low probability of coronary disease, the pattern of regional variation in longitudinal velocity (higher in the septum) was the opposite of radial velocity (higher in the free wall) and the combination was homogenous. In 57 patients undergoing angiography, velocity in abnormal segments was less than normal segments using longitudinal (6.0 +/- 3.6 vs 9.0 +/- 2.2 cm/s, P = .01) and radial velocity (6.0 +/- 4.0 vs 8.0 +/- 3.9 cm/s, P = .02). However, the composite velocity permitted better separation of abnormal and normal segments (13.3 +/- 5.6 vs 17.5 +/- 4.2 cm/s, P = .001). There was no significant difference between the accuracy of this quantitative approach and expert visual wall motion analysis (81% vs 84%, P = .56). Conclusion: Regional variation of uni-dimensional myocardial velocities necessitates site-specific normal ranges, probably because of different fiber directions. Combined analysis of longitudinal and radial velocities allows the derivation of a composite velocity, which is homogenous in all segments and may allow better separation of normal and abnormal myocardium.

Urbanization, population transition, and growth

This paper analyzes a dual economy consisting of urban market areas and less developed rural areas with or without local markets. Urban areas have better opportunities for earnings and education than rural areas. Rural families choose whether to move to urban areas at costs that differ from location to location. As per capita output grows relative to the moving cost, urbanization proceeds, leading to lower fertility, more investments in human and physical capital per child relative to output per worker, and faster economic growth. These impacts are stronger if rural areas have no access to markets.

Simulating growth, development, and yield of tillering pearl millet. III. Biomass accumulation and partitioning

Pearl millet landraces from Rajasthan, India, yield significantly less than improved cultivars under optimum growing conditions, but not under stressed conditions. To successfully develop a simulation model for pearl millet, capable of capturing such genotype x environment (G x E) interactions for grain yield, we need to understand the causes of the observed yield interaction. The aim of this paper is to quantify the key parameters that determine the accumulation and partitioning of biomass: the,light extinction coefficient, radiation use efficiency (RUE), pattern of dry matter allocation to the leaf blades, the determination of grain number, and the rate and duration of dry matter accumulation into individual grains. We used data on improved cultivars and landraces, obtained from both published and unpublished sources collected at ICRISAT, Patancheru, India. Where possible, the effects of cultivar and axis (main shoot vs. tillers) on these parameters were analysed, as previous research suggested that G x E interactions for grain yield are associated with differences in tillering habit. Our results indicated there were no cultivar differences in extinction coefficient, RUE, and biomass partitioning before anthesis, and differences between axes in biomass partitioning were negligible. This indicates there was no basis for cultivar differences in the potential grain yield. Landraces, however, produced consistently less grain yield for a given rate of dry matter accumulation at anthesis than did improved cultivars. This was caused by a combination of low grain number and small grain size. The latter was predominantly due to a lower grain growth rate, as genotypic differences in the duration of grain filling were relatively small. Main shoot and tillers also had a similar duration of grain filling. The low grain yield of the landraces was associated with profuse nodal tillering, supporting the hypothesis that grain yield was below the potential yield that could be supported by assimilate availability. We hypothesise this is a survival strategy, which enhances the prospects to escape the effects of stress around anthesis. (C) 2002 E.J. van Oosterom. Published by Elsevier Science B.V. All rights reserved.

Productivity growth in pre-1990 Mongolian agriculture: Spiralling disaster or emerging success?

The reasons for the spectacular collapse of so many centrally-planned economies are a source of ongoing debate. In this paper, we use detailed farm-level data to measure total factor productivity (TFP) changes in Mongolian grain and potato farming during the 14-year period immediately preceding the 1990 economic reforms. We measure TFP growth using stochastic frontier analysis (SFA) and data envelopment analysis (DEA) methods. Our results indicate quite poor overall performance, with an average annual TFP change of - 1.7% in grain and 0.8% in potatoes, over the 14-year period. However, the pattern of TFP growth changed substantially during this period, with TFP growth exceeding 7% per year in the latter half of this period. This suggests that the new policies of improved education, greater management autonomy, and improved incentives, which were introduced in final two planning periods in the 1980s, were beginning to have a significant influence upon the performance of Mongolian crop farming. Crown Copyright (C) 2002 Published by Elsevier Science B.V. All rights reserved.

Drop penetration into porous powder beds

The kinetics of drop penetration were studied by filming single drops of several different fluids (water, PEG200, PEG600, and HPC solutions) as they penetrated into loosely packed beds of glass ballotini, lactose, zinc oxide, and titanium dioxide powders. Measured times ranged from 0.45 to 126 s and depended on the powder particle size,viscosity, surface tensions, and contact angle. The experimental drop penetration times were compared to existing theoretical predictions by M. Denesuk et al. (J. Colloid Interface Sci. 158, 114, 1993) and S. Middleman (Modeling Axisymmetric Flows: Dynamics of Films, Jets, and Drops, Academic Press, San Diego, 1995) but did not agree. Loosely packed powder beds tend to have a heterogeneous bed structure containing large macrovoids which do not participate in liquid flow but are included implicitly in the existing approach to estimating powder pore size. A new two-phase model was proposed where the total volume of the macrovoids was assumed to be the difference between the bed porosity and the tap porosity. A new parameter, the effective porosity (epsilon)eff, was defined as the tap porosity multiplied by the fraction of pores that terminate at a macrovoid and are effectively blocked pores. The improved drop penetration model was much more successful at estimating the drop penetration time on all powders and the predicted times were generally within an order of magnitude of the experimental results. (C) 2002 Elsevier Science (USA).