Isolating and recognizing crudeoiklegrading [sic] bacteria of Queshm Island shores for biodegradation of crude oil pollutions

This research was carried out for recognizing Natural Flora Bacteria of oil pollution in the coasts of Queshm island. In The First steps, The coasts of this Island were scrutinized as a Field of research and For knowing whether oil stains exist or not. It gets obvious That southern coasts of Queshm have got oil pollution which is created by oil tankers which carry oil of Iran continental shelf. Them oil stains were sampled from to certain stations. In The First step, primary isolation of exisiting bacteria in every oil sample was done and then purification of each bacterium was carried out. Then each purified bacterium that has got strong, recognized, typic growth was enriched oil sample of T5 station. And Bacterium C4 (gram—negative coccobacillus) was chosen as the second priority From oil sample of TA station and Bacterium B1 (gram—positive coccus) was chosen as The third priority From oil sample of TI station. All The above mentioned bacteria were biochemically, physiologically and morphologically experimented For specking The species. According To The tests done and comparing with The tests done and comparing with the reference Berge y' s, bacterium A5 Pelongs to the species pseudomonas sp and becterium C4 belongs to the species Aeromonas sp and bacterium BI belongs to The species micrococcus sp. In The Last stage, bacterium with The First priority (TA5 pseudomonas sp) was used in the planned microcosm. The sake of optimum and adapting to Laboratory conditions Each enriched and purified bacterium was given a code for station and a code For itself . Then This bacterium was studied and it was proved that it has potentiality For using oil as a source of carbon. From oil samples of 10 stations, 30 various Colonies of bacterium were Isolated, of which 20 bacteria had the highest potentiality of growth. And the other bacteria that has no typic growth were omitted From being studied. Since all of These 20 bacterium are able to use oil, a bacterium with maximum rate of growth in the presence of crude oil and Lack of other hydrocarbonic sources and with The code A5 ( gram — negative Bacillus ) was chosen as First priority From The mentioned microcosm contains sea water , suspension oil degrading bacterium , crude oil, azote and various concentrations of carbon and Incubated in 30°` and shook 150 PRA1 According to the results , index oil degrading bacterium (pseudomonas sp) belongs oil sample of T5 stations (east of sheeb draz Gulf) which growth best and have the potentiality of degrading oil in 25 glli malas and 50 glli cheese water and with 5 gill urea .

Faecal pellets in deep marine soft clay crusts: Implications for hot-oil pipeline design

In recent years, the presence of crusts within near surface sediments found in deep water locations off the west coast of Angola has been of interest to hot-oil pipeline designers. The origin for these crusts is considered to be of biological origin, based on the observation of thousands of faecal pellets in natural crust core samples. This paper presents the results of laboratory tests undertaken on natural and faecal pellet-only samples. These tests investigate the role faecal pellets play in modifying the gemechanical behaviour of clayey sediments. It is found that faecal pellets are able to significantly alter both the strength and the average grain-size of natural sediments, and therefore, influence the permeability and stiffness. Hot-oil pipelines self-embed into and subsequent shear on crusts containing faecal pellets. Being able to predict the time required for installed pipelines to consolidate the underlying sediment and thus, how soon after pipe-laying, the interface strength will develop is of great interest to pipeline designers. It is concluded from wet-sieving samples before and after oedometer tests, that the process of pipe laying is unlikely to destroy pellets. They will therefore, be a major constituent of the sediment subject to soil-pipeline shearing behaviour during axial pipe-walking and lateral buckling. Based on the presented results, a discussion highlighting the key implications for pipeline design is therefore provided. Copyright © 2011 by ASME.

Spray combustion characteristics of palm biodiesel

The potential of palm methyl esters (PME) as an alternative fuel for gas turbines is investigated using a swirl burner. The main air flow is preheated to 623 K, and a swirling spray flame is established at atmospheric pressure. The spray combustion characteristics of PME are compared to diesel and Jet-A1 fuel under the same burner power output of 6 kW. Investigation of the fuel atomizing characteristics using phase Doppler anemometry (PDA) shows that most droplets are distributed within the flame reaction zone region. PME droplets exhibit higher Sautermean diameter (SMD) values than baseline fuels, and thus higher droplet penetration length and longer evaporation timescales. The PME swirl flame presents a different visible flame reaction zone while combusting with low luminosity and produces no soot. NO x emissions per unit mass of fuel and per unit energy are reduced by using PME relative to those of conventional fuels. © 2012 Copyright Taylor and Francis Group, LLC.

Extent of oxidation of hydrocarbons desorbing from the lubricant oil layer in spark-ignition engines

The extent of oxidation of hydrocarbons desorbing from the oil layer has been measured directly in a hydrogen-fueled, spark-ignited engine in which the lubricant oil was doped with a single component hydrocarbon. The amount of hydrocarbon desorbed and oxidized could be measured simultaneously as the dopant was only source of carbon-containing species. The fraction oxidized was strongly dependent on engine load, hydrogen fuel-air ratio and dopant chemical reactivity, but only modestly dependent on spark timing and nitrogen dilution levels below 20 percent. Fast FID measurements at the cylinder exit showed that the surviving hydrocarbons emerge late in the exhaust stroke. © Copyright 1996 Society of Automotive Engineers, Inc.

Novel experiment on in-cylinder desorption of fuel from the oil layer

A technique has been developed to measure the desorption and subsequent oxidation of fuel in the oil layer by spiking the oil with liquid fuel and firing the engine on gaseous fuel or motoring with air. Experiments suggest that fuel desorption is not diffusion limited above 50°C and indicated that approximately two to four percent of the cylinder oil layer is fresh oil from the sump. The increase in hydrocarbon emissions is of the order of 100 ppmC1 per 1% liquid fuel introduced into the fresh oil in a methane fired engine at mid-speed and light load conditions. Calculations indicate that fuel desorbing from oil is much more likely to produce hydrocarbon emissions than fuel emerging from crevices. © Copyright 1994 Society of Automotive Engineers, Inc.

Simulations of thermal upgrading methods for oil shale reservoirs

This paper analyzes reaction and thermal front development in porous reservoirs with reacting flows, such as those encountered in shale oil extraction. A set of dimensionless parameters and a 3D code are developed in order to investigate the important physical and chemical variables of such reservoirs when heated by in situ methods. This contribution builds on a 1D model developed for the precursor study to this work. Theory necessary for this study is presented, namely shale decomposition chemical mechanisms, governing equations for multiphase flow in porous media and necessary closure models. Plotting the ratio of the thermal wave speed to the fluid speed allows one to infer that the reaction wave front ends where this ratio is at a minimum. The reaction front follows the thermal front closely, thus allowing assumptions to be made about the extent of decomposition solely by looking at thermal wave progression. Furthermore, this sensitivity analysis showed that a certain minimum permeability is required in order to ensure the formation of a traveling thermal wave. It was found that by studying the non-dimensional governing parameters of the system one can ascribe characteristic values for these parameters for given initial and boundary conditions. This allows one to roughly predict the performance of a particular method on a particular reservoir given approximate values for initial and boundary conditions. Channelling and flow blockage due to carbon residue buildup impeded each method's performance. Blockage was found to be a result of imbalanced heating. Copyright 2012, Society of Petroleum Engineers.

Headspace solid-phase microextraction with novel sol-gel permethylated-beta-cyclodextrin/hydroxyl-termination silicone oil fiber for determination of polybrominated diphenyl ethers by gas chromatography-mass spectrometry in soil

A simple, sensitive, and accurate method for determination of polybrominated diphenyl ethers (PBDEs) in soil has been developed based on headspace solid-phase microextraction (HS-SPME) followed by gas chromatography-mass spectrometry (GC-MS). Permethylated-beta-cyclodextrin/hydroxyl-termination silicone oil (PM-beta-CD/OH-TSO) fiber was first prepared by sol-gel technology and employed in SPME procedure. By exploiting the superiorities of sot-gel coating technique and the advantages of the high hydrophobic doughnut-shaped cavity of PM-beta-CD, the novel fiber showed desirable operational stability and extraction ability. After optimization on extraction conditions like water addition, extraction temperature, extraction time, salts effect, and solvents addition, the method was validated in soil samples, achieving good linearity (r>0.999), precision (R.S.D. < 10%), accuracy (recovery>78%), and detection limits (S/N =3) raging from 13.0 to 78.3 pg/g. (c) 2007 Published by Elsevier B.V.

Composition of volatile oil of Primula obconica in Central China

Primula obconica was introduced to Europe from Hubei, China in 1880, and has been cultivated worldwide as one of popular ornamental plants. The volatile oil of wild P. obconica collected from its original place, Yichang, Hubei was first investigated. A total of 43 compounds constituting 93.49% of the oil were identified by using GC and GC-MS. The major compounds were methyl 2,4-dihydroxy-5-methyl benzoate (30.41%), methyl 2,6-dihydroxy-4-methyl benzoate (29.27%), and hypnone (8.92%) etc. In comparison with the published data of some European cultivars, the native P. obconica seems to be allergen-free due to absence of primin and miconidin.

Oil-immersion or solid-immersion power enhancement of very-small-aperture lasers

An analysis of the enhancement of light transmission through a sub-wavelength aperture by oil- or solid-immersion is presented in this letter. An output power enhancement phenomenon related to the oil-immersion or solid-immersion mechanism is realized experimentally and reported for a very small aperture laser, which is an agreement with simulation analysis. This phenomenon could be useful for future optical data storage, microscopy and lithography.