877 resultados para ICL (Computer program language)


Relevância:

100.00% 100.00%

Publicador:

Resumo:

The use of non-pressure compensating drip hose in horticultural and annual cycle fruits is growing in Brazil. In this case, the challenge for designers is getting longer lateral lines with high values of uniformity. The objective of this study was to develop a model to design longer lateral lines using non-pressure compensating drip hose. Using the developed model, the hypotheses to be evaluated were: a) the use of two different spacing between emitters in the same lateral line allows longer length; b) it is possible to get longer lateral lines using high values of pressure variation in the lateral lines since the distribution uniformity stays below allowable limits. A computer program was developed in Delphi based on the model developed and it is able to design lateral lines in level using non-pressure compensating drip hose. The input data are: desired distribution uniformity (DU); initial and final pressure in the lateral line; coefficients of relationship between emitter discharge and pressure head; hose internal diameter; pipe cross-sectional area with the dripper; and roughness coefficient for the Hazen-Williams equation. The program allows calculate the lateral line length with three possibilities: selecting two spacing between emitters and defining the exchange point; using two pre-established spacing between emitters and calculating the length of each section with different spacing; using one emitter spacing. Results showed that the use of two sections with different spacing between drippers in the lateral line didn't allow longer length but got better uniformity when compared with lateral line with one spacing between emitters. The adoption of two spacing increased the flow rate per meter in the final section which represented approximately 80% of the lateral line total length and this justifies their use. The software allowed DU above 90% with pressure head variation of 40% and the use of two spacing between emitters. The developed model/software showed to be accurate, easy to handle and useful for lateral line design using non-pressure compensating drip hose.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Dengue virus is a mosquito-borne flavivirus that has a large impact in global health. It is considered as one of the medically important arboviruses, and developing a preventive or therapeutic solution remains a top priority in the medical and scientific community. Drug discovery programs for potential dengue antivirals have increased dramatically over the last decade, largely in part to the introduction of high-throughput assays. In this study, we have developed an image-based dengue high-throughput/high-content assay (HT/HCA) using an innovative computer vision approach to screen a kinase-focused library for anti-dengue compounds. Using this dengue HT/HCA, we identified a group of compounds with a 4-(1-aminoethyl)-N-methylthiazol-2-amine as a common core structure that inhibits dengue viral infection in a human liver-derived cell line (Huh-7.5 cells). Compounds CND1201, CND1203 and CND1243 exhibited strong antiviral activities against all four dengue serotypes. Plaque reduction and time-of-addition assays suggests that these compounds interfere with the late stage of viral infection cycle. These findings demonstrate that our image-based dengue HT/HCA is a reliable tool that can be used to screen various chemical libraries for potential dengue antiviral candidates. © 2013 Cruz et al.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Study design: cross-sectional study. Objective: The objective of this study was to analyze the association between body composition, mobility and balance of elderly aged 80 years or older. Methods: The sample consisted of 123 elderly aged 80 and 95 years (83.2 ± 2.7 years) with 78 women (83.2 ± 2.9 years) and 45 men (83.2 ± 2, 4 years) residing in the city of Presidente Prudente - SP. Assessment of body composition was made by absorpiometria dual energy X-ray (DXA). The mobility and balance were assessed by means of tests of speed walking, and static balance lower limb strength. For statistical analysis we carried out the chi-square test, the software used was SPSS (13.0) and the significance level was set at 5%. Results: In males, those with higher performance in the functional tests showed higher percentages of muscle mass (MM) (35.6%) compared to lower performance (15.6%), p = 0.026. In the female group, the elderly with higher performance on tests showed higher bone mineral density (BMD) values (30.8%) compared with those with lower performance (20.5%) p = 0.041. Conclusion: MM for elderly males and BMD for females were the components of body composition that is associated with functional capacity.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Study Design: Prospective study Objective: To evaluate the effect of a protocol of concurrent training lasting 16 weeks on risk factors for the accumulation of hepatic fat in obese youth. Methods: 38 obese children and adolescents of both sexes, between 12 and 15 years old. The obesity was attested by the percentage of body fat, which was estimated by dual-energy X-ray absorptiometry (DEXA). Additionally, the amount of fat located in the trunk (kg) was estimated too. Before and after the intervention, the youths underwent biochemical blood tests (fasting complete lipid profile [mg / dL]) and ultrasonography of the liver (right size Wolves [LD cm] and left [LE in cm]). The intervention consisted of concurrent training (strength training [30 minutes] and endurance training [30 minutes]) with three sessions per week, totaling 180 minutes a week, for ten weeks. Statistical analysis was made by the test t of Student for paired data using SPSS software (17.0) and significance statistical fixed at p <5%. Results: After the intervention, significant improvements were observed in the percentage of total fat (PRE: 45.1 ± 5.3 and POST: 41.7 ± 5.6, p = 0.001) and in the trunk region (PRE: 46, 5 ± 5.6 and POST: 42.9 ± 6.3, p = 0.001). For lipid profile, reduction in total cholesterol (PRE: 164 ± 34 and POST: 148 ± 29, p = 0.001), triglycerides (PRE: 118 ± 59 and POST: 104 ± 53, p = 0.002) and lipoproteins density (PRE: 100 ± 29 and POST: 85 ± 26, p = 0.001), but not for high-density (p = 0.981). Both the LE (PRE: 8.8 ± 1.4 and POST: 7.8 ± 1.3, p = 0.001) and LD (PRE: 13.6 ± 1.3 and POST: 12.9 ± 1, 1, p = 0.001) experienced a decrease in its proportions. Conclusion: The concurrent training was effective in combating some risk factors to the accumulation of fat in the liver, as well as in reducing fat in both lobes of the organ in young obese.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Background: The fungus Paracoccidioides spp is the agent of paracoccidioidomycosis (PCM), a pulmonary mycosis acquired by the inhalation of fungal propagules. Paracoccidioides malate synthase (PbMLS) is important in the infectious process of Paracoccidioides spp because the transcript is up-regulated during the transition from mycelium to yeast and in yeast cells during phagocytosis by murine macrophages. In addition, PbMLS acts as an adhesin in Paracoccidioides spp. The evidence for the multifunctionality of PbMLS indicates that it could interact with other proteins from the fungus and host. The objective of this study was to identify and analyze proteins that possibly bind to PbMLS (PbMLS-interacting proteins) because protein interactions are intrinsic to cell processes, and it might be possible to infer the function of a protein through the identification of its ligands. Results: The search for interactions was performed using an in vivo assay with a two-hybrid library constructed in S. cerevisiae; the transcripts were sequenced and identified. In addition, an in vitro assay using pull-down GST methodology with different protein extracts (yeast, mycelium, yeast-secreted proteins and macrophage) was performed, and the resulting interactions were identified by mass spectrometry (MS). Some of the protein interactions were confirmed by Far-Western blotting using specific antibodies, and the interaction of PbMLS with macrophages was validated by indirect immunofluorescence and confocal microscopy. In silico analysis using molecular modeling, dynamics and docking identified the amino acids that were involved in the interactions between PbMLS and PbMLS-interacting proteins. Finally, the interactions were visualized graphically using Osprey software. Conclusion: These observations indicate that PbMLS interacts with proteins that are in different functional categories, such as cellular transport, protein biosynthesis, modification and degradation of proteins and signal transduction. These data suggest that PbMLS could play different roles in the fungal cell. © 2013 de Oliveira et al.; licensee BioMed Central Ltd.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

The objective of this study was to optimize an internal control to improve SYBR-Green-based qPCR to amplify/detect the BoHV-5 US9 gene in bovine embryos produced invitro and experimentally exposed to the virus. We designed an SYBR-Green-based binding assay that is quick to perform, reliable, easily optimized and compares well with the published assay. Herein we demonstrated its general applicability to detect BoHV-5 US9 gene in bovine embryos produced invitro experimentally exposed to BoHV-5. In order to validate the assay, three different reference genes were tested; and the histone 2a gene was shown to be the most adequate for normalizing the qPCR reaction, by considering melting and standard curves ( p<0.05). On the other hand, no differences were found in the development of bovine embryos invitro whether they were exposed to BoHV-5 reference and field strains comparing to unexposed embryos. The developed qPCR assay may have important field applications as it provides an accurate BoHV-5 US9 gene detection using a proven reference gene and is considerably less expensive than the TaqMan qPCR currently employed in sanitary programs. © 2013 Elsevier Ltd.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Pós-graduação em Pesquisa e Desenvolvimento (Biotecnologia Médica) - FMB

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Pós-graduação em Engenharia Mecânica - FEIS

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Incluye Bibliografía

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)