水质对UV/H_2O_2降解邻苯二甲酸二甲酯反应动力学的影响

研究了不同初始pH值、浊度与常见阴离子浓度等水质条件对UV/H2O2工艺降解邻苯二甲酸二甲酯(DMP)反应速率的影响,并进一步比较了去离子水和自来水中DMP的降解速率。结果表明,UV/H2O2对DMP的光降解过程符合一级反应动力学模型,不同水质条件对降解速率有不同程度的影响。酸性条件较碱性条件更有利于DMP降解;水的浊度大于7NTU时,光降解速率常数迅速下降;NO3-、Cl-、HCO3-等阴离子对DMP降解有抑制作用,且随离子浓度增大,抑制作用增强,3种离子对DMP光降解的抑制程度顺序为HCO3->NO3->Cl-。在5个30W低压汞灯照射下,当H2O2的浓度为20mg.L-1时,DMP在去离子水和自来水中光降解速率常数分别为0.0428min-1和0.0315min-1,自来水中的光降解速率常数较去离子水中的低,这可能是水中多种离子影响的结果。

水中无机阴离子对UV/H_2O_2降解LAS的影响及机理

研究了UV/H2O2工艺对直链烷基苯磺酸钠(LAS)的去除效果以及水中常见无机阴离子对LAS降解的影响和机理.结果表明,UV/H2O2工艺可以有效的去除水中LAS,光降解过程符合一级反应动力学模型.在H2O2投加量为8 mg.L-1,14 W低压汞灯照射下,LAS在蒸馏水和自来水中光降解速率常数分别为0.0180 min-1和0.0122 min-1;NO3-、Cl-、SO42-和HCO3-对LAS光降解有抑制作用,4种离子在浓度分别为5、10、15 mmol.L-1时,对LAS光降解的抑制程度均为HCO3->NO3->Cl->SO42-;随着离子浓度增大,抑制作用增强;自来水中的光降解速率常数低于蒸馏水中的光降解速率常数是由于水中多种离子影响的结果.

脱落酸对UV-C胁迫下小麦幼苗光合特性及抗氧化酶活性的影响

研究了UV-C辐射下短期和长期脱落酸(ABA)处理对小麦幼苗CO2同化作用、羧化效率、光合CO2响应以及抗氧化酶活性等的影响.结果表明,在无UV-C辐射情况下,短期和长期ABA处理能提高光合速率,比对照增加14·69%和20·46%,降低气孔导度,比对照降低14·74%和17·31%,但对胞间CO2浓度和羧化效率影响不大.当受到UV-C辐射时,光合速率、羧化效率、气孔导度和胞间CO2浓度逐渐降低.长期ABA处理变化最小,其次为ABA短期处理,对照降低最大.ABA处理能够提高小麦光合对CO2的响应,UV-C辐射抑制光合对CO2的响应.ABA处理能够提高小麦抗氧化酶(CAT、SOD、POD)活性而降低MDA含量.在UV-C辐射下,CAT活性先升高随后降低,在辐射处理1h时活性达最大值,ABA处理的SOD和POD活性先升高后降低,且ABA长期处理比短期处理增加明显,对照则逐渐降低.ABA处理可能通过提高小麦CO2同化作用和抗氧化酶活性增强对UV-C胁迫的抗性,且ABA长期处理比短期处理效果更明显.

增强UV-C辐射作用下小麦和豌豆幼苗光合响应及其相对抗性

以小麦和豌豆为材料,研究了UV-C辐射(波长<280nm)对叶片光合特性及抗氧化酶活性的影响.结果表明:UV-C辐射增强,可使豌豆叶片光合速率减弱,气孔导度、胞间CO2浓度、蒸腾速率和羧化效率明显降低,而对小麦叶片上述各项指标的影响则是先增加、后降低;在UV-C辐射下,豌豆的CO2补偿点逐渐升高,而小麦的CO2补偿点先降低、后升高.UV-C辐射除了使豌豆的POD活性和小麦的SOD活性逐渐降低外,其他抗氧化酶活性则呈先升高、后降低的变化趋势.小麦对短时间UV-C辐射的抗性比豌豆强,但随着UV-C辐射时间的延长,小麦和豌豆的抗氧化酶活性均降低,光合作用减弱.

Characterization of saccharides and phenolic acids in the Chinese herb Tanshen by ESI-FT-ICR-MS and HPLC

This study sought to determine the main components (saccharides and phenolic acids) in crude extract of the Chinese herb Tanshen by electrospray ionization Fourier transform ion cyclotron resonant mass spectrometry (ESI-FT-ICR-MS) in negative-ion mode. Eleven compounds were identified as phenolic acids by exact mass measurement and further confirmed by sustained off-resonance irradiation (SORI) CID data. In addition, monosaccharicles and oligosaccharides (n = 2 similar to 5) and a serial of corresponding anionic adducts of saccharide were observed without adding any anions additionally to the extract solution, and the anionic components were unambiguously identified as H2O, HCl, HCOOH, HNO3, C3H6O2, H2SO4 and C5H7NO3 according to the exact mass measurement results.

Studies on the stability of diester-diterpenoid alkaloids from the genus Aconitum L. by high performance liquid chromatography combined with electrospray ionisation tandem mass spectrometry (HPLC/ESI/MSn)

The stability of diester-diterpenoid alkaloids (DDA) from plants of the genus Aconitum L. has been studied in different solvents and pH buffers. The HPLC/ESIMS method for analysing the concentration of DDA was established and DDA's decomposition products were elucidated by HPLC/ESI-MS/MSn. In different solvents, e.g. dichloromethane, ether, methanol and distilled water, the decomposition pathways of DDA are quite different and their difference in stabilities depends on the difference of their structures, in which substituents at the N atom and substituents at C-3 are different. The pyrolytic products of DDA, such as deacetoxy aconitine-type alkaloids, have been observed in the above solvents, whereas 8-methoxy-14-benzoyl aconitine-type alkaloids have been obtained only in methanol.

生附片化学成分的HPLC/ESI-MS~n研究

采用高效液相色谱与电喷雾质谱联用技术,对生附片的化学成分进行了系统的研究.并辅以提取离子色谱方法.发现微量的化学成分.通过保留时间,质荷比及多级串联质谱数据,共鉴定了48个成分,其中双酯型生物碱8个,单酯型生物碱7个,脂型生物碱29个.其中双酯型生物碱是生附片中的主要成分,而单酯型和脂型生物碱的含量和种类较少.

西洋参与北沙参的HPLC、ESI-MS指纹图谱识别

目的:通过HPLC、ESI-MS指纹图谱对中药西洋参与北沙参进行鉴别。方法:利用HPLC和ESI-MS技术,优化西洋参、北沙参提取物的色谱和质谱分离分析条件,建立二者HPLC、ESI-MS指纹图谱。结果:确定出西洋参与北沙参HPLC的各色谱峰相对保留时间;根据MS图中各成份的m/z值,确定相应成分的分子量。二者的液相色谱和质谱指纹图谱完全不同。结论:通过HPLC、ESI-MS指纹图谱可以完全鉴别中药西洋参与北沙参,方法简单准确,重现性好,具有实用价值。

Studies on Triterpenoids and Flavones in Glycyrrhiza uralensis Fisch by HPLC-ESI-MSn and FT-ICR-MSn

Seven compounds, four flavones and three triterpenoids from Glycyrrhiza uralensis Fisch. extract are identified by high performance liquid chromatography coupled with electrospray ionization multi-tandem mass spectrometry (HPLC-ESI-MSn). The fragmentation pathways of these compounds are investigated by ESI-MSn and Fourier transform ion cyclotron resonance multiple-stage tandem mass spectrometry (FT-ICR-MSn). Comparing the retention times (t(R)) and mass spectra with those of reference compounds, seven components are identified in Glycyrrhiza uralensis Fisch. and their MSn data proposed plausible schemes for their fragmentation. All the experimental results show that ESI-MSn and FT-ICR-MSn are powerful tools for the structural characterization of triterpenoids and flavones

Studies on the aconitine-type alkaloids in the roots of Aconitum Carmichaeli Debx. by HPLC/ESIMS/MSn

Studies of aconitine-type alkaloids in the Chinese herb Aconitum Carmichaeli were performed by HPLC/ESIMS/MSn and FTICR/ESIMS in positive ion mode. The characteristic fragmentation pathways in the MSn spectra were summarized based on previously published research literature and further study. According to the fragmentation pathways of mass spectrometry, results from the analysis of standard compounds and reports from literature, 111 compounds were identified or deduced in a total of 117 found compounds in A. Carmichaeli. In the 11 monoester-diterpenoid alkaloids (MDA), 10 diesterditerpenoid alkaloids (DDA) and 81 lipo-alkaloids, the novel alkaloids including 1 MDA, 2 DDA and 48 lipo-alkaloids were detected.

A quantitative HPLC method for determining lactide content using hydrolytic kinetics

A new method for quantitative analysis of lactide has been developed by applying chemical kinetics to a HPLC system. The most important advance is its practical approach to the quantification of analytes that are unstable in the HPLC mobile phase. In HPLC analysis, anhydrous mobile phases cannot separate lactide from impurities, and only mixtures of water and organic solvent can achieve effective separation. By selecting conditions for testing and studying the kinetics of lactide hydrolysis, extensive experiments revealed that lactide degradation can be treated as a pseudo-first-order reaction under the given HPLC conditions, and lactide content or purity can be quantitatively determined. This method is practical for measuring the purity of the intermediate lactide in polylactic acid (PLA) production and the lactide content in PLA.

Cinnamate-Functionalized Poly(ester-carbonate): Synthesis and Its UV Irradiation-Induced Photo-Crosslinking

A functionalized. cyclic carbonate monomer containing a cinnamate moiety, 5-methyl-5-cinnamoyloxymethyl-1,3-dioxan-2-one (MC), was prepared for the first time with 1,1,1-tri(hydroxymethyl) ethane as a starting material. Subsequent polymerization of the new cyclic carbonate and its copolymerization with L-lactide (LA) were successfully performed with diethyl zinc (ZnEt2) as initiator/catalyst. NMR was used for microstructure identification of the obtained monomer and copolymers. Differential scanning calorimetry (DSC) was used to characterize the functionalized poly(ester-carbonate). The results indicated that the copolymers displayed a single glass transition temperature (T-g) and the T, decreased with increasing carbonate content and followed the Fox equation, indicative of a random microstructure of the copolymer. The photo-crosslinking of the cinnamate-carrying copolymer was also demonstrated.

Undercut structures fabricated by microtransfer printing combined with UV exposure and their applications

In this paper. the undercut structures were fabricated by microtransfer printing of metal films on the surface of photoresist combined with UV exposure and photoresist film developing. The patterned metal films were used as mask to realize the selective UV exposure of photoresist Firstly. The undercut structures. which consist of the top metal films and the patterned bottom photoresist, formed in the subsequent developing process because of the lateral dissolving of photoresist at the edge of the unexposed regions. The method proposed in this paper has wider tolerance to the changing of the patterning parameters. but, without effect on patterning resolution since the metal film was used as the top layer. The undercut Structures were Used as separators to pattern passive-matrix display of organic light-emitting diodes (OLEDs). No visible difference of the device performance was observed Compared with the OLEDs patterned by the shadow mask.