891 resultados para Effect on human
Resumo:
Two kinds of dewetting and their transition induced by composition fluctuation due to different composition in blend [poly(methyl methacrylate) (PMMA) and poly(styrene-ran-acrylonitrile) (SAN)] films on SiOx substrate at 145 degrees C have been studied by in-situ atomic force microscopy (AFM). The results showed that morphology and pathway of dewetting depended crucially on the composition. Possible reason is the variation in intensity of composition fluctuation resulted from the change of components in polymer blend. Based on the discussion of this fluctuation due to the composition gradient, parameter of U-q0/E, which describes the initial amplitude of the surface undulation and original thickness of film respectively, has been employed to distinguish the morphologies of spontaneous dewetting including bicontinuous structures and holes.
Resumo:
A series of europium complexes were synthesized and their electroluminescent (EL) characteristics were studied. It was found by comparison that the different substituted groups, such as methyl, chlorine, and nitryl, on ligand 1,10-phenanthroline affect significantly the EL performance of devices based on these complexes. The more methyl-substituted groups on ligand 1,10-phenanthroline led to higher device efficiency. A chlorine-substituted group showed the approximate EL performance as two methyl-substituted groups, whereas a nitryl substituent reduced significantly the EL luminous efficiency. However, beta-diketonate ligand TTA and DBM exhibited similar EL performance. The improved EL luminous efficiency by proper substituted groups on the 1, 10-phenanthroline was attributed to the reduction of the energy loss caused by light hydrogen atom vibration, as well as concentration quenching caused by intermolecular interaction, and the match of energy level between the ligand and Eu3+.
Resumo:
The effects of plasticizer ethylene carbonate (EC) on the AC impedance spectra and the ionic conductivity are reported. With increasing of EC concentration the semicircle in high frequency disappears, and the slope of the straight line in low frequency decreases. The data obtained from impedance experiments can be explained using an equivalent circuit proposed. On the other hand, the room temperature conductivity increases with EC concentration because of the increase of the segmental flexibility of PEO. For lower EC concentration samples, the temperature dependence of conductivity in low temperature range follows Arrhenius type, but when EC concentration is larger than 20%, the temperature dependence of conductivity obeys the Vogel-Tamman-Fulcher (VTF) equation in all temperature ranges.
Resumo:
The TiO2 nanoparticle thin films have been sensitized in situ with CdS nanoparticles. The SPS measurement showed that large surface state density was present on the TiO2 nanoparticles and the surface state can be efficiently decreased by sensitization as well as selecting suitable heat treatment, Both the photocurrent response and the charge recombination kinetics in TiO2 thin films were strongly influenced by trapping/detrapping of surface states. The slow photocurrent response of TiO2 nanoparticulate thin films upon the illumination was attributed to the trap saturation effects, The semiconductor sensitization made the slow photoresponse disappeared and the steady-state photocurrent value increased drastically, which suggested that the sensitization of TiO2 thin films with CdS could get a better charge separation and provide a simple alternative to minimize the effect of surface state on the photocurrent response.
Resumo:
The mixed oxide La2CuO4 was synthesized by four different methods and characterized with XRD, BET, TEM and low angle XRD. The effect of the synthetic method on the crystal structure, crystal size, surface area and catalytic activity to NO - CO reaction were studied. The results showed that the samples derived from different methods exhibited different activity to NO-CO reaction, the reason may be that the concentration and type of oxygen defect were different when the synthetic methods were different.
Resumo:
A new solid solution series, NdSr(1-x)M(x)NiO(4) (M = Ca: 0.0 less than or equal to x less than or equal to 1.0; M = Ba: 0.0 less than or equal to x less than or equal to 0.6), was synthesized by solid state reaction, and the structures, magnetic and electrical properties and optical spectra of this series have been studied. All the samples crystalized in tetragonal systems, with the exception of NdCaNiO4, which crystallized in the orthohombic system. IR spectra of NdSr1-xCaxNiO4 indicated that the lengths of two Ni-O bonds decrease with increasing Ca content. The electrical conduction changed from metallic-type to semiconductive-type when x greater than or equal to 0.4 (M = Ca, Ba), and the room temperature resistivities of NdSr1-xCaxNiO4 increased with the increase of Ca content. Magnetic susceptibility measurements revealed that Ni+3 ions in all the samplies were in low-spin state over the temperature range 77-300 K.
Resumo:
Phenolphthalein poly(ether ketone) (PEK-C) was tested using an instrumented impact tester to determine the temperature effect on the fracture toughness K-c and critical strain energy release rate G(c). Two different mechanisms, namely the relaxation processes and thermal blunting of the crack tip were used to explain the temperature effect on the fracture toughness. Examination of the fracture surfaces revealed the presence of crack growth bands. It is suggested that these bands are the consequence of variations in crack growth along crazes that are formed in the crack tip stress field. As the crack propagates, the stress is relaxed locally, decreasing the growth rate allowing a new bundle of crazes to nucleate along which the crack advances.
Resumo:
The influence of thin-layer resistance in cyclic voltammetry was studied in detail. Under the experimental conditions, a linear relationship between the peak-peak potential difference and the product of the peak current and the resistance was obtained and
Resumo:
The corrosion rate of low alloy steel in different sea zones has close correlation with the content of the alloy element. From the field data of steel corrosion rates in atmospheric zone, splash zone and immersion zone, regression analysis was used to study the correlation between the corrosion rate of steels and the amount of added alloy elements. Three regression equations were obtained in different sea zones. Based on the equations, the anti-corrosion performance of the alloy elements can be deduced which can be used to screen out low alloy steel with good anti-corrosion performance. (C) 2007 Elsevier B.V. All rights reserved.
Resumo:
The influence of air and soil warming on root vole (Microtus oeconomus L.) population was studied in winter period in top open chambers (OTC) (0.8-1.8 m(2) warmed by conical fiberglass material and situated in alpine meadow (3250 m) at Qinghai-Tibet Plateau, China. The OTCs were distributed on an area of 30 x 30 m of experimental warming site; another site of the same area was a control one. The root vole population was investigated on two pairs of sites in "low-grazing" and "high-grazing" (by sheep) parts of the meadow; mark-recapture method was used. The winter-season averaged air and soil temperature inside of the chambers were 1.3 degrees C higher than the temperature outside the chambers. The warming in the chambers had no statistically significant effect on root vole numbers, on average body mass of individual, and on average body mass of males and females. In conclusion, as small as 1.3 degrees C warming of soil and air introduced locally and on small (several m(2)) scale, in the alpine meadow habitat in winter period, has possibly no effect on root vole numbers and biomass.