Simultaneous determination of cadmium and lead in wine by electrothermal atomic absorption spectrometry

A method has been developed for the direct simultaneous determination of Cd and Pb in white and red wine by electrothermal atomic absorption spectrometry (ET-AAS) using a transversely heated graphite tube atomizer (THGA) with longitudinal Zeeman-effect background correction. The thermal behavior of both analytes during pyrolysis and atomization stages were investigated in 0.028 mol l(-1) HNO3 and in 1 + 1 v/v diluted wine using mixtures of Pd(NO3)(2) + Mg(NO3)(2) and NH4H2PO4 + Mg(NO3)(2) as chemical modifiers. With 5 mug Pd + 3 mug Mg as the modifiers and a two-step pyrolysis (10 s at 400 degreesC and 10 s at 600 degreesC), the formation of carbonaceous residues inside the atomizer was avoided. For 20 mul of sample (wine + 0.056 mol l(-1) HNO3, 1 + 1, v/v) dispensed into the graphite tube, analytical curves in the 0.10-1.0 mug l(-1) Cd and 5.0-50 mug l(-1) Pb ranges were established. The characteristic mass was approximately 0.6 pg for Cd and 33 pg for Pb, and the lifetime of the tube was approximately 400 firings. The limits of detection (LOD) based on integrated absorbance (0.03 mug l(-1) for Cd, 0.8 mug l(-1) for Pb) exceeded the requirements of Brazilian Food Regulations (decree #55871 from Health Department), which establish the maximum permissible level for Cd at 200 mug l(-1) and for Pb at 500 mug l(-1). The relative standard deviations (n = 12) were typically < 8% for Cd and < 6% for Pb. The recoveries of Cd and Pb added to wine samples varied from 88 to 107% and 93 to 103%, respectively. The accuracy of the direct determination of Cd and Ph was checked for 10 table wines by comparing the results with those obtained for digested wine using single-element ET-AAS, which were in agreement at the 95% confidence level. (C) 2001 Elsevier B.V. B.V. All rights reserved.

PHENYLBUTANOID AND TAXANE-LIKE METABOLITES FROM NEEDLES OF TAXUS-BREVIFOLIA

The structures for brevifoliol and three baccatin VI derivatives were revised to possess the novel 11(15 --> 1)-abeotaxane tricylic skeleton based on X-ray crystallographic studies. Four more new rearranged taxane derivatives related to brevifoliol and the unusual phenylbutanoid, (-)-rhododendrol, were isolated from the needles of Taxus breuifolia. Their structures were established as 10 beta-benzoxy-5 alpha-(3'-dimethylamino-3'-phenyl)-propanoxy-1 beta-hydroxy- 7 beta,9 alpha,13 alpha-triacetoxy-11(15 --> 1)-abeotaxa-4(20),11-diene; 10 beta-benzoxy-1 beta-hydroxy-5 alpha-(3'-methylamino-3'-phenyl)- propanoxy-7 beta,9 alpha,l3 alpha-triacetoxy-11(15 --> 1)-abeotaxa-4(20),11-diene; 10 beta-benzoxy-5 alpha-cinnamoxy-1 beta-hydroxy-7 beta,9 alpha,13 alpha-triacetoxy-1 1(15 --> 1)-abeotaxa-4(20),11-diene; 10 beta-benzoxy-1 beta,5 alpha-dihydroxy-7 beta,9 alpha,13 alpha-triacetoxy-11(15 --> 1)-abeotaxa-4(20),11-diene and 2(R)-hydroxy-4-(4'-hydroxyphenyl)-butane.

PhotoLin: a program to identify and analyze linear structures in aerial photographs, satellite images and maps

A computer program, PhotoLin, written for an IBM-PC-compatible microcomputer is described which detects linear features in aerial photographs, satellite images and topographic maps. The program accepts images saved to PCX files as input and applies noise correction and smoothing filters and thinning routines. The output consists of a skeleton containing the median lines of linear features which can be represented on a map. The branches of the skeleton can be broken into sections of constant length for which the mean orientations are obtained for the preparation of rose diagrams. (C) 2001 Elsevier B.V. Ltd. All rights reserved.

A general survey and some taxonomic implications of diterpenes in the Asteraceae

This paper provides a general survey of the occurrence of diterpenes in the Asteraceae. Data on 4351 botanical occurrences were obtained from the literature. These were grouped by skeleton for each genus. Then, the genera were grouped by subtribes, which, in turn, were gathered in tribes, followed by subfamilies. In spite of the low number of species containing diterpenes, it was possible to describe some structural features of these compounds, i.e. The skeletal types in various taxa and the positions in some skeletons that are always oxidized or never undergo oxidation in some genera. Thus, it was verified that: in the subfamily Cichorioideae, only a few of the studied species possess diterpenes, wherein kaurane is the most frequent diterpene skeleton. In the Asteroideae, the presence of diterpenes is much greater than that in the Cichorioideae and Carduoideae. At tribal taxonomic level, for example, the Astereae produce labdanes and clerodanes; Heliantheae and Eupatorieae produce kauranes and labdanes, respectively; and Calenduleae produce pimaranes. Some taxonomic implications are presented. (c) 2005 the Linnean Society of London.

Automatic identification by C-13 NMR of substituent groups bonded in natural product skeletons

The aim of this paper is to present a procedure that utilizes C-13 NMR for identification of substituent groups which are bonded to carbon skeletons of natural products. For so much was developed a new version of the program (MACRONO), that presents a database with 161 substituent types found in the most varied terpenoids. This new version was widely tested in the identification of the substituents of 60 compounds that, after removal of the signals that did not belong to the carbon skeleton, served to test the prediction of skeletons by using other programs of the expert system (SISTEMAT). (C) 2002 Elsevier B.V. Ltd. All rights reserved.

A constraints generator in structural determination by microcomputer

We present a new expert system: a constraints generator for structure determination of natural products. The constraints that the system furnishes are: skeleton (reliability: 95%), large substructures (reliability: 98%) and their associated assignments (reliability: 90%) This system is intended for structure determination of carbon-rich compounds (sesqui-, di- and triterpenes, sterols etc.) for which most structures generators are not very effective. We also present a new algorithm that can avoid the combinatorial explosion during subspectrum/substructure analysis.

About the nanoporosity elimination above 800 degrees C in xerogels prepared from TEOS sono-hydrolysis

Small angle X-ray scattering measurements, bulk and skeleton density data and an in-situ study by dilatometric thermal analysis about the nanoporosity elimination above 800 degreesC in TEOS sonogels are presented. Apparently, two processes act during the nanoporosity elimination, which precedes the foaming phenomenon often observed in such systems. The first, with an activation energy of (3.9 +/- 0.4) x 10(2) kJ/mol and high frequency factor, is the controlling process of the most nanoporosity elimination at higher temperature. The value of this activation energy is compatible to that for viscous flux throughout densification process in typical silica-based materials. The second, with an activation energy of (49 +/- 5) kJ/mol and low frequency factor, seems to be the controlling process of the first and extremely slow nanoporosity elimination at low temperature.

PALEOCLIMATIC CONTROLS ON STABLE OXYGEN AND CARBON ISOTOPES IN CALICHE OF THE ABO FORMATION (PERMIAN), SOUTH-CENTRAL NEW-MEXICO, USA

The stable oxygen and carbon isotopic composition of caliche in fluvial and supratidal rocks of the Abo Formation (Permian), south-central New Mexico, is controlled by palecoclimate and depositional environment. Fluvial caliche consists of low-Mg calcite nodules and vertically oriented tubules that display stage II texture. Micrite matrix support, brecciation, ooids/pisoliths, aveolar-septal texture, and peloids are common in the fluvial caliche and, along with red color and slickensides in the host shale, indicate pedogenesis in a well-oxidized vadose zone. In contrast, periodic waterlogging of the supratidal paleosols, probably due to high water table, is indicated by drab colors, carbonaceous flecks, horizontal rhizoliths, and the paucity of vadose textures in the stage II caliche nodules.Stable oxygen isotopes are similar in the fluvial and supratidal caliches and range from 21.6 to 30.5 parts per thousand (SMOW). The data exhibit a crude bimodality and delta-O-18 enrichment with a decrease in age (higher in the section). Consideration of these data in the context of delta-temperature relations suggests that 1) surface waters responsible for caliche formation increased in delta-O-18 (from roughly -8 to + 1 parts per thousand) over the 18 m.y. time interval that separated the lowest stratigraphic nodule horizon from the highest, 2) the increasing delta-O-18 values also reflect a warming trend (approximately 15-degrees to nearly 30-degrees-C) in the mean monthly temperature over this same time period, with perhaps an associated increase in Permian ocean temperatures, and 3) the significant variation in delta-O-18 from oldest to youngest caliche was probably enhanced by the amount effect, such that as the temperature increased, the amount of precipitation decreased, resulting in high delta-O-18 values.Caliches in the Abo are enriched in heavy carbon (-7.2 to -1.5 part per thousand PDB) compared to that of soil carbonate derived exclusively from C3 plants (-12 part per thousand PDB), and the supratidal caliches contain somewhat heavier carbon compared to the fluvial caliche. The delta-C-13 values for both environments increase with a decrease in caliche age. These results indicate that as the temperature increased and rainfall decreased with time, the level of C3 plant productivity apparently declined, allowing a greater influx of atmospheric CO2 into the soil. This can only occur when soil respiration rates are quite low or at very shallow depths (less than 10 cm), or both. Atmospheric CO2 seems to have invaded the supratidal soils to a somewhat greater extent than the fluvial soils.

Characterisation of sugar cane combustion particles in the Araraquara region, Southeast Brazil

Biomass burning is an important primary and secondary source of aerosol particles. The presence of carbonaceous particles in the respirable size range makes the study of this fraction important in view of possible health and climatic effects. The annual burning of sugar cane plantations causes emission of huge amounts of pyrogenic particles. Aerosol samples were collected in Araraquara city, São Paulo state, Brazil, during the harvest season for fine and coarse particles and bulk; they were analysed by electron-probe microanalysis, including facilities for low-Z element determination (low-Z EPMA) and by energy-dispersive X-ray fluorescence (EDXRF), in order to investigate the elemental composition of individual particles and bulk samples, respectively. Numerical analysis of the EPMA results by hierarchical clustering shows high contributions of carbonaceous particles that can be distinguished mainly in two different types: biogenic and carbon-rich. Additionally, two significant contributions of aluminosilicate particles were identified: as rather pure aluminosilicates or mixed with carbonaceous species. The EDXRF results are compatible with those of aerosol particles in Amazon, which is nowadays one of the main sources of biogenic particles in the world.

Thermal behaviour of fumaric acid, sodium fumarate and its compounds with light trivalent lanthanides in air atmosphere

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Sewage sludge coke estimation using thermal analysis

The imposition of more stringent legislation by CETESB in the State of So Paulo (Brazil) governing the disposal and utilization of sewage sludge, coupled with the growth in its generation has prompted a drive for alternative uses of sewage sludge. One option that is especially promising, due to its potential to valorize sludge, is its conversion into carbonaceous adsorbents or coke for industrial effluents treatment. Thus, a methodology is presented to estimate the coke produced from the sludge of a sewage treatment station using thermal analysis. The used sewage sludge, which comes from aerobic treatment, was collected in the wastewater treatment station of Barueri, one of the largest of the So Paulo metropolitan area. The sludge samples were collected, dried, ground, and milled until they passed an ABNT 200 sieve. The inert ambient used during its thermal treatment produces inorganic matter and coke as residual materials. Coke formation occurs in the 200-500 A degrees C range and, between 500 and 900 A degrees C, its thermal decomposition occurs. The highest formation of coke occurs at 500 A degrees C.

A New Species of Brachycephalus from the Atlantic Rain Forest in São Paulo State, Southeastern Brazil (Amphibia: Anura: Brachycephalidae)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

L'etude des signaux de 13C PAR microordinateur un programme simple et rapide

We present an unsophisticated and prompt software for the study of the spectroscopic properties of natural products. The main program searches substructures into the data set, selects the matching substructures and tests the selectivity of its chemical shifts for each skeleton. Some applications are presented. © 1990.

Cogasification of solid fuels

High efficiency gas turbine based systems, utility deregulation and more stringent environmental regulations strongly favor the use of natural gas over coal and other solid fuels in new electricity generators. Solid fuels could continue to compete, however, if a low cost gasifier fed by low cost feedstocks can be coupled with a gas turbine system. We examine on-site gasification of coal with other domestic fuels in an indirectly heated gasifier as a strategy to lower the costs of solid fuel systems. The systematics of gaseous pyrolysis yields assembled with the help of thermal measurement data and molecular models suggests blending carbonaceous fuels such as coal, coke or char with oxygenated fuels such as biomass, RDF, MSW, or dried sewage sludge. Such solid fuel blending can, with the help of inexpensive catalysts, achieve an optimum balance of volatiles, heating values and residual char thus reducing the technical demands upon the gasifier. Such simplifications should lower capital and operating costs of the gasifier to the mutual benefit of both solid fuel communities.

SISTAX - An intelligent tool for recovering information on natural products chemistry

This work describes the development of a new program, named SISTAX, for the expert system SISTEMAT. This program allows anyone interested in chemotaxonomy to carry out an intelligent search for organic compounds in databases through chemical structures. When coupled with can efficient encoding system, the program recognizes skeletal types and can find any substructural constraints demanded by the user. An example of an application of the program to the diterpene class found in plants is described.