970 resultados para Ag additions
Resumo:
All the exciting work on developing new and better alloys has led older alloys, such as AZ9l , being abandoned by researchers. lt is believed that the full potential of AZ9l in automotive design has not been realized. Whatever works have been carried out on AZ9lalloy to improve its mechanical properties are insufficient in terms of its potential usage in auto industries. Due to the fact that AZ91 offers high room temperature mechanical properties and good castability, still this alloy is a primary choice for the auto component manufactures. Small improvement in its creep properties will have a huge impact in the transportation industries. Hence, in the present work, “Influence of Si, Sb and Sr Additions on the Microstructure, Mechanical Properties and Corrosion Behavior of AZ91 Magnesium Alloy”, an attempt has been made to improve the creep properties of AZ9l alloy through minor alloying elemental additions and to understand its strengthening mechanisms. The effect of alloying additions on the ageing and tensile properties of AZ9l is also studied. In addition to that, role of various intermetallics formed due to the alloying additions on the corrosion properties of AZ9l alloy is investigated.
Resumo:
It is important that long superconducting tape must have desired strain tolerance (less reduction of Jc with applied strains) and stress tolerance (less reduction of JC in applied stresses) for its use as coils and magnets. Ag addition to the BPSCCO system has many advantages with its physical and chemical inertness to the system, reduces the processing temperature, and promotes the grain growth, grain alignment and connectivity. All these not only enhance the critical current density of the tapes but also improve the mechanical properties. But the published results show very much scattering on the type of Ag additive to be selected, method of addition and its optimum percentage. Also there are some negative reports in this regard. The present work has been undertaken to study the effect of silver addition in different forms (Ag powder, Ag2O, AgNO3) on the superconducting and mechanical properties of (Bi,Pb)-2223/Ag tapes and to find out a suitable form of Ag additive and its optimum percentage to have better superconducting and mechanical properties. Also it is the aim of the present work is to optimise the process parameters needed to prepare (Bi,Pb)-2223/Ag multifilamentary tapes of length ~ 12 m in solenoid and pancake coil forms with good critical current density and homogeneity of J C along the length of the tapes.
Resumo:
The optical-absorption spectrum of a cationic Ag0 atom in a KCl crystal has been studied theoretically by means of a series of cluster models of increasing size. Excitation energies have been determined by means of a multiconfigurational self-consistent field procedure followed by a second-order perturbation correlation treatment. Moreover results obtained within the density-functional framework are also reported. The calculations confirm the assignment of bands I and IV to transitions of the Ag-5s electron into delocalized states with mainly K-4s,4p character. Bands II and III have been assigned to internal transitions on the Ag atom, which correspond to the atomic Ag-4d to Ag-5s transition. We also determine the lowest charge transfer (CT) excitation energy and confirm the assignment of band VI to such a transition. The study of the variation of the CT excitation energy with the Ag-Cl distance R gives additional support to a large displacement of the Cl ions due to the presence of the Ag0 impurity. Moreover, from the present results, it is predicted that on passing to NaCl:Ag0 the CT onset would be out of the optical range while the 5s-5p transition would undergo a redshift of 0.3 eV. These conclusions, which underline the different character of involved orbitals, are consistent with experimental findings. The existence of a CT transition in the optical range for an atom inside an ionic host is explained by a simple model, which also accounts for the differences with the more common 3d systems. The present study sheds also some light on the R dependence of the s2-sp transitions due to s2 ions like Tl+.
Resumo:
The interface of MgO/Ag(001) has been studied with density functional theory applied to slabs. We have found that regular MgO films show a small adhesion to the silver substrate, the binding can be increased in off-stoichiometric regimes, either by the presence of O vacancies at the oxide film or by a small excess of O atoms at the interface between the ceramic to the metal. By means of theoretical methods, the scanning tunneling microscopy signatures of these films is also analyzed in some detail. For defect free deposits containing 1 or 2 ML and at low voltages, tunnelling takes place from the surface Ag substrate, and at large positive voltages Mg atoms are imaged. If defects, oxygen vacancies, are present on the surface of the oxide they introduce much easier channels for tunnelling resulting in big protrusions and controlling the shape of the image, the extra O stored at the interface can also be detected for very thin films.
Resumo:
The application vistas of superconductors have widened very much since the discovery of high TC superconductors (HTS) as many of the applications can be realised at 77 K rather than going down to 4.2 K, the liquid He temperature. One such application is the HTS current lead which is used to connect a superconducting system with a room temperature power source. Minimising heat leak to the cryogenic environment is the main advantage of introducing current leads into superconducting systems. The properties of HTSS likes zero resistance (avoiding joule heating) and very low thermal conductivity (minimized conductive heat transfer) make them ideal candidates to be used as current leads. There are two forms of HTS current leads. (i) bulk form (tube or rod) prepared either from YBCO or BSCCO and (ii) tape form prepared from Bi-2223 multifilamentary tapes. The tape form of current leads has many advantages with respect to the mechanical and thermal stability related criteria. Crucial information on various aspects of HTS current lead development are not available in the literature as those are kept proprietary by various companies around the world. The present work has been undertaken to tailor the properties of multifilamentary tapes for the current lead application and to optimise the processing parameters of the same for enhanced critical current density and field tolerance. Also it is the aim of the present investigation is to prepare prototype current leads engineered for operation in conduction cooled mode and test them for operational stability
Resumo:
The study was carried out to understand the effect of silver-silica nanocomposite (Ag-SiO2NC) on the cell wall integrity, metabolism and genetic stability of Pseudomonas aeruginosa, a multiple drugresistant bacterium. Bacterial sensitivity towards antibiotics and Ag-SiO2NC was studied using standard disc diffusion and death rate assay, respectively. The effect of Ag-SiO2NC on cell wall integrity was monitored using SDS assay and fatty acid profile analysis while the effect on metabolism and genetic stability was assayed microscopically, using CTC viability staining and comet assay, respectively. P. aeruginosa was found to be resistant to β-lactamase, glycopeptidase, sulfonamide, quinolones, nitrofurantoin and macrolides classes of antibiotics. Complete mortality of the bacterium was achieved with 80 μgml-1 concentration of Ag-SiO2NC. The cell wall integrity reduced with increasing time and reached a plateau of 70 % in 110 min. Changes were also noticed in the proportion of fatty acids after the treatment. Inside the cytoplasm, a complete inhibition of electron transport system was achieved with 100 μgml-1 Ag-SiO2NC, followed by DNA breakage. The study thus demonstrates that Ag-SiO2NC invades the cytoplasm of the multiple drug-resistant P. aeruginosa by impinging upon the cell wall integrity and kills the cells by interfering with electron transport chain and the genetic stability
Resumo:
In the collision system Xe - Ag, the thresholds for excitation of quasimolecular L radiation and characteristic Ag L radiation have been found to lie at about 5 MeV and 1 MeV, respectively. These results are discussed on the basis of ab initio calculations of the screened interaction potential and the electron-correlation diagram.
Resumo:
Our new simple method for calculating accurate Franck-Condon factors including nondiagonal (i.e., mode-mode) anharmonic coupling is used to simulate the C2H4+X2B 3u←C2H4X̃1 Ag band in the photoelectron spectrum. An improved vibrational basis set truncation algorithm, which permits very efficient computations, is employed. Because the torsional mode is highly anharmonic it is separated from the other modes and treated exactly. All other modes are treated through the second-order perturbation theory. The perturbation-theory corrections are significant and lead to a good agreement with experiment, although the separability assumption for torsion causes the C2 D4 results to be not as good as those for C2 H4. A variational formulation to overcome this circumstance, and deal with large anharmonicities in general, is suggested
Resumo:
· S'ha preparat i caracteritzat una família de complexos de Cu(III) contenint lligands triazamacrocíclics, estudiant-se les seves propietats estructurals, espectroscòpiques i redox. Aquesta àmplia família de complexos tenen un gran interès perquè permeten descriure les propietats dels complexos de Cu en un estat d'oxidació poc habitual i a més ens han permès mesurar de manera quantitativa l'efecte Meyerstein. · Una nova família de complexos de Cu(I) amb els lligands triazamacrocíclics es sintetitzada i caracteritzada per tècniques espectroscòpiques i estructurals, demostrant que aquests complexos presenten diferents estructures a l'estat sòlid i en dissolució. Així doncs, mentre que en dissolució es demostra per RMN que es tracta d'una espècie monomèrica, la determinació estructural per difracció de raigs X d'aquests complexos de Cu(I), ens confirma la formació d'espècies polimèriques. Per altra banda, s'ha estudiat la seva reactivitat; a) la seva implicació en la formació de lligands deuterats mitjançant l'intercanvi H/D en condicions suaus i b) la formació de complexos bisfenoxo a partir de la reactivitat entre els corresponents complexos de Cu(I) i oxigen molecular. De la mateixa manera, s'ha preparat el corresponent anàleg de Ag(I) en estat sòlid, obtenint la formació d'un polímer de Ag(I), el qual presenta a l'estat sòlid una estructura en forma de ziga-zaga, diferent a l'estructura del polímer de Cu(I), que és lineal. · S'ha determinat i proposat el mecanisme que té lloc en l'activació de l'enllaç C-H i posterior reacció de transferència per tal d'estabilitzar els productes finals mitjançant una reacció de desproporció. El seguiment de la reacció té lloc mitjançant tècniques espectroscòpiques com UV-vis. Dit seguiment, ens permet determinar les diferents influències electròniques sobre la reacció de formació dels complexos organometàl·lics de Cu(III). A més a més, el seguiment de la reacció a baixa temperatura ens permet determinar espectroscòpica i teòricament la formació d'un intermedi de Cu(II), i mitjançant la determinació dels paràmetres cinètics i termodinàmics es proposa un mecanisme de reacció. Posteriorment, s'ha assajat la reactivitat d'una sal de Cu(II) amb un lligand macrocíclic que conté un grup metil en el carboni orientat cap al centre del macrocicle, implicant la formació d'un intermedi agòstic. De la determinació estructural d'aquest intermedi de CuII i del lligand protonat, s'extreuen una sèrie de conclusions molt interessants, com són la demostració estructural de l'activació de l'enllaç C-C en la primera etapa de formació i de manera anàloga poder comparar-ho amb els sistemes macrocíclics HL2-HL6, demostrant la possible formació d'un intermedi agòstic, on es produeix l'activació de l'enllaç C-H. Aquesta similitud estaria d'acord amb els sistemes HL2-HL6, els quals espectroscòpica i teòricament s'havia detectat la presència d'un intermedi de característiques similars. Degut a l'acidesa d'aquest protó, i gràcies a la presència d'una base com és el propi lligand, aquest podia ésser extret donant lloc a la formació dels corresponents organometàl·lics de Cu(III). Dita estructura també representa un dels pocs exemples d'un organometàl·lic de CuII, un estat d'oxidació poc conegut dins d'aquest camp. · S'ha descrit la reactivitat dels nous complexos organometàl·lics de Cu(III), els quals sota medi pròtic i en condicions àcides o neutres són espècies totalment estables, però en condicions bàsiques o reductores aquestes espècies reaccionen donant lloc a la formació de noves espècies de tipus bisfenoxo, on el Cu es troba en estat d'oxidació +2. S'han caracteritzat mitjançant difracció de RX, on es s'observa l'entorn químic del Cu, la geometria del complex bisfenoxo i l'hidroxilació de l'anell aromàtic. · Finalment, s'ha descrit per primera vegada la síntesi i caracterització d'uns nous complexos organometàl·lics de Ni. Aquests són sintetitzats en base als càlculs teòrics realitzats sobre els nostres sistemes macrocíclics. Per aquests complexos hem investigat l'efecte del metall, canviant el coure per altres metalls de la primera sèrie de transició (Mn, Fe, Co, Ni, Cu, Zn) i de la segona sèrie de transició (Ru, Rh, Pd, Ag). Els resultats demostren que el Ni(II), és el metall que presenta una major capacitat de l'activació de l'enllaç C-H en aquests sistemes aromàtics. Aquests compostos s'oxiden lentament cap a complexos de Ni(III). Per altra banda, l'addició d'una sal de clor sobre una solució d'un complex de Ni(II) permet aïllar el corresponent complex de Ni(III), caracteritzat per ressonància de spin electrònic
Resumo:
Application of organic materials to soils to enhance N immobilization into microbial biomass, thereby reducing inorganic N concentrations, was studied as a management option to accelerate the reestablishment of the native vegetation on abandoned arable fields on sandy soils the Kiskunsag National Park, Hungary. Sucrose and sawdust were used at three different topographic sites over 4 years. N availability and extractable inorganic N concentrations were significantly reduced in all sites. Soil microbial biomass C and microbial biomass N increased significantly following C additions, but the microbial C to microbial N ratio remained unaffected. It is concluded that the combined application of the rapidly utilized C source (sucrose) promoted N immobilization, whereas the addition of the slowly utilized C source (sawdust) maintained the elevated microbial biomass C and microbial biomass N in the field.
Resumo:
The surface of a nanofiber that is formed from a self-assembling pseudopeptide has been decorated by gold and silver nanoparticles that are stabilized by a dipeptide. Transmission electron microscopic images make the decoration visible. In this paper, a new strategy of mineralizing a pseudopeptide based nanofiber by gold and silver nanoparticles with use of a two-component nanografting method is described.