(Table 1) Biomass per area of picoplankton algae, cyanobacteria, and total picoplankton and their contribution to total phytoplankton biomass in 0-200 m layer

Abundance of picophytoplankton in the Subantarctic and subtropical frontal zones was found to be 10**6-10**7 cells/l. Biomass of eucaryotes and procaryotes reached 2 g/m**2 and accounted for 1-15% of total phytoplankton biomass. A deep peak in the distribution of phytoplankton abundance was found at 40-120 m. Maximum number of dividing cyanobacteria cells occurred at depths of 40-60 m. An estimate of picophytoplankton production shows that picophytoplankton accounts for 30-40% of total primary production.

Hydro-sedimentary parameters measurements within the proglacial area of the Bossons glacier (Mont-Blanc massif, France)

This dataset presents hydro-sedimentary data within the Bossons glacier proglacial area. Bossons glacier is rapidly retreating and its proglacial area is deglaciated for ~ 30 years. It is an intriguing location to study periglacial, proglacial and subglacial erosion processes which requires estimating Total Dissolved Solid (TDS) and Total Suspended Solid (TSS) concentrations, and discharge. Measurements were performed at three distinct locations within Bosson glacier watershed : Bossons downstream (BDS), Bossons upstream (BUS) and Crosette (CRO). The latter is located at the glacier termini whereas BDS and BUS stations are farther downstream from the glacier, at 1.5 and 1.15 km, respectively .

Figure 1 Geomorphological map of proglacial area of Yala (Dakpatsen) Glacier, Langtang Himal, Nepal (pdf 500 kB)

A series of minor moraine ridges are observed on the till surface in the proglacial area of Yala Glacier, Nepal Himalaya. The till surface, which is often fluted, consists ofsix different till sheets. It lies present glacial margin and the bulky terminal moraine ridges. These till sheets correspond to six re-advance stages during the general retreat which followed Little Ice Age ad- vance which formed the bulky terminal moraine ridges. Field observations and till fabric analysis suggest that the minor moraine ridges of Yala Glacier seem to be formed annually, by ice push. On the assumption that their annual character was maintained for a long time, and that the time span needed for each re-advance was proportional to the height of terminal moraine of each till sheet, the dating of Little fee Age moraines was attempted. The results indicate that Little Ice Age advances occurred in 1815 and in 1843, roughly simultanously with those in Europe.

n-Alkanes and lignin in bottom sediments of the West European Basin (area of the battleship Bismark wreck site)

Three bottom sediment cores were collected from the top, slope, and foot of a small topographic high located near the West European continental rise within the Porcupine abyssal plain at the battleship Bismark wreck site. Using high-efficient gas chromatography technique we determined content and examined molecular composition of n-alkane fraction of hydrocarbons and phenol compounds of lignin. n-Alkane and phenol concentrations in bottom sediments of all three cores were low both in values per unit mass of sediments and in organic matter composition that is typical for pelagic deposits of the World Ocean. They vary from 0.07 to 2.01 µg/g of dry sediment and from 0.0001 to 0.01% of TOC; phenol ranges are from 1.43 to 11.1 µg/g and from 0.03 to 0.6%. Non-uniform supply of terrigenous matter to the bottom under conditions of changes in sedimentation environment in different geological epochs is the principal reason for significant variations in n-alkane and lignin concentrations with depth in the cores. Lignin and its derivatives make the main contribution to formation of organic matter composition of the region in study. With respect to n-alkane and lignin concentrations organic matter of deposits of the West European Basin is composed of remains of higher plants and of autochtonous organic matter of marine flora; they have mixed terrigenous-autochtonous (terrigenous-planktonogenic) origin.

Tab. 6+7: Altitudes and variations of altitudes in the area of the Filchner and Neumayer Stations

The determination of the strain and velocity behaviour of the ice surface near the two German Antarctic Stations on Filchner/Ronne and Ekström ice shelves was performed by the use of various geodetic measuring techniques. The relative positions and heights of control points valid for reference data were deduced from terrestrial observations (horizontal and vertical angle selectro optical distances). After a second sampling of data, these values served as the basis for the deformation analyses. Doppler-Satellite-observations (Navy Navigation Satellite System) made absolute positioning (latitude, longitude, height) of special points possible. These Doppler observations, supported by azimuth measurements (gyro-theodolite and sun observations) provided the datum of control networks (translations and orientation). After the repetition of these observations, the drift rates and azimuths of the control points as wenas the rotanon rates of the surface elements could be given. From vertical angles and horizontal distances differences in height end refraction coefficients were calculated. On days without clouds the refraction coefflcients increased by arnounts of up to 3.0 (in extreme cases up to 5.0). Distances over 1 km have to be subdivided to reach a standard deviation level of an heigh: difference better than 0.05 m. In order to determine the heterögeneity of refraction, some height differences should be measured with higher accuracy end-by subdivision of distances.

(Table 2) Production parameters of phytoplankton and some associated parameters in the area of the Titanic Polygon

Studies were carried out mostly in the area of RMS Titanic wreck site (41°44'N, 49°57'W) located above the continental slope and the south of the Grand Banks of Newfoundland. In a period from 18.06 to 24.09.2001 five surveys of production characteristics of surface phytoplankton were conducted over 5-9 days. Mean values of these characteristics obtained during the surveys were 9.2-11.7 mg C/m**3 per day for primary production (C_phs), 0.102-0.188 mg/m**3 for chlorophyll a (C_chls), and 4.44-7.42 mg C/mg chl. a per hour for assimilation number (AN). The main reason for low C_phs variability was a significant inverse relationship (R=-0.66) between AN and C_chls found over the research area. When cold shelf waters dominated in the area (27.07 to 19.08.2001), C_chls values for the slope region (0.125+/-0.031 µg/l) and for the outer shelf (0.130+/-0.040 µg/l) were similar. During strengthening of influence of warmer slope waters within area (from 29.08 to 13.09.2001), C_chls concentration within surface waters of the outer shelf was 0.152+/-0.039 µg/l and exceeded one for the slope region (0.094+/-0.004 µg/l) by factor 1.6. Against the background of low Cchls values, the High values of integral primary production in the water column (510-1010 mg C/m**2 per day) at low C_chls values measured within the area were determined both by high assimilation activity of phytoplankton and by the deep (30-40 m) maximum of primary production. Main reasons for formation of such a maximum were high chlorophyll concentration within the layer of the deep chlorophyll maximum (up to 0.5-2.5 µg/l) and in the relatively high solar irradiance within this layer varying from 1.4 to 8.6% of subsurface PAR.

CTD measurement at station GeoB12761-1 in the area of the Coral Patch seamount (NE Atlantic)

To gain information on the physical parameters of the water masses in the area of the Coral Patch seamount (NE Atlantic), one CTD measurement was accomplished in close vicinity to the seamount (station GeoB 12761: 34°31.210'N, 11°08.510'W, 4430m water depth). CTD measurement were conducted during R/V PELAGIA expedition 64PE284 in spring 2008 (Hebbeln and cruise participants, 2008, urn:nbn:de:gbv:46-ep000103738). The CTD measurement of the water column down to a maximum water depth of 2500m was conducted using a SEABIRD "SBE 9 plus" underwater unit and a SEABIRD "SBE 11 plus" deck unit. The vertical profile over the water column provided standard data for conductivity, temperature and pressure. Additionally, the CTD was equipped with sensors for optical backscatter (turbidity), fluorescence (chlorophyll) and dissolved oxygen. Conductivity and temperature data were used to compute salinity.