Pawn [i.e. prawn] fishery in Gujarat location of new prawn grounds off Veraval

Details about the three departmental vessels, Gulf shrimp, Indian Salmon and Silver Pomfret and gear in the exploratory fishing off Veraval coast are reported. Potential prawn fishing grounds have been located by their operation in section 20-70, 21-69 and 22-69 in the cruises conducted in October, 1962. Observation regarding suitability of gear and composition of catch are given. The possibility of better prawn grounds occurring in areas deeper than the present grounds is indicated.

Minimization of cannibalism of African catfish (Clarias gariepinus Burchell) larvae in indoor culture system

For minimizing cannibalism of African catfish (Clarias gariepinus) larvae two trials for a period of 14 and 15 days respectively in four aquaria of size 120x49x32 cm³ were conducted. Seven days old African catfish larvae with an initial total length and weight of 7.84 (±0.40) mm and 4.40 (±1.18) mg respectively in the first trial and similarly 7.52(±0.61) mm and 3.98 (±0.56) mg in the second trial at the rate of same stocking densities of 2500 larvae in each aquarium were stocked in both trials. Cannibalistic larvae were separated by using grader frame from each treatment at 7 days and 5 days interval during first and second trial respectively. Two mesh sizes i.e., 5 mm and 7 mm were used in the grader frame in both trials. Survival rate was significantly higher in T1 than that of T2 in each trial. Grading of larvae with 5 days interval resulted higher survival rate than that of 7 days interval.

Echo location of fishes in Dhudawa reservoir (Madhya Pradesh)

An investigation was undertaken in order to locate fish using an echo sounder in Dhudawa Reservoir, Madhya Pradesh, India. In general, fish were found to be distributed either towards off-bottom or mid-water areas. Echo sounding is recommended for use in other reservoirs for fish detection.

Effect of bend orientation on life and puncture point location due to solid particle erosion of a high concentration flow in pneumatic conveyors

An investigation into predicting failure of pneumatic conveyor pipe bends due to hard solid particle impact erosion has been carried out on an industrial scale test rig. The bend puncture point locations may vary with many factors. However, bend orientation was suspected of being a main factor due to the biased particle distribution pattern of a high concentration flow. In this paper, puncture point locations have been studied with different pipe bend orientations and geometry (a solids loading ratio of 10 being used for the high concentration flow). Test results confirmed that the puncture point location is indeed most significantly influenced by the bend orientation (especially for a high concentration flow) due to the biased particle distribution and biased particle flux distribution. © 2004 Elsevier B.V. All rights reserved.