Systematic bias in MODIS dust aerosol retrieval at Kanpur (AERONET), Indo-Gangetic Basin - art.no.640816

We have compared the spectral aerosol optical depth (AOD) and aerosol fine mode fraction (AFMF) derived from Moderate Resolution Imaging Spectroradiometer (MODIS) with those of Aerosol Robotic Network (AERONET) at Kanpur (26.45N, 80.35E), northern India for the pre-monsoon season (March to June, 2001-2005). We found that MODIS systematically overestimates AOD during pre-monsoon season (known to be influenced by dust transport from north-west of India). The errors in AOD were correlated with the MODIS top-of-atmosphere apparent surface reflectance in 2.1 mu m channel (rho*(2.1)). MODIS aerosol algorithm uses p*(2.1) to derive the surface reflectance in visible channels (rho(0.47), rho(0.66)) using an empirical mid IR-visible correlation (rho(0.47) = rho(2.1)/4, rho(0.66) = rho(2.1)/2). The large uncertainty in estimating surface reflectance in visible channels (Delta rho(0.66)+/- 0.04, Delta rho(0.47)+/- 0.02) at higher values of p*(2.1) (p*(2.1) > 0.18) leads to higher aerosol contribution in the total reflected radiance at top-of atmosphere to compensate for the reduced surface reflectance in visible channels and thus leads to overestimation of AOD. This was also reflected in the very low values of AFMF during pre-monsoon whose accuracy depends on the aerosol path radiance in 0.47 and 0.66 mu m channels and aerosol models. The errors in AOD were also high in the scattering angle range 110 degrees-140 degrees, where the effect of dust non-spherity on its optical properties is significant. The direct measurements of spectral surface reflectance are required over the Indo-Gangetic basin in order to validate the mid IR-visible relationship. MODIS aerosol models should also be modified to incorporate the effect of non-spherity of dust aerosols.

A TEM study on TiB2-20%MoSi2 composite: Microstructure development and densification mechanism

We report the results of transmission electron microscopy (TEM) study, carried out on a hot-pressed TiB2-20 wt.%MoSi2 composite. One of the important microstructural observations includes the detection of crystalline TiSi2 at triple grain junctions. The densification mechanism is discussed, based on experimental observations and thermodynamic analysis

SC-FDMA versus OFDMA: Sensitivity to Large Carrier Frequency and Timing Offsets on the Uplink

In this paper, we present a comparison between the sensitivity of SC-FDMA and OFDMA schemes to large carrier frequency offsets (CFO) and timing offsets (TO) of different users on the uplink. Our study shows the following observations: 1) In the ideal case of zero CFOs and TOs (i.e., perfect synchronization), the uncoded BER performance of SC-FDMA with frequency domain MMSE equalizer is better than that of OFDMA due to the inherent frequency diversity that is possible in SCFDMA. Also, because of inter-symbol interference in SC-FDMA, the performance of SC-FDMA with MMSE equalizer can be further improved by using low-complexity interference cancellation (IC) techniques. 2) In the presence of large CFOs and TOs, significant multiuser interference (MUI) gets introduced, and hence the performance of SC-FDMA with MMSE equalizer can get worse than that of OFDMA. However, the performance advantage of SC-FDMA with MMSE equalizer over OFDMA (due to the potential for frequency diversity benefit in SC-FDMA) can be restored by adopting multistage IC techniques, using the knowledge of CFOs and TOs of different users at the receiver

Identification and expression of the 20 kd structural protein gene of colitis bacteriophage

The 2.3 kb BamHI fragment from the colitis bacteriophage DNA was transcribed and translated into a 20 kd structural protein P6, in a coupled transcription-translation system derived from Escherichia coli. This protein was expressed in vivo by the 2.3 kb DNA cloned in pBR322. The gene with the regulatory elements for this protein was located on the 680 bp AvaII fragment of the insert DNA. It hybridized with two RNAs of sizes 520 and 1630 nucleotides indicating that both are messengers for the 20 kd protein. Dot-blot hybridization showed that the transcripts for P6 reached a maximum level at 12 min after phage infection.

Importance of local heating in the compaction of thermally sensitive solids

Local heating is an important parameter in compaction of thermally sensitive solids since local hot spots could conceivably raise the temperature of the system by several hundred degrees. To understand the importance of local hot spots, 20 g of ammonium perchlorate (AP) and potassium perchlorate (KP) were pressed together at 1500 kg cm−2 for 5 min. The surface structural examination of the compact revealed a secondary phase at the interfaces between the grains in the compositions ranging from 50% AP-50% KP to 10% AP-90% KP. The observation of the secondary phase only at the interfaces has been attributed to the short life times of temperature pulses present during the compaction. An interesting aspect of the investigation is the formation of a series of solid solutions of AP-KP.

Alaviisaudenhampaan juuren etäisyys alaleuanhermosta 20-vuotiailla

Alaviisaudenhampaiden poistojen harvinaisiin komplikaatioihin kuuluu alaleuanhermon vaurioituminen. Ennen poistoa panoraamakuvasta määritetään hampaan ja hermokanavan välinen etäisyys: rakenteiden kuvautuessa erilleen ei hermovaurion vaaraa katsota olevan. Tutkielman tarkoituksena oli selvittää, kuinka usein alaviisaudenhammas ja hermokanava kuvautuvat panoraamakuvassa päällekkäin, erilleen tai sivuavat toisiaan. Tutkimusaineiston panoraamakuvat on otettu Ylioppilaiden Terveydenhoitosäätiöllä Helsingissä osana normaalia hammashoitoa 20-vuotiaista (20,3±0,6 vuotta) Helsingin yliopiston opiskelijoista (N=137, naisia 71 %). Mukaan otetuissa kuvissa näkyi molemmat alaviisaudenhampaat. Panoraamakuvista mitattiin alaviisaudenhampaan etäisyys hermokanavasta millimetreinä. Tilastollisena menetelmänä käytettiin Khin-neliötestiä ja merkitsevänä erona P<0,05. Tulosten mukaan vain viidennes (19 %) alaviisaudenhampaista kuvautui erilleen hermokanavasta. Sivuavia oli 21 % ja päällekkäin kuvautuvia 60 %. Naisilla hermokanavan kanssa päällekkäin kuvautuvia hampaita oli huomattavasti enemmän kuin miehillä (65 % ja 46 %, P=0,003). Johtopäätöksenä oli, että ennen poistoa lähes kaikkien kohdalla (4/5) on pohdittava hermovaurion mahdollisuutta ja otettava potilas mukaan hoitopäätöksen tekoon. Tutkimuksen tulos on tärkeä, sillä alaviisaudenhampaita poistetaan paljon ja panoraamakuvaus on yleisin tutkimus ennen poistoja.

The structure of 3[beta],20[alpha]-bis(dimethylamino)pregn-5-en-18-ol

Abstract. C25H44N20 , M r= 388.6, orthorhombic, P21212 I, a = 6.185 (2), b = 18.123 (2), c = 20.852 (2) A, U= 2337.2 A 3, Z = 4, D x = 1.104 Mg m -a, 2(Cu Ka) = 1.5418 A,/~ = 0.47 mm -~, F(000) = 864, T= 293 K. Final R - 0.038 for 1791 reflections with I >_ 3a(I). Rings A and C are in chair conformation. Ring B is in an 8fl,9a-half-chair conformation. Ring D adopts a conformation in between 13fl,14a-half-chair and 13t-envelope. There is a quasitrans fusion of rings A and B, whilst ring systems B/C and C/D are trans fused about the bonds C(8)-C(9)and C(13)-C(14).

Silva Fennica Vol. 20, 1986.

Julkaistu Silva Fennica Vol. 20(4) -numeron liitteenä.

An in situ electron microscope investigation of the icosahedral-to-decagonal quasicrystalline transformation in Al-20 at.% Mn

The solid-state transformation behaviour of the icosahedral phase in rapidly solidified Al-20 at.% Mn has been investigated by in situ heating experiments in the transmission electron microscope. As-rapidly-solidified Al-20 at.% Mn consists mainly of a dendritic icosahedral phase, with a small amount of interdendritic f.c.c. agr-Al. During subsequent heat treatment at temperatures below about 500°C, the dendritic icosahedral phase grows and consumes the interdendritic agr-Al. At about 500°C the decagonal phase nucleates near icosahedral dendrite and grain boundaries and then grows into the icosahedral matrix by lateral motion of ledges 10-20 nm high across facet planes normal to the twofold symmetry axes. At about 600°C the decagonal phase transforms into a crystalline phase. The present study suggests that solid-state decomposition of the icosahedral phase is the mechanism of decagonal phase formation in as-rapidly-solidified Al-Mn alloys.

Covalent attachment of two important dicopper(II) systems in a one-dimensional polymeric chain: An x-ray structure of [Cu2(en)2(OH)2·Cu2(O2CMe)4](PF6)2·0.5EtOH]α showing the shortest Cucdots, three dots, centeredCu Distance in the tetraacetato core

Reaction of Cu2(O2CMe)4(H2O)2 with 1,2-diaminoethane(en) in ethanol, followed by the addition of NH4PF6, led to the formation of a covalently linked 1D polymeric copper(II) title complex showing alternating [Cu2(en)2(OH)22+] and [Cu2(O2CMe)4] units in the chain and the shortest Cucdots, three dots, centeredCu separation of 2.558(2) Å in the tetraacetato core.