Simulation of the influence of rate- and state-dependent friction on the macroscopic behavior of complex fault zones with the lattice solid model

In order to understand the earthquake nucleation process, we need to understand the effective frictional behavior of faults with complex geometry and fault gouge zones. One important aspect of this is the interaction between the friction law governing the behavior of the fault on the microscopic level and the resulting macroscopic behavior of the fault zone. Numerical simulations offer a possibility to investigate the behavior of faults on many different scales and thus provide a means to gain insight into fault zone dynamics on scales which are not accessible to laboratory experiments. Numerical experiments have been performed to investigate the influence of the geometric configuration of faults with a rate- and state-dependent friction at the particle contacts on the effective frictional behavior of these faults. The numerical experiments are designed to be similar to laboratory experiments by DIETERICH and KILGORE (1994) in which a slide-hold-slide cycle was performed between two blocks of material and the resulting peak friction was plotted vs. holding time. Simulations with a flat fault without a fault gouge have been performed to verify the implementation. These have shown close agreement with comparable laboratory experiments. The simulations performed with a fault containing fault gouge have demonstrated a strong dependence of the critical slip distance D-c on the roughness of the fault surfaces and are in qualitative agreement with laboratory experiments.

Exchange rate sensitivity of Australian international equity funds

This paper analyses the exchange rate exposure displayed by a sample of Australian international equity trusts (IET). Exchange rate exposure is also examined in the context of differing economic climates with particular emphasis on the Asian crisis in mid-1997. It is found that there is evidence of exchange rate exposure particularly in the context of a multiple exchange rate model. Exposure varies substantially between three alternative time periods with different exposure apparent subsequent to the Asian crisis than prior to this event.

The effect of heat transfer mode on heart rate responses and hysteresis during heating and cooling in the estuarine crocodile Crocodylus porosus

The effect of heating and cooling on heart rate in the estuarine crocodile Crocodylus porosus was studied in response to different heat transfer mechanisms and heat loads. Three heating treatments were investigated. C. porosus were: (1) exposed to a radiant heat source under dry conditions; (2) heated via radiant energy while half-submerged in flowing water at 23degreesC and (3) heated via convective transfer by increasing water temperature from 23degreesC to 35degreesC. Cooling was achieved in all treatments by removing the heat source and with C. porosus half-submerged in flowing water at 23degreesC. In all treatments, the heart rate of C. porosus increased markedly in response to heating and decreased rapidly with the removal of the heat source. Heart rate during heating was significantly faster than during cooling at any given body temperature, i.e. there was a significant heart rate hysteresis. There were two identifiable responses to heating and cooling. During the initial stages of applying or removing the heat source, there was a dramatic increase or decrease in heart rate ('rapid response'), respectively, indicating a possible cardiac reflex. This rapid change in heart rate with only a small change or no change in body temperature (

On the robustness of short-term interest rate models

This paper investigates the robustness of a range of short–term interest rate models. We examine the robustness of these models over different data sets, time periods, sampling frequencies, and estimation techniques. We examine a range of popular one–factor models that allow the conditional mean (drift) and conditional variance (diffusion) to be functions of the current short rate. We find that parameter estimates are highly sensitive to all of these factors in the eight countries that we examine. Since parameter estimates are not robust, these models should be used with caution in practice.

Application of fairness theory to service failures and service recovery

This article presents a fairness theory-based conceptual framework for studying and managing consumers’ emotions during service recovery attempts. The conceptual framework highlights the central role played by counterfactual thinking and accountability. Findings from five focus groups are also presented to lend further support to the conceptual framework. Essentially, the article argues that a service failure event triggers an emotional response in the consumer, and from here the consumer commences an assessment of the situation, considering procedural justice, interactional justice, and distributive justice elements, while engaging in counterfactual thinking and apportioning accountability. More specifically, the customer assesses whether the service provider could and should have done something more to remedy the problem and how the customer would have felt had these actions been taken. The authors argue that during this process situational effort is taken into account when assessing accountability. When service providers do not appear to exhibit an appropriate level of effort, consumers attribute this to the service provider not caring. This in turn leads to the customer feeling more negative emotions, such as anger and frustration. Managerial implications of the study are discussed.

The role of gender in reactions to service failure and recovery

Male and female consumers place different emphasis on elements of the service recovery process. Perceptions were influenced by gender of the service provider and by a match of customer and service provider gender. The study, an experimental design with 712 respondents, found that when service providers, irrespective of gender, display concern and give customers voice and a sizable compensation, both men and women reported more positive attitudes compared with when this was not so. Combinations of high voice with high outcome and high voice with high concern were especially important in positively influencing perceptions of effort, regardless of gender. However, the authors also found that there were significant differences between male and female respondents regarding their perceptions of how service recovery should be handled. Women want their views heard during service recovery attempts and to be allowed to provide input. Men, in contrast, do not view voice as important.

A mathematical model of concentrate solids content for the wet drum magnetic separator

Low concentrate density from wet drum magnetic separators in dense medium circuits can cause operating difficulties due to inability to obtain the required circulating medium density and, indirectly, high medium solids losses. The literature is almost silent on the processes controlling concentrate density. However, the common name for the region through which concentrate is discharged-the squeeze pan gap-implies that some extrusion process is thought to be at work. There is no model of magnetics recovery in a wet drum magnetic separator, which includes as inputs all significant machine and operating variables. A series of trials, in both factorial experiments and in single variable experiments, was done using a purpose built rig which featured a small industrial scale (700 mm lip length, 900 turn diameter) wet drum magnetic separator. A substantial data set of 191 trials was generated in this work. The results of the factorial experiments were used to identify the variables having a significant effect on magnetics recovery. It is proposed, based both on the experimental observations of the present work and on observations reported in the literature, that the process controlling magnetic separator concentrate density is one of drainage. Such a process should be able to be defined by an initial moisture, a drainage rate and a drainage time, the latter being defined by the volumetric flowrate and the volume within the drainage zone. The magnetics can be characterised by an experimentally derived ultimate drainage moisture. A model based on these concepts and containing adjustable parameters was developed. This model was then fitted to a randomly chosen 80% of the data, and validated by application to the remaining 20%. The model is shown to be a good fit to data over concentrate solids content values from 40% solids to 80% solids and for both magnetite and ferrosilicon feeds. (C) 2003 Elsevier Science B.V. All rights reserved.

Repetitive brief ischemia: Intermittent reperfusion during ischemia ameliorates the extent of injury in the perfused kidney

Acute renal failure commonly follows reduced renal perfusion or ischemia. Reperfusion is essential for recovery but can itself cause functional and structural injury to the kidney. The separate contributions of ischemia and of reperfusion were examined in the isolated perfused rat kidney. Three groups were studied: brief (5 min) ischemia, 20 min ischemia, and repetitive brief ischemia (4 periods of 5 min) with repetitive intervening reperfusion of 5 min. A control group had no intervention, the three ischemia groups were given a baseline perfusion of 30 min before intervention and all groups were perfused for a total of 80 min. In addition, the effects of exogenous (NO)-N-. from sodium nitroprusside and xanthine oxidase inhibition by allopurinol were assessed in the repetitive brief ischemia-reperfusion model. Brief ischemia produced minimal morphological injury with near normal functional recovery. Repetitive brief ischemia reperfusion caused less functional and morphological injury than an equivalent single period of ischemia (20 min) suggesting that intermittent reperfusion is less injurious than ischemia alone over the time course of study. Pretreatment with allopurinol improved renal function after repetitive brief ischemia-reperfusion compared with the allopurinol-untreated repetitive brief ischemia-reperfusion group. Similarly, sodium nitroprusside reduced renal vascular resistance but did not improve the glomerular filtration rate or sodium reabsorption in the repetitive brief ischemia-reperfusion model. Thus, these studies show that the duration of uninterrupted ischemia is more critical than reperfusion in determining the extent of renal ischemia-reperfusion injury and that allopurinol, in particular, counteracts the oxidative stress of reperfusion.

CRIM1 Regulates the Rate of Processing and Delivery of Bone Morphogenetic Proteins to the Cell Surface

The Crim1 gene is predicted to encode a transmembrane protein containing six von Willebrand-like cysteine-rich repeats (CRRs) similar to those in the BMP-binding antagonist Chordin (Chrd). In this study, we verify that CRIM1 is a glycosylated, Type I transmembrane protein and demonstrate that the extracellular CRR-containing domain can also be secreted, presumably via processing at the membrane. We have previously demonstrated Crim1 expression at sites consistent with an interaction with bone morphogenetic proteins (BMPs). Here we show that CRIM1 can interact with both BMP4 and BMP7 via the CRR-containing portion of the protein and in so doing acts as an antagonist in three ways. CRIM1 binding of BMP4 and -7 occurs when these proteins are co-expressed within the Golgi compartment of the cell and leads to (i) a reduction in the production and processing of preprotein to mature BMP, (ii) tethering of pre-BMP to the cell surface, and (iii) an effective reduction in the secretion of mature BMP. Functional antagonism was verified by examining the effect of coexpression of CRIM1 and BMP4 on metanephric explant culture. The presence of CRIM1 reduced the effective BMP4 concentration of the media, thereby acting as a BMP4 antagonist. Hence, CRIM1 modulates BMP activity by affecting its processing and delivery to the cell surface

Exceptionally high-rate nitrification in sequencing batch reactors treating high ammonia landfill leachate

The nitrogen removal capacity of a suspended culture system treating mature landfill leachate was investigated. Leachate containing high ammonium levels of 300-900 mg N/L was nitrified in a bench scale sequencing batch reactor. Leachate from four different landfills was treated over a two year period for the removal of nitrogen. In this time, a highly specific nitrifying culture was attained that delivered exceptionally high rates of ammonia removal. No sludge was wasted from the system to increase the throughput and up to 13 g/L of MLSS was obtained. Settleability of the purely nitrifying biomass was excellent with SVI less than 40 mL/g, even at the high sludge concentrations. Nitrification rates up to 246 mg NI(L h) (5.91 g N/(L d)) and specific nitrification rates of 36 mg N/(gVSS h) (880 mg N/(gVSS d)) were obtained. The loading to the system at this time allowed complete nitrification of the leachate with a hydraulic retention time of only 5 hours. Following these successful treatability studies, a full-scale plant was designed and built at one of the landfills investigated.

Development of a quality use of medicines coding system to rate clinical pharmacists' medication review recommendations

Objective: To develop a 'quality use of medicines' coding system for the assessment of pharmacists' medication reviews and to apply it to an appropriate cohort. Method: A 'quality use of medicines' coding system was developed based on findings in the literature. These codes were then applied to 216 (111 intervention, 105 control) veterans' medication profiles by an independent clinical pharmacist who was supported by a clinical pharmacologist with the aim to assess the appropriateness of pharmacy interventions. The profiles were provided for veterans participating in a randomised, controlled trial in private hospitals evaluating the effect of medication review and discharge counselling. The reliability of the coding was tested by two independent clinical pharmacists in a random sample of 23 veterans from the study population. Main outcome measure: Interrater reliability was assessed by applying Cohen's kappa score on aggregated codes. Results: The coding system based on the literature consisted of 19 codes. The results from the three clinical pharmacists suggested that the original coding system had two major problems: (a) a lack of discrimination for certain recommendations e. g. adverse drug reactions, toxicity and mortality may be seen as variations in degree of a single effect and (b) certain codes e. g. essential therapy were in low prevalence. The interrater reliability for an aggregation of all codes into positive, negative and clinically non-significant codes ranged from 0.49-0.58 (good to fair). The interrater reliability increased to 0.72-0.79 (excellent) when all negative codes were excluded. Analysis of the sample of 216 profiles showed that the most prevalent recommendations from the clinical pharmacists were a positive impact in reducing adverse responses (31.9%), an improvement in good clinical pharmacy practice (25.5%) and a positive impact in reducing drug toxicity (11.1%). Most medications were assigned the clinically non-significant code (96.6%). In fact, the interventions led to a statistically significant difference in pharmacist recommendations in the categories; adverse response, toxicity and good clinical pharmacy practice measured by the quality use of medicine coding system. Conclusion: It was possible to use the quality use of medicine coding system to rate the quality and potential health impact of pharmacists' medication reviews, and the system did pick up differences between intervention and control patients. The interrater reliability for the summarised coding system was fair, but a larger sample of medication regimens is needed to assess the non-summarised quality use of medicines coding system.