Risk of foot and mouth disease associated with proximity in space and time to infected premises and the implications for control policy during the 2001 epidemic in Cumbria

An analysis was made that calculated the risk of disease for premises in the most heavily affected parts of the county of Cumbria during the foot-and-mouth disease epidemic in the UK in 2001. In over half the cases the occurrence of the disease was not directly attributable to a recently infected premises being located within 1.5 km. Premises more than 1.5 km from recently infected premises faced sufficiently high infection risks that culling within a 1.5 km radius of the infected premises alone could not have prevented the progress of the epidemic. A comparison of the final outcome in two areas of the county, south Penrith and north Cumbria, indicated that focusing on controlling the potential spread of the disease over short distances by culling premises contiguous to infected premises, while the disease continued to spread over longer distances, may have resulted in excessive numbers of premises being culled. Even though the contiguous cull in south Penrith appeared to have resulted in a smaller proportion of premises becoming infected, the overall proportion of premises culled was considerably greater than in north Cumbria, where, because of staff and resource limitations, a smaller proportion of premises contiguous to infected premises was culled

Including a time-of-year effect in the analysis of a matched case-control study

Motivated by a matched case-control study to investigate potential risk factors for meningococcal disease amongst adolescents, we consider the analysis of matched case-control studies where disease incidence, and possibly other risk factors, vary with time of year. For the cases, the time of infection may be recorded. For controls, however, the recorded time is simply the time of data collection, which is shortly after the time of infection for the matched case, and so depends on the latter. We show that the effect of risk factors and interactions may be adjusted for the time of year effect in a standard conditional logistic regression analysis without introducing any bias. We also show that, if the time delay between data collection for cases and controls is constant, provided this delay is not very short, estimates of the time of year effect are approximately unbiased. In the case that the length of the delay varies over time, the estimate of the time of year effect is biased. We obtain an approximate expression for the degree of bias in this case. Copyright © 2004 John Wiley & Sons, Ltd.

Multi-microprocessor control of processes with pure time delay

In 1967 a novel scheme was proposed for controlling processes with large pure time delay (Fellgett et al, 1967) and some of the constituent parts of the scheme were investigated (Swann, 1970; Atkinson et al, 1973). At that time the available computational facilities were inadequate for the scheme to be implemented practically, but with the advent of modern microcomputers the scheme becomes feasible. This paper describes recent work (Mitchell, 1987) in implementing the scheme in a new multi-microprocessor configuration and shows the improved performance it provides compared with conventional three-term controllers.

Discrete demand side control performance under dynamic building simulation: a heat pump application

This study presents the findings of applying a Discrete Demand Side Control (DDSC) approach to the space heating of two case study buildings. High and low tolerance scenarios are implemented on the space heating controller to assess the impact of DDSC upon buildings with different thermal capacitances, light-weight and heavy-weight construction. Space heating is provided by an electric heat pump powered from a wind turbine, with a back-up electrical network connection in the event of insufficient wind being available when a demand occurs. Findings highlight that thermal comfort is maintained within an acceptable range while the DDSC controller maintains the demand/supply balance. Whilst it is noted that energy demand increases slightly, as this is mostly supplied from the wind turbine, this is of little significance and hence a reduction in operating costs and carbon emissions is still attained.

Transputer based real time robot control

A parallel processor architecture based on a communicating sequential processor chip, the transputer, is described. The architecture is easily linearly extensible to enable separate functions to be included in the controller. To demonstrate the power of the resulting controller some experimental results are presented comparing PID and full inverse dynamics on the first three joints of a Puma 560 robot. Also examined are some of the sample rate issues raised by the asynchronous updating of inertial parameters, and the need for full inverse dynamics at every sample interval is questioned.

From saccades to smooth pursuit: real-time gaze control using motion feedback

The authors present an active vision system which performs a surveillance task in everyday dynamic scenes. The system is based around simple, rapid motion processors and a control strategy which uses both position and velocity information. The surveillance task is defined in terms of two separate behavioral subsystems, saccade and smooth pursuit, which are demonstrated individually on the system. It is shown how these and other elementary responses to 2D motion can be built up into behavior sequences, and how judicious close cooperation between vision and control results in smooth transitions between the behaviors. These ideas are demonstrated by an implementation of a saccade to smooth pursuit surveillance system on a high-performance robotic hand/eye platform.

Control of flowering time in temperate cereals: genes, domestication, and sustainable productivity

The control of flowering is central to reproductive success in plants, and has a major impact on grain yield in crop species. The global importance of temperate cereal crops such as wheat and barley has meant emphasis has long been placed on understanding the genetics of flowering in order to enhance yield. Leads gained from the dissection of the molecular genetics of model species have combined with comparative genetic approaches, recently resulting in the isolation of the first flowering time genes in wheat and barley. This paper reviews the genetics and genes involved in cereal flowering pathways and the current understanding of how two of the principal genes, Vrn and Ppd, have been involved in domestication and adaptation to local environments, and the implications for future breeding programmes are discussed.

The impact of cognitive control on children's goal monitoring in a time-based prospective memory task

The present study investigated whether developmental changes in cognitive control may underlie improvements of time-based prospective memory. Five-, 7-, 9-, and 11-year-olds (N = 166) completed a driving simulation task (ongoing task) in which they had to refuel their vehicle at specific points in time (PM task). The availability of cognitive control resources was experimentally manipulated by imposing a secondary task that required divided attention. Children completed the driving simulation task both in a full attention condition and a divided attention condition where they had to carry out a secondary task. Results revealed that older children performed better than younger children on the ongoing task and PM task. Children performed worse on the ongoing and PM tasks in the divided attention condition compared to the full attention condition. With respect to time monitoring in the final interval prior to the PM target, divided attention interacted with age such that older children’s time monitoring was more negatively affected by the secondary task compared to younger children. Results are discussed in terms of developmental shifts from reactive to proactive monitoring strategies.