The preparation and stability of the inclusion complex of astaxanthin with beta-cyclodextrin

Inclusion complex of astaxanthin with beta-cyclodextrin was prepared. The water solubility of the inclusion complex was < 0.5 mg/ml, which is better than that of astaxanthin. Large aggregates were observed in the aqueous solution of the inclusion complex. Furthermore, the stability of the inclusion complex against temperature and light was greatly enhanced compared to that of astaxanthin. (c) 2006 Elsevier Ltd. All rights reserved.

Biosorption of Cr(VI) from aqueous solutions by nonliving green algae Cladophora albida

Biosorption of Cr(VI) from aqueous solutions by nonliving green algae Cladophora albida was investigated in batch experiments. The influence of pH, algal dosage, initial Cr(VI) concentration, temperature and coexisting anions on removal efficiencies of C. albida was studied. Cr(VI) removal process was influenced significantly by the variation of pH, and the optimum pH was chosen at a range of 1.0-3.0. The optimum algal dosage 2 g/L was used in the experiment. The removal rate of Cr(VI) was relatively rapid in the first 60 min, but then the rate decreased gradually. Removal mechanism was studied by analyzing Cr(VI) and total Cr in the solution. Biosorption and bioreduction were involved in the Cr(VI) removal. Biosorption of Cr(VI) was the first step. followed by Cr(VI) bioreduction and Cr(III) biosorption on the algal biomass. Actual industrial wastewater was used to evaluate the practicality of the biomass C. albida. From a practical viewpoint, the abundant and economic biomass C. albida could be used for removal of Cr(VI) from wastewater by the reduction of toxic Cr(VI) to less toxic Cr(III). (C) 2008 Elsevier Ltd. All rights reserved.

Photocatalytic degradation of CI Acid Blue 80 in aqueous suspensions of titanium dioxide under sunlight

The dye C.I. Acid Blue 80 (AB80) was easily degraded by TiO2-P25 assisted photocatalysis in aqueous dispersion under irradiation of sunlight. The optimal reaction conditions were [TiO2] = 2.0 g/L, pH = 10, [H2O2] = 5 mmol/L. The photocatalytic reaction followed pseudo-first order kinetics. The adsorption of AB80 onto TiO2 was in accord with Langmuir equation.

Biosorption of copper(II) from aqueous solutions by green alga Cladophora fascicularis

Biosorption is an effective means of removal of heavy metals from wastewater. In this work the biosorption behavior of Cladophora fascicularis was investigated as a function of pH, amount of biosorbent, initial Cu2+ concentration, temperature, and co-existing ions. Adsorption equilibria were well described by Langmuir isotherm models. The enthalpy change for the biosorption process was found to be 6.86 kJ mol(-1) by use of the Langmuir constant b. The biosorption process was found to be rapid in the first 30 min. The presence of co-existing cations such as Na+, K+, Mg2+, and Ca2+ and anions such as chloride, nitrate, sulfate, and acetate did not significantly affect uptake of Cu2+ whereas EDTA substantially affected adsorption of the metal. When experiments were performed with different desorbents the results indicated that EDTA was an efficient desorbent for the recovery of Cu2+ from biomass. IR spectral analysis suggested amido or hydroxy, C=O, and C-O could combine strongly with Cu2+.

Biosorption of copper (II) and lead (II) from aqueous solutions by nonliving green algae Cladophora fascicularis: Equilibrium, kinetics and environmental effects

Biosorption of Cu2+ and Pb2+ by Cladophora fascicularis was investigated as a function of initial pH, initial heavy metal concentrations, temperature and other co-existing ions. Adsorption equilibriums were well described by Langmuir and Freundlich isotherm models. The maximum adsorption capacities were 1.61 mmol/ g for Cu2+ and 0.96 mmol/ g for Pb2+ at 298K and pH 5.0. The adsorption processes were endothermic and biosorption heats calculated by the Langmuir constant b were 39.0 and 29.6 kJ/ mol for Cu2+ and Pb2+, respectively. The biosorption kinetics followed the pseudo- second order model. No significant effect on the uptake of Cu2+ and Pb2+ by co-existing cations and anions was observed, except EDTA. Desorption experiments indicated that Na(2)EDTA was an efficient desorbent for the recovery of Cu2+ and Pb2+ from biomass. The results showed that Cladophora fascicularis was an effective and economical biosorbent material for the removal and recovery of heavy metal ions from wastewater.

水-盐-气天然流体的物理化学性质模拟与流体包裹体应用研究

Natural fluids with water-salt-gas are often found in every sphere of the Earth, whose physicochemical properties and geochemical behaviors are complicated. To study these properties and behaviors turns out to be one of the challenging issues in geosciences. Traditional approaches mainly depend on experiments and observations. However, it is impossible to obtain a large number of data covering a large T-P space of the Earth by experimental methods in the near future, which will hinder the advance of the theoretical study. Therefore, it is important to model natural fluids by advanced theoretical methods, by which limited experimental data can be extended to a large temperature-pressure-composition space. Physicochemical models developed in this dissertation are not only more accurate, but also extend the applied T-P-m region of the experimental data of the multi-fluid systems by about two times. These models provide the new and accurate theoretical tools for the geochemical research, especially for the water-rock interactions and the study of the fluid inclusions. The main achievements can be summarized as follows: (1) A solubility model on components of natural gases is presented. The solubility model on the systems of CH4-H2O-NaCl, C2H6-H2O-NaCl or N2-H2O-NaCl takes advantage of modern physicochemical theory and methods, and is an improvement over previous models whose prediction and precision are relatively poor. The model can predict not only the gas solubility in liquid phase but also water content in the gas phase. In addition, it can predict gases (methane or nitrogen) solubility in seawater and brine. Isochores can be determined, which are very important in the interpretation of fluid inclusions. (2) A density model on common aqueous salt solutions is developed. The density models with high precision for common aqueous salt solutions (H2O-NaCl, H2O-LiCl, H2O-KCl, H2O-MgCl2, H2O-CaCl2, H2O-SrCl2 or H2O-BaCl2) are absent in the past. Previous density models are limited to the relatively small range of experimental data, and cannot meet the requirement of the study of natural fluids. So a general density model of the above systems is presented by us based on the international standard density model of the water. The model exceeds the other models in both precision and prediction. (3) A viscosity model on common aqueous alkali-chloride solutions is proposed. Dynamic viscosity of water-salt systems, an important physics variable, is widely used in three-dimension simulation of the fluids. But in most cases, due to the lack of viscosity models with a wide T-P range, the viscosity of aqueous salt solutions is replaced by that of the water, giving rise to a relatively large uncertainty. A viscosity model with good prediction for the systems (H2O-NaCl, H2O-LiCl or H2O-KCl) is presented on the base of the international standard viscosity model of water and the density model developed before. (4) Equation of State applied in fluid inclusions. The best Equations of State in the world developed by others or us recently are applied in the study of the fluid inclusions. Phase equilibria and isochores of unitary system (e.g. H2O, CO2, CH4, O2, N2, C2H6 or H2S), binary H2O-NaCl system and ternary H2O-CH4-NaCl system are finished. From these programs and thermodynamic equations of coexisting ores, the physicochemical conditions before or after the deposits form can be determined. To some extent, it is a better tool.

高温实验中重金属钼在硅酸盐熔体中的含量研究

This dissertation discusses current status of high temperature and high pressure and focuses on analyzing systematically the solubility of heavy metals in the silicate magma in HTHP experiments. The high temperature study on the content of heavy metal molybdenum in the silicate melts in this dissertation, which is granted, based on the geology mineralization model and the theory of HTHP experiments and combined with mineralization grade and geochemical nature of Mo, discusses the difference of mineralization between mantle plume and aqueous fluids and comes to the conclusions, which are as follows: (1) The content of Mo in the silicate melts is much greater than Mo mineralization grade. The molybdenum ore has the exploitation value when the industrial grade is higher than 0.06%. Mo content in different silicate melts varies because of the concentration of SiO2, that is, Mo content in the granodiorite is greater. (2) The content of Mo, which varies with reaction time, arises first and drops down in the alkali basalt melts, while variation is not too obvious in the granodiorite melts on the whole. (3) According to the picture of sample, the conclusion is not reached very well on some issues, such as the volatility and characteristic of molybdenum oxide and dependence on the geology environment.