Fishing gear survey of Kainji Lake, northern Nigeria, 1996

A survey was carried out in September 1996 alongside the annual frame survey of Kainji Lake, Nigeria. As in the previous surveys, there were 6 main fishing gear types in use on the lake, which included gill nets, drift nets, beach seines, cast nets, longlines (baited and foul hooking) acid fishing traps. A total of 813 canoes were sampled. The canoe lengths were similar to the previous gear surveys. Altogether 466 gill nets were measured. They had an average length of 149 m, and were mostly bottom set. Of the gill nets measured 68% had a mesh size below 3 inches the minimum mesh size allowable according to the Niger and Kebbi State Fisheries Edict, 1996. Of concern was the large increase in the number of 1 inch meshed nets recorded on the lake. Drift nets had a mean length of 74 m. A total of 88% of all drift nets measured had a mesh size below 2.5 inches, the minimum mesh size stipulated in the State Edict. A total number of 102 beach seines were sampled with a mean length of 110 m, the mesh size in use on the lake remained as 0.1 inches under the Edict beach seines are banned from fishing in Kainji Lake. The decline in the lengths of the beach seines (and therefore catch rates) recorded since l995 was encouraging in the light of the destructive nature of these nets. A total of 30 cast nets were sampled, they had a mean diameter of 9.8 and a mean mesh size of 1.9 inches. All the nets had a hanging ratio of 0.5. Of the cast nets measured 40% had a mesh size below the minimum size of 2 inches recommended by the State Fisheries Edicts. Of concern was the continued rise in the number of gill nets with mesh sizes less than 2 inches. There were 2 types of longlines in operation on the lake. The baited and the foul hooking longlines. They were mostly bottom set and the hook size nos. 12-14 (Kirby sea hook) were predominant. Two types of fishing traps were identified, one was covered with a mesh of thin cane, one with netting material. The fishing traps had a mean height of 0.8 m and a mean width at the vase of 0.53 m. The mean mesh size used was 0.86 inches. Citharinus was reported as the most targeted of all fish species on the lake. Synodontis membranaceous was also targeted by most gears especially the smaller meshed nets. Labeo and Tilapia were low on the list of targeted species but their incidence remains high in the catches. (PDF contains 27 pages)

Marketing of fishing gear materials and fishing gear making in parts of Kainji Lake basin

The importance of fishing gear in fishing cannot be over-emphasized; as without it fish cannot be obtained. The method used to catch fish affects the condition in which the product is landed. This means that a bad-catching method would produced bad fish to the consumer. To achieve the goal of self-sufficiency in fish production in Nigeria, there is need to address the lingering problems of fishing gear and craft technology, especially in terms of availability of materials and their cost. The sale and making of fishing gear materials are two areas of fisheries, which are yet to be exploited by the general public as forms of businesses for livelihood. The study is conducted in villages around the lower part of Kainji Lake, towards the dam, including New Bussa. It reveals that only the fishermen themselves are involved in making their own fishing gears while those involved in the selling of fishing gear materials like the sheet netting, ropes, twines, floats, sinkers etc are business men and women who may not have any experience of fishing. Also considered in the study is the art of making fishing crafts like the canoe and gourd. Very few entrepreneurs are involved and they are so skilled that each is specialized in the making of only one kind of craft or gear

Fishing gear experiments in Finland

A comparison of some different European methods of estimating the numbers of fish in a lake using different fishing gear is described. The different gears used were 1. surface trawl used by night 2. bottom trawl used by day 3. trammel nets, set in the evening and lifted in the morning 4. surface seine net used by night 5. bottom seine net used by day 6. Fyke nets, emptied each morning and evening 7. gill nets, set in the evening and lifted in the morning. The most variable catches were from those gears used by day on the bottom and the least variable were those used by night at the surface. The work continued by examining the use of acoustic systems for pelagic fish stock assessment. This gear gave reasonable population estimates for pelagic fish 10m and more below the surface. The advantage of the accoustic method is that it is quick and requires little labour. Its disadvantage is that it is not possible to identify the species and so it must be supplemented by another, conventional method.

Length and sex effects on the spatial structure of catches of Pacific halibut (Hippoglossus stenolepis) on longline gear

Field experiments were conducted to test the hypotheses that Pacific halibut (Hippoglossus stenolepis) display small-scale spatial structure within longline catches, relative to other species and empty hooks, or within-species based on sex or length. Sequential hook-by-hook inventories, along with length and sex data, were taken at thirty-one survey stations. Two-dimensional spatial statistics were used to test for 1) aggregation, defined as the clustering of individuals within a given demographic of size or sex over small intervals of distance; and 2) segregation, defined as the sequential occurrence of individuals within a given demographic of size or sex, uninterrupted by other observations, irrespective of the distance between individuals. Statistically significant structure was detected within catches that is more commonly associated with fish length than sex. Significant spatial structuring occurred at 60% of all stations tested. Significant aggregation of halibut of legal length for commercial retention (≥82 cm) was detected at 44% of stations and aggregation of sublegal-size halibut was detected at 11%. Maleand female-based aggregations were observed at 22% and 11% of stations, respectively. Significant segregation of females was observed at 20% of stations, male segregation occurred at 8% of stations, and segregation by size at 16% of stations. Understanding small-scale spatial structure within longline catches may help us interpret changes in survey and commercial catch data. If structure is generated by behavior, then observed size-at-age or relative sex-ratios may be biased relative to underlying distributions. Although physical processes such as gape limitation should remain stable over the time, dynamic processes may be spatially and temporally variabl

No evidence of bias from fish behavior in the selectivity of size and sex of the protogynous red porgy (Pagrus pagrus, Sparidae) by hook-and-line gear

Most fisheries select the size of fish to be caught (are size selective), and many factors, including gear, market demands, species distributions, fishery laws, and the behavior of both fishermen and fish, can contribute to that selectivity. Most fishing gear is size-selective and some, such as gill nets, are more so than others. The targeting behavior of fishermen is another key reason commercial and recreational fisheries tend to be size-selective. The more successful fishermen constantly seek areas and methods that yield larger or more profitable sizes of fish. Fishery regulations, especially size limits, produce size-selective harvests. Another factor with the potential to cause selectivity in a hook-and-line fishery is the different behavioral responses of fish to the bait or lure, whether the different responses arise among different fish sizes or between the sexes.

Interactions between marine mammals and pelagic longline fishing gear in the U.S. Atlantic Ocean between 1992 and 2004

The U.S. East Coast pelagic longline fishery has a history of interactions with marine mammals, where animals are hooked and entangled in longline gear. Pilot whales (Globicephala spp.) and Risso’s dolphin (Grampus griseus) are the primary species that interact with longline gear. Logistic regression was used to assess the environmental and gear characteristics that influence interaction rates. Pilot whale inter-actions were correlated with warm water temperatures, proximity to the shelf break, mainline lengths greater than 20 nautical miles, and damage to swordfish catch. Similarly, Risso’s dolphin interactions were correlated with geographic location, proximity the shelf break, the length of the mainline, and bait type. The incidental bycatch of marine mammals is likely associated with depredation of the commercial catch and is increased by the overlap between marine mammal and target species habitats. Altering gear characteristics and fishery practices may mitigate incidental bycatch and reduce economic losses due to depredation.

Whole-gear efficiency of a benthic survey trawl for flatfish

Whole-gear efficiency (the proportion of fish passing between the otter doors of a bottom trawl that are subsequently captured) was estimated from data collected during experiments to measure the herding efficiency of bridles and doors, the capture efficiency of the net, and the length of the bridles sufficiently close to the seafloor to elicit a herding response. The experiments were focused on four species of flatfish: arrowtooth flounder (Atheresthes stomias), flathead sole (Hippoglossoides elassodon), rex sole (Glyptocephalus zachirus), and Dover sole (Microstomus pacificus). Whole-gear efficiency varied with fish length and reached maximum values between 40% and 50% for arrowtooth flounder, flathead sole, and rex sole. For Dover sole, however, whole-gear efficiency declined from a maximum of 33% over the length range sampled. Such efficiency estimates can be used to determine catchability, which, in turn, can be used to improve the accuracy of stock assessment models when the time series of a survey is short.

Experiments in gear configuration to reduce bycatch in an estuarine squid-trawl fishery

Three experiments were performed in an estuarine squid-trawl fishery in New South Wales, Australia, to test modifications to trawl nets. Lateral mesh openings were experimentally increased and physical bycatch reduction devices (BRDs) were placed in codends. These modifications aimed to reduce nontargeted catches of fish, while maintaining catches of the targeted broad squid (Photololigo etheridgei) and bottle squid (Loliolus noctiluca). Compared to conventional codends made with 41-mm diamond mesh, codends made with different posterior circumferences and larger 45-mm mesh had no significant effect on the catches of any species. The best performing configurations involved the installation of BRDs designed to separate organisms according to differences in behavior. In particular, versions of a composite square-mesh panel reduced the total weight of bycatch by up to 71% and there was no significant effect on the catches of squid. The results are discussed in terms of the probable differences in behavior between fish and squid in codends. After this study, a square-mesh panel BRD was voluntarily adopted throughout the fishery.

Survival of white marlin (Tetrapturus albidus) released from commercial pelagic longline gear in the western North Atlantic

To estimate postrelease survival of white marlin (Tetrapturus albidus) caught incidentally in regular commercial pelagic longline fishing operations targeting swordfish and tunas, short-duration popup satellite archival tags (PSATs) were deployed on captured animals for periods of 5−43 days. Twenty (71.4%) of 28 tags transmitted data at the preprogrammed time, including one tag that separated from the fish shortly after release and was omitted from subsequent analyses. Transmitted data from 17 of 19 tags were consistent with survival of those animals for the duration of the tag deployment. Postrelease survival estimates ranged from 63.0% (assuming all nontransmitting tags were evidence of mortality) to 89.5% (excluding nontransmitting tags from the analysis). These results indicate that white marlin can survive the trauma resulting from interaction with pelagic longline gear, and indicate that current domestic and international management measures requiring the release of live white marlin from this fishery will reduce fishing mortality on the Atlantic-wide stock.

Diversity of selective and non-selective fishing gear and their impact on inland fisheries in Bangladesh

The paper describes the wide range of traditional fishing gear used by subsistence and professional fishers in the inland waters in Bangladesh as well as their impact on the fisheries and the environment. The negative impacts indicate the need for regulation of specific types of fishing gear at particular times of the year. An awareness/training program should be extended to the fishermen to create awareness of the long-term effects of their fishing practices and to impart knowledge of fishing laws.

Who's working on fishing gear design and construction for small-scale fisheries?

The findings are presented of a search conducted on traditional fishing gear design and construction using the ASFA database (1971-90) and the ICLARM Library and professional staff collections.

Effects of Gear Modifications on the Trawl Performance and Catching Efficiency of the West Coast Upper Continental Slope Groundfish Survey Trawl

Since 1984, annual bottom trawl surveys of the west coast (California–Washington) upper continental slope (WCUCS) have provided information on the abundance, distribution, and biological characteristics of groundfish resources. Slope species of the deep-water complex (DWC) are of particular importance and include Dover sole, Microstomus pacificus; sablefish, Anoplopoma fimbria; shortspine thornyhead, Sebastolobus alascanus; and longspine thornyhead, S. altivelis. In the fall of 1994, we conducted an experimental gear research cruise in lieu of our normal survey because of concerns about the performance of the survey trawl. The experiment was conducted on a soft mud bottom at depths of 460–490 m off the central Oregon coast. Treatments included different combinations of door-bridle rigging, groundgear weight, and scope length. The experimental design was a 2 ´ 2 ´ 2 factorial within a randomized complete-block. Analysis of variance was used to examine the effects of gear modifications on the engineering performance of the trawl (i.e. trawl dimensions, variation in trawl dimensions, and door attitude) and to determine if catch rates in terms of weight and number of DWC species and invertebrates were affected by the gear modifications. Trawl performance was highly variable for the historically used standard trawl configuration. Improvements were observed with the addition of either a 2-bridle door or lighter ground gear. Changes in scope length had relatively little effect on trawl performance. The interaction of door bridle and ground gear weight had the most effect on trawl performance. In spite of the standard trawl’s erratic performance, catch rates of all four DWC species and invertebrates were not significantly different than the 2-bridle/heavy combination, which did the best in terms of engineering performance. The most important factor affecting DWC catch rates was ground gear. Scope length and the type of door bridle had little effect on DWC catch rates. Subsequent revisions to survey gear and towing protocol and their impact on the continuity of the slope survey time series are discussed.

Temporal Changes in a Tropical Nekton Assemblage and Performance of a Prawn Selective Gear

The temporal variation of components of a moderately diverse (H=1.46) tropical estuarine fish assemblage (long. 146°30'E, lat. 8°45'S) was directed by salinities that had been determined by local oceanographic and probably topographic conditions. For this assemblage, two types of intrayear component profiles are predicted. Pooled data (1988-91) reveal a large component of regular/resident species (43%) in an assemblage which has been under a narrow temperature regime «5T). These results facilitate a discussion on the relevance and usefulness of three hypotheses often cited in studies concerning species diversity and component characteristics of the subtropical/tropical coastal nonreef fish assemblages. Manifestations of the assemblage are reflected in catch composition and weights of 39 trials conducted for a selective prawning gear whose performance in bycatch reduction, mainly for finfishes, is judged by an index, E, we have previously proposed. This gear is capable of harvesting the prawn while conserving the demersal fish. Behavioral responses to netting of the prawns and the finfishes, especially the nearshore surface schoolers such as leiognathids, are discussed from several points of view. An adaptation in terms of group selection for leiognathids of their locking mechanism of median fin spines has been interpreted. For the purpose of bycatch reduction or E enhancement, suggestions for improvements in net design and trawl configuration by considering the behavioral features of fish are made. Our original formula of E is modified for general use. Bycatch problems in the regional prawn fisheries and their possible impacts on fishery planning and development in Papua New Guinea as a developing country are discussed. The gear tested may offer enormous ecological and economic benefits. The gear is multipurpose, extremely simple, and can also be used as a biological sampler.