964 resultados para Phase content
Resumo:
High-resolution down-core analyses of the solid phase content of total barium (Batot) and total organic carbon (TOC) back to 25 kyr B.P. were performed on a gravity core from the upper continental slope off Cape Yubi (Morocco). The observed discrepancy between the two potential paleoproductivity proxies, Batot and TOC, initiated supplementary examinations of the pore water, the geochemistry of the clay fraction, X-ray diffraction analyses, and the application of a sequential Ba extraction method of selected samples. Additionally, we analyzed down-core samples of the planktonic foraminifera Turborotalita quinqueloba and Globorotalia inflata for their Ba/Ca ratios. These analyses, which were performed for the first time on these species, were used to reconstruct past oceanic Ba concentrations. We suggest that in the study area, which is characterized by high accumulation rates, the preserved TOC content is a valuable proxy for past primary productivity, whereas the solid phase Batot contents appear to be affected by other mechanisms and factors. Peaks of total barium content in the clay fraction and of Ba/Ca ratios in the planktonic foraminifera shells found during the Younger Dryas and the Heinrich 1 event are likely to result from increased meltwater influx into the northern North Atlantic. We suggest that Ba-enriched meltwater was transmitted by the eastern boundary current system from higher latitudes to the region of the Canary Islands. Total barium contents of the clay fraction (Batot,clay) and Ba/Ca in planktonic foraminifera shells seem to be reliable proxies for this discharge of meltwater.
Resumo:
The need for the simulation of spectrum compatible earthquake time histories has existed since earthquake engineering for complicated structures began. More than the safety of the main structure, the analysis of the equipment (piping, racks, etc.) can only be assessed on the basis of the time history of the floor in which they are contained. This paper presents several methods for calculating simulated spectrum compatible earthquakes as well as a comparison between them. As a result of this comparison, the use of the phase content in real earthquakes as proposed by Ohsaki appears as an effective alternative to the classical methods. With this method, it is possible to establish an approach without the arbitrary modulation commonly used in other methods. Different procedures are described as is the influence of the different parameters which appear in the analysis. Several numerical examples are also presented, and the effectiveness of Ohsaki's method is confirmed.
Resumo:
We investigate the impact of methane concentration in hydrogen plasma on the growth of large-grained polycrystalline diamond (PCD) films and its hydrogen impurity incorporation. The diamond samples were produced using high CH4 concentration in H2 plasma and high power up to 4350 W and high pressure (either 105 or 110 Torr) in a microwave plasma chemical vapor deposition (MPCVD) system. The thickness of the free-standing diamond films varies from 165 µm to 430 µm. Scanning electron microscopy (SEM), micro-Raman spectroscopy and Fourier-transform infrared (FTIR) spectroscopy were used to characterize the morphology, crystalline and optical quality of the diamond samples, and bonded hydrogen impurity in the diamond films, respectively. Under the conditions employed here, when methane concentration in the gas phase increases from 3.75% to 7.5%, the growth rate of the PCD films rises from around 3.0 µm/h up to 8.5 µm/h, and the optical active bonded hydrogen impurity content also increases more than one times, especially the two CVD diamond specific H related infrared absorption peaks at 2818 and 2828 cm−1 rise strongly; while the crystalline and optical quality of the MCD films decreases significantly, namely structural defects and non-diamond carbon phase content also increases a lot with increasing of methane concentration. Based on the results, the relationship between methane concentration and diamond growth rate and hydrogen impurity incorporation including the form of bonded infrared active hydrogen impurity in CVD diamonds was analyzed and discussed. The effect of substrate temperature on diamond growth was also briefly discussed. The experimental findings indicate that bonded hydrogen impurity in CVD diamond films mainly comes from methane rather than hydrogen in the gas source, and thus can provide experimental evidence for the theoretical study of the standard methyl species dominated growth mechanism of CVD diamonds grown with methane/hydrogen mixtures.
Resumo:
It was evaluated the effects of metabolizable energy (ME) and digestible lysine (dLYS) densities on performance and body composition of weaned piglets. The study used 114 piglets weaned at 7.4 ± 0.80 kg, out of which 108 were allotted in the nursery and 6 were slaughtered on the weaning day to determine comparative data of body chemical composition. Six nutrients densities were stipulated from a previous study based on the highest nitrogen retention, maintaining the following ME:LYS relationship in the experimental diets: 3,390:1.291; 3,450:1.409; 3,650:1.411; 3,780:1.461; 3,940:1.507; and 4,109 kcal/kg ME:1.564% dLYS. The experimental diets were offered for 13 days when the piglets reached 12.986 ± 1.449 kg of body weight. The probable residual effects of nutritional density on the subsequent performance of the piglets were evaluated. At the end of initial phase 1, six piglets from each density were slaughtered to determine their chemical composition in body fractions and empty body. There was no significant influence of nutritional levels on the performance of the piglets at the end of the evaluation. The results of food conversion and body composition confirm the level indicated in the previous study, 4 g dLYS/Mcal of ME. The increase of energy and lysine densities confirms the need for a correct relationship among both of them to assure better performance of the piglets at the beginning of the growing phase.
Resumo:
Protein content of leaf-cutting ant queens before the nuptial flight and during the post-claustral phase. This study evaluated the crude protein content of queens of Atta sexdens before the nuptial flight and after the claustral phase in laboratory and field colonies. The hypothesis was that protein is used for survival of the queen and for early colony growth during the claustral phase. Additionally, the nest morphology, live biomass and adult population of field colonies were evaluated. Crude protein was determined by digestion of the organic material with sulfuric acid at high temperatures. The mean crude protein content was 123.23 ± 11.20 mg for females before the nuptial flight and 70.44 ± 12.21 mg for laboratory-reared queens after the claustral phase. The post-claustral crude protein content of field-collected queen was 55.90 ± 9.18 mg. With respect to the loss of crude protein as a function of duration of the claustral phase, laboratory-reared queens lost 52.79 mg and field-collected queens lost 67.33 mg compared to females before the nuptial flight. A positive linear correlation was observed between the weight of field-collected queens (256.4 ± 36.3 mg) and colony biomass (13.02 ± 9.12 g), but there was no correlation between biomass and nest depth (13.11 ± 3.82 cm). As expected, the present results support the hypothesis that protein is used for survival of the queen and for early colony growth, as demonstrated by the reduction in crude protein content as a function of duration of the claustral phase. To our knowledge, this is the first study to provide data of the dynamics of protein reserves in leaf-cutting ant queens during the claustral phase.
Resumo:
To conserve natural resources and energy, the amount of recycled asphalt pavement has been steadily increasing in the construction of asphalt pavements. The objective of this study is to develop quality standards for inclusion of high RAP content. To determine if the higher percentage of RAP materials can be used on Iowa’s state highways, three test sections with target amounts of RAP materials of 30%, 35% and 40% by weight were constructed on Highway 6 in Iowa City. To meet Superpave mix design requirements for mixtures with high RAP contents, it was necessary to fractionate the RAP materials. Three test sections with actual RAP materials of 30.0%, 35.5% and 39.2% by weight were constructed and the average field densities from the cores were measured as 95.3%, 94.0%, and 94.3%, respectively. Field mixtures were compacted in the laboratory to evaluate moisture sensitivity using a Hamburg Wheel Tracking Device. After 20,000 passes, rut depths were less than 3mm for mixtures obtained from three test sections. The binder was extracted from the field mixtures from each test section and tested to identify the effects of RAP materials on the performance grade of the virgin binder. Based on Dynamic Shear Rheometer and Bending Beam Rheometer tests, the virgin binders (PG 64-28) from test sections with 30.0%, 35.5% and 39.2% RAP materials were stiffened to PG 76-22, PG 76-16, and PG 82-16, respectively. The Semi-Circular Bending (SCB) test was performed on laboratory compacted field mixtures with RAP amounts of 30.0%, 35.5% and 39.2% at two different temperatures of -18 and -30 °C. As the test temperature decreased, the fracture energy decreased and the stiffness increased. As the RAP amount increased, the stiffness increased and the fracture energy decreased. Finally, a condition survey of the test sections was conducted to evaluate their short-term pavement performance and the reflective transverse cracking did not increase as RAP amount was increased from 30.0% to 39.2%.
Resumo:
The influence of the Al content on the phase transformations in Cu-Al-Ag alloys was studied by classical differential thermal analysis (DTA), optical microscopy (OM) and X-ray diffractometry (XRD). The results indicated that the increase in the Al content and the presence of Ag decrease the rate of the b1 phase decomposition reaction and contribute for the raise of this transition temperature, thus decreasing the stability range of the perlitic phase resulted from the b1 decomposition reaction.
Resumo:
• Background and Aims Earlier studies have suggested that the drying conditions routinely used by genebanks may not be optimal for subsequent seed longevity. The aim of this study was to compare the effect of hot-air drying with low temperature drying on subsequent seed longevity for 20 diverse rice accessions and to consider how factors related to seed production history might influence the results. • Methods Seeds were produced according to normal regeneration procedures at IRRI. They were harvested at different times (harvest date and days after anthesis (DAA), once for each accession) and dried either in a drying room (DR; 15% RH, 15°C), or in a flat-bed heated-air batch dryer (BD; 45°C, 8 h d-1) for up to 6 daily cycles followed by drying in the DR. Relative longevity was assessed by storage at 10.9% moisture content (m.c.) and 45°C. • Key Results Initial drying in the BD resulted in significantly greater longevity compared with the DR for 14 accessions (seed lots): the period of time for viability to fall to 50% for seeds dried in the BD as a percentage of that for seeds dried throughout in the DR varied between 1.3 and 372.2% for these 14 accessions. The seed lots that responded the most were harvested earlier in the season and at higher moisture content. Drying in the BD did not reduce subsequent longevity compared with DR drying for any of the remaining accessions. • Conclusions Seeds harvested at a m.c. where, according to the moisture desorption isotherm, they could still be metabolically active (>16.2%), may be in the first stage of the post-mass maturity, desiccation phase of seed development and able to increase longevity in response to hot-air drying. The genebank standards regarding seed drying for rice and, perhaps, for other tropical species should be reconsidered.
Resumo:
In this paper an alternative method based on artificial neural networks is presented to determine harmonic components in the load current of a single-phase electric power system with nonlinear loads, whose parameters can vary so much in reason of the loads characteristic behaviors as because of the human intervention. The first six components in the load current are determined using the information contained in the time-varying waveforms. The effectiveness of this method is verified by using it in a single-phase active power filter with selective compensation of the current drained by an AC controller. The proposed method is compared with the fast Fourier transform.
Resumo:
Avaliaram-se os efeitos da densidade de energia metabolizável (EM) e lisina digestível (LIS) sobre o desempenho e a composição corporal de leitões após o desmame. Utilizaram-se 114 animais desmamados aos 7,4 ± 0,80 kg; desses animais, 108 foram alojados na unidade de creche e 6 foram abatidos no dia do desmame para determinação dos dados comparativos da composição química corporal. Seis densidades de nutrientes foram estipuladas a partir de estudo anterior, com base na maior retenção de nitrogênio, mantendo-se as seguintes relações EM:LIS nas dietas experimentais: 3.390:1,291; 3.450:1,409; 3.650:1,411; 3.780:1,461; 3.940:1,507; e 4.109 kcal/kg EM:1,564% LIS. As dietas experimentais foram oferecidas durante 13 dias, quando os leitões atingiram o peso de 12,986 ± 1,449 kg. Avaliaram-se os prováveis efeitos residuais da densidade nutricional no desempenho subseqüente dos leitões. Ao término da fase inicial-1, seis leitões de cada densidade foram abatidos para determinação da composição química nas frações corporais e no corpo vazio. Não houve influência significativa dos níveis nutricionais no desempenho dos leitões ao término da avaliação. Os resultados de conversão alimentar e composição corporal ratificam o nível indicado em estudo anterior, de 4 g LIS/Mcal. O aumento da densidade de energia e lisina confirma a necessidade da correta relação entre ambos para assegurar o melhor desempenho dos leitões na fase inicial de crescimento.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
A neural method is presented in this paper to identify the harmonic components of an ac controller. The components are identified by analyzing the single-phase current waveform. The method effectiveness is verified by applying it to an active power filter (APF) model dedicated to the selective harmonic compensation. Simulation results using theoretical and experimental data are presented to validate the proposed approach. © 2008 IEEE.
Resumo:
An alternative method is presented in this paper to identify the harmonic components of non-linear loads in single phase power systems based on artificial neural networks. The components are identified by analyzing the single phase current waveform in time domain in half-cycle of the ac voltage source. The proposed method is compared to the fast Fourier transform. Simulation and experimental results are presented to validate the proposed approach.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)