Intensities and self-broadening coefficients of the strongest water vapour lines in the 2.7 and 6.25μm absorption bands

Intensities and self-broadening coefficients are presented for about 460 of the strongest water vapour lines in the spectral regions 1400–1840 cm−1 and 3440–3970 cm−1 at room temperature, obtained from rather unique measurements using a 5-mm-path-length cell. The retrieved spectral line parameters are compared with those in the HITRAN database ver. 2008 and 2012 and with recent ab-initio calculations. Both the retrieved intensities and half-widths are on average in reasonable agreement with those in HITRAN-2012. Maximum systematic differences do not exceed 4% for intensities (1600 cm−1 band) and 7% for self-broadening coefficients (3600 cm−1 band). For many lines however significant disagreements were detected with the HITRAN-2012 data, exceeding the average uncertainty of the retrieval. In addition, water vapour line parameters for 5300 cm−1 (1.9 μm) band reported by us in 2005 were also compared with HITRAN-2012, and show average differences of 4–5% for both intensities and half-widths.

Singlet oxygen reacts with 2 `,7 `-dichlorodihydrofluorescein and contributes to the formation of 2 `,7 `-dichlorofluorescein

There are controversial reports in the literature concerning the reactivity of singlet oxygen ((1)O(2)) with the redox probe 2`,7`-dichlorodihydrofluorescein (DCFH). By carefully preparing solutions in which (1)O(2) is quantitatively generated in the presence of DCFH, we were able to show that the formation rate of the fluorescent molecule derived from DCFH oxidation, which is 2`,7`-dichlorofluorescein (DCF), increases in D(2)O and decreases in sodium azide, proving the direct role of (1)O(2) in this process. We have also prepared solutions in which either (1)O(2) or dication (MB(center dot 2+)) and semi-reduced (MB(center dot)) radicals of the sensitizer and subsequently super-oxide radical (O(2)(center dot-)) are generated. The absence of any effect of SOD and catalase ruled out the DCFH oxidation by O(2)(center dot-), indicating that both (1)O(2) and MB(center dot 2+) react with DCFH. Although the formation of DCF was 1 order of magnitude larger in the presence of MB(center dot 2+) than in the presence of (1)O(2), considering the rate of spontaneous decays of these species in aqueous solution, we were able to conclude that the reactivity of (1)O(2) with DCFH is actually larger than that of MB(center dot 2+). We conclude that DCFH can continue to be used as a probe to monitor general redox misbalance induced in biologic systems by oxidizing radicals and (1)O(2).

Estudo de reatividade e resolução enantiomérica do (+-)-10-exo-hidróxipentaciclo[6.2.1.1 3,6.0 2,7. 0 5.9] dodecan-4-ona

Neste trabalho, realizou-se a síntese do ceto-álcool pentaciclíco (±)-5, assim como o estudo de reatividade do grupo carbonila do mesmo frente a reações de oximação e redução. Realizou-se também a resolução enantiomérica do composto (±)-5 através de reação de transesterificação com acetato de vinila catalisada pela lipase da Candida rugosa. Altos excessos enantioméricos foram obtidos (>95%, RMN) tanto para o álcool (+)-5 quanto para o éster formado (-)-8. Sugere-se a existência de uma interconversão enantiomérica no composto (+)-5, devido a observação de mistura racêmica, quando o mesmo foi analisado por cromatografia gasosa em coluna quiral. Um mecanismo para tal interconversão, o qual envolve um rearranjo intramolecular, é proposto.

Estudo da expressão imuno-histoquímica das MMPs -2, -7, -9 e -26 e TIMPs -1 e -2 em adenomas pleomórficos e carcinomas adenóides císticos de glândulas salivares menores

The balance between the expression of matrix metalloproteinases (MMPs) and their tissue inhibitors (TIMPs) has been related to various physiological and pathological processes, including salivary gland morphogenesis and tumor invasion and metastasis processes. Pleomorphic adenoma (PA) and adenoid cystic carcinoma (ACC) respectively represent benign and malignant neoplasias of salivary glands. Although they share the same cell origin, they present distinct biological behavior. The aim of this study was to compare the immunohistochemical expression of MMPs -2, -7, -9 and -26, and of TIMPs -1 and -2, in cases of PA and ACC of minor salivary glands. Twenty cases of PA and twenty cases of ACC were assessed according to the presence, intensity and location of MMPs and TIMPs in the tumor parenchyma. Most of the PAs and ACCs presented a high expression of MMP -2, -7, -9 and -26 and of TIMP -1 and -2, predominantly located in tumor cells. There was no significant difference in the expression of MMPs -2 (p=0.359), -7 (p=0.081) and -26 (p=0.553), as well as of TIMPs -1 (p=0.657) and -2 (p=0.248), between the parenchyma of PAs and ACCs. However, MMP-9 showed a significant difference of expression between the two tumors, with the ACC showing more intense marking for this gelatinase (p=0.041). The strong expression of MMP-9 observed in the parenchyma suggests that this gelatinase may play an important role in the biological behavior of these tumors. On the other hand, although there was no significant difference between the marking of MMP -2, 7 and 26 in the studied tumors, the data, when analyzed as a whole, suggest that these proteases may take part in the process of tissue remodeling in both tumors, but do not present a direct relation with the pattern of aggressiveness of ACC. Nonetheless, matrilisins may indirectly influence the behavior of this tumor due to their capacity of activating MMP-9, strongly expressed in the parenchyma of ACC

Shikimate Kinase (EC 2.7.1.71) from Mycobacterium tuberculosis: Kinetics and Structural Dynamics of a Potential Molecular Target for Drug Development

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Estudos das propriedades estruturais de análogos substituídos com 'TRP POT.2,7 ou 24' do fragmento com 30 resíduos da região amino-terminal da Esticolisina II

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Cinética de sinterização do combustível nuclear 'UO IND. 2.'7%'Gd IND.2''O IND. 3': cálculo da curva mestre de sinterização

Pós-graduação em Ciência e Tecnologia de Materiais - FC

Polymer Light Emitting Diode Using PFT-Poly(9,9 `-n-dihexil-2,7-fluorenodiilvinylene-alt-2,5thiophene)

The development of new electroluminescence polymers for specific colour tuning in Polymer Light Emitting Devices (PLEDs) is currently one of the most important fields for organic electronics. This work reports a synthesis of a new electroluminescent polymer and the concomitant test as PLED emissive layer. The polymer, synthesised from fluorene, is poly(9,9`-n-dihexil-2,7-fluorenodiilvinylene-alt-2,5thiophene) or PFT The luminescence shows large bands with maxima around 480 nm in absorption and 560 nm in emission. The device was made in a three layer structure, with PEDOT:PSS as hole transport layer, PFT as emissive layer and butyl-PBD as electron transport layer. The electroluminescence spectrum shows a strong band peaked at 540 nm. For an applied voltage of 12 Volt, the brightness at normal angle of viewing is near 10 cd/m(2) and the luminous efficiency is of 0.01 lm/W. A discussion about carrier transport and the electroluminescence properties is made.

Photovoltaics from discotic liquid crystalline HBCs & poly(2,7-carbazole)s

In this study, the use of the discotic liquid crystalline HBCs and conjugated polymers based on 2,7-carbazole were investigated in detail as donor materials in organic bulk-heterojunction solar cells. It has been shown that they perform efficiently in photovoltaic devices in combination with suitable acceptors. The efficiency was found to depend strongly dependent on the morphology of the film. By investigation of a series of donor materials with similar molecular structures based on both discotic molecules and conjugated polymers, a structure-performance relation was established, which is not only instructive for these materials but also serves as a guideline for improved molecular design. For the series of HBCs used in this study, it is found that the device efficiency decreases with increasing length of the alkyl substituents in the HBC. Thus, the derivative with the smallest alkyl mantle, being more crystalline compared to the HBCs with longer alkyl chains, gave the highest EQE of 12%. A large interfacial separation was found in the blend of HBC-C6,2 and PDI, since the crystallization of the acceptor occurred in a solid matrix of HBC. This led to small dispersed organized domains and benefited the charge transport. In contrast, blends of HBC-C10,6/PDI or HBC-C14,10/PDI revealed a rather homogeneous film limiting the percolation pathways due to a mixed phase. For the first time, poly(2,7-carbazole) was incorporated as a donor material in solar cells using PDI as an electron acceptor. The good fit in orbital energy levels and absorption spectra led to high efficiency. This result indicates that conjugated polymers with high band-gap can also be applied as materials to build efficient solar cells if appropriate electron acceptors are chosen. In order to enhance the light absorption ability, new ladder-type polymers based on pentaphenylene and hexaphenylene with one and three nitrogen bridges per repeat unit have been synthesized and characterized. The polymer 2 with three nitrogen bridges showed more red-shifted absorbance and emission and better packing in the solid-state than the analogous polymer 3 with only one nitrogen bridge per monomer unit. An overall efficiency as high as 1.3% under solar light was obtained for the device based on 1 and PDI, compared with 0.7% for the PCz based device. Therefore, the device performance correlates to a large extent with the solar light absorption ability and the lateral distance between conjugated polymer chains. Since the lateral distance is determined by the length and number of attached alkyl side chains, it is possible to assume that these substituents insulate the charge carrier pathways and decrease the device performance. As an additional consequence, the active semiconductor is diluted in the insulating matrix leading to a lower light absorption. This work suggests ways to improve device performance by molecular design, viz. maintaining the HOMO level while bathochromically shifting the absorption by adopting a more rigid ladder-type structure. Also, a high ratio of nitrogen bridges with small alkyl substituents was a desirable feature both in terms of adjusting the absorption and maintaining a low lateral inter-chain separation, which was necessary for obtaining high current and efficiency values.

Amphiphile Kammpolymere von Poly(2,7-carbazol)

Die vorliegende Dissertation beschreibt die Verschmelzung der Konzepte von konjugierten Polyelektrolyten und amphiphilen Kammpolymeren in Form von konjugierten, Poly(2,7-carbazol)-basierenden Polyelektrolytkammpolymeren mit Poly(L-lysin)seitenketten sowie Alkyl- oder Polyethylenglykolsubstituenten. Die Synthese wurde durch die Suzuki-Polykondensation von monodispersen Makromonomeren erreicht. Hierbei fand die Precursor-Synthesestrategie Anwendung. In diesem Ansatz war die ε-Aminofunktion des Lysins mit einer Benzoyloxycarbonylschutzgruppe geschützt. Der Aufbau der benötigten monodispersen Makromonomere erfolgte durch die Kupplung von Poly(L-lysin)ketten an den Carbazolbaustein mittels eines aktivierten Esters. Eine Besonderheit der hergestellten Kammpolymere lag in den konformativen Eigenschaften seiner einzelnen Komponenten. Dabei konnte die Konformation der Poly(L-lysin)seitenketten infolge ihres Polyelektrolyt- und Peptidcharakters gezielt mit Hilfe des pH-Wertes und der Ionenstärke variiert werden, wohingegen das konjugierte Rückgrat seine steife Konformation beibehielt. Infolge des Polyelektrolytcharakters zeigte sich zudem, dass die Polymere in sauren und neutralen, wässrigen Lösungen zu großen Teilen in Form von Domänenstrukturen auftraten, während im Basischen eine sofortige Aggregation eintrat. Ein weiteres Merkmal der vorgestellten Polyelektrolytkammpolymere war ihr amphiphiler Charakter. Diese Amphiphilie der in dieser Arbeit vorgestellten Polyelektrolytkammpolymere beeinflusste dabei maßgeblich ihre unstrukturierte Anordnung in Lösung, in der festen Phase sowie an Oberflächen.