Avaliação e modelagem da absorção de H2S do gás natural em coluna de leito estagnado

Natural gas, although basically composed by light hydrocarbons, also presents contaminant gases in its composition, such as CO2 (carbon dioxide) and H2S (hydrogen sulfide). The H2S, which commonly occurs in oil and gas exploration and production activities, causes damages in oil and natural gas pipelines. Consequently, the removal of hydrogen sulfide gas will result in an important reduction in operating costs. Also, it is essential to consider the better quality of the oil to be processed in the refinery, thus resulting in benefits in economic, environmental and social areas. All this facts demonstrate the need for the development and improvement in hydrogen sulfide scavengers. Currently, the oil industry uses several processes for hydrogen sulfide removal from natural gas. However, these processes produce amine derivatives which can cause damage in distillation towers, can cause clogging of pipelines by formation of insoluble precipitates, and also produce residues with great environmental impact. Therefore, it is of great importance the obtaining of a stable system, in inorganic or organic reaction media, able to remove hydrogen sulfide without formation of by-products that can affect the quality and cost of natural gas processing, transport, and distribution steps. Seeking the study, evaluation and modeling of mass transfer and kinetics of hydrogen removal, in this study it was used an absorption column packed with Raschig rings, where the natural gas, with H2S as contaminant, passed through an aqueous solution of inorganic compounds as stagnant liquid, being this contaminant gas absorbed by the liquid phase. This absorption column was coupled with a H2S detection system, with interface with a computer. The data and the model equations were solved by the least squares method, modified by Levemberg-Marquardt. In this study, in addition to the water, it were used the following solutions: sodium hydroxide, potassium permanganate, ferric chloride, copper sulfate, zinc chloride, potassium chromate, and manganese sulfate, all at low concentrations (»10 ppm). These solutions were used looking for the evaluation of the interference between absorption physical and chemical parameters, or even to get a better mass transfer coefficient, as in mixing reactors and absorption columns operating in counterflow. In this context, the evaluation of H2S removal arises as a valuable procedure for the treatment of natural gas and destination of process by-products. The study of the obtained absorption curves makes possible to determine the mass transfer predominant stage in the involved processes, the mass transfer volumetric coefficients, and the equilibrium concentrations. It was also performed a kinetic study. The obtained results showed that the H2S removal kinetics is greater for NaOH. Considering that the study was performed at low concentrations of chemical reagents, it was possible to check the effect of secondary reactions in the other chemicals, especially in the case of KMnO4, which shows that your by-product, MnO2, acts in H2S absorption process. In addition, CuSO4 and FeCl3 also demonstrated to have good efficiency in H2S removal

Thermoluminescence of aluminophosphate glasses in the metaphosphate composition

Potassium aluminum phosphate (KAP) glasses in the system xKPO(3)-(100-x)AI(PO3)3 with x = 10, 30 and 50 mol% were prepared in the metaphosphate composition. The glasses were doped with MnO2 and their thermoluminescent (TL) response was investigated. Raman spectra showed that these glasses did not undergo structural changes with the substitution of manganese ions. The glass composition x = 50 mol% doped with 1.0 mol% of MnO2 presented the best TL response. The material displayed good sensitivity for gamma-rays, X-rays and UV light. The emission curves exhibited two TL peaks, one at a low temperature (similar to 150 degrees C) and the other at a high temperature (similar to 365 degrees C), whose positions were dependent on the type of exciting radiation applied. The results of the present study indicated that the high temperature peak is a good candidate for TL dosimetric investigations. (c) 2006 Elsevier B.V. All rights reserved.

Modos de aplicação de calcário e de micronutrientes em pomar de laranjeira 'Natal' e análise comparativa de custos

De acordo com o Agrianual (2005), a produção citrícola brasileira é de 17,7 milhões de toneladas ano-1,ocupando aproximadamente 1 milhão de hectares no território brasileiro e, deste total, 810 mil hectares localizam-se no Estado de São Paulo. A maioria dos solos brasileiros, inclusive aqueles onde foram instalados os pomares cítricos, apresenta reação ácida. Esta é, sem dúvida, a principal condição desfavorável dos solos e um dos fatores limitantes da produção em solos tropicais. O presente trabalho teve por objetivo estudar o efeito de diferentes modos de aplicação de calcário e de micronutrientes e analisar, de forma comparativa, os custos destes tratamentos em um pomar de laranjeira. O experimento foi desenvolvido na Fazenda Morumbi, município de Estrela D'Oeste-SP, num Argissolo Vermelho-Amarelo. A variedade de laranjeira utilizada foi a 'Natal', enxertada em limão Cravo, com 6 anos de idade e espaçamento 5 x 8 m. O delineamento experimental foi em parcelas subdivididas, com 3 repetições, com 5 tratamentos principais (sem calcário; a necessidade total de calcário (NC) incorporado; NC sem incorporação; ¹/2 NC no primeiro ano + ¹/2 NC no segundo ano e ¹/3 NC no primeiro ano, + ¹/3 NC no segundo ano, + ¹/3 NC no terceiro ano) e dois tratamentos secundários [micronutrientes via solo (FTE-BR 12: 11,5 % de ZnO e B2O3; 1% CuO; 5,4% de Fe2O3; 5,5% de MnO2; 0,2% de MoO3) e micronutrientes via foliar (sulfato de zinco a 0,5% e ácido bórico a 0,08%)], distribuídos em blocos casualizados. Não houve efeito significativo dos modos de aplicação da calagem e de micronutrientes sobre as variáveis avaliadas (produção, sólidos solúveis totais, acidez total titulável). Para massa média do fruto, o efeito significativo aconteceu apenas no primeiro ano, com a calagem em dose única e sem incorporação, e micronutrientes via solo. Concluiu-se que não houve efeito significativo dos modos de aplicação do calcário e dos micronutrientes para produção e massa média dos frutos da laranjeira 'Natal', e a receita líquida foi positiva em todos os tratamentos, sendo que o tratamento 5 [¹/3 da necessidade total de calcário (NC) no 1º ano + ¹/3 da NC no 2º ano, + ¹/3 da NC no 3º ano] apresentou o melhor valor acumulado (U$ 3.721,85 ha-1).

Surface equilibrium angle for anisotropic grain growth in SnO2 systems

Usually, the kinetic models used in the study of sintered ceramic are performed by means of indirect physical tests, such as, results obtained from data of linear shrinkage and mass loss. This fact is justified by the difficulty in the determinations of intrinsic parameters of ceramic materials along every sintering process. In this way, the technique of atomic force microscopy (AFM) was used in order to determine the importance and the evolution of the dihedral angle in the sintering of 0.5 mol% MnO2-doped tin dioxide obtained by the polymeric precursor method.

Evaluation of rare earth oxides doping SnO2.(Co1/4,Mn3/4)O-based varistor system

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Use of a carbon paste electrode modified with spinel-type manganese oxide as a potentiometric sensor for lithium ions in flow injection analysis

A potentiometric sensor constructed from a mixture of 25% (m/m) spinel-type manganese oxide (lambda-MnO2), 50% (m/m) graphite powder and 25% (m/m) mineral oil is used for the determination of lithium ions in a flow injection analysis system. Experimental parameters, such as pH of the carrier solution, flow rate, injection sample volume, and selectivity for Li+ against other alkali and alkaline-earth ions and the response time of this sensor were investigated. The sensor response to lithium ions was linear in the concentration range 8.6 x 10(-5) - 1.0 x 10(-2) mol L-1 with a slope 78.9 +/- 0.3 mV dec(-1) over a wide pH range 7 - 10 (Tris buffer), without interference of other alkali and alkaline-earth metals. For a flow rate of 5.0 mL min(-1) and a injection sample volume of 408.6 muL, the relative standard deviation for repeated injections of a 5.0 x 10(-4) mol L-1 lithium ions was 0.3%.

Influence of the oxygen adsorbed on tin varistors doped with Co, Mn and Cr oxides

The non-ohmic properties of the 98.90% SnO2+(1-x)%CoO+0.05% Cr2O3+0.05% Nb2O5+x% MnO2 varistor system (all of them in mol %), as well as the influence of the oxidizing and reducing atmosphere on this system were studied in this work. Experimental evidence indicates that the electrical properties of the varistor depend on the defects that occur at the grain boundary and on the adsorbed oxygen species such as O''(2), O'(2), O in this region. Thermal treatments at 900 degreesC in oxygen and nitrogen atmospheres indicated such a dependence with the values of the non-linearity coefficient (alpha) increasing under oxygen atmosphere, being reduced in nitrogen atmosphere and restored after a new treatment in oxygen atmosphere, presenting a reversibility in the process. EDS analysis accomplished by SEM showed the distribution of the oxides in the varistor matrix. (C) 2002 Kluwer Academic Publishers.

Influence of the rare-earths oxides doped on the SnO2CoOMnO2Ta2O5 varistor system

The tin dioxide is an n-type semiconductor, which exhibits varistor behavior with high capacity of absorption of energy, whose function is to restrict transitory over-voltages without being destroyed, when it is doped with some oxides. Varistors are used in alternated current fields as well as in continuous current, and it can be applied in great interval of voltages or in great interval of currents. The electric properties of the varistor depend on the defects that happen at the grain boundaries and the adsorption of oxygen. The (98.90-x)%SnO2.0.25%CoO+0.75%MnO2+0.05%Ta2O5+0.05%Tr2O3 systems, in which Tr=La or Nd. Current-voltage measurements were accomplished for determination of the non-linear coefficient were studied. SEM microstructure analysis was made to evaluate the microstructural characteristics of the systems. The results showed that the rare-earth oxides have influenced the electrical behavior presented by the system. (C) 2002 Kluwer Academic Publishers.

Effect of cobalt(II) oxide and manganese(IV) oxide on sintering of tin(IV) oxide

Additions of 0.5 to 2.0 mol% of CoO or MnO2 onto SnO, promote densification of this oxide up to 99% of theoretical density. The temperature of the maximum shrinkage rate (TM) and the relative density in the maximum densification rate (p*) during constant sintering heating rate depend on the dopant concentration. Thus, dopant concentration controls the densifying and nondensifying mechanisms during sintering. The densification of SnO2 witih addition of CoO or MnO, is explained in terms of the creation of oxygen vacancies.

Interações de alguns ácidos orgânicos com minerais e um latossolo vermelho

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Estudo de um sistema varistor à base de 'SN''O IND.2' dopado com terras-raras

Pós-graduação em Química - IQ

Major elements and trace ferrides in deep sea cores obtained during the Swedish Deep-Sea Expedition in 1947-1948

Samples from sediment cores collected during the Swedish Deep-Sea Expedition 1947-1948 have been analyzed in the Geochemical laboratory of the Geological Survey of Sweden. Most samples were placed at our disposal by Professor Hans Pettersson, leader of the expedition mentioned. For complementary studies, samples from the Atlantic and Indian oceans were included in our investigation and the samples placed at our disposal by Professor B. Kullenberg, Göteborg. From the Tyrrhenian Sea we got samples from Professor E. Norin, Uppsala.

Description and chemical composition of manganese deposits during the deep-sea expedition of the streamer Valdivia in 1898-1899

This monograph forms the fourth part of the tenth volume of the scientific results of the voyage of the German exploring ship Valdivia in the Atlantic and Indian Oceans, made during the years 1898-1899. These volumes are published under the editorship of Prof. Chun, the zoologist of Leipzig, who was leader of the expedition ; and Prof. E. Philippi with the cooperation of Sir John Murray. The nature of the materials brought up at various points during the voyage is well illustrated by a series of plates, similar to those accompanying the Challenger volumes. Among the concretions from the Agulhas Bank were found phosphatic nodules containing 33 per cent, of calcium carbonate, 28 of calcium phosphate, 14.6 of calcium sulphate, and 4.8 of magnesium carbonate, with some ferric oxide, alumina, and silica. These nodules were dredged at a depth of 155 metres. Off the coast of Namibia, a large quantity of manganese nodules were also dredged. Their chemical analysis performed at the Mineralogical Institute of the University Jena show similar composition as the nodules recovered by the "Challenger" at station 253 in the Pacific Ocean.

Description and chemical composition of ferromanganese encrustations and deposits in the Atlantic Ocean from R/V Atlantis II cruises 20, 42, 60, 85; R/V Chain cruise 35; R/V Knorr cruise 61 and RRS Shackleton cruise 75/1 stations

Chemical and mineralogical compositions of ferromanganese oxide coatings on rocks dredged from the New England Seamounts, the Sierra Leone Rise and the Mid-Atlantic Ridge near the Equator have been determined in an investigation of regional differences in Atlantic ferromanganese deposits. Most encrustations are clearly of hydrogenous origin, consisting mainly of todorokite and delta MnO2, but several recovered from the equatorial fracture zones may be hydrothermal accumulations. Differences in the chemistry of the water column and in growth rates of the ferromanganese coatings may be important in producing this regional contrast in composition. Fine-scale changes in element abundances within the encrustations indicate that the nature of the substrate has little influence on compositional variations.

Geochemical composition of a representative collection of manganese nodules and slabs collected in the Western Pacific

Chemical analyses were performed on seveteen manganese nodules collected from the Pacific Ocean floor. The results were discussed compared with the previous data on the manganese nodules. Minerals were found to be todorokite, delta-MnO2 and other silicates, montmorillonite, illite, phillipsite and alpha-SiO2. Average composition shows that copper is concentrated on the deep sea nodules more than the shallow ones, and that the todorokite rich nodules contain more copper and nickel than the delta-MnO2 rich ones.