Interference cancellation in two-path successive relay system with network coding

This paper proposes a novel interference cancellation algorithm for the two-path successive relay system using network coding. The two-path successive relay scheme was proposed recently to achieve full date rate transmission with half-duplex relays. Due to the simultaneous data transmission at the relay and source nodes, the two-path relay suffers from the so-called inter-relay interference (IRI) which may significantly degrade the system performance. In this paper, we propose to use the network coding to remove the IRI such that the interference is first encoded with the network coding at the relay nodes and later removed at the destination. The network coding has low complexity and can well suppress the IRI. Numerical simulations show that the proposed algorithm has better performance than existing approaches.

Joint compensation of multiple RF impairments in MIMO STBC systems

In this paper, we propose a compensation method for the joint effect of high-power amplifier (HPA) nonlinearity, in-phase/quadrature-phase (I/Q) imbalance and crosstalk in multiple-input multiple-output (MIMO) orthogonal space-time block coding (OSTBC) systems. The performance of the MIMO OSTBC equipped with the proposed compensation mechanism is evaluated in terms of average symbol error probability and system capacity, in Rayleigh fading channels. Numerical results are provided and show the effects on performance of several system parameters, namely, the HPA parameters, image-leakage ratio, crosstalk, numbers of antennas, and phase-shift keying modulation order.

Optimal beamforming in MIMO systems with HPA nonlinearity

In this paper, multiple-input multiple-output (MIMO) transmit beamforming (TB) systems under the consideration of nonlinear high-power amplifiers (HPAs) are investigated. The optimal beamforming scheme, with the optimal beamforming weight vector and combining vector, is proposed for MIMO systems with HPA nonlinearity. The performance of the proposed MIMO beamforming scheme in the presence of HPA nonlinearity is evaluated in terms of average symbol error probability (SEP), outage probability and system capacity, considering transmission over uncorrelated quasi-static frequency-flat Rayleigh fading channels. Numerical results are provided and show the effects of several system parameters, namely, parameters of nonlinear HPA, numbers of transmit and receive antennas, and modulation order of phase-shift keying (PSK), on performance.

Impact of HPA nonlinearity on MIMO systems with quantized equal gain transmission

In this paper, we investigate the performance of multiple-input multiple-output (MIMO) transmit beamforming (TB) systems in the presence of nonlinear high-power amplifiers (HPAs). Due to the suboptimality of maximal ratio transmission/maximal ratio combining (MRT/MRC) under HPA nonlinearity, quantized equal gain transmission (QEGT) is suggested as a feasible TB scheme. The effect of HPA nonlinearity on the performance of MIMO QEGT/MRC is evaluated in terms of the average symbol error probability (SEP) and system capacity, considering transmission over uncorrelated quasi-static frequency-flat Rayleigh fading channels. Numerical results are provided and show the effects of several system parameters, such as the parameters of nonlinear HPA, cardinality of the beamforming weight vector codebook, and modulation order of quadrature amplitude modulation (QAM), on performance.

Estudo do efeito de dipolos em arranjos de antenas adaptativas de sistemas de comunicação DS-CDMA

This master dissertation introduces a study about some aspects that determine the aplication of adaptative arrays in DS-CDMA cellular systems. Some basics concepts and your evolution in the time about celular systems was detailed here, meanly the CDMA tecnique, specialy about spread-codes and funtionaly principies. Since this, the mobile radio enviroment, with your own caracteristcs, and the basics concepts about adaptive arrays, as powerfull spacial filter was aborded. Some adaptative algorithms was introduced too, these are integrants of the signals processing, and are answerable for weights update that influency directly in the radiation pattern of array. This study is based in a numerical analysis of adaptative array system behaviors related to the used antenna and array geometry types. All the simulations was done by Mathematica 4.0 software. The results for weights convergency, square mean error, gain, array pattern and supression capacity based the analisis made here, using RLS (supervisioned) and LSDRMTA (blind) algorithms

Predicao de campo em comunicacao sem fio

Even living in the XXI century are still some difficulties in access to broadband Internet in several Brazilian cities, due to the purchasing power of people and lack of government investment. But even with these difficulties, we seek to encourage the use of wireless technology, which is based on the IEEE 802.11b protocol - also known as Wi-Fi (Wireless Fidelity) Wireless Fidelity Communications, having wide range of commercial applications in the world market, nationally and internationally. In Brazil, this technology is in full operation in major cities and has proved attractive in relation to the access point to multipoint and point-to-point. This paper is a comparative analysis of prediction field, using models based on the prediction of propagation loss. To validate the techniques used here, the Okumura-Hata models, modified Okumura-Hata, Walfisch-Ikegami model, were applied to a wireless computer network, located in the neighborhood of Cajupiranga in the city of Melbourn, in Rio Grande do Norte . They are used for networking wireless 802.11b, using the Mobile Radio to measure signal levels, beyond the heights of the antennas and distances from the transmitter. The performance data versus distance are added to the graphs generated and compared with results obtained through calculations of propagation models

Estudo do efeito de dipolos em arranjos de antenas adaptativas de sistemas de comunicação DS-CDMA

This master dissertation introduces a study about some aspects that determine the aplication of adaptative arrays in DS-CDMA cellular systems. Some basics concepts and your evolution in the time about celular systems was detailed here, meanly the CDMA tecnique, specialy about spread-codes and funtionaly principies. Since this, the mobile radio enviroment, with your own caracteristcs, and the basics concepts about adaptive arrays, as powerfull spacial filter was aborded. Some adaptative algorithms was introduced too, these are integrants of the signals processing, and are answerable for weights update that influency directly in the radiation pattern of array. This study is based in a numerical analysis of adaptative array system behaviors related to the used antenna and array geometry types. All the simulations was done by Mathematica 4.0 software. The results for weights convergency, square mean error, gain, array pattern and supression capacity based the analisis made here, using RLS (supervisioned) and LSDRMTA (blind) algorithms.

Limitations of trust management schemes in VANET and countermeasures

Vehicular networks ensure that the information received from any vehicle is promptly and correctly propagated to nearby vehicles, to prevent accidents. A crucial point is how to trust the information transmitted, when the neighboring vehicles are rapidly changing and moving in and out of range. Current trust management schemes for vehicular networks establish trust by voting on the decision received by several nodes, which might not be required for practical scenarios. It might just be enough to check the validity of incoming information. Due to the ephemeral nature of vehicular networks, reputation schemes for mobile ad hoc networks (MANETs) cannot be applied to vehicular ad hoc networks (VANET). We point out several limitations of trust management schemes for VANET. In particular, we identify the problem of information cascading and oversampling, which commonly arise in social networks. Oversampling is a situation in which a node observing two or more nodes, takes into consideration both their opinions equally without knowing that they might have influenced each other in decision making. We show that simple voting for decision making, leads to oversampling and gives incorrect results. We propose an algorithm to overcome this problem in VANET. This is the first paper which discusses the concept of cascading effect and oversampling effects to ad hoc networks. © 2011 IEEE.

SCAD: Sensor Context-aware Adaptive Duty-cycled Beaconless Opportunistic Routing for WSNs

Low quality of wireless links leads to perpetual transmission failures in lossy wireless environments. To mitigate this problem, opportunistic routing (OR) has been proposed to improve the throughput of wireless multihop ad-hoc networks by taking advantage of the broadcast nature of wireless channels. However, OR can not be directly applied to wireless sensor networks (WSNs) due to some intrinsic design features of WSNs. In this paper, we present a new OR solution for WSNs with suitable adaptations to their characteristics. Our protocol, called SCAD-Sensor Context-aware Adaptive Duty-cycled beaconless opportunistic routing protocol is a cross-layer routing approach and it selects packet forwarders based on multiple sensor context information. To reach a balance between performance and energy-efficiency, SCAD adapts the duty-cycles of sensors according to real-time traffic loads and energy drain rates. We compare SCAD against other protocols through extensive simulations. Evaluation results show that SCAD outperforms other protocols in highly dynamic scenarios.

Robust indoor localization of narrowband signals

Many location-based services target users in indoor environments. Similar to the case of dense urban areas where many obstacles exist, indoor localization techniques suffer from outlying measurements caused by severe multipath propaga??tion and non-line-of-sight (NLOS) reception. Obstructions in the signal path caused by static or mobile objects downgrade localization accuracy. We use robust multipath mitigation techniques to detect and filter out outlying measurements in indoor environments. We validate our approach using a power-based lo??calization system with GSM. We conducted experiments without any prior knowledge of the tracked device's radio settings or the indoor radio environment. We obtained localization errors in the range of 3m even if the sensors had NLOS links to the target device.

Proceso de replanteo de un nodo urbano

El continuo desarrollo que está teniendo el mundo de las telecomunicaciones móviles hace que la red móvil esté sufriendo progresivos cambios para adaptarse a las nuevas tecnologías móviles que ofrecen un mejor servicio. El cambio en la red móvil no solo se produce por el desarrollo de las nuevas generaciones móviles. La red móvil se adapta también a la demanda de usuarios la cual no deja de incrementar a lo largo de los últimos años. Por tanto, los operadores tienen que ampliar su red instalando nodos que tengan las nuevas tecnologías y también las anteriores. Aparte de crear nuevos nodos también tienen que modificar sus nodos antiguos y convertirlos en nodos que soporten mayor número de usuarios. Hoy en día, en España, se están instalando nuevos nodos con 2G, 3G y 4G y además se están realizando ampliaciones de portadora para 3G. Este proyecto se divide en cuatro partes, la primera de ella se centra en explicar el proceso a seguir para la instalación de un nuevo nodo urbano. Este proceso es muy parecido para instalar un nodo con una tecnología u otra, en el caso del proyecto se explicarán los pasos a seguir para la instalación de un nodo con 2G y 3G. Posteriormente se explicará cómo se realizan las medidas para corroborar el correcto funcionamiento de un nodo rural y se compararán a las medidas de zona urbana mediante capturas de un nodo específico. En la penúltima parte del proyecto se estudia la cobertura en interiores y las diversas soluciones que se toman normalmente para mejorar dicha cobertura en edificios, almacenes y centros comerciales. Por último aparecen las conclusiones del proyecto y los trabajos futuros en donde se realiza una visión de posibles estudios relacionados con este proyecto y una visión de cómo puede quedar formada la red en unos años. ABSTRACT. Due to the continuous development of mobile telecommunications the mobile networks have undergone rapid changes to adapt to new mobile technologies that offer a better service. The mobile network change hasn´t only occurred because of the development of new generations of mobile radio-communications. The mobile network adapts itself to user demand, which has been growing over the last few years faster than expected. Therefore, mobile operators have to enlarge its network by installing nodes that share the old and new technologies. Apart from creating new nodes, the operators have to modify the old ones and turn them into nodes that support an increasing number of users. Nowadays, in Spain new nodes with 2G 3G and 4G are being installed, and carrier extensions for 3G are being made as well. This project is divided into four parts. The first chapter focuses on explaining the process that should be followed to install a new urban node. This process is similar to install a node with any of the technologies available. In the case of this project, the steps to follow in setting up a wireless node with 2G and 3G will be detailed. Afterwards, in the second chapter the document continues explaining the measurements that should be carried out to ensure proper performance of a rural node. Then, those measurements will be compared with the ones of an urban node. In the third part of the project it is explained how coverage indoor studies are performed, and the different solutions that are usually proposed to improve coverage in buildings, stores and shopping centers. The last chapter explains the conclusions that have been reached and future works. It is provided a widespread view of possible studies related to this project and how the mobile will improve in the following years.

CB-AIDS digital adapter : technical manual no. 1 /

Mode of access: Internet.

CB-AIDS remote station : technical manual no. 2 /

Mode of access: Internet.

Investigations into a wideband spatial beamformer employing a rectangular array of planar monopoles

This paper presents a rectangular array antenna with a suitable signal-processing algorithm that is able to steer the beam in azimuth over a wide frequency band. In the previous approach, which was reported in the literature, an inverse discrete Fourier transform technique was proposed for obtaining the signal weighting coefficients. This approach was demonstrated for large arrays in which the physical parameters of the antenna elements were not considered. In this paper, a modified signal-weighting algorithm that works for arbitrary-size arrays is described. Its validity is demonstrated in examples of moderate-size arrays with real antenna elements. It is shown that in some cases, the original beam-forming algorithm fails, while the new algorithm is able to form the desired radiation pattern over a wide frequency band. The performance of the new algorithm is assessed for two cases when the mutual coupling between array elements is both neglected and taken into account.

Packet voice/data in local broadcast networks

A local area network that can support both voice and data packets offers economic advantages due to the use of only a single network for both types of traffic, greater flexibility to changing user demands, and it also enables efficient use to be made of the transmission capacity. The latter aspect is very important in local broadcast networks where the capacity is a scarce resource, for example mobile radio. This research has examined two types of local broadcast network, these being the Ethernet-type bus local area network and a mobile radio network with a central base station. With such contention networks, medium access control (MAC) protocols are required to gain access to the channel. MAC protocols must provide efficient scheduling on the channel between the distributed population of stations who want to transmit. No access scheme can exceed the performance of a single server queue, due to the spatial distribution of the stations. Stations cannot in general form a queue without using part of the channel capacity to exchange protocol information. In this research, several medium access protocols have been examined and developed in order to increase the channel throughput compared to existing protocols. However, the established performance measures of average packet time delay and throughput cannot adequately characterise protocol performance for packet voice. Rather, the percentage of bits delivered within a given time bound becomes the relevant performance measure. Performance evaluation of the protocols has been examined using discrete event simulation and in some cases also by mathematical modelling. All the protocols use either implicit or explicit reservation schemes, with their efficiency dependent on the fact that many voice packets are generated periodically within a talkspurt. Two of the protocols are based on the existing 'Reservation Virtual Time CSMA/CD' protocol, which forms a distributed queue through implicit reservations. This protocol has been improved firstly by utilising two channels, a packet transmission channel and a packet contention channel. Packet contention is then performed in parallel with a packet transmission to increase throughput. The second protocol uses variable length packets to reduce the contention time between transmissions on a single channel. A third protocol developed, is based on contention for explicit reservations. Once a station has achieved a reservation, it maintains this effective queue position for the remainder of the talkspurt and transmits after it has sensed the transmission from the preceeding station within the queue. In the mobile radio environment, adaptions to the protocols were necessary in order that their operation was robust to signal fading. This was achieved through centralised control at a base station, unlike the local area network versions where the control was distributed at the stations. The results show an improvement in throughput compared to some previous protocols. Further work includes subjective testing to validate the protocols' effectiveness.