1000 resultados para LIME APPLICATION
Resumo:
This work aimed to evaluate root growth, shoot development and nutrient absorption efficiency by rice cultivars Caiapo and Maravilha as affected by lime application. The experiment was carried out in a greenhouse, with treatments set up by Caiapo and Maravilha cultivars in combination with the base saturation (V%) of 10%, 40% and 70%. The experiment was in a randomized complete block design, with four replications. The number of tillers, root length, root dry matter, leaves and stems, leaf content and macronutrients absorption efficiency were evaluated. Comparing cultivars, Maravilha cultivar presented higher root dry weight, root length, number of stems, dry matter of stems and shoot than Caiapo cultivar, as well as accumulated more nutrients in the shoots. on the other hand, nutrient contents were higher in the cultivar Caiapo compared to Maravilha. Maravilha cultivar shows greater root and shoot growth while Caiapo shows higher nutrient absorption efficiency from the soil. The base saturation of 40% is the most effective for both cultivars.
Resumo:
Toxic levels of Al and low availability of Ca have been shown to decrease root growth, which can also be affected by P availability. In the current experiment, initial plant growth and nutrition of cotton (Gossypium hirsutum var. Latifolia) were studied as related to its root growth in response to phosphorus and lime application. The experiment was conducted in Botucatu, Sao Paulo, Brazil, in pots containing a Dark Red Latosol (Acrortox, 20% clay, 72% sand). Lime was applied at 0.56, 1.12 and 1.68 g kg -1 and phosphorus was applied at 50, 100 and 150 mg kg -1. Two cotton (cv. IAC 22) plants were grown per pot for up to 42 days after plant emergence. There was no effect of liming on shoot dry weight, root dry matter yield, root surface and length, but root diameter was decreased with the increase in soil Ca. Shoot dry weight, as well as root length, surface and dry weight were increased with soil P levels up to 83 mg kg -1. Phosphorus concentration in the shoots was increased from 1.6 to 3.0 g kg -1 when soil P was increased from 14 to 34 mg kg -1. No further increases in P concentration were observed with higher P rates. The shoot/root ratio was also increased with P application as well as the amount of nutrients absorbed per unit of root surface. In low soil P soils the transport of the nutrient to the cotton root surface limits P uptake. In this case an increase in root growth rate due to P fertilisation does not compensate for the low P diffusion in the soil.
Resumo:
Applying lime on the soil surface in soils managed under no-tillage has caused an excess of basic cations in the most superficial layers of the soil profile. On the other hand, subsoil acidity is considered a constraint to the development of deep plant roots. The objective of this study was to evaluate Ca 2+, Mg 2+, NO 3- and SO 4 2- leaching in the soil profile as affected by liming and top dressing nitrogen fertilization in cotton, grown with straw cover on the soil surface. Cotton plants (Gossypium hirsutum) were grown for 60 days in PVC columns filled with a Distroferric Red Latosol (sand loam Rhodic Oxisol) with liming applied over the straw on the soil surface, incorporated liming 0-20 cm deep, or without liming. Nitrogen was applied at rates of 0, 50, 100 and 150 kg ha -1 as ammonium sulfate. The PVC columns were set up in layers of 0-5, 5-10, 10-20, 20-30 and 30-30 cm, totaling 15.71 dm 3. The ammonium sulfate application caused intense leaching of SO 4 2- in the soil, irrespective of the lime application method. Liming increased the concentration of NO 3 in the 0-20 cm soil layer, whereas the correction of the soil acidity did not affect the NO 3- concentration in the 30-50 cm soil layer. The influence of ammonium sulfate on Ca 2+ leaching below 20 cm was only observed in the soil with incorporated lime. Nitrogen application resulted in extensive Mg 2+ leaching from the soil, regardless of the lime application method. In the soil layer below 30 cm, SO 4 2- presented a higher correlation than NO 3- in the formation of ionic pairs with Ca 2+ and Mg 2+.
Resumo:
Pós-graduação em Agronomia (Ciência do Solo) - FCAV
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Pós-graduação em Agronomia (Agricultura) - FCA
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Pós-graduação em Agronomia - FEIS
Resumo:
Pós-graduação em Agronomia - FEIS
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Traditionally, asphalt mixtures were produced at high temperatures (between 150°C to 180°C) and therefore often referred to as Hot Mix Asphalt (HMA). Recently, a new technology named Warm Mix Asphalt (WMA) was developed in Europe that allows HMA to be produced at a lower temperature. Over years of research efforts, a few WMA technologies were introduced including the foaming method using Aspha-min® and Advera® WMA; organic additives such as Sasobit® and Asphaltan B®; and chemical packages such as Evotherm® and Cecabase RT®. Benefits were found when lower temperatures were used to produce asphalt mixtures, especially when it comes to environmental and energy savings. Even though WMA has shown promising results in energy savings and emission reduction, however, only limited studies and laboratory tests have been conducted to date. The objectives of this project are to 1) develop a mix design framework for WMA by evaluating its mechanical properties; 2) evaluate performance of WMA containing high percentages of recycled asphalt material; and 3) evaluate the moisture sensitivity in WMA. The test results show that most of the WMA has higher fatigue life and TSR which indicated WMA has better fatigue cracking and moisture damage resistant; however, the rutting potential of most of the WMA tested were higher than the control HMA. A recommended WMA mix design framework was developed as well. The WMA design framework was presented in this study to provide contractors, and government agencies successfully design WMA. Mixtures containing high RAP and RAS were studied as well and the overall results show that WMA technology allows the mixture containing high RAP content and RAS to be produced at lower temperature (up to 35°C lower) without significantly affect the performance of asphalt mixture in terms of rutting, fatigue and moisture susceptibility. Lastly, the study also found that by introducing the hydrated lime in the WMA, all mixtures modified by the hydrated lime passed the minimum requirement of 0.80. This indicated that, the moisture susceptibility of the WMA can be improved by adding the hydrated lime.
Resumo:
The objective of this study was to evaluate the effect of girdling of branches and the application of GA3, still in the main crop flowering on the formation of reproductive structures, the fruit set of the following extemporaneous flowering of 'Tahiti' acid lime. This work used a randomized block design with five replications in a 4x3 factorial design. The first factor was the foliar application of GA3, 88 days before extemporaneous flowering at five concentrations (0, 7, 14 and 21 mg.L-1). The second factor was the girdling times, 108 days before flowering onset (A108AF), 78 days before flowering (A78AF) plus no-girdling control (NG). In extemporaneous flowering, the proportion of buds, flowers and fruits that abscised was 38.75, 31.25 and 18.64% respectively and 11.34% of all reproductive structures formed were collected. GA3 did not affect fruit set. Girdling increased fruit set by 229 and 256% at A108DAF and A78DAF respectively, in relation to NG plants. The GA3 reduced the formation of floral structures, which resulted in a quadratic increase in field production by reducing the competition for photoassimilates among fruits. The concentration of 21 mg.L-1 was the most productive, with 15.97 fruit.plant-1.
Resumo:
Intern.Conference AZULEJAR, Univ. Aveiro, 10-12 October 2012